@article{HennemannKohlReisertetal.2013,
  author    = {Hennemann, J{\"o}rg and Kohl, Claus-Dieter and Reisert, Steffen and Kirchner, Patrick and Sch{\"o}ning, Michael Josef},
  title     = {Copper oxide nanofibres for detection of hydrogen peroxide vapour at high concentrations},
  series = {physica status solidi (a)},
  volume    = {210},
  journal   = {physica status solidi (a)},
  number    = {5},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1862-6319},
  doi       = {10.1002/pssa.201200775},
  pages     = {859 -- 863},
  year      = {2013},
  abstract  = {We present a sensor concept based on copper(II)oxide (CuO) nanofibres for the detection of hydrogen peroxide (H2O2) vapour in the percent per volume (\% v/v) range. The fibres were produced by using the electrospinning technique. To avoid water condensation in the pores, the fibres were initially modified by an exposure to H2S to get an enclosed surface. By a thermal treatment at 350 °C the fibres were oxidised back to CuO. Thereby, the visible pores disappear which was verified by SEM analysis. The fibres show a decrease of resistance with increasing H2O2 concentration which is due to the fact that hydrogen peroxide is an oxidising gas and CuO a p-type semiconductor. The sensor shows a change of resistance within the minute range to the exposure until the maximum concentration of 6.9\% v/v H2O2. At operating temperatures below 450 °C the corresponding sensor response to a concentration of 4.1\% v/v increases. The sensor shows a good reproducibility of the signal at different measurements. CuO seems to be a suitable candidate for the detection of H2O2 vapour at high concentrations. Resistance behaviour of the sensor under exposure to H2O2 vapours between 2.3 and 6.9\% v/v at an operating temperature of 450 °C.},
  language  = {en}
}
@article{ReisertSchneiderGeissleretal.2013,
  author    = {Reisert, Steffen and Schneider, Benno and Geissler, Hanno and Gompel, Matthias van and Wagner, Patrick and Sch{\"o}ning, Michael Josef},
  title     = {Multi-sensor chip for the investigation of different types of metal oxides for the detection of H2O2 in the ppm range},
  series = {physica status solidi (a)},
  volume    = {210},
  journal   = {physica status solidi (a)},
  number    = {5},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1862-6319},
  pages     = {898 -- 904},
  year      = {2013},
  abstract  = {In this work, a multi-sensor chip for the investigation of the sensing properties of different types of metal oxides towards hydrogen peroxide in the ppm range is presented. The fabrication process and physical characterization of the multi-sensor chip are described. Pure SnO2 and WO3 as well as Pd- and Pt-doped SnO2 films are characterized in terms of their sensitivity to H2O2. The sensing films have been prepared by drop-coating of water-dispensed nano-powders. A physical characterization, including scanning electron microscopy and X-ray diffraction analysis of the deposited metal-oxide films, was done. From the measurements in hydrogen peroxide atmosphere, it could be shown, that all of the tested metal oxide films are suitable for the detection of H2O2 in the ppm range. The highest sensitivity and reproducibility was achieved using Pt-doped SnO2. Calibration plot of a SnO2, WO3, Pt-, and Pd-doped SnO2 gas sensor for H2O2 concentrations in the ppm range.},
  language  = {en}
}
@article{KotliarHanssenEberhardtetal.2013,
  author    = {Kotliar, Konstantin and Hanssen, Henner and Eberhardt, Karla and Vilser, Walthard and Schmaderer, Christoph and Halle, Martin and Heemann, Uwe and Baumann, M.},
  title     = {Retinal pulse wave velocity in young male normotensive and mildly hypertensive subjects},
  series = {Microcirculation},
  journal   = {Microcirculation},
  publisher = {Wiley},
  address   = {Malden},
  issn      = {1549-8719},
  year      = {2013},
  language  = {en}
}
@article{KirchnerOberlaenderSusoetal.2013,
  author    = {Kirchner, Patrick and Oberl{\"a}nder, Jan and Suso, Henri-Pierre and Rysstad, Gunnar and Keusgen, Michael and Sch{\"o}ning, Michael Josef},
  title     = {Towards a wireless sensor system for real-time H2O2 monitoring in aseptic food processes},
  series = {Physica status solidi (a)},
  volume    = {210},
  journal   = {Physica status solidi (a)},
  number    = {5},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1862-6319},
  doi       = {10.1002/pssa.201200920},
  pages     = {877 -- 883},
  year      = {2013},
