@article{JiminezGermanBehbahaniMiettinenetal.2013,
  author    = {Jiminez German, Salvador and Behbahani, Mehdi and Miettinen, Susanna and Grijpma, Dirk W. and Haimi, Suvi P.},
  title     = {Proliferation and differentiation of adipose stem cells towards smooth muscle cells on poly(trimethylene carbonate) membranes},
  series = {Macromolecular symposia},
  volume    = {Vol. 334},
  journal   = {Macromolecular symposia},
  number    = {Iss. 1},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {0258-0322},
  pages     = {133 -- 142},
  year      = {2013},
  language  = {en}
}
@article{JakobMartinezMandaweetal.2013,
  author    = {Jakob, Felix and Martinez, Ronny and Mandawe, John and Hellmuth, Hendrik and Siegert, Petra and Maurer, Karl-Heinz and Schwaneberg, Ulrich},
  title     = {Surface charge engineering of a Bacillus gibsonii subtilisin protease},
  series = {Applied microbiology and biotechnology},
  volume    = {Vol. 97},
  journal   = {Applied microbiology and biotechnology},
  number    = {Iss. 15},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1432-0614 (E-Journal); 0171-1741 (Print); 0175-7598 (Print); 0340-2118 (Print)},
  pages     = {6793 -- 6802},
  year      = {2013},
  language  = {en}
}
@article{ItabashiKosakaMiyamotoetal.2013,
  author    = {Itabashi, Akinori and Kosaka, Naoki and Miyamoto, Ko-ichiro and Wagner, Torsten and Sch{\"o}ning, Michael Josef},
  title     = {High-speed chemical imaging system based on front-side-illuminated LAPS},
  series = {Sensors and actuators B: Chemical},
  volume    = {182},
  journal   = {Sensors and actuators B: Chemical},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1873-3077},
  doi       = {10.1016/j.snb.2013.03.016},
  pages     = {315 -- 321},
  year      = {2013},
  abstract  = {The chemical imaging sensor is a semiconductor-based chemical sensor that can visualize the spatial distribution of specific ions on the sensing surface. The conventional chemical imaging system based on the light-addressable potentiometric sensor (LAPS), however, required a long time to obtain a chemical image, due to the slow mechanical scan of a single light beam. For high-speed imaging, a plurality of light beams modulated at different frequencies can be employed to measure the ion concentrations simultaneously at different locations on the sensor plate by frequency division multiplex (FDM). However, the conventional measurement geometry of back-side illumination limited the bandwidth of the modulation frequency required for FDM measurement, because of the low-pass filtering characteristics of carrier diffusion in the Si substrate. In this study, a high-speed chemical imaging system based on front-side-illuminated LAPS was developed, which achieved high-speed spatiotemporal recording of pH change at a rate of 70 frames per second.},
  language  = {en}
}
@misc{IngebrandtWagnerSchoening2013,
  author    = {Ingebrandt, Sven and Wagner, Patrick and Sch{\"o}ning, Michael Josef},
  title     = {Engineering of functional interfaces / guest eds. Sven Ingebrandt ; Patrick Wagner ; Michael J. Sch{\"o}ning},
  series = {Physica Status Solidi (A)},
  volume    = {Vol. 210},
  journal   = {Physica Status Solidi (A)},
  number    = {Iss. 5},
  issn      = {1521-396X (E-Journal); 1862-6319 (E-Journal); 0031-8965 (Print); 1862-6300 (Print)},
  pages     = {845},
  year      = {2013},
  language  = {en}
}
@article{IkenAhlbornGerlachetal.2013,
  author    = {Iken, Heiko and Ahlborn, Kristina and Gerlach, Frank and Vonau, Winfried and Zander, Wilhelm and Schubert, J{\"u}rgen P. and Sch{\"o}ning, Michael Josef},
  title     = {Development of redox glasses and subsequent processing by means of pulsed laser deposition for realizing silicon-based thin-film sensors},
  series = {Electrochimica acta},
  journal   = {Electrochimica acta},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1873-3859 (E-Journal); 0013-4686 (Print)},
  pages     = {Available online 30.8.2013},
  year      = {2013},
  language  = {en}
}
@article{HuckSchiffelsHerreraetal.2013,
  author    = {Huck, Christina and Schiffels, Johannes and Herrera, Cony N. and Schelden, Maximilian and Selmer, Thorsten and Poghossian, Arshak and Baumann, Marcus and Wagner, Patrick and Sch{\"o}ning, Michael Josef},
  title     = {Metabolic responses of Escherichia coli upon glucose pulses captured by a capacitive field-effect sensor},
  series = {Physica Status Solidi (A)},
  volume    = {210},
  journal   = {Physica Status Solidi (A)},
  number    = {5},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {0031-8965},
  doi       = {10.1002/pssa.201200900},
  pages     = {926 -- 931},
  year      = {2013},
