@article{FingerBraunBil2018,
  author    = {Finger, Felix and Braun, Carsten and Bil, Cees},
  title     = {Impact of electric propulsion technology and mission requirements on the performance of VTOL UAVs},
  series = {CEAS Aeronautical Journal},
  volume    = {10},
  journal   = {CEAS Aeronautical Journal},
  number    = {3},
  publisher = {Springer},
  issn      = {1869-5582 print},
  doi       = {10.1007/s13272-018-0352-x},
  pages     = {843},
  year      = {2018},
  abstract  = {One of the engineering challenges in aviation is the design of transitioning vertical take-off and landing (VTOL) aircraft. Thrust-borne flight implies a higher mass fraction of the propulsion system, as well as much increased energy consumption in the take-off and landing phases. This mass increase is typically higher for aircraft with a separate lift propulsion system than for aircraft that use the cruise propulsion system to support a dedicated lift system. However, for a cost-benefit trade study, it is necessary to quantify the impact the VTOL requirement and propulsion configuration has on aircraft mass and size. For this reason, sizing studies are conducted. This paper explores the impact of considering a supplemental electric propulsion system for achieving hovering flight. Key variables in this study, apart from the lift system configuration, are the rotor disk loading and hover flight time, as well as the electrical systems technology level for both batteries and motors. Payload and endurance are typically used as the measures of merit for unmanned aircraft that carry electro-optical sensors, and therefore the analysis focuses on these particular parameters.},
  language  = {en}
}
@inproceedings{FingerBraunBil2018,
  author    = {Finger, Felix and Braun, Carsten and Bil, Cees},
  title     = {Case studies in initial sizing for hybrid-electric general aviation aircraft},
  series = {2018 AIAA/IEEE Electric Aircraft Technologies Symposium, Cincinnati, Ohio},
  booktitle = {2018 AIAA/IEEE Electric Aircraft Technologies Symposium, Cincinnati, Ohio},
  doi       = {10.2514/6.2018-5005},
  year      = {2018},
  language  = {en}
}
@inproceedings{FingerBraunBil2018,
  author    = {Finger, Felix and Braun, Carsten and Bil, Cees},
  title     = {An Initial Sizing Methodology for Hybrid-Electric Light Aircraft},
  series = {AIAA AVIATION Forum 2018 Aviation Technology, Integration, and Operations Conference, Atlanta, Georgia, June 25 - 29, 2018},
  booktitle = {AIAA AVIATION Forum 2018 Aviation Technology, Integration, and Operations Conference, Atlanta, Georgia, June 25 - 29, 2018},
  doi       = {10.2514/6.2018-4229},
  year      = {2018},
  language  = {en}
}
@article{GoettenFingerHavermannetal.2018,
  author    = {G{\"o}tten, Falk and Finger, Felix and Havermann, Marc and Braun, Carsten and Gomez, Francisco and Bill, C.},
  title     = {On the flight performance impact of landing gear drag reduction methods for unmanned air vehicles},
  series = {Deutscher Luft- und Raumfahrtkongress 2018},
  journal   = {Deutscher Luft- und Raumfahrtkongress 2018},
  publisher = {DGLR},
  address   = {Bonn},
  doi       = {10.25967/480058},
  pages     = {11 S.},
  year      = {2018},
  abstract  = {The flight performance impact of three different landing gear configurations on a small, fixed-wing UAV is analyzed with a combination of RANS CFD calculations and an incremental flight performance algorithm. A standard fixed landing gear configuration is taken as a baseline, while the influence of retracting the landing gear or applying streamlined fairings is investigated. A retraction leads to a significant parasite drag reduction, while also fairings promise large savings. The increase in lift-to-drag ratio is reduced at high lift coefficients due to the influence of induced drag. All configurations are tested on three different design missions with an incremental flight performance algorithm. A trade-off study is performed using the retracted or faired landing gear's weight increase as a variable. The analysis reveals only small mission performance gains as the aerodynamic improvements are negated by weight penalties. A new workflow for decision-making is presented that allows to estimate if a change in landing gear configuration is beneficial for a small UAV.},
  language  = {en}
}
@inproceedings{LudowicyRingsFingeretal.2018,
  author    = {Ludowicy, Jonas and Rings, Ren{\´e} and Finger, Felix and Braun, Carsten},
  title     = {Sizing Studies of Light Aircraft with Parallel Hybrid Propulsion Systems},
  series = {Deutscher Luft- und Raumfahrtkongress 2018},
  booktitle = {Deutscher Luft- und Raumfahrtkongress 2018},
  doi       = {10.25967/480227},
  pages     = {15 S.},
  year      = {2018},
  language  = {en}
}
@inproceedings{FingerGoettenBraun2018,
  author    = {Finger, Felix and G{\"o}tten, Falk and Braun, Carsten},
  title     = {Initial Sizing for a Family of Hybrid-Electric VTOL General Aviation Aircraft},
  series = {67. Deutscher Luft- und Raumfahrtkongress 2018},
  booktitle = {67. Deutscher Luft- und Raumfahrtkongress 2018},
  pages     = {14 S.},
  year      = {2018},
  language  = {en}
}
@inproceedings{LudowicyRingsFingeretal.2018,
  author    = {Ludowicy, Jonas and Rings, Ren{\´e} and Finger, Felix and Braun, Carsten},
  title     = {Sizing Studies of Light Aircraft with Serial Hybrid Propulsion Systems},
  series = {Luft- und Raumfahrt - Digitalisierung und Vernetzung : Deutscher Luft- und Raumfahrtkongress 2018. 4. - 6. September 2018 - Friedrichshafen},
  booktitle = {Luft- und Raumfahrt - Digitalisierung und Vernetzung : Deutscher Luft- und Raumfahrtkongress 2018. 4. - 6. September 2018 - Friedrichshafen},
  pages     = {11 S.},
  year      = {2018},
  language  = {en}
}