@article{MarinkovićFloresCalvinistiButenweg2020,
  author    = {Marinković, Marko and Flores Calvinisti, Santiago and Butenweg, Christoph},
  title     = {Numerical analysis of reinforced concrete frame buildings with decoupled infill walls},
  series = {Building Materials and Structures},
  volume    = {63},
  journal   = {Building Materials and Structures},
  number    = {4},
  publisher = {Society for Materials and Structures Testing of Serbia},
  address   = {Belgrad},
  issn      = {2217-8139},
  doi       = {10.5937/GRMK2004013M},
  pages     = {13 -- 48},
  year      = {2020},
  abstract  = {Reinforced concrete (RC) buildings with masonry infill walls are widely used in many countries all over the world. Although infills are considered as non-structural elements, they significantly change dynamic characteristics of RC frame structures during earthquake excitation. Recently, significant effort was spent on studying decoupled infills, which are isolated from the surrounding frame usually by adding a gap between frame and infill. In this case, the frame deformation does not activate infill wall, thus infills are not influencing the behaviour of the frame. This paper presents the results of the investigation of the behaviour of RC frame buildings with the INODIS system that decouples masonry infills from the surrounding frame. Effect of masonry infill decoupling was investigated first on the one-bay onestorey frame. This was used as a base for parametric study on the frames with more bays and storeys, as well as on the building level. Change of stiffness and dynamic characteristics was analysed as well as response under earthquake loading. Comparison with the bare frame and traditionally infilled frame was performed. The results show that behaviour of the decoupled infilled frames is similar to the bare frame, whereas behaviour of frames with traditional infills is significantly different and demands complex numerical models. This means that if adequate decoupling is applied, design of},
  language  = {mul}
}
@article{MartinBergHackeretal.1985,
  author    = {Martin, S. A. and Berg, G. P. A. and Hacker, U. and Hardt, Arno and K{\"o}hler, M. and Meißburger, J. and Osterfeld, F. and Prasuhn, D. and Riepe, G. and Rogge, M. and Schult, O. W. B. and Speth, J. and Turek, P. and Gaul, G. and Hagedoorn, H. and Heide, J. A. van der and Hinterberger, F. and Huber, M. and Jahn, R. and Mayer-Kuckuk, T. and Poth, H. and Paetz gen. Schieck, H.},
  title     = {COSY - a cooler synchrotron and storage ring},
  series = {IEEE transactions on nuclear science. Vol. 32, iss. 5},
  journal   = {IEEE transactions on nuclear science. Vol. 32, iss. 5},
  issn      = {1558-1578 (E-Journal); 0018-9499 (Print)},
  pages     = {2694 -- 2696},
  year      = {1985},
  language  = {en}
}
@article{MarxSchenkBehrensetal.2013,
  author    = {Marx, Ulrich and Schenk, Friedrich and Behrens, Jan and Meyr, Ulrike and Wanek, Paul and Zang, Werner and Schmitt, Robert and Br{\"u}stle, Oliver and Zenke, Martin and Klocke, Fritz},
  title     = {Automatic production of induced pluripotent stem cells},
  series = {Procedia CIRP : First CIRP Conference on BioManufacturing},
  volume    = {Vol. 5},
  journal   = {Procedia CIRP : First CIRP Conference on BioManufacturing},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {2212-8271},
  pages     = {2 -- 6},
  year      = {2013},
  language  = {en}
}
@article{MeissenKrischer1978,
  author    = {Meißen, Ralf and Krischer, C.},
  title     = {Elektronische Fernsehlesehilfe f{\"u}r hochgradig sehbehinderte},
  series = {Biomedical Engineering / Biomedizinische Technik},
  volume    = {23},
  journal   = {Biomedical Engineering / Biomedizinische Technik},
  number    = {s1},
  publisher = {De Gruyter},
  address   = {Berlin},
  doi       = {10.1515/bmte.1978.23.s1.220},
  pages     = {220 -- 221},
  year      = {1978},
  language  = {de}
}
@article{MelissOesterwindVoss1975,
  author    = {Meliß, Michael and Oesterwind, Dieter and Voß, Alfred},
  title     = {Non-nuclear and non-fossil energy resources and their possibilities for future power generation},
  series = {Kerntechnik},
  volume    = {17},
  journal   = {Kerntechnik},
  number    = {7},
  publisher = {De Gruyter},
  address   = {Berlin},
  issn      = {0932-3902},
  doi       = {10.18419/opus-8093},
  pages     = {301 -- 306},
  year      = {1975},
