@article{SchusserLeinhosBaeckeretal.2013,
  author    = {Schusser, Sebastian and Leinhos, Marcel and B{\"a}cker, Matthias and Poghossian, Arshak and Wagner, Patrick and Sch{\"o}ning, Michael Josef},
  title     = {Impedance spectroscopy: A tool for real-time in situ monitoring of the degradation of biopolymers},
  series = {Physica Status Solidi (A)},
  volume    = {210},
  journal   = {Physica Status Solidi (A)},
  number    = {5},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1521-396X ; 0031-8965},
  doi       = {10.1002/pssa.201200941},
  pages     = {905 -- 910},
  year      = {2013},
  abstract  = {Investigation of the degradation kinetics of biodegradable polymers is essential for the development of implantable biomedical devices with predicted biodegradability. In this work, an impedimetric sensor has been applied for real-time and in situ monitoring of degradation processes of biopolymers. The sensor consists of two platinum thin-film electrodes covered by a polymer film to be studied. The benchmark biomedical polymer poly(D,L-lactic acid) (PDLLA) was used as a model system. PDLLA films were deposited on the sensor structure from a polymer solution by using the spin-coating method. The degradation kinetics of PDLLA films have been studied in alkaline solutions of pH 9 and 12 by means of an impedance spectroscopy (IS) method. Any changes in a polymer capacitance/resistance induced by water uptake and/or polymer degradation will modulate the global impedance of the polymer-covered sensor that can be used as an indicator of the polymer degradation. The degradation rate can be evaluated from the time-dependent impedance spectra. As expected, a faster degradation has been observed for PDLLA films exposed to pH 12 solution.},
  language  = {en}
}
@article{MolinnusPoghossianKeusgenetal.2017,
  author    = {Molinnus, Denise and Poghossian, Arshak and Keusgen, Michael and Katz, Evgeny and Sch{\"o}ning, Michael Josef},
  title     = {Coupling of Biomolecular Logic Gates with Electronic Transducers: From Single Enzyme Logic Gates to Sense/Act/Treat Chips},
  series = {Electroanalysis},
  volume    = {29},
  journal   = {Electroanalysis},
  number    = {8},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1521-4109},
  doi       = {10.1002/elan.201700208},
  pages     = {1840 -- 1849},
  year      = {2017},
  abstract  = {The integration of biomolecular logic principles with electronic transducers allows designing novel digital biosensors with direct electrical output, logically triggered drug-release, and closed-loop sense/act/treat systems. This opens new opportunities for advanced personalized medicine in the context of theranostics. In the present work, we will discuss selected examples of recent developments in the field of interfacing enzyme logic gates with electrodes and semiconductor field-effect devices. Special attention is given to an enzyme OR/Reset logic gate based on a capacitive field-effect electrolyte-insulator-semiconductor sensor modified with a multi-enzyme membrane. Further examples are a digital adrenaline biosensor based on an AND logic gate with binary YES/NO output and an integrated closed-loop sense/act/treat system comprising an amperometric glucose sensor, a hydrogel actuator, and an insulin (drug) sensor.},
  language  = {en}
}
@article{BegingLeinhosJablonskietal.2015,
  author    = {Beging, Stefan and Leinhos, Marcel and Jablonski, Melanie and Poghossian, Arshak and Sch{\"o}ning, Michael Josef},
  title     = {Studying the spatially resolved immobilisation of enzymes on a capacitive field-effect structure by means of nano-spotting},
  series = {Physica status solidi (a)},
  volume    = {212},
  journal   = {Physica status solidi (a)},
  number    = {6},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1862-6319},
  doi       = {10.1002/pssa.201431891},
  pages     = {1353 -- 1358},
  year      = {2015},
  language  = {en}
}
@article{BaeckerSchusserPoghossianetal.2014,
  author    = {B{\"a}cker, Matthias and Schusser, Sebastian and Poghossian, Arshak and Sch{\"o}ning, Michael Josef},
  title     = {Multi-Parametererfassung mit siliziumbasiertem Sensorchip: Aus Drei mach Eins},
  series = {GIT Labor-Fachzeitschrift},
  journal   = {GIT Labor-Fachzeitschrift},
