@article{MiyamotoSekiWagneretal.2014,
  author    = {Miyamoto, K. and Seki, K. and Wagner, Torsten and Sch{\"o}ning, Michael Josef and Yoshinobu, T.},
  title     = {Enhancement of the spatial resolution of the chemical imaging sensor by a hybrid fiber-optic illumination},
  series = {Procedia Engineering},
  volume    = {87},
  journal   = {Procedia Engineering},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1877-7058},
  doi       = {10.1016/j.proeng.2014.11.563},
  pages     = {612 -- 615},
  year      = {2014},
  abstract  = {The chemical imaging sensor, which is based on the principle of the light-addressable potentiometric sensor (LAPS), is a powerful tool to visualize the spatial distribution of chemical species on the sensor surface. The spatial resolution of this sensor depends on the diffusion of photocarriers excited by a modulated light. In this study, a novel hybrid fiber-optic illumination was developed to enhance the spatial resolution. It consists of a modulated light probe to generate a photocurrent signal and a ring of constant light, which suppresses the lateral diffusion of minority carriers excited by the modulated light. It is demonstrated that the spatial resolution was improved from 92 μm to 68 μm.},
  language  = {en}
}
@article{BragardBragard2003,
  author    = {Bragard, Michael and Bragard, G.},
  title     = {Erweiterungen f{\"u}r das CBL2-Messinterface von Texas-Instruments},
  series = {Der mathematische und naturwissenschaftliche Unterricht : MNU ; Organ des Deutschen Vereins zur F{\"o}rderung des Mathematischen und Naturwissenschaftlichen Unterrichts e.V.},
  volume    = {56},
  journal   = {Der mathematische und naturwissenschaftliche Unterricht : MNU ; Organ des Deutschen Vereins zur F{\"o}rderung des Mathematischen und Naturwissenschaftlichen Unterrichts e.V.},
  number    = {2},
  publisher = {Seeberger},
  address   = {Neuss},
  issn      = {0025-5866},
  pages     = {87 -- 88},
  year      = {2003},
  abstract  = {Das von Texas-Instruments (TI) vertriebene Interface CBL2 wird {\"u}ber einige TI-Grafik-Rechner (TI-92, TI-89 usw.) angesteuert. Wegen seiner Handlichkeit wird dieses System beim Unterricht in wechselnden R{\"a}umen »großen« Messwerterfassungssystemen oft vorgezogen. Das CBL2 bietet drei analoge Eing{\"a}nge, die immerhin mit 10 Bit Aufl{\"o}sung und bis zu einer Frequenz von 50 kHz arbeiten. Weiterhin besitzt das CBL2 eine Buchse f{\"u}r angeblich nur einen digitalen Ein- bzw. Ausgang. An diesem Eingang wird standardm{\"a}ßig haupts{\"a}chlich der Bewegungssensor CBR betrieben. In diesem Beitrag werden Erweiterungsm{\"o}glichkeiten dieses Anschlusses beschrieben.},
  language  = {de}
}
@article{Bragard2008,
  author    = {Bragard, Michael},
  title     = {Effektvoller LED-Kreisel : zeigt Text wie programmiert, wenn er rotiert},
  series = {Elektor : electronics worldwide},
  volume    = {39},
  journal   = {Elektor : electronics worldwide},
  number    = {12},
  issn      = {0932-5468},
  pages     = {18 -- 23},
  year      = {2008},
  abstract  = {Wenn eine runde Platine mit LED-Zeile rotiert, entstehen leuchtende Ringe. Steuert man die LEDs mit einem Mikrocontroller an, lassen sich aber auch "stehende" Bilder darstellen. Unser elektronischer Kreisel kann Buchstaben und Ziffern anzeigen. Dabei wird das Erdmagnetfeld auf clevere Weise zur Synchronisation genutzt. Hier reichen die Anwendungen vom Rundenz{\"a}hler bis zum Kompass!},
  language  = {de}
}
@article{BragardBragard2012,
  author    = {Bragard, G. and Bragard, Michael},
  title     = {Ein kosteng{\"u}nstiges, universelles Modellbauinterface},
  series = {Der mathematische und naturwissenschaftliche Unterricht : MNU ; Organ des Deutschen Vereins zur F{\"o}rderung des Mathematischen und Naturwissenschaftlichen Unterrichts e.V.},
  volume    = {65},
  journal   = {Der mathematische und naturwissenschaftliche Unterricht : MNU ; Organ des Deutschen Vereins zur F{\"o}rderung des Mathematischen und Naturwissenschaftlichen Unterrichts e.V.},
