@article{NiehausGaborWielandetal.2011,
  author    = {Niehaus, F. and Gabor, E. and Wieland, S. and Siegert, Petra and Maurer, Karl-Heinz and Eck, J.},
  title     = {Enzymes for the laundry industries: tapping the vast metagenomic pool of alkaline proteases},
  series = {Microbial biotechnology},
  volume    = {Vol. 4},
  journal   = {Microbial biotechnology},
  number    = {Iss. 6},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1432-0614 (E-Journal); 0171-1741 (Print); 0175-7598 (Print); 0340-2118 (Print)},
  pages     = {767 -- 776},
  year      = {2011},
  language  = {en}
}
@article{AlebouyehSamamiPieperBreitbachetal.2014,
  author    = {Alebouyeh Samami, Behzad and Pieper, Martin and Breitbach, Gerd and Hodapp, Josef},
  title     = {Heat production in the windings of the stators of electric machines under stationary condition},
  series = {Heat and mass transfer},
  volume    = {50},
  journal   = {Heat and mass transfer},
  publisher = {Springer},
  address   = {Heidelberg},
  issn      = {0947-7411 (Print) ; 1432-1181 (E-Journal)},
  doi       = {10.1007/s00231-014-1371-8},
  pages     = {1707 -- 1716},
  year      = {2014},
  abstract  = {In electric machines due to high currents and resistive losses (joule heating) heat is produced. To avoid damages by overheating the design of effective cooling systems is required. Therefore the knowledge of heat sources and heat transfer processes is necessary. The purpose of this paper is to illustrate a good and effective calculation method for the temperature analysis based on homogenization techniques. These methods have been applied for the stator windings in a slot of an electric machine consisting of copper wires and resin. The key quantity here is an effective thermal conductivity, which characterizes the heterogeneous wire resin-arrangement inside the stator slot. To illustrate the applicability of the method, the analysis of a simplified, homogenized model is compared with the detailed analysis of temperature behavior inside a slot of an electric machine according to the heat generation. We considered here only the stationary situation. The achieved numerical results are accurate and show that the applied homogenization technique works in practice. Finally the results of simulations for the two cases, the original model of the slot and the homogenized model chosen for the slot (unit cell), are compared to experimental results.},
  language  = {en}
}
@article{KuertenMottaghyZiegler2015,
  author    = {K{\"u}rten, Sylvia and Mottaghy, Darius and Ziegler, Martin},
  title     = {A new model for the description of the heat transfer for plane thermo-active geotechnical systems based on thermal resistances},
  series = {Acta Geotechnica},
  volume    = {10},
  journal   = {Acta Geotechnica},
  number    = {2},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1861-1133},
  doi       = {10.1007/s11440-014-0311-6},
  pages     = {219 -- 229},
  year      = {2015},
  language  = {en}
}
@article{KhaydukovaZadorozhnayaKirsanovetal.2014,
  author    = {Khaydukova, M. M. and Zadorozhnaya, O. A. and Kirsanov, D. O. and Iken, Heiko and Rolka, David and Sch{\"o}ning, Michael Josef and Babain, V. A. and Vlasov, Yu. G. and Legin, A. V.},
  title     = {Multivariate processing of atomic-force microscopy images for detection of the response of plasticized polymeric membranes},
  series = {Russian journal of applied chemistry},
  volume    = {87},
  journal   = {Russian journal of applied chemistry},
  number    = {3},
  publisher = {Springer},
  address   = {Dordrecht},
  issn      = {1608-3296 (E-Journal); 1070-4272 (Print)},
  doi       = {10.1134/S1070427214030112},
  pages     = {307 -- 314},
  year      = {2014},
  abstract  = {The possibility of using the atomic-force microscopy as a method for detection of the analytical signal from plasticized polymeric sensor membranes was analyzed. The surfaces of cadmium-selective membranes based on two polymeric matrices were examined. The digital images were processed with multivariate image analysis techniques. A correlation was found between the surface profile of an ion-selective membrane and the concentration of the ion in solution.},
  language  = {en}
}
@article{BorchertHasenbeckJungbluthetal.2009,
  author    = {Borchert, J{\"o}rg and Hasenbeck, Marc and Jungbluth, Christian and Schemm, Ralf},
  title     = {Bewertung und Steuerung von Gasspeichern bzw. Gasspeicherscheiben},
  series = {Zeitschrift f{\"u}r Energiewirtschaft},
  volume    = {33},
  journal   = {Zeitschrift f{\"u}r Energiewirtschaft},
  number    = {4},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1866-2765},
  doi       = {10.1007/s12398-009-0033-x},
  pages     = {279 -- 293},
  year      = {2009},
  abstract  = {In diesem Artikel werden zun{\"a}chst einleitend der Gasmarkt Deutschland und der sich daraus ergebende Speicherbedarf skizziert. Folgend wird auf verschiedene Speichernutzen aus betriebswirtschaftlicher Perspektive eingegangen und die in diesem Artikel vorgestellten Bewertungsverfahren einleitend beschrieben. In diesem Artikel werden stochastische Optimierungsmethoden aufgegriffen, die sowohl eine Bewertung der Speicher gegen{\"u}ber einem Spotpreis, als auch gegen{\"u}ber einer gesamten Forwardcurve erm{\"o}glichen. Hierzu werden zun{\"a}chst Modelle zur Beschreibung der Marktpreise vorgestellt und anhand empirischer Daten kalibriert. Dann wird eine beispielhafte Speicherscheibe zun{\"a}chst auf Basis der LeastSquareMonteCarloTechnik gegen{\"u}ber dem stochastischen mehrfaktoriellen Spotpreismodell bewertet. Hieran schließt sich die Vorstellung der Bewertung sowie des Hedgings gegen{\"u}ber der Forwardcurve an. Abschließend erfolgt eine vergleichende Gegen{\"u}berstellung beider Verfahren.},
