@article{BayonValeroGarciaBartualetal.2016,
  author    = {Bayon, Arnau and Valero, Daniel and Garcia-Bartual, Rafael and Vall{\´e}s-Mor{\´a}n, Francisco Jos{\´e} and L{\´o}pez-Jim{\´e}nez, P. Amparo},
  title     = {Performance assessment of OpenFOAM and FLOW-3D in the numerical modeling of a low Reynolds number hydraulic jump},
  series = {Environmental Modelling \& Software},
  volume    = {80},
  journal   = {Environmental Modelling \& Software},
  publisher = {Elsevier},
  address   = {Amsterdam},
  isbn      = {1364-8152},
  doi       = {10.1016/j.envsoft.2016.02.018},
  pages     = {322 -- 335},
  year      = {2016},
  abstract  = {A comparative performance analysis of the CFD platforms OpenFOAM and FLOW-3D is presented, focusing on a 3D swirling turbulent flow: a steady hydraulic jump at low Reynolds number. Turbulence is treated using RANS approach RNG k-ε. A Volume Of Fluid (VOF) method is used to track the air-water interface, consequently aeration is modeled using an Eulerian-Eulerian approach. Structured meshes of cubic elements are used to discretize the channel geometry. The numerical model accuracy is assessed comparing representative hydraulic jump variables (sequent depth ratio, roller length, mean velocity profiles, velocity decay or free surface profile) to experimental data. The model results are also compared to previous studies to broaden the result validation. Both codes reproduced the phenomenon under study concurring with experimental data, although special care must be taken when swirling flows occur. Both models can be used to reproduce the hydraulic performance of energy dissipation structures at low Reynolds numbers.},
  language  = {en}
}
@article{LaumannMainz2012,
  author    = {Laumann, J{\"o}rg and Mainz, Stefan},
  title     = {Direkte Ermittlung der erforderlichen Einspanntiefe von I‑f{\"o}rmigen Stahlquerschnitten in Betonkonstruktionen},
  volume    = {81},
  number    = {11},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1437-1049},
  doi       = {10.1002/stab.201201620},
  pages     = {850 -- 860},
  year      = {2012},
  abstract  = {F{\"u}r die Ermittlung der erforderlichen Einspanntiefe von eingespannten Stahlquerschnitten in Betonkonstruktionen existieren verschiedene Bemessungsmodelle. Diese basieren vorwiegend auf Grundlage nationaler Normen wie z. B. DIN 18800 [1] und DIN 1045 [2], die durch die europ{\"a}ische Normung ersetzt wurden. Aus diesem Grund wird in diesem Aufsatz ein Berechnungsmodell f{\"u}r die erforderliche Einspanntiefe von eingespannten Stahlquerschnitten in Betonkonstruktionen auf Grundlage des Eurocodes vorgestellt. Das Grundger{\"u}st f{\"u}r dieses Berechnungsmodell bildet das Verfahren nach Kindmann und Laumann, welches in [3] behandelt wurde. Gleichzeitig werden neue Formeln zur direkten Ermittlung der Mindesteinspanntiefe vorgestellt. Behandelt werden gewalzte I-Profile f{\"u}r einachsige Biegung um die starke Achse (y-y) mit Drucknormalkraft.},
  language  = {de}
}
@article{EgnerHeydeLaumannetal.2015,
  author    = {Egner, Ralf and Heyde, Stefan and Laumann, J{\"o}rg and Prokop, Ines},
  title     = {Vorschl{\"a}ge f{\"u}r eine anwenderfreundliche und praxistaugliche Novellierung der allgemeinen Bemessungsregeln und Regeln f{\"u}r den Hochbau (EN 1993 Teil 1-1)},
  series = {Stahlbau},
  volume    = {84},
  journal   = {Stahlbau},
  number    = {10},
  publisher = {Ernst \& Sohn},
  address   = {Berlin},
  issn      = {1437-1049},
  doi       = {10.1002/stab.201510321},
  pages     = {811 -- 822},
  year      = {2015},
  language  = {de}
}
@article{OertelBung2015,
  author    = {Oertel, Mario and Bung, Daniel Bernhard},
  title     = {Numerische Str{\"o}mungssimulationen von Fließgew{\"a}ssern : Praxisanwendungen und zuk{\"u}nftige Entwicklungen},
  series = {Korrespondenz Wasserwirtschaft : KW},
  volume    = {8},
  journal   = {Korrespondenz Wasserwirtschaft : KW},
  number    = {H. 3},
  publisher = {Gesellschaft zur F{\"o}rderung der Abwassertechnik},
  address   = {Hennef},
  issn      = {1616-430X},
