@article{KlingeOttoMuehl2015,
  author    = {Klinge, Uwe and Otto, Jens and M{\"u}hl, Thomas},
  title     = {High Structural Stability of Textile Implants Prevents Pore Collapse and Preserves Effective Porosity at Strain},
  series = {BioMed Research International},
  volume    = {2015},
  journal   = {BioMed Research International},
  issn      = {2314-6133 (Print)},
  doi       = {10.1155/2015/953209},
  pages     = {7 pages},
  year      = {2015},
  language  = {en}
}
@article{WuBronderPoghossianetal.2015,
  author    = {Wu, Chunsheng and Bronder, Thomas and Poghossian, Arshak and Werner, Frederik and Sch{\"o}ning, Michael Josef},
  title     = {Label-free detection of DNA using light-addressable potentiometric sensor modified with a positively charged polyelectrolyte layer},
  series = {Nanoscale},
  volume    = {14},
  journal   = {Nanoscale},
  number    = {7},
  publisher = {Royal Society of Chemistry (RSC)},
  address   = {Cambridge},
  doi       = {10.1039/C4NR07225A},
  pages     = {6143 -- 6150},
  year      = {2015},
  abstract  = {A multi-spot (16 spots) light-addressable potentiometric sensor (MLAPS) consisting of an Al-p-Si-SiO2 structure modified with a weak polyelectrolyte layer of PAH (poly(allylamine hydrochloride)) was applied for the label-free electrical detection of DNA (deoxyribonucleic acid) immobilization and hybridization by the intrinsic molecular charge for the first time. To achieve a preferentially flat orientation of DNA strands and thus, to reduce the distance between the DNA charge and MLAPS surface, the negatively charged probe single-stranded DNAs (ssDNA) were electrostatically adsorbed onto the positively charged PAH layer using a simple layer-by-layer (LbL) technique. In this way, more DNA charge can be positioned within the Debye length, yielding a higher sensor signal. The surface potential changes in each spot induced due to the surface modification steps (PAH adsorption, probe ssDNA immobilization, hybridization with complementary target DNA (cDNA), non-specific adsorption of mismatched ssDNA) were determined from the shifts of photocurrent-voltage curves along the voltage axis. A high sensor signal of 83 mV was registered after immobilization of probe ssDNA onto the PAH layer. The hybridization signal increases from 5 mV to 32 mV with increasing the concentration of cDNA from 0.1 nM to 5 μM. In contrast, a small signal of 5 mV was recorded in the case of non-specific adsorption of fully mismatched ssDNA (5 μM). The obtained results demonstrate the potential of the MLAPS in combination with the simple and rapid LbL immobilization technique as a promising platform for the future development of multi-spot light-addressable label-free DNA chips with direct electrical readout.},
  language  = {en}
}
@article{BegingLeinhosJablonskietal.2015,
  author    = {Beging, Stefan and Leinhos, Marcel and Jablonski, Melanie and Poghossian, Arshak and Sch{\"o}ning, Michael Josef},
  title     = {Studying the spatially resolved immobilisation of enzymes on a capacitive field-effect structure by means of nano-spotting},
  series = {Physica status solidi (a)},
  volume    = {212},
  journal   = {Physica status solidi (a)},
  number    = {6},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1862-6319},
  doi       = {10.1002/pssa.201431891},
  pages     = {1353 -- 1358},
  year      = {2015},
  language  = {en}
}
@article{SeifarthGossmannGrosseetal.2015,
  author    = {Seifarth, Volker and Goßmann, Matthias and Grosse, J. O. and Becker, C. and Heschel, I. and Artmann, Gerhard and Temiz Artmann, Ayseg{\"u}l},
  title     = {Development of a Bioreactor to Culture Tissue Engineered Ureters Based on the Application of Tubular OPTIMAIX 3D Scaffolds},
  series = {Urologia Internationalis},
  volume    = {2015},
  journal   = {Urologia Internationalis},
  number    = {95},
  publisher = {Karger},
  address   = {Basel},
  issn      = {0042-1138},
  doi       = {10.1159/000368419},
  pages     = {106 -- 113},
  year      = {2015},
  language  = {en}
}
@article{SchreiberBarkschatKraftetal.2015,
  author    = {Schreiber, Marc and Barkschat, Kai and Kraft, Bodo and Z{\"u}ndorf, Albert},
  title     = {Quick Pad Tagger : An Efficient Graphical User Interface for Building Annotated Corpora with Multiple Annotation Layers},
  series = {Computer Science \& Information Technology (CS \& IT)},
  volume    = {5},
  journal   = {Computer Science \& Information Technology (CS \& IT)},
  number    = {4},
  publisher = {Academy \& Industry Research Collaboration Center (AIRCC)},
  isbn      = {978-1-921987-32-8},
  issn      = {2231 - 5403},
  doi       = {10.5121/csit.2015.50413},
  pages     = {131 -- 143},
  year      = {2015},
  language  = {en}
}
@article{PoghossianKatzSchoening2015,
  author    = {Poghossian, Arshak and Katz, Evgeny and Sch{\"o}ning, Michael Josef},
  title     = {Enzyme logic AND-Reset and OR-Reset gates based on a field-effect electronic transducer modified with multi-enzyme membrane},
  series = {Chemical Communications},
  volume    = {51},
