@article{HennemannKohlReisertetal.2013,
  author    = {Hennemann, J{\"o}rg and Kohl, Claus-Dieter and Reisert, Steffen and Kirchner, Patrick and Sch{\"o}ning, Michael Josef},
  title     = {Copper oxide nanofibres for detection of hydrogen peroxide vapour at high concentrations},
  series = {physica status solidi (a)},
  volume    = {210},
  journal   = {physica status solidi (a)},
  number    = {5},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1862-6319},
  doi       = {10.1002/pssa.201200775},
  pages     = {859 -- 863},
  year      = {2013},
  abstract  = {We present a sensor concept based on copper(II)oxide (CuO) nanofibres for the detection of hydrogen peroxide (H2O2) vapour in the percent per volume (\% v/v) range. The fibres were produced by using the electrospinning technique. To avoid water condensation in the pores, the fibres were initially modified by an exposure to H2S to get an enclosed surface. By a thermal treatment at 350 °C the fibres were oxidised back to CuO. Thereby, the visible pores disappear which was verified by SEM analysis. The fibres show a decrease of resistance with increasing H2O2 concentration which is due to the fact that hydrogen peroxide is an oxidising gas and CuO a p-type semiconductor. The sensor shows a change of resistance within the minute range to the exposure until the maximum concentration of 6.9\% v/v H2O2. At operating temperatures below 450 °C the corresponding sensor response to a concentration of 4.1\% v/v increases. The sensor shows a good reproducibility of the signal at different measurements. CuO seems to be a suitable candidate for the detection of H2O2 vapour at high concentrations. Resistance behaviour of the sensor under exposure to H2O2 vapours between 2.3 and 6.9\% v/v at an operating temperature of 450 °C.},
  language  = {en}
}
@article{SchusserMenzelBaeckeretal.2013,
  author    = {Schusser, Sebastian and Menzel, S. and B{\"a}cker, Matthias and Leinhos, Marcel and Poghossian, Arshak and Wagner, P. and Sch{\"o}ning, Michael Josef},
  title     = {Degradation of thin poly(lactic acid) films: characterization by capacitance-voltage, atomic force microscopy, scanning electron microscopy and contact-angle measurements},
  series = {Electrochimica Acta},
  volume    = {Vol. 113},
  journal   = {Electrochimica Acta},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1873-3859 (E-Journal); 0013-4686 (Print)},
  pages     = {779 -- 784},
  year      = {2013},
  language  = {en}
}
@article{BaeckerSchusserPoghossianetal.2013,
  author    = {B{\"a}cker, Matthias and Schusser, Sebastian and Poghossian, Arshak and Sch{\"o}ning, Michael Josef},
  title     = {Degradationsverhalten bioabbaubarer Polymere : siliziumbasierte Sensorik zur {\"U}berwachung},
  series = {GIT Labor-Fachzeitschrift},
  journal   = {GIT Labor-Fachzeitschrift},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {0016-3538},
  pages     = {32 -- 33},
  year      = {2013},
  language  = {de}
}
@article{ZhubanovaMansurovDigeletal.2013,
  author    = {Zhubanova, А. and Mansurov, Z.A. and Digel, Ilya and Saviskaya, I.S. and Akimbekov, Nuraly S.},
  title     = {Designing of Heterogeneous Nanobiocomposites for Biotechnology},
  series = {KazNU Bulletin. Biology series},
  volume    = {59},
  journal   = {KazNU Bulletin. Biology series},
  number    = {No 3/1},
  isbn      = {1563-0218},
  pages     = {89 -- 93},
  year      = {2013},
  language  = {ru}
}
@article{IkenAhlbornGerlachetal.2013,
  author    = {Iken, Heiko and Ahlborn, Kristina and Gerlach, Frank and Vonau, Winfried and Zander, Wilhelm and Schubert, J{\"u}rgen P. and Sch{\"o}ning, Michael Josef},
  title     = {Development of redox glasses and subsequent processing by means of pulsed laser deposition for realizing silicon-based thin-film sensors},
  series = {Electrochimica acta},
  journal   = {Electrochimica acta},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1873-3859 (E-Journal); 0013-4686 (Print)},
  pages     = {Available online 30.8.2013},
  year      = {2013},
  language  = {en}
}
@phdthesis{Kotliar2013,
  author    = {Kotliar, Konstantin},
  title     = {Dynamische retinale Gef{\"a}ßanalyse f{\"u}r die Diagnostik und Fr{\"u}herkennung von System- und Augenerkrankungen vaskul{\"a}rer Genese},
  pages     = {128 Bl.},
  year      = {2013},
  language  = {de}
}
@article{BassamDigelHescheleretal.2013,
  author    = {Bassam, Rasha and Digel, Ilya and Hescheler, J{\"u}rgen and Temiz Artmann, Ayseg{\"u}l and Artmann, Gerhard},
  title     = {Effects of spermine NONOate and ATP on protein aggregation: light scattering evidences},
  series = {BMC Biophysics},
  journal   = {BMC Biophysics},