  pages     = {177 -- 182},
  year      = {2015},
  language  = {de}
}
@article{OertelBung2015,
  author    = {Oertel, Mario and Bung, Daniel Bernhard},
  title     = {Stability and scour development of bed material on crossbar block ramps},
  series = {International journal of sediment research},
  volume    = {30},
  journal   = {International journal of sediment research},
  number    = {4},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1001-6279},
  doi       = {10.1016/j.ijsrc.2014.12.003},
  pages     = {344 -- 350},
  year      = {2015},
  abstract  = {Block ramps are ecologically oriented drop structures with adequate energy dissipation and partially moderate flow velocities. A special case is given with crossbar block ramps, where the upstream and downstream level difference is reduced by a series of basins. To prevent the total structure from failing, the stability of single boulders within the crossbars and the bed material in between must be guaranteed. The present paper addresses the stability of bed material and scour development for various flow regimes. Any bed material erosion may affect the stability of the crossbar boulders, which in turn can result in major damages of the ramp. Therefore new design approaches are developed to choose an appropriate bed material size and to avoid failures of crossbar block ramp structures.},
  language  = {en}
}
@article{DoeringRegerKuhnhenneetal.2015,
  author    = {D{\"o}ring, Bernd and Reger, Vitali and Kuhnhenne, Markus and Feldmann, Markus and Kesti, Jyrki and Lawson, Mark and Botti, Andrea},
  title     = {Steel solutions for enabling zero-energy buildings},
  series = {Steel Construction - Design and Research},
  volume    = {8},
  journal   = {Steel Construction - Design and Research},
  number    = {3},
  publisher = {Ernst \& Sohn},
  address   = {Berlin},
  issn      = {1867-0539},
  doi       = {10.1002/stco.201510029},
  pages     = {194 -- 200},
  year      = {2015},
  language  = {en}
}
@article{KirschKolymbas2005,
  author    = {Kirsch, Ansgar and Kolymbas, Dimitrios},
  title     = {Theoretische Untersuchung zur Ortsbruststabilit{\"a}t},
  series = {Bautechnik : Zeitschrift f{\"u}r den gesamten Ingenieurbau},
  volume    = {Bd. 82},
  journal   = {Bautechnik : Zeitschrift f{\"u}r den gesamten Ingenieurbau},
  number    = {H. 7},
  issn      = {1437-0999 (E-Journal); 0005-6820 (Print); 0932-8351 (Print)},
  doi       = {10.1002/bate.200590151},
  pages     = {449 -- 456},
  year      = {2005},
  language  = {de}
}
@article{GieseKirschZiegler2006,
  author    = {Giese, S. and Kirsch, Ansgar and Ziegler, M.},
  title     = {Numerische Untersuchung von Schervorg{\"a}ngen mit der Diskrete-Partikel-Methode},
  series = {Bauingenieur : die richtungsweisende Zeitschrift im Bauingenieurswesen ; offizielle Zeitschrift der VDI-Gesellschaft Bautechnik},
  volume    = {Bd. 81},
  journal   = {Bauingenieur : die richtungsweisende Zeitschrift im Bauingenieurswesen ; offizielle Zeitschrift der VDI-Gesellschaft Bautechnik},
  number    = {H. 5},
  issn      = {0005-6650},
  pages     = {232 -- 239},
  year      = {2006},
  language  = {de}
}
@article{KolymbasFellinKirsch2006,
  author    = {Kolymbas, Dimitrios and Fellin, W. and Kirsch, Ansgar},
  title     = {Squeezing due to stress relaxation in foliated rock},
  series = {International journal for numerical and analytical methods in geomechanics},
  volume    = {Vol. 30},
  journal   = {International journal for numerical and analytical methods in geomechanics},
  number    = {Iss. 13},
  issn      = {1096-9853 (E-Journal); 0363-9061 (Print)},
  doi       = {10.1002/nag.530},
  pages     = {1357 -- 1367},
  year      = {2006},
  language  = {en}
}
@article{Kirsch2008,
  author    = {Kirsch, Ansgar},
  title     = {Experimentelle Untersuchung des Ortsbrustversagens seichter Tunnel},
  series = {{\"O}sterreichische Bauwirtschaft},
  journal   = {{\"O}sterreichische Bauwirtschaft},
  number    = {Sondernr.},
  pages     = {6 -- 9},
  year      = {2008},
  language  = {de}
}