@article{StaatVu2007, author = {Staat, Manfred and Vu, Duc-Khoi}, title = {Limit analysis of flaws in pressurized pipes and cylindrical vessels. Part I: Axial defects}, series = {Engineering Fracture Mechanics. 74 (2007), H. 3}, journal = {Engineering Fracture Mechanics. 74 (2007), H. 3}, isbn = {0013-7944}, pages = {431 -- 450}, year = {2007}, language = {en} } @incollection{HoffschmidtFaber2007, author = {Hoffschmidt, Bernhard and Faber, Christian}, title = {Lighthouse project for North-Rhine Westfalia - Solar thermal R \& D Power Planet in J{\"u}lich}, series = {Energy security, climate change and sustainable development / ed. Jyotirmay Mathur ...}, booktitle = {Energy security, climate change and sustainable development / ed. Jyotirmay Mathur ...}, publisher = {Anamaya Publ.}, address = {New Delhi}, isbn = {81-88342-81-5}, pages = {101 -- 116}, year = {2007}, language = {en} } @article{WagnerSchoening2007, author = {Wagner, Torsten and Sch{\"o}ning, Michael Josef}, title = {Light-addressable potentiometric sensors (LAPS): recent trends and applications}, series = {Electrochemical sensor analysis / edited by S. Alegret ...}, journal = {Electrochemical sensor analysis / edited by S. Alegret ...}, publisher = {Elsevier}, address = {Amsterdam}, isbn = {978-0-444-53053-0}, pages = {87 -- 128}, year = {2007}, language = {en} } @misc{Kaemper2007, author = {K{\"a}mper, Klaus-Peter}, title = {Lecture notes Sensors and Actuators}, year = {2007}, abstract = {Kennwortgesch{\"u}tzter Zugang nur f{\"u}r Studierende bei Prof. Dr. Klaus-Peter K{\"a}mper. Wintersemester 2007/2008. Version vom 30.08.2007. 472 Seiten (pdf-Format)}, subject = {Sensor}, language = {en} } @inproceedings{Wessling2007, author = {Weßling, Matthias}, title = {Leadership Perspectives: Research Findings, Theories, Practical Experiences}, year = {2007}, abstract = {Leadership Perspectives: Research Findings, Theories, Practical Experiences: Results of Leadership Research and exemplarily application cases show the perspectives and consequences for leadership practice and the following requirements for executives in future.}, subject = {Leadership}, language = {en} } @article{IngebrandtHanNakamuraetal.2007, author = {Ingebrandt, S. and Han, Y. and Nakamura, F. and Poghossian, Arshak and Sch{\"o}ning, Michael Josef and Offenh{\"a}usser, A.}, title = {Label-free detection of single nucleotide polymorphisms utilizing the differential transfer function of field-effect transistors}, series = {Biosensors and Bioelectronics. 22 (2007), H. 12}, journal = {Biosensors and Bioelectronics. 22 (2007), H. 12}, isbn = {0956-5663}, pages = {2834 -- 2840}, year = {2007}, language = {en} } @article{PoghossianIngebrandtAbouzaretal.2007, author = {Poghossian, Arshak and Ingebrandt, S. and Abouzar, Maryam H. and Sch{\"o}ning, Michael Josef}, title = {Label-free detection of charged macromolecules by using a field-effect-based sensor platform: Experiments and possible mechanisms of signal generation}, series = {Applied Physics A: Materials Science \& Processing. 87 (2007), H. 3}, journal = {Applied Physics A: Materials Science \& Processing. 87 (2007), H. 3}, isbn = {0947-8396}, pages = {517 -- 524}, year = {2007}, language = {en} } @article{Pietsch2007, author = {Pietsch, Wolfram}, title = {IT Service Deployment}, series = {QFD : transactions from International Symposium on QFD 2007 - Williamsburg, the Nineteenth Symposium on Quality Function Deployment ; September 7 - 8, 2007, Williamsburg, VA ; [companion document to the Thirteenth International and Nineteenth North American Symposium on Quality Function Deployment (ISQFD'07)] / [organized and hosted by the QFD Institute]}, journal = {QFD : transactions from International Symposium on QFD 2007 - Williamsburg, the Nineteenth Symposium on Quality Function Deployment ; September 7 - 8, 2007, Williamsburg, VA ; [companion document to the Thirteenth International and Nineteenth North American Symposium on Quality Function Deployment (ISQFD'07)] / [organized and hosted by the QFD Institute]}, publisher = {QFD Inst.