  abstract  = {A wireless sensor system based on the industrial ZigBee standard for low-rate wireless networking was developed that enables real-time monitoring of gaseous H2O2 during the package sterilization in aseptic food processes. The sensor system consists of a remote unit connected to a calorimetric gas sensor, which was already established in former works, and an external base unit connected to a laptop computer. The remote unit was built up by an XBee radio frequency (RF) module for data communication and a programmable system-on-chip controller to read out the sensor signal and process the sensor data, whereas the base unit is a second XBee RF module. For the rapid H2O2 detection on various locations inside the package that has to be sterilized, a novel read-out strategy of the calorimetric gas sensor was established, wherein the sensor response is measured within the short sterilization time and correlated with the present H2O2 concentration. In an exemplary measurement application in an aseptic filling machinery, the suitability of the new, wireless sensor system was demonstrated, wherein the influence of the gas velocity on the H2O2 distribution inside a package was determined and verified with microbiological tests.},
  language  = {en}
}
@article{MuribGrinsvenGrietenetal.2013,
  author    = {Murib, M. S. and Grinsven, B. van and Grieten, L. and Janssens, S. D. and Vermeeren, V. and Eersels, K. and Broeders, J. and Ameloot, M. and Michiels, L. and Ceuninck, W. De and Haenen, K. and Sch{\"o}ning, Michael Josef and Wagner, Patrick},
  title     = {Electronic monitoring of chemical DNA denaturation on nanocrystalline diamond electrodes with different molarities and flow rates},
  series = {Physica Status Solidi (A). Vol. 210 (2013), iss. 5},
  journal   = {Physica Status Solidi (A). Vol. 210 (2013), iss. 5},
  publisher = {Wiley-VCH},
  address   = {Berlin},
  issn      = {0031-8965},
  pages     = {911 -- 917},
  year      = {2013},
  language  = {en}
}
@article{HeggerClassenSchaumannetal.2013,
  author    = {Hegger, Josef and Claßen, Martin and Schaumann, Peter and Sothmann, J{\"o}rg and Feldmann, Markus and D{\"o}ring, Bernd},
  title     = {Entwicklung einer integrierten Verbunddecke f{\"u}r nachhaltige Stahlbauten},
  series = {Stahlbau},
  volume    = {Vol. 82},
  journal   = {Stahlbau},
  number    = {Iss. 1},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1437-1049 (E-Journal); 0038-9145 (Print)},
  pages     = {11 -- 17},
  year      = {2013},
  language  = {de}
}
@article{JiminezGermanBehbahaniMiettinenetal.2013,
  author    = {Jiminez German, Salvador and Behbahani, Mehdi and Miettinen, Susanna and Grijpma, Dirk W. and Haimi, Suvi P.},
  title     = {Proliferation and differentiation of adipose stem cells towards smooth muscle cells on poly(trimethylene carbonate) membranes},
  series = {Macromolecular symposia},
  volume    = {Vol. 334},
  journal   = {Macromolecular symposia},
  number    = {Iss. 1},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {0258-0322},
  pages     = {133 -- 142},
  year      = {2013},
  language  = {en}
}
@article{MartinezJakobTuetal.2013,
  author    = {Martinez, Ronny and Jakob, Felix and Tu, Ran and Siegert, Petra and Maurer, Karl-Heinz and Schwaneberg, Ulrich},
  title     = {Increasing activity and thermal resistance of Bacillus gibsonii alkaline protease (BgAP) by directed evolution},
  series = {Biotechnology and bioengineering},
  volume    = {Vol. 110},
  journal   = {Biotechnology and bioengineering},
  number    = {Iss. 3},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1097-0290 (E-Journal); 0006-3592 (Print); 0368-1467 (Print)},
  pages     = {711 -- 720},
  year      = {2013},
  language  = {en}
}
@article{OrzadaJohstMaderwaldetal.2013,
  author    = {Orzada, Stephan and Johst, S{\"o}ren and Maderwald, Stefan and Bitz, Andreas and Solbach, Klaus and Ladd, Mark E.},
  title     = {Mitigation of B1(+) inhomogeneity on single-channel transmit systems with TIAMO},
  series = {Magnetic Resonance in Medicine},
  volume    = {70},
  journal   = {Magnetic Resonance in Medicine},
  number    = {1},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1522-2594},
  doi       = {10.1002/mrm.24453},
  pages     = {290 -- 294},
  year      = {2013},
  language  = {en}
}
@article{KraffWredeSchoembergetal.2013,
  author    = {Kraff, Oliver and Wrede, Karsten H. and Schoemberg, Tobias and Dammann, Philipp and Noureddine, Yacine and Orzada, Stephan and Ladd, Mark E. and Bitz, Andreas},
  title     = {MR safety assessment of potential RF heating from cranial fixation plates at 7 T},
  series = {Medical Physics},
  volume    = {40},
  journal   = {Medical Physics},
  number    = {4},
  publisher = {Wiley},
  address   = {Hoboken},
  issn      = {2473-4209},
  doi       = {10.1118/1.4795347},
  pages     = {042302-1 -- 042302-10},
  year      = {2013},
  language  = {en}
}