  number    = {5},
  publisher = {Seeberger},
  address   = {Neuss},
  issn      = {0025-5866},
  pages     = {290 -- 293},
  year      = {2012},
  abstract  = {Wir stellen einen USB-Baustein vor, der eine kosteng{\"u}nstige und universelle M{\"o}glichkeit schafft , im Unterricht den Themenkreis Messen-Steuern-Regeln zu behandeln. Die Funktionalit{\"a}t orientiert sich am CVK-Interface der Firma Fischertechnik. Im Gegensatz zu kommerziellen L{\"o}sungen erlaubt unser Aufbau auch den preiswerten Einsatz in Gruppen- oder Einzelarbeit. Abschließend berichten wir {\"u}ber ein Beispiel aus dem Unterrichtseinsatz.},
  language  = {de}
}
@article{BragardvanHoekDeDoncker2012,
  author    = {Bragard, Michael and van Hoek, H. and De Doncker, R. W.},
  title     = {A major design step in IETO concept realization that allows overcurrent protection and pushes limits of switching performance},
  series = {IEEE transactions on power electronics},
  volume    = {27},
  journal   = {IEEE transactions on power electronics},
  number    = {9},
  publisher = {IEEE},
  address   = {New York},
  issn      = {0885-8993},
  doi       = {10.1109/TPEL.2012.2189136},
  pages     = {4163 -- 4171},
  year      = {2012},
  abstract  = {This paper presents the latest prototype of the integrated emitter turn-off thyristor concept, which potentially ranks among thyristor high-power devices like the gate turn-off thyristor and the integrated gate-commutated thyristor (IGCT). Due to modifications of the external driver stage and mechanical press-pack design optimization, this prototype allows for full device characterization. The turn-off capability was increased to 1600 A with an active silicon area of 823mm2 . This leads to a transient peak power of 672.1kW/cm² . Within this paper, measurements and concept assessment are presented and a comparison to state-of-the-art IGCT devices is provided.},
  language  = {en}
}
@article{BragardConradvanHoeketal.2011,
  author    = {Bragard, Michael and Conrad, M. and van Hoek, H. and De Doncker, R. W.},
  title     = {The integrated emitter turn-off thyristor (IETO) : an innovative thyristor-based high power semiconductor device using MOS assisted turn-off},
  series = {IEEE transactions on industry applications},
  volume    = {47},
  journal   = {IEEE transactions on industry applications},
  number    = {5},
  publisher = {IEEE},
  address   = {New York},
  issn      = {0093-9994},
  doi       = {10.1109/TIA.2011.2161432},
  pages     = {2175 -- 2182},
  year      = {2011},
  language  = {en}
}
@article{DachwaldMikuckiTulaczyketal.2014,
  author    = {Dachwald, Bernd and Mikucki, Jill and Tulaczyk, Slawek and Digel, Ilya and Espe, Clemens and Feldmann, Marco and Francke, Gero and Kowalski, Julia and Xu, Changsheng},
  title     = {IceMole : A maneuverable probe for clean in situ analysis and sampling of subsurface ice and subglacial aquatic ecosystems},
  series = {Annals of Glaciology},
  volume    = {55},
  journal   = {Annals of Glaciology},
  number    = {65},
  publisher = {Cambridge University Press},
  address   = {Cambridge},
  issn      = {1727-5644},
  doi       = {10.3189/2014AoG65A004},
  pages     = {14 -- 22},
  year      = {2014},
  abstract  = {There is significant interest in sampling subglacial environments for geobiological studies, but they are difficult to access. Existing ice-drilling technologies make it cumbersome to maintain microbiologically clean access for sample acquisition and environmental stewardship of potentially fragile subglacial aquatic ecosystems. The IceMole is a maneuverable subsurface ice probe for clean in situ analysis and sampling of glacial ice and subglacial materials. The design is based on the novel concept of combining melting and mechanical propulsion. It can change melting direction by differential heating of the melting head and optional side-wall heaters. The first two prototypes were successfully tested between 2010 and 2012 on glaciers