@article{NovacekTranKlingeetal.2012, author = {Novacek, V. and Tran, Thanh Ngoc and Klinge, U. and Tolba, R. H. and Staat, Manfred and Bronson, D. G. and Miesse, A. M. and Whiffen, J. and Turquier, F.}, title = {Finite element modelling of stapled colorectal end-to-end anastomosis : Advantages of variable height stapler design}, series = {Journal of Biomechanics}, volume = {45}, journal = {Journal of Biomechanics}, number = {115}, publisher = {Elsevier}, address = {Amsterdam}, issn = {1873-2380}, doi = {10.1016/j.jbiomech.2012.07.021}, pages = {2693 -- 2697}, year = {2012}, abstract = {The impact of surgical staplers on tissues has been studied mostly in an empirical manner. In this paper, finite element method was used to clarify the mechanics of tissue stapling and associated phenomena. Various stapling modalities and several designs of circular staplers were investigated to evaluate the impact of the device on tissues and mechanical performance of the end-to-end colorectal anastomosis. Numerical simulations demonstrated that a single row of staples is not adequate to resist leakage due to non-linear buckling and opening of the tissue layers between two adjacent staples. Compared to the single staple row configuration, significant increase in stress experienced by the tissue at the inner staple rows was observed in two and three rows designs. On the other hand, adding second and/or third staple row had no effect on strain in the tissue inside the staples. Variable height design with higher staples in outer rows significantly reduced the stresses and strains in outer rows when compared to the same configuration with flat cartridge.}, language = {en} } @article{Huening2008, author = {H{\"u}ning, Felix}, title = {Die Anforderungen steigen : Entwicklungstrends bei MOSFETs f{\"u}r den Automobilbereich}, series = {Elektronik-Industrie. 39 (2008), H. 5}, journal = {Elektronik-Industrie. 39 (2008), H. 5}, publisher = {-}, isbn = {0174-5522}, pages = {74 -- 76}, year = {2008}, language = {de} } @article{CaroMazzonCaemmereretal.2011, author = {Caro, Abrao and Mazzon, Jos{\´e} Afonso and Caemmerer, Barbara and Weßling, Matthias}, title = {Inovatividade, envolvimento, atitude e experiencia na adocao da compra on-line - Innovation, involvement, attitude and experience in buying online}, series = {Revista de administra{\c{c}}{\~a}o de empr{\^e}sas : RAE}, volume = {51}, journal = {Revista de administra{\c{c}}{\~a}o de empr{\^e}sas : RAE}, number = {6}, publisher = {-}, address = {S{\~a}o Paulo}, issn = {0034-7590}, pages = {568 -- 584}, year = {2011}, language = {de} } @article{SpelthahnSchubertSchoening2012, author = {Spelthahn, Heiko and Schubert, J{\"u}rgen and Sch{\"o}ning, Michael Josef}, title = {D{\"u}nnschichtsensoren f{\"u}r die Schwermetallanalytik}, series = {GIT : Labor-Fachzeitschrift}, volume = {56}, journal = {GIT : Labor-Fachzeitschrift}, number = {4}, publisher = {Wiley-VCH}, address = {Weinheim}, issn = {0016-3538}, pages = {285 -- 287}, year = {2012}, abstract = {Die Detektion von Schadstoffen repr{\"a}sentiert in der Umweltanalytik eine wichtige Aufgabenstellung. Gerade die Abwasser- bzw. Brauchwasseranalytik sowie die Prozesskontrolle haben einen hohen Stellenwert. Siliziumbasierte D{\"u}nnschichtsensoren bieten eine kosteng{\"u}nstige M{\"o}glichkeit, „online"-Messungen bzw. Vor-Ort-Messungen zeitnah durchzuf{\"u}hren. In dieser Arbeit wird ein potentiometrisches Sensorarray auf der Basis von Chalkogenidgl{\"a}sern zur Detektion von Schwermetallen in w{\"a}ssrigen Medien vorgestellt.}, language = {en} } @article{Huening2009, author = {H{\"u}ning, Felix}, title = {Hart im Nehmen : Low-Voltage-Powermosfets mit Super-Junction-1-Technologie optimieren}, series = {Elektronik-Journal. 44 (2009), H. 12}, journal = {Elektronik-Journal. 44 (2009), H. 12}, publisher = {-}, isbn = {0013-5674}, pages = {36 -- 38}, year = {2009}, language = {de} } @article{Huening2012, author = {H{\"u}ning, Felix}, title = {Using Trench PowerMOSFETs in Linear Mode}, series = {Power Electronics Europe (2012)}, journal = {Power Electronics Europe (2012)}, publisher = {DFA Media}, address = {Tonbridge}, issn = {1748-3530}, pages = {27 -- 29}, year = {2012}, abstract = {If we think about applications for modern Power MOSFETs using trench technology, running them in linear mode may not be top of the priority list. Yet there are multiple uses for Trench Power MOSFETs in linear mode. In fact, even turning the device on and off in switching applications is a form of linear operation. Also, these components can be run in linear mode to protect the device against voltage surges. This article will illustrate the factors that need to be considered for linear operation and show how Trench Power MOSFETs are suited to it.}, language = {en} } @article{Huening2011, author = {H{\"u}ning, Felix}, title = {PowerMOSFETs in ANL2-Technologie : Ansteuerungen bis in den kW-Bereich mit wenig Verlustleistung und Platzbedarf}, series = {Elektronik-Industrie}, volume = {42}, journal = {Elektronik-Industrie}, number = {10}, publisher = {H{\"u}thig}, address = {Heidelberg}, issn = {0174-5522}, pages = {36 -- 39}, year = {2011}, language = {de} } @article{Huening2009, author = {H{\"u}ning, Felix}, title = {Mosfet ottimizzati per l'automotive}, series = {Selezione di Elettronica (2009)}, journal = {Selezione di Elettronica (2009)}, publisher = {-}, pages = {115 -- 117}, year = {2009}, language = {de} } @article{Huening2008, author = {H{\"u}ning, Felix}, title = {Entwicklungstrends bei MOSFETs f{\"u}r den Automobilbereich}, series = {Elektronik-Industrie . 39 (2008), H. 5}, journal = {Elektronik-Industrie . 39 (2008), H. 5}, publisher = {-}, isbn = {0174-5522}, pages = {74 -- 76}, year = {2008}, language = {en} } @article{Huening2009, author = {H{\"u}ning, Felix}, title = {SMD packages for PowerMOSFETs in automotive applications - developments and trends}, series = {Automotive Designline Europe (2009)}, journal = {Automotive Designline Europe (2009)}, publisher = {-}, year = {2009}, language = {en} }