  abstract  = {Living cells are complex biological systems transforming metabolites taken up from the surrounding medium. Monitoring the responses of such cells to certain substrate concentrations is a challenging task and offers possibilities to gain insight into the vitality of a community influenced by the growth environment. Cell-based sensors represent a promising platform for monitoring the metabolic activity and thus, the "welfare" of relevant organisms. In the present study, metabolic responses of the model bacterium Escherichia coli in suspension, layered onto a capacitive field-effect structure, were examined to pulses of glucose in the concentration range between 0.05 and 2 mM. It was found that acidification of the surrounding medium takes place immediately after glucose addition and follows Michaelis-Menten kinetic behavior as a function of the glucose concentration. In future, the presented setup can, therefore, be used to study substrate specificities on the enzymatic level and may as well be used to perform investigations of more complex metabolic responses. Conclusions and perspectives highlighting this system are discussed.},
  language  = {en}
}
@inproceedings{HoeflingSchirraSpohretal.2013,
  author    = {Hoefling, J. and Schirra, Julian and Spohr, A. and Sch{\"a}fer, Daniel},
  title     = {Induced drag computation with wake model schemes for highly non-planar wing systems},
  series = {Deutscher Luft- und Raumfahrtkongress 2013 : 10.9. - 12.9.2013, Stuttgart},
  booktitle = {Deutscher Luft- und Raumfahrtkongress 2013 : 10.9. - 12.9.2013, Stuttgart},
  publisher = {Dt. Ges. f{\"u}r Luft- und Raumfahrt},
  address   = {Bonn},
  organization    = {Deutscher Luft- und Raumfahrtkongress <62, 2013, Stuttgart>},
  pages     = {1 -- 10},
  year      = {2013},
  language  = {en}
}
@inproceedings{HeuermannSadeghfamFinger2013,
  author    = {Heuermann, Holger and Sadeghfam, Arash and Finger, Torsten},
  title     = {Alternative ignition system based on microwave plasma},
  series = {Advanced ignition systems for gasoline engines : [Vortr{\"a}ge der 1st International Conference Advanced Ignition Systems for Gasoline Engines - 1. Internationale Tagung Z{\"u}ndsysteme f{\"u}r Ottomotoren, 12.-13. November 2012, Berlin]},
  booktitle = {Advanced ignition systems for gasoline engines : [Vortr{\"a}ge der 1st International Conference Advanced Ignition Systems for Gasoline Engines - 1. Internationale Tagung Z{\"u}ndsysteme f{\"u}r Ottomotoren, 12.-13. November 2012, Berlin]},
  publisher = {Expert-Verl.},
  address   = {Renningen},
  organization    = {International Conference Advanced Ignition Systems for Gasoline Engines <1, 2012, Berlin>},
  isbn      = {9783816931904},
  pages     = {95 -- 103},
  year      = {2013},
  language  = {en}
}
@inproceedings{HerzwurmPietsch2013,
  author    = {Herzwurm, Georg and Pietsch, Wolfram},
  title     = {Introduction of RePriCo'13},
  series = {19th International Working Conference on Requirements Engineering: Foundation for Software Quality (REFSQ 2013) : proceedings of the REFSQ 2013 Workshops CreaRE, IWSPM, and RePriCo, the REFSQ 2013 Empirical Track (Empirical Live Experiment and Empirical Research Fair), the REFSQ 2013 Doctoral Symposium, and the REFSQ 2013 Poster Session. ICB-research report. No. 56},
  booktitle = {19th International Working Conference on Requirements Engineering: Foundation for Software Quality (REFSQ 2013) : proceedings of the REFSQ 2013 Workshops CreaRE, IWSPM, and RePriCo, the REFSQ 2013 Empirical Track (Empirical Live Experiment and Empirical Research Fair), the REFSQ 2013 Doctoral Symposium, and the REFSQ 2013 Poster Session. ICB-research report. No. 56},
  publisher = {Duisburg-Essen},
  address   = {Univ.},
  issn      = {ISSN 1860-2770 (Print ) ; ISSN 1866-5101 (Online)},
  pages     = {103 -- 105},
  year      = {2013},
  language  = {en}
}
@article{HennemannKohlReisertetal.2013,
  author    = {Hennemann, J{\"o}rg and Kohl, Claus-Dieter and Reisert, Steffen and Kirchner, Patrick and Sch{\"o}ning, Michael Josef},
  title     = {Copper oxide nanofibres for detection of hydrogen peroxide vapour at high concentrations},
  series = {physica status solidi (a)},
  volume    = {210},
  journal   = {physica status solidi (a)},
  number    = {5},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1862-6319},
  doi       = {10.1002/pssa.201200775},
  pages     = {859 -- 863},
  year      = {2013},
  abstract  = {We present a sensor concept based on copper(II)oxide (CuO) nanofibres for the detection of hydrogen peroxide (H2O2) vapour in the percent per volume (\% v/v) range. The fibres were produced by using the electrospinning technique. To avoid water condensation in the pores, the fibres were initially modified by an exposure to H2S to get an enclosed surface. By a thermal treatment at 350 °C the fibres were oxidised back to CuO. Thereby, the visible pores disappear which was verified by SEM analysis. The fibres show a decrease of resistance with increasing H2O2 concentration which is due to the fact that hydrogen peroxide is an oxidising gas and CuO a p-type semiconductor. The sensor shows a change of resistance within the minute range to the exposure until the maximum concentration of 6.9\% v/v H2O2. At operating temperatures below 450 °C the corresponding sensor response to a concentration of 4.1\% v/v increases. The sensor shows a good reproducibility of the signal at different measurements. CuO seems to be a suitable candidate for the detection of H2O2 vapour at high concentrations. Resistance behaviour of the sensor under exposure to H2O2 vapours between 2.3 and 6.9\% v/v at an operating temperature of 450 °C.},
  language  = {en}
}