  number    = {2},
  publisher = {Wiley},
  issn      = {0016-3538},
  pages     = {28 -- 30},
  year      = {2014},
  language  = {de}
}
@article{HuckPoghossianBaeckeretal.2015,
  author    = {Huck, Christina and Poghossian, Arshak and B{\"a}cker, Matthias and Reisert, Steffen and Kramer, Friederike and Begoyan, Vardges K. and Buniatyan, Vahe V. and Sch{\"o}ning, Michael Josef},
  title     = {Multi-parameter sensing using high-k oxide of barium strontium titanate},
  series = {Physica status solidi (a)},
  volume    = {212},
  journal   = {Physica status solidi (a)},
  number    = {6},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1862-6319},
  doi       = {10.1002/pssa.201431911},
  pages     = {1259},
  year      = {2015},
  abstract  = {High-k perovskite oxide of barium strontium titanate (BST) represents a very attractive multi-functional transducer material for the development of (bio-)chemical sensors. In this work, a Si-based sensor chip containing Pt interdigitated electrodes covered with a thin BST layer (485 nm) has been developed for multi-parameter chemical sensing. The chip has been applied for the contactless measurement of the electrolyte conductivity, the detection of adsorbed charged macromolecules (positively charged polyelectrolytes of polyethylenimine) and the concentration of hydrogen peroxide (H2O2) vapor. The experimental results of functional testing of individual sensors are presented. The mechanism of the BST sensitivity to charged polyelectrolytes and H2O2 vapor has been proposed and discussed.},
  language  = {en}
}
@article{MuribGrinsvenGrietenetal.2013,
  author    = {Murib, M. S. and Grinsven, B. van and Grieten, L. and Janssens, S. D. and Vermeeren, V. and Eersels, K. and Broeders, J. and Ameloot, Marcel and Michiels, L. and Ceuninck, W. De and Haenen, K. and Sch{\"o}ning, Michael Josef and Wagner, Patrick},
  title     = {Electronic monitoring of chemical DNA denaturation on nanocrystalline diamond electrodes with different molarities and flow rates},
  series = {Physica Status Solidi (A). Vol. 210 (2013), iss. 5},
  journal   = {Physica Status Solidi (A). Vol. 210 (2013), iss. 5},
  publisher = {Wiley-VCH},
  address   = {Berlin},
  issn      = {0031-8965},
  pages     = {911 -- 917},
  year      = {2013},
  language  = {en}
}
@article{OezsoyluKizildagSchoeningetal.2019,
  author    = {{\"O}zsoylu, Dua and Kizildag, Sefa and Sch{\"o}ning, Michael Josef and Wagner, Torsten},
  title     = {Effect of plasma treatment on the sensor properties of a light-addressable potentiometric sensor (LAPS)},
  series = {physica status solidi a : applications and materials sciences},
  volume    = {216},
  journal   = {physica status solidi a : applications and materials sciences},
  number    = {20},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1862-6319},
  doi       = {10.1002/pssa.201900259},
  pages     = {8 Seiten},
  year      = {2019},
  abstract  = {A light-addressable potentiometric sensor (LAPS) is a field-effect-based (bio-) chemical sensor, in which a desired sensing area on the sensor surface can be defined by illumination. Light addressability can be used to visualize the concentration and spatial distribution of the target molecules, e.g., H+ ions. This unique feature has great potential for the label-free imaging of the metabolic activity of living organisms. The cultivation of those organisms needs specially tailored surface properties of the sensor. O2 plasma treatment is an attractive and promising tool for rapid surface engineering. However, the potential impacts of the technique are carefully investigated for the sensors that suffer from plasma-induced damage. Herein, a LAPS with a Ta2O5 pH-sensitive surface is successfully patterned by plasma treatment, and its effects are investigated by contact angle and scanning LAPS measurements. The plasma duration of 30 s (30 W) is found to be the threshold value, where excessive wettability begins. Furthermore, this treatment approach causes moderate plasma-induced damage, which can be reduced by thermal annealing (10 min at 300 °C). These findings provide a useful guideline to support future studies, where the LAPS surface is desired to be more hydrophilic by O2 plasma treatment.},
  language  = {en}
}