}, address = {Ann Arbor, Mich.}, isbn = {1-889477-19-2}, pages = {203 -- 212}, year = {2007}, language = {en} } @article{MangKolzMartinsetal.2007, author = {Mang, Thomas and Kolz, J. and Martins, J. and Kremer, K.}, title = {Investigation of the Elastomer-Foam Production with Single-Sided NMR / Kolz, J. ; Martins, J. ; Kremer, K. ; Mang, Thomas ; Bl{\"u}mich, B.}, series = {Kautschuk Gummi Kunststoffe. 60 (2007), H. 4}, journal = {Kautschuk Gummi Kunststoffe. 60 (2007), H. 4}, isbn = {0948-3276}, pages = {179 -- 183}, year = {2007}, language = {en} } @article{MangKolzHungeretal.2007, author = {Mang, Thomas and Kolz, J. and Hunger, K. and Rath, S.}, title = {Investigation of self-diffusion processes in ionic hydrogels with a single-sided sensor / Kolz, J. ; Hunger, K. ; Rath, S. ; Mang, T. ; Bl{\"u}mich, B.}, series = {Magnetic Resonance Imaging. 25 (2007), H. 4}, journal = {Magnetic Resonance Imaging. 25 (2007), H. 4}, isbn = {0730-725X}, pages = {566 -- 567}, year = {2007}, language = {en} } @inproceedings{WeissAbanteribaEsch2007, author = {Weiss, Alexander and Abanteriba, Sylvester and Esch, Thomas}, title = {Investigation of Flow Separation Inside a Conical Rocket Nozzle With the Aid of an Annular Cross Flow}, series = {Proceedings of the ASME/JSME 2007 5th Joint Fluids Engineering Conference. Volume 1: Symposia, Parts A and B}, booktitle = {Proceedings of the ASME/JSME 2007 5th Joint Fluids Engineering Conference. Volume 1: Symposia, Parts A and B}, publisher = {American Society of Mechanical Engineers (ASME)}, address = {New York}, isbn = {0-7918-4288-6}, doi = {10.1115/FEDSM2007-37387}, pages = {1861 -- 1871}, year = {2007}, abstract = {Flow separation is a phenomenon that occurs in all kinds of supersonic nozzles sometimes during run-up and shut-down operations. Especially in expansion nozzles of rocket engines with large area ratio, flow separation can trigger strong side loads that can damage the structure of the nozzle. The investigation presented in this paper seeks to establish measures that may be applied to alter the point of flow separation. In order to achieve this, a supersonic nozzle was placed at the exit plane of the conical nozzle. This resulted in the generation of cross flow surrounding the core jet flow from the conical nozzle. Due to the entrainment of the gas stream from the conical nozzle the pressure in its exit plane was found to be lower than that of the ambient. A Cold gas instead of hot combustion gases was used as the working fluid. A mathematical simulation of the concept was validated by experiment. Measurements confirmed the simulation results that due to the introduction of a second nozzle the pressure in the separated region of the conical nozzle was significantly reduced. It was also established that the boundary layer separation inside the conical nozzle was delayed thus allowing an increased degree of overexpansion. The condition established by the pressure measurements was also demonstrated qualitatively using transparent nozzle configurations.}, language = {en} } @inproceedings{DiltheySchleserPuterman2007, author = {Dilthey, Ulrich and Schleser, Markus and Puterman, Moshe}, title = {Investigation and improvement of concrete reinforced with epoxy impregnated fabrics}, series = {Proceedings / 12th International Congress Polymers in Concrete, ICPIC 07, chuncheon, Korea, Sept. 26. - 28., 2007}, booktitle = {Proceedings / 12th International Congress Polymers in Concrete, ICPIC 07, chuncheon, Korea, Sept. 26. - 28., 2007}, publisher = {Kangwoon National Univ.