@article{OrzadaJohstMaderwaldetal.2013,
  author    = {Orzada, Stephan and Johst, S{\"o}ren and Maderwald, Stefan and Bitz, Andreas and Solbach, Klaus and Ladd, Mark E.},
  title     = {Mitigation of B1(+) inhomogeneity on single-channel transmit systems with TIAMO},
  series = {Magnetic Resonance in Medicine},
  volume    = {70},
  journal   = {Magnetic Resonance in Medicine},
  number    = {1},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1522-2594},
  doi       = {10.1002/mrm.24453},
  pages     = {290 -- 294},
  year      = {2013},
  language  = {en}
}
@article{YazdanbakhshSolbachBitz2012,
  author    = {Yazdanbakhsh, Pedram and Solbach, Klaus and Bitz, Andreas},
  title     = {Variable power combiner for RF mode shimming in 7-T MR imaging},
  series = {IEEE Transaction on Biomedical Engineering},
  volume    = {59},
  journal   = {IEEE Transaction on Biomedical Engineering},
  number    = {9},
  publisher = {IEEE},
  address   = {New York},
  issn      = {1558-2531},
  doi       = {10.1109/TBME.2012.2205926},
  pages     = {2549 -- 2557},
  year      = {2012},
  abstract  = {This contribution discusses the utilization of RF power in an MRI system with RF mode shimming which enables the superposition of circularly polarized modes of a transmit RF coil array driven by a Butler matrix. Since the required power for the individual modes can vary widely, mode-shimming can result in a significant underutilization of the total available RF power. A variable power combiner (VPC) is proposed to improve the power utilization: it can be realized as a reconfiguration of the MRI transmit system by the inclusion of one additional matrix network which receives the power from all transmit amplifiers at its input ports and provides any desired (combined) power distribution at its output ports by controlling the phase and amplitude of the amplifiers' input signals. The power distribution at the output ports of the VPC is then fed into the "mode" ports of the coil array Butler matrix in order to superimpose the spatial modes at the highest achievable power utilization. The VPC configuration is compared to the standard configuration of the transmit chain of our MRI system with 8 transmit channels and 16 coils. In realistic scenarios, improved power utilization was achieved from 17\% to 60\% and from 14\% to 55\% for an elliptical phantom and a region of interest in the abdomen, respectively, and an increase of the power utilization of 1 dB for a region of interest in the upper leg. In general, it is found that the VPC allows significant improvement in power utilization when the shimming solution demands only a few modes to be energized, while the technique can yield loss in power utilization in cases with many modes required at high power level.},
  language  = {en}
}
@article{OrzadaBitzJohstetal.2017,
  author    = {Orzada, Stephan and Bitz, Andreas and Johst, S{\"o}ren and Gratz, Marcel and V{\"o}lker, Maximilian N. and Kraff, Oliver and Abuelhaija, Ashraf and Fiedler, Thomas M. and Solbach, Klaus and Quick, Harald H. and Ladd, Mark E.},
  title     = {Analysis of an integrated 8-Channel Tx/Rx body array for use as a body coil in 7-Tesla MRI},
  series = {Frontiers in Physics},
  volume    = {5},
  journal   = {Frontiers in Physics},
  number    = {Jun},
  issn      = {2296-424X},
  doi       = {10.3389/fphy.2017.00017},
  year      = {2017},
  language  = {en}
}
@article{OrzadaSolbachGratzetal.2019,
  author    = {Orzada, Stephan and Solbach, Klaus and Gratz, Marcel and Brunheim, Sascha and Fiedler, Thomas M. and Johst, S{\"o}ren and Bitz, Andreas and Shooshtary, Samaneh and Abuelhaija, Asjraf and Voelker, Maximilian N. and Rietsch, Stefan H. G. and Kraff, Oliver and Maderwald, Stefan and Fl{\"o}ser, Martina and Oehmingen, Mark and Quick, Harald H. and Ladd, Mark E.},
  title     = {A 32-channel parallel transmit system add-on for 7T MRI},
  series = {Plos one},
  journal   = {Plos one},
  doi       = {10.1371/journal.pone.0222452},
  year      = {2019},
  language  = {en}
}