  language  = {de}
}
@article{Kirsch2010,
  author    = {Kirsch, Ansgar},
  title     = {Experimental investigation of the face stability of shallow tunnels in sand},
  series = {Acta Geotechnica},
  volume    = {5},
  journal   = {Acta Geotechnica},
  number    = {1},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1861-1125},
  doi       = {10.1007/s11440-010-0110-7},
  pages     = {43 -- 62},
  year      = {2010},
  abstract  = {Various models have been proposed for the prediction of the necessary support pressure at the face of a shallow tunnel. To assess their quality, the collapse of a tunnel face was modelled with small-scale model tests at single gravity. The development of the failure mechanism and the support force at the face in dry sand were investigated. The observed displacement patterns show a negligible influence of overburden on the extent and evolution of the failure zone. The latter is significantly influenced, though, by the initial density of the sand: in dense sand a chimney-wedge-type collapse mechanism developed, which propagated towards the soil surface. Initially, loose sand did not show any discrete collapse mechanism. The necessary support force was neither influenced by the overburden nor the initial density. A comparison with quantitative predictions by several theoretical models showed that the measured necessary support pressure is overestimated by most of the models. Those by Vermeer/Ruse and L{\´e}ca/Dormieux showed the best agreement to the measurements.},
  language  = {en}
}
@article{FischerSelverGezeretal.2015,
  author    = {Fischer, Felix and Selver, M. Alper and Gezer, Sinem and Dicle, Oguz and Hillen, Walter},
  title     = {Systematic Parameterization, Storage, and Representation of Volumetric DICOM Data},
  series = {Journal of Medical and Biological Engineering},
  volume    = {35},
  journal   = {Journal of Medical and Biological Engineering},
  number    = {6},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {2199-4757},
  doi       = {10.1007/s40846-015-0097-5},
  pages     = {709 -- 723},
  year      = {2015},
  language  = {en}
}
@article{Bung2011,
  author    = {Bung, Daniel Bernhard},
  title     = {Fließcharakteristik und Sauerstoffeintrag bei selbstbel{\"u}fteten Gerinnestr{\"o}mungen auf Kaskaden mit gem{\"a}ßigter Neigung},
  series = {{\"O}sterreichische Wasser- und Abfallwirtschaft},
  volume    = {Vol. 63},
  journal   = {{\"O}sterreichische Wasser- und Abfallwirtschaft},
  number    = {Iss. 3-4},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1613-7566 (E-Journal); 0945-358X (Print)},
  pages     = {76 -- 81},
  year      = {2011},
  language  = {de}
}
@article{HagenkampBlankeDoering2021,
  author    = {Hagenkamp, Markus and Blanke, Tobias and D{\"o}ring, Bernd},
  title     = {Thermoelectric building temperature control: a potential assessment},
  series = {International Journal of Energy and Environmental Engineering},
  volume    = {13},
  journal   = {International Journal of Energy and Environmental Engineering},
  publisher = {Springer},
  address   = {Berlin},
  doi       = {10.1007/s40095-021-00424-x},
  pages     = {241 -- 254},
  year      = {2021},
  abstract  = {This study focuses on thermoelectric elements (TEE) as an alternative for room temperature control. TEE are semi-conductor devices that can provide heating and cooling via a heat pump effect without direct noise emissions and no refrigerant use. An efficiency evaluation of the optimal operating mode is carried out for different numbers of TEE, ambient temperatures, and heating loads. The influence of an additional heat recovery unit on system efficiency and an unevenly distributed heating demand are examined. The results show that TEE can provide heat at a coefficient of performance (COP) greater than one especially for small heating demands and high ambient temperatures. The efficiency increases with the number of elements in the system and is subject to economies of scale. The best COP exceeds six at optimal operating conditions. An additional heat recovery unit proves beneficial for low ambient temperatures and systems with few TEE. It makes COPs above one possible at ambient temperatures below 0 ∘C. The effect increases efficiency by maximal 0.81 (from 1.90 to 2.71) at ambient temperature 5 K below room temperature and heating demand Q˙h=100W but is subject to diseconomies of scale. Thermoelectric technology is a valuable option for electricity-based heat supply and can provide cooling and ventilation functions. A careful system design as well as an additional heat recovery unit significantly benefits the performance. This makes TEE superior to direct current heating systems and competitive to heat pumps for small scale applications with focus on avoiding noise and harmful refrigerants.},
  language  = {en}
}
@article{KerpenBungValeroetal.2017,
  author    = {Kerpen, Nils B. and Bung, Daniel Bernhard and Valero, Daniel and Schlurmann, Torsten},
  title     = {Energy dissipation within the wave run-up at stepped revetments},
  series = {Journal of Ocean University of China},
  volume    = {16},
  journal   = {Journal of Ocean University of China},
  number    = {4},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1993-5021},
  doi       = {10.1007/s11802-017-3355-z},
  pages     = {649 -- 654},
  year      = {2017},
  language  = {en}
}