}, address = {Chancheon}, isbn = {978-89-9600450-9}, pages = {725 -- 733}, year = {2007}, language = {en} } @article{MistlerAnthoineButenweg2007, author = {Mistler, Michael and Anthoine, A. and Butenweg, Christoph}, title = {In-plane and out-of-plane homogenisation of masonry}, series = {Computers \& structures}, volume = {Volume 85}, journal = {Computers \& structures}, number = {Issues 17-18}, issn = {1879-2243 (E-Journal); 0045-7949 (Print)}, doi = {10.1016/j.compstruc.2006.08.087}, pages = {1321 -- 1330}, year = {2007}, language = {en} } @inproceedings{SchleserDiltheyMundetal.2007, author = {Schleser, Markus and Dilthey, Ulrich and Mund, F. and B{\"o}hm, Stefan}, title = {Improvement of textile reinforced concrete by use of polymers}, series = {Adhesion in interfaces of building materials: a multi-scale approach : [Symposium "Adhesion in Building Bonds: Macro-, Micro- and Nano-Scale" at Warsaw University of Technology in the framework of the European Materials Research Society, fall meeting 2005 ; selected papers]. (Advances in materials science and restoration. No. 2)}, booktitle = {Adhesion in interfaces of building materials: a multi-scale approach : [Symposium "Adhesion in Building Bonds: Macro-, Micro- and Nano-Scale" at Warsaw University of Technology in the framework of the European Materials Research Society, fall meeting 2005 ; selected papers]. (Advances in materials science and restoration. No. 2)}, editor = {Czarnecki, Lech and Garbacz, Andrzej}, publisher = {Aedificatio Publ.}, address = {Freiburg}, isbn = {978-3-931681-89-0}, pages = {153 -- 162}, year = {2007}, language = {en} } @article{DachwaldMcDonaldMcInnesetal.2007, author = {Dachwald, Bernd and McDonald, Malcolm and McInnes, Colin R. and Mengali, Giovanni}, title = {Impact of Optical Degradation on Solar Sail Mission Performance}, series = {Journal of Spacecraft and Rockets. 44 (2007), H. 4}, journal = {Journal of Spacecraft and Rockets. 44 (2007), H. 4}, isbn = {0022-4650}, pages = {740 -- 749}, year = {2007}, language = {en} } @article{Grap2007, author = {Grap, Rolf Dietmar}, title = {If you think, education is expensive, try incompetence}, series = {Beschaffung aktuell (2007)}, journal = {Beschaffung aktuell (2007)}, isbn = {0341-4507}, pages = {62 -- 63}, year = {2007}, language = {en} } @article{FoersterLepsaFreundt2007, author = {F{\"o}rster, Arnold and Lepsa, M. I. and Freundt, D.}, title = {Hot electron injector Gunn diode for advanced driver assistance systems}, series = {Applied physics A: materials science and processing. 87 (2007), H. 3}, journal = {Applied physics A: materials science and processing. 87 (2007), H. 3}, isbn = {0947-8396}, pages = {545 -- 558}, year = {2007}, language = {en} } @article{LinderDigelTemizArtmannetal.2007, author = {Linder, Peter and Digel, Ilya and Temiz Artmann, Ayseg{\"u}l and Kayser, Peter and Porst, Dariusz and Artmann, Gerhard}, title = {High-throughput testing of mechanical forces generated in thin cell and tissue layers}, series = {Tissue Engineering. 13 (2007), H. 7}, journal = {Tissue Engineering. 13 (2007), H. 7}, isbn = {1076-3279}, pages = {1778 -- 1778}, year = {2007}, language = {en} } @article{SchuhGottschalkHoehne2007, author = {Schuh, G. and Gottschalk, S. and H{\"o}hne, Tim}, title = {High Resolution Production Management}, series = {CIRP Annals}, volume = {56}, journal = {CIRP Annals}, number = {1}, issn = {0007-8506}, doi = {10.1016/j.cirp.2007.05.105}, pages = {439 -- 442}, year = {2007}, language = {en} } @article{DachwaldMacDonaldMcInnes2007, author = {Dachwald, Bernd and MacDonald, Malcolm and McInnes, Colin R.}, title = {Heliocentric Solar Sail Orbit Transfers with Locally Optimal Control Laws / Malcolm Macdonald ; Colin McInnes ; Bernd Dachwald}, series = {Journal of Spacecraft and Rockets. 44 (2007), H. 1}, journal = {Journal of Spacecraft and Rockets. 44 (2007), H. 1}, isbn = {0022-4650}, pages = {273 -- 276}, year = {2007}, language = {en} }