@article{ReisertSchneiderGeissleretal.2013,
  author    = {Reisert, Steffen and Schneider, Benno and Geissler, Hanno and Gompel, Matthias van and Wagner, Patrick and Sch{\"o}ning, Michael Josef},
  title     = {Multi-sensor chip for the investigation of different types of metal oxides for the detection of H2O2 in the ppm range},
  series = {physica status solidi (a)},
  volume    = {210},
  journal   = {physica status solidi (a)},
  number    = {5},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1862-6319},
  pages     = {898 -- 904},
  year      = {2013},
  abstract  = {In this work, a multi-sensor chip for the investigation of the sensing properties of different types of metal oxides towards hydrogen peroxide in the ppm range is presented. The fabrication process and physical characterization of the multi-sensor chip are described. Pure SnO2 and WO3 as well as Pd- and Pt-doped SnO2 films are characterized in terms of their sensitivity to H2O2. The sensing films have been prepared by drop-coating of water-dispensed nano-powders. A physical characterization, including scanning electron microscopy and X-ray diffraction analysis of the deposited metal-oxide films, was done. From the measurements in hydrogen peroxide atmosphere, it could be shown, that all of the tested metal oxide films are suitable for the detection of H2O2 in the ppm range. The highest sensitivity and reproducibility was achieved using Pt-doped SnO2. Calibration plot of a SnO2, WO3, Pt-, and Pd-doped SnO2 gas sensor for H2O2 concentrations in the ppm range.},
  language  = {en}
}
@article{SchusserLeinhosBaeckeretal.2013,
  author    = {Schusser, Sebastian and Leinhos, Marcel and B{\"a}cker, Matthias and Poghossian, Arshak and Wagner, Patrick and Sch{\"o}ning, Michael Josef},
  title     = {Impedance spectroscopy: A tool for real-time in situ monitoring of the degradation of biopolymers},
  series = {Physica Status Solidi (A)},
  volume    = {210},
  journal   = {Physica Status Solidi (A)},
  number    = {5},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1521-396X ; 0031-8965},
  doi       = {10.1002/pssa.201200941},
  pages     = {905 -- 910},
  year      = {2013},
  abstract  = {Investigation of the degradation kinetics of biodegradable polymers is essential for the development of implantable biomedical devices with predicted biodegradability. In this work, an impedimetric sensor has been applied for real-time and in situ monitoring of degradation processes of biopolymers. The sensor consists of two platinum thin-film electrodes covered by a polymer film to be studied. The benchmark biomedical polymer poly(D,L-lactic acid) (PDLLA) was used as a model system. PDLLA films were deposited on the sensor structure from a polymer solution by using the spin-coating method. The degradation kinetics of PDLLA films have been studied in alkaline solutions of pH 9 and 12 by means of an impedance spectroscopy (IS) method. Any changes in a polymer capacitance/resistance induced by water uptake and/or polymer degradation will modulate the global impedance of the polymer-covered sensor that can be used as an indicator of the polymer degradation. The degradation rate can be evaluated from the time-dependent impedance spectra. As expected, a faster degradation has been observed for PDLLA films exposed to pH 12 solution.},
  language  = {en}
}
@article{ThielTippkoetterSucketal.2013,
  author    = {Thiel, Alexander and Tippk{\"o}tter, Nils and Suck, Kirstin and Sohling, Ulrich and Ruf, Friedrich and Ulber, Roland},
  title     = {New zeolite adsorbents for downstream processing of polyphenols from renewable resources},
  series = {Engineering in Life Sciences},
  volume    = {13},
  journal   = {Engineering in Life Sciences},
  number    = {3},
  publisher = {Wiley},
  address   = {Weinheim},
  doi       = {10.1002/elsc.201200188},
  pages     = {239 -- 246},
  year      = {2013},
  abstract  = {Commercial materials with polyvinylpolypyrrolidone and polymeric amberlites (XAD7HP, XAD16) are commonly used for the adsorptive downstream processing of polyphenols from renewable resources. In this study, beta-zeolite-based adsorbent systems were examined, and their properties were compared to organic resins. Batch adsorption experiments were conducted with synthetic solutions of major polyphenols. Adsorption isotherms and desorption characteristics of individual adsorbent were determined based on these results. Maximum adsorption capacities were calculated using the Langmuir model. For example, the zeolites had capacities up to 203.2 mg/g for ferulic acid. To extend these results to a complex system, additional experiments were performed on rapeseed meal and wheat seed extracts as representative renewable resources. HPLC analysis showed that with 7.5\% w/v, which is regarded as the optimum amount of zeolites, zeolites A and B could bind 100\% of the major polyphenols as well as release polyphenols at high yields. Additionally, regeneration experiments were performed with isopropyl alcohol at 99°C to evaluate how zeolites regenerate under mild conditions. The results showed only a negligible loss of adsorption capacity and no loss of desorption capacity. In summary, it was concluded that beta-zeolites were promising adsorbents for developing new processes to isolate polyphenols from renewable resources.},
  language  = {en}
}
@article{TippkoetterAlKaidyWollnyetal.2013,
  author    = {Tippk{\"o}tter, Nils and Al-Kaidy, Huschyar and Wollny, Steffen and Ulber, Roland},
  title     = {Functionalized magnetizable particles for downstream processing in single-use systems},
  series = {Chemie Ingenieur Technik},
  volume    = {85},
  journal   = {Chemie Ingenieur Technik},
  number    = {1-2: Special Issue: Single-Use Technology},
  publisher = {Wiley},
  address   = {Weinheim},
  doi       = {10.1002/cite.201200130},
  pages     = {76 -- 86},
  year      = {2013},
  abstract  = {Biotechnological downstream processing is usually an elaborate procedure, requiring a multitude of unit operations to isolate the target component. Besides the disadvantageous space-time yield, the risks of cross-contaminations and product loss grow fast with the complexity of the isolation procedure. A significant reduction of unit operations can be achieved by application of magnetic particles, especially if these are functionalized with affinity ligands. As magnetic susceptible materials are highly uncommon in biotechnological processes, target binding and selective separation of such particles from fermentation or reactions broths can be done in a single step. Since the magnetizable particles can be produced from iron salts and low priced polymers, a single-use implementation of these systems is highly conceivable. In this article, the principles of magnetizable particles, their synthesis and functionalization are explained. Furthermore, applications in the area of reaction engineering, microfluidics and downstream processing are discussed focusing on established single-use technologies and development potential.},
  language  = {en}
}
@article{VoigtSchroeterJuergenetal.2013,
  author    = {Voigt, Birgit and Schroeter, Rebecca and J{\"u}rgen, Britta and Albrecht, Dirk and Evers, Stefan and Bongaerts, Johannes and Maurer, Karl-Heinz and Schweder, Thomas and Hecker, Michael},
  title     = {The response of Bacillus licheniformis to heat and ethanol stress and the role of the SigB regulon},
  series = {Proteomics},
  volume    = {Vol. 13},
  journal   = {Proteomics},
  number    = {Iss. 14},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1615-9861 (E-Journal); 1615-9853 (Print)},
  pages     = {2140 -- 2146},
  year      = {2013},
  language  = {en}
}