in Switzerland and Iceland. They demonstrated downward, horizontal and upward melting, as well as curve driving and dirt layer penetration. A more advanced probe is currently under development as part of the Enceladus Explorer (EnEx) project. It offers systems for obstacle avoidance, target detection, and navigation in ice. For the EnEx-IceMole, we will pay particular attention to clean protocols for the sampling of subglacial materials for biogeochemical analysis. We plan to use this probe for clean access into a unique subglacial aquatic environment at Blood Falls, Antarctica, with return of a subglacial brine sample.},
  language  = {en}
}
@article{BragardSoltauThomasetal.2010,
  author    = {Bragard, Michael and Soltau, N. and Thomas, S. and De Doncker, R. W.},
  title     = {The balance of renewable sources and user demands in grids : power electronics for modular battery energy storage systems},
  series = {IEEE transactions on power electronics},
  volume    = {25},
  journal   = {IEEE transactions on power electronics},
  number    = {12},
  publisher = {IEEE},
  address   = {New York},
  issn      = {0885-8993},
  doi       = {10.1109/TPEL.2010.2085455},
  pages     = {3049 -- 3056},
  year      = {2010},
  abstract  = {The continuously growing amount of renewable sources starts compromising the stability of electrical grids. Contradictory to fossil fuel power plants, energy production of wind and photovoltaic (PV) energy is fluctuating. Although predictions have significantly improved, an outage of multi-MW offshore wind farms poses a challenging problem. One solution could be the integration of storage systems in the grid. After a short overview, this paper focuses on two exemplary battery storage systems, including the required power electronics. The grid integration, as well as the optimal usage of volatile energy reserves, is presented for a 5- kW PV system for home application, as well as for a 100- MW medium-voltage system, intended for wind farm usage. The efficiency and cost of topologies are investigated as a key parameter for large-scale integration of renewable power at medium- and low-voltage.},
  language  = {en}
}
@article{KoellenspergerBragardPlumetal.2009,
  author    = {K{\"o}llensperger, P. and Bragard, Michael and Plum, T. and De Doncker, R. W.},
  title     = {The dual GCT : new high-power device using optimized GCT technology},
  series = {IEEE transactions on industry applications},
  volume    = {45},
  journal   = {IEEE transactions on industry applications},
  number    = {5},
  issn      = {0093-9994},
  doi       = {10.1109/TIA.2009.2027364},
  pages     = {1754 -- 1762},
  year      = {2009},
  language  = {en}
}
@article{Stulpe2014,
  author    = {Stulpe, Werner},
  title     = {From the attempt of certain classical reformulations of quantum mechanics to quasi-probability representations},
  series = {Journal of Mathematical Physics},
  volume    = {55},
  journal   = {Journal of Mathematical Physics},
  number    = {1},
  publisher = {AIP Publishing},
  address   = {College Park, Md.},
  issn      = {222-488},
  doi       = {10.1063/1.4861939},
  pages     = {Artikel 012109},
  year      = {2014},
  abstract  = {The concept of an injective affine embedding of the quantum states into a set of classical states, i.e., into the set of the probability measures on some measurable space, as well as its relation to statistically complete observables is revisited, and its limitation in view of a classical reformulation of the statistical scheme of quantum mechanics is discussed. In particular, on the basis of a theorem concerning a non-denseness property of a set of coexistent effects, it is shown that an injective classical embedding of the quantum states cannot be supplemented by an at least approximate classical description of the quantum mechanical effects. As an alternative approach, the concept of quasi-probability representations of quantum mechanics is considered.},
  language  = {en}
}