  abstract  = {It must be stressed that the assessment of the exploitation possibilities of the energy resources discussed in this paper requires further studies. With this proviso, the situation can be provisionally summarised as follows: The total potential of known geothermal steam sources is only 64 GW. Geothermal energy could therefore only make a significant contribution to covering the worldwide power needs if we succeed in exploiting dry geothermal reservoirs. Exploitation of tidal energy is limited to a few geographically favourable locations. The power generation potential at these locations is only about 64 GW. An important drawback of tidal power is discontinuous power generation. Large scale exploitation of wind, wave and glacier energy, and of ocean heat, requires solution of a number of technological problems. The environmental effects of exploitation of these energy resources are to some extent of a qualitatively different nature from those of operation of fossil-fuel-fired and of nuclear power plants. The scanty knowledge in this area often results in these effects being underestimated. In any case, however, it would be deliberately misleading to postulate that any form of power generation is possible without some detrimental effects on the environment. It may be stated in conclusion that, owing to their small potential or to the as yet insufficiently advanced technological development, none of the energy resources discussed in this paper can make a significant contribution to the solution of middle-term energy supply problems, i.e., to a rapid replacement of mineral oil and natural gas.},
  language  = {en}
}
@article{MeskourisButenwegGellert2009,
  author    = {Meskouris, Konstantin and Butenweg, Christoph and Gellert, Christoph},
  title     = {Einfache Nachweise : einige Beispiele f{\"u}r die Anwendung des Bemessungsprogramms der RWTH Aachen f{\"u}r den Nachweis von Mauerwerksbauten in Erdbebengebieten},
  series = {Deutsches Ingenieur-Blatt : Ingenieurwesen, Bautechnik, Umweltschutz ; Organ der deutschen Ingenieurkammern / Hrsg.: Bundes-Ingenieurkammer e.V.},
  journal   = {Deutsches Ingenieur-Blatt : Ingenieurwesen, Bautechnik, Umweltschutz ; Organ der deutschen Ingenieurkammern / Hrsg.: Bundes-Ingenieurkammer e.V.},
  number    = {Heft 6},
  publisher = {Rauh Medien GmbH},
  address   = {Wandlitz},
  issn      = {0946-2422},
  pages     = {26 -- 29},
  year      = {2009},
  language  = {de}
}
@article{MeskourisButenwegGellert2009,
  author    = {Meskouris, Konstantin and Butenweg, Christoph and Gellert, Christoph},
  title     = {Iterativ verbessert : die RWTH Aachen entwickelt eine Software f{\"u}r einfache Nachweise von Mauerwerksbauten in Erdbebengebieten},
  series = {Deutsches Ingenieur-Blatt : Ingenieurwesen, Bautechnik, Umweltschutz ; Organ der deutschen Ingenieurkammern / Hrsg.: Bundes-Ingenieurkammer e.V.},
  journal   = {Deutsches Ingenieur-Blatt : Ingenieurwesen, Bautechnik, Umweltschutz ; Organ der deutschen Ingenieurkammern / Hrsg.: Bundes-Ingenieurkammer e.V.},
  number    = {Heft 5},
  publisher = {Rauh Medien GmbH},
  address   = {Wandlitz},
  issn      = {2365-192X},
  pages     = {31 -- 36},
  year      = {2009},
  language  = {de}
}
@article{MeskourisButenwegRenault2006,
  author    = {Meskouris, Konstantin and Butenweg, Christoph and Renault, Philippe},
  title     = {Beurteilung der Erdbebensicherheit von bestehenden Bauwerken},
  series = {Der Pr{\"u}fingenieur : das Magazin der Bundesvereinigung der Pr{\"u}fingenieure f{\"u}r Bautechnik},
  journal   = {Der Pr{\"u}fingenieur : das Magazin der Bundesvereinigung der Pr{\"u}fingenieure f{\"u}r Bautechnik},
  number    = {Ausgabe 28},
  issn      = {1430-9084},
  pages     = {56 -- 65},
  year      = {2006},
  language  = {de}
}
@article{MeskourisButenwegRenault2006,
  author    = {Meskouris, Konstantin and Butenweg, Christoph and Renault, Philippe},
  title     = {Mehrstufen-Konzept f{\"u}r mehr Erdbebensicherheit : ein Werkzeug f{\"u}r die Beurteilung der Erdbebengef{\"a}hrdung von Ingenieurbauwerken},
  series = {Deutsches Ingenieurblatt},
  volume    = {Band 13},
  journal   = {Deutsches Ingenieurblatt},
  number    = {Heft 6},
  issn      = {0946-2422},
  pages     = {18 -- 26},
  year      = {2006},
  language  = {de}
}
@article{MeyerButenwegFehling2014,
  author    = {Meyer, Udo and Butenweg, Christoph and Fehling, Ekkehard},
  title     = {EU-Projekt INSYSME : innovative Systeme f{\"u}r erdbebentaugliche Ausfachungsw{\"a}nde aus Ziegelmauerwerk},
  series = {Bauingenieur : die richtungsweisende Zeitschrift im Bauingenieurswesen ; offizielle Zeitschrift der VDI-Gesellschaft Bautechnik. Beilage: D-A-CH-Mitteilungsblatt},
  volume    = {89 (2014)},
  journal   = {Bauingenieur : die richtungsweisende Zeitschrift im Bauingenieurswesen ; offizielle Zeitschrift der VDI-Gesellschaft Bautechnik. Beilage: D-A-CH-Mitteilungsblatt},
  number    = {April},
  publisher = {VDI Fachmedien},
  address   = {D{\"u}sseldorf},
  issn      = {1436-4867 (E-Journal); 0005-6650 (Print)},
  pages     = {S14 -- S15},
  year      = {2014},
  language  = {de}
}