  publisher = {BioMed Central},
  address   = {London},
  isbn      = {2046-1682},
  url       = {http://nbn-resolving.de/10.1186/2046-1682-6-1},
  pages     = {1 -- 14},
  year      = {2013},
  language  = {en}
}
@article{LindenFischoederLaacketal.2013,
  author    = {Linden, A. and Fisch{\"o}der, M. and Laack, Walter van and Staat, Manfred},
  title     = {Einschr{\"a}nkung von Taluskippung und -vorschub durch Sprunggelenkorthesen nach fibularer Bandruptur},
  series = {OUP Zeitschrift f{\"u}r die orthop{\"a}dische und unfallchirurgische Praxis},
  volume    = {2},
  journal   = {OUP Zeitschrift f{\"u}r die orthop{\"a}dische und unfallchirurgische Praxis},
  number    = {6},
  publisher = {Deutscher {\"A}rzte-Verl.},
  address   = {K{\"o}ln},
  isbn      = {2193-5785},
  doi       = {10.3238/oup.2013.0306-0309},
  pages     = {306 -- 309},
  year      = {2013},
  abstract  = {Die fibulare Bandruptur z{\"a}hlt zu einer der am h{\"a}ufigsten auftretenden Verletzungen des Bewegungsapparats. In den meisten F{\"a}llen wird heute die konservativ fr{\"u}hfunktionelle Therapie mit Sprunggelenkorthesen allgemein bevorzugt. Im Rahmen der vorliegenden Studie wurden 14 verschiedene Sprunggelenkorthesen im Hinblick auf ihre Einschr{\"a}nkung von Taluskippung und Talusvorschub untersucht. Zur Simulation einer fibularen Bandruptur wurde ein Unterschenkelmodell aus Holz mit Fußteil, mit angelegten Orthesen in einen Scheuba-Halteapparat eingespannt und mit 150 N seitlich sowie anterior-posterior belastet. Anhand der erstellten "gehaltenen" R{\"o}ntgenaufnahmen konnten Taluskippung und Talusvorschub jeder einzelnen Orthese eindeutig bestimmt werden. Die meisten Orthesen erreichten zufriedenstellende Ergebnisse. Es stellte sich heraus, dass vor allem eine eng anliegende, im Gelenkbereich anatomisch angepasste Form vorteilhaft zu sein scheint.},
  language  = {de}
}
@article{PoghossianWeilCherstvyetal.2013,
  author    = {Poghossian, Arshak and Weil, M. and Cherstvy, A. G. and Sch{\"o}ning, Michael Josef},
  title     = {Electrical monitoring of polyelectrolyte multilayer formation by means of capacitive field-effect devices},
  series = {Analytical and bioanalytical chemistry},
  volume    = {405},
  journal   = {Analytical and bioanalytical chemistry},
  number    = {20},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1432-1130 ; 1618-2642},
  doi       = {10.1007/s00216-013-6951-9},
  pages     = {6425 -- 6436},
  year      = {2013},
  abstract  = {The semiconductor field-effect platform represents a powerful tool for detecting the adsorption and binding of charged macromolecules with direct electrical readout. In this work, a capacitive electrolyte-insulator-semiconductor (EIS) field-effect sensor consisting of an Al-p-Si-SiO2 structure has been applied for real-time in situ electrical monitoring of the layer-by-layer formation of polyelectrolyte (PE) multilayers (PEM). The PEMs were deposited directly onto the SiO2 surface without any precursor layer or drying procedures. Anionic poly(sodium 4-styrene sulfonate) and cationic weak polyelectrolyte poly(allylamine hydrochloride) have been chosen as a model system. The effect of the ionic strength of the solution, polyelectrolyte concentration, number and polarity of the PE layers on the characteristics of the PEM-modified EIS sensors have been studied by means of capacitance-voltage and constant-capacitance methods. In addition, the thickness, surface morphology, roughness and wettabilityof the PE mono- and multilayers have been characterised by ellipsometry, atomic force microscopy and water contact-angle methods, respectively. To explain potential oscillations on the gate surface and signal behaviour of the capacitive field-effect EIS sensor modified with a PEM, a simplified electrostatic model that takes into account the reduced electrostatic screening of PE charges by mobile ions within the PEM has been proposed and discussed.},
  language  = {en}
}
@article{MuribGrinsvenGrietenetal.2013,
  author    = {Murib, M. S. and Grinsven, B. van and Grieten, L. and Janssens, S. D. and Vermeeren, V. and Eersels, K. and Broeders, J. and Ameloot, Marcel and Michiels, L. and Ceuninck, W. De and Haenen, K. and Sch{\"o}ning, Michael Josef and Wagner, Patrick},
  title     = {Electronic monitoring of chemical DNA denaturation on nanocrystalline diamond electrodes with different molarities and flow rates},
  series = {Physica Status Solidi (A). Vol. 210 (2013), iss. 5},
  journal   = {Physica Status Solidi (A). Vol. 210 (2013), iss. 5},
  publisher = {Wiley-VCH},
  address   = {Berlin},
  issn      = {0031-8965},
  pages     = {911 -- 917},
  year      = {2013},
  language  = {en}
}