  journal   = {Chemical Communications},
  publisher = {Royal Society of Chemistry (RSC)},
  address   = {Cambridge},
  doi       = {10.1039/C5CC01362C},
  pages     = {6564 -- 6567},
  year      = {2015},
  abstract  = {Capacitive field-effect sensors modified with a multi-enzyme membrane have been applied for an electronic transduction of biochemical signals processed by enzyme-based AND-Reset and OR-Reset logic gates. The local pH change at the sensor surface induced by the enzymatic reaction was used for the activation of the Reset function for the first time.},
  language  = {en}
}
@article{KuschRieserKnuppetal.2015,
  author    = {Kusch, Peter and Rieser, Claudia and Knupp, Gerd and Mang, Thomas},
  title     = {Characterization of copolymers of methacrylic acid with poly(ethylene glycol) methyl ether methacrylate macromonomers by analytical pyrolysis-gas chromatography/mass spectrometry (Py-GC/MS)},
  series = {Journal of Analytical and Applied Pyrolysis},
  volume    = {Vol. 113},
  journal   = {Journal of Analytical and Applied Pyrolysis},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {0165-2370},
  doi       = {10.1016/j.jaap.2015.03.003},
  pages     = {412 -- 418},
  year      = {2015},
  language  = {de}
}
@article{Alexopoulos2015,
  author    = {Alexopoulos, Spiros},
  title     = {Simulation model for the transient process behaviour of solar aluminium recycling in a rotary kiln},
  series = {Applied Thermal Engineering},
  volume    = {78},
  journal   = {Applied Thermal Engineering},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1359-4311},
  doi       = {10.1016/j.applthermaleng.2015.01.007},
  pages     = {387 -- 396},
  year      = {2015},
  language  = {en}
}
@article{OberlaenderBrommWendeleretal.2015,
  author    = {Oberl{\"a}nder, Jan and Bromm, Alexander and Wendeler, Luisa and Iken, Heiko and Palomar Duran, Marlena and Greeff, Anton and Kirchner, Patrick and Keusgen, Michael and Sch{\"o}ning, Michael Josef},
  title     = {Towards a biosensor to monitor the sterilisation efficiency of aseptic filling machines},
  series = {Physica status solidi (a)},
  volume    = {212},
  journal   = {Physica status solidi (a)},
  number    = {6},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1862-6319},
  doi       = {10.1002/pssa.201431900},
  pages     = {1299 -- 1305},
  year      = {2015},
  abstract  = {Sterilisation processes are compulsory in medicine, pharmacy, and food industries to prevent infections of consumers and microbiological contaminations of products. Monitoring the sterilisation by conventional microbiological methods is time- and lab-consuming. To overcome this problem, in this work a novel biosensor has been proposed. The sensor enables a fast method to evaluate sterilisation processes. By means of thin-film technology the sensor's transducer structures in form of IDEs (interdigitated electrodes) have been fabricated on a silicon substrate. Physical characterisation of the developed sensor was done by AFM, SEM, and profilometry. Impedance analyses were conducted for the electrical characterisation. As microbiological layer spores of B. atrophaeus have been immobilised on the sensing structure; spores of this type are a well-known sterilisation test organism. Impedance measurements at a fixed frequency over time were performed to monitor the immobilisation process. A sterilisation process according to aseptic filling machines was applied to demonstrate the sensor functionality. After both, immobilisation and sterilisation, a change in impedance could successfully be detected.},
  language  = {en}
}
@article{HuckPoghossianBaeckeretal.2015,
  author    = {Huck, Christina and Poghossian, Arshak and B{\"a}cker, Matthias and Reisert, Steffen and Kramer, Friederike and Begoyan, Vardges K. and Buniatyan, Vahe V. and Sch{\"o}ning, Michael Josef},
  title     = {Multi-parameter sensing using high-k oxide of barium strontium titanate},
  series = {Physica status solidi (a)},
  volume    = {212},
  journal   = {Physica status solidi (a)},
  number    = {6},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1862-6319},
  doi       = {10.1002/pssa.201431911},
  pages     = {1259},
  year      = {2015},
  abstract  = {High-k perovskite oxide of barium strontium titanate (BST) represents a very attractive multi-functional transducer material for the development of (bio-)chemical sensors. In this work, a Si-based sensor chip containing Pt interdigitated electrodes covered with a thin BST layer (485 nm) has been developed for multi-parameter chemical sensing. The chip has been applied for the contactless measurement of the electrolyte conductivity, the detection of adsorbed charged macromolecules (positively charged polyelectrolytes of polyethylenimine) and the concentration of hydrogen peroxide (H2O2) vapor. The experimental results of functional testing of individual sensors are presented. The mechanism of the BST sensitivity to charged polyelectrolytes and H2O2 vapor has been proposed and discussed.},
  language  = {en}
}