@article{ValeroBung2016,
  author    = {Valero, Daniel and Bung, Daniel B.},
  title     = {Sensitivity of turbulent Schmidt number and turbulence model to simulations of jets in crossflow},
  series = {Environmental Modelling and Software},
  volume    = {82},
  journal   = {Environmental Modelling and Software},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1364-8152 (electronic)},
  doi       = {10.1016/j.envsoft.2016.04.030},
  pages     = {218 -- 228},
  year      = {2016},
  abstract  = {Environmental discharges have been traditionally designed by means of cost-intensive and time-consuming experimental studies. Some extensively validated models based on an integral approach have been often employed for water quality problems, as recommended by USEPA (i.e.: CORMIX). In this study, FLOW-3D is employed for a full 3D RANS modelling of two turbulent jet-to-crossflow cases, including free surface jet impingement. Results are compared to both physical modelling and CORMIX to better assess model performance. Turbulence measurements have been collