@article{Starke1986,
  author    = {Starke, G{\"u}nther},
  title     = {Sensoren fuer Schutzgasschweissroboter: Problemstellung, Funktionsweise, Handhabung und Programmierung von praxiserprobten Systemen},
  pages     = {1 -- 22},
  year      = {1986},
  language  = {de}
}
@article{SchusserKrischerMolinetal.2015,
  author    = {Schusser, Sebastian and Krischer, M. and Molin, D. G. M. and Akker, N. M. S. van den and B{\"a}cker, Matthias and Poghossian, Arshak and Sch{\"o}ning, Michael Josef},
  title     = {Sensor System for in-situ and Real-time Monitoring of Polymer (bio) degradation},
  series = {Procedia Engineering},
  volume    = {120},
  journal   = {Procedia Engineering},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1877-7058},
  doi       = {10.1016/j.proeng.2015.08.815},
  pages     = {948 -- 951},
  year      = {2015},
  abstract  = {A sensor system for investigating (bio)degradationprocesses of polymers is presented. The system utilizes semiconductor field-effect sensors and is capable of monitoring the degradation process in-situ and in real-time. The degradation of the polymer poly(d,l-lactic acid) is exemplarily monitored in solutions with different pH value, pH-buffer solution containing the model enzyme lipase from Rhizomucormiehei and cell-culture medium containing supernatants from stimulated and non-stimulated THP-1-derived macrophages mimicking activation of the immune system.},
  language  = {en}
}
@article{ValeroBung2016,
  author    = {Valero, Daniel and Bung, Daniel Bernhard},
  title     = {Sensitivity of turbulent Schmidt number and turbulence model to simulations of jets in crossflow},
  series = {Environmental Modelling and Software},
  volume    = {82},
  journal   = {Environmental Modelling and Software},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1364-8152 (electronic)},
  doi       = {10.1016/j.envsoft.2016.04.030},
  pages     = {218 -- 228},
  year      = {2016},
  abstract  = {Environmental discharges have been traditionally designed by means of cost-intensive and time-consuming experimental studies. Some extensively validated models based on an integral approach have been often employed for water quality problems, as recommended by USEPA (i.e.: CORMIX). In this study, FLOW-3D is employed for a full 3D RANS modelling of two turbulent jet-to-crossflow cases, including free surface jet impingement. Results are compared to both physical modelling and CORMIX to better assess model performance. Turbulence measurements have been collected for a better understanding of turbulent diffusion's parameter sensitivity. Although both studied models are generally able to reproduce jet trajectory, jet separation downstream of the impingement has been reproduced only by RANS modelling. Additionally, concentrations are better reproduced by FLOW-3D when the proper turbulent Schmidt number is used. This study provides a recommendation on the selection of the turbulence model and the turbulent Schmidt number for future outfall structures design studies.},
  language  = {en}
}
@article{BuehlerChristenKowalskietal.2011,
  author    = {B{\"u}hler, Yves and Christen, Marc and Kowalski, Julia and Bartelt, Perry},
  title     = {Sensitivity of snow avalanche simulations to digital elevation model quality and resolution},
  series = {Annals of Glaciology},
  volume    = {52},
  journal   = {Annals of Glaciology},
  number    = {58},
  publisher = {Cambridge University Press},
  address   = {Cambridge},
  isbn      = {1727-5644},
  pages     = {72 -- 80},
  year      = {2011},
  abstract  = {Digital elevation models (DEMs), represent the three-dimensional terrain and are the basic input for numerical snow avalanche dynamics simulations. DEMs can be acquired using topographic maps or remote-sensing technologies, such as photogrammetry or lidar. Depending on the acquisition technique, different spatial resolutions and qualities are achieved. However, there is a lack of studies that investigate the sensitivity of snow avalanche simulation algorithms to the quality and resolution of DEMs. Here, we perform calculations using the numerical avalance dynamics model RAMMS, varying the quality and spatial resolution of the underlying DEMs, while holding the simulation parameters constant. We study both channelized and open-terrain avalanche tracks with variable roughness. To quantify the variance of these simulations, we use well-documented large-scale avalanche events from Davos, Switzerland (winter 2007/08), and from our large-scale avalanche test site, Valĺee de la Sionne (winter 2005/06). We find that the DEM resolution and quality is critical for modeled flow paths, run-out distances, deposits, velocities and impact pressures. Although a spatial resolution of ~25 m is sufficient for large-scale avalanche modeling, the DEM datasets must be checked carefully for anomalies and artifacts before using them for dynamics calculations.},
  language  = {en}
}
@article{Staat1993,
  author    = {Staat, Manfred},
  title     = {Sensitivity of and Influences on the Reliability of an HTR-Module Primary Circuit Pressure Boundary},
  series = {Transactions of the 12th International Conference on Structural Mechanics in Reactor Technology (SMiRT-12) / Kussmaul, K. [ed]},
  journal   = {Transactions of the 12th International Conference on Structural Mechanics in Reactor Technology (SMiRT-12) / Kussmaul, K. [ed]},
  publisher = {Elsevier},
  address   = {Amsterdam},
  isbn      = {0-444-81515-5},
  pages     = {147 -- 152},
  year      = {1993},
  language  = {en}
}
@article{DiktaDegenringFroemmeletal.2004,
  author    = {Dikta, Gerhard and Degenring, D. and Froemmel, C. and Takors, R.},
  title     = {Sensitivity analysis for the reduction of complex metabolism models / Degenring, D. ; Froemmel, C. ; Dikta, G.; Takors, R.},
  series = {Journal of Process Control. 14 (2004)},
  journal   = {Journal of Process Control. 14 (2004)},
  isbn      = {0959-1524},
  pages     = {729 -- 745},
  year      = {2004},
  language  = {en}
}
@article{CornelisGivanoudiYongabietal.2019,
  author    = {Cornelis, Peter and Givanoudi, Stella and Yongabi, Derick and Iken, Heiko and Duw{\´e}, Sam and Deschaume, Olivier and Robbens, Johan and Dedecker, Peter and Bartic, Carmen and W{\"u}bbenhorst, Michael and Sch{\"o}ning, Michael Josef and Heyndrickx, Marc and Wagner, Patrick},
  title     = {Sensitive and specific detection of E. coli using biomimetic receptors in combination with a modified heat-transfer method},
  series = {Biosensors and Bioelectronics},
  volume    = {136},
  journal   = {Biosensors and Bioelectronics},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {0956-5663},
  doi       = {10.1016/j.bios.2019.04.026},
  pages     = {97 -- 105},
  year      = {2019},
  language  = {en}
}
@article{AchtsnichtNeuendorfFassbenderetal.2019,
  author    = {Achtsnicht, Stefan and Neuendorf, Christian and Faßbender, Tobias and N{\"o}lke, Greta and Offenh{\"a}usser, Andreas and Krause, Hans-Joachim and Schr{\"o}per, Florian},
  title     = {Sensitive and rapid detection of cholera toxin subunit B using magnetic frequency mixing detection},
  series = {Plos One},
  volume    = {14},
  journal   = {Plos One},
  number    = {7},
  publisher = {Plos},
  address   = {San Francisco},
  issn      = {1932-6203},
  doi       = {10.1371/journal.pone.0219356},
  pages     = {e0219356},
  year      = {2019},
  abstract  = {Cholera is a life-threatening disease caused by the cholera toxin (CT) as produced by some Vibrio cholerae serogroups. In this research we present a method which directly detects the toxin's B subunit (CTB) in drinking water. For this purpose we performed a magnetic sandwich immunoassay inside a 3D immunofiltration column. We used two different commercially available antibodies to capture CTB and for binding to superparamagnetic beads. ELISA experiments were performed to select the antibody combination. The beads act as labels for the magnetic frequency mixing detection technique. We show that the limit of detection depends on the type of magnetic beads. A nonlinear Hill curve was fitted to the calibration measurements by means of a custom-written python software. We achieved a sensitive and rapid detection of CTB within a broad concentration range from 0.2 ng/ml to more than 700 ng/ml.},
  language  = {en}
}
@article{KrauseSchuppeSaureetal.1989,
  author    = {Krause, Gregor and Schuppe, W.D. and Saure, M. and Andress, H.},
  title     = {Sensitive Analytische und Physikalische Verfahren zum Nachweis von Ver{\"a}nderungen in Platten und Kabelisolierungen aus Polyolefinen / W.D. Schuppe, M. Saure, H. Andress, K. M{\"o}ller, D. Meurer, G. Krause},
  series = {AEG Technische Mitteilungen (1989)},
  journal   = {AEG Technische Mitteilungen (1989)},
  year      = {1989},
  language  = {de}
}
@article{KrauseSchuppeSaureetal.1988,
  author    = {Krause, Gregor and Schuppe, W.D. and Saure, M. and Andress, H.},
  title     = {Sensitive Analytical and Physical Methods for Diagnosis of Variations in Polyolefin Plaques and Cable Insulations / W.D. Schuppe, M. Saure, H. Andress, K. M{\"o}ller, D. Meurer, G. Krause},
  series = {Proceedings of the 32nd session : 28th August - 3rd September.},
  journal   = {Proceedings of the 32nd session : 28th August - 3rd September.},
  year      = {1988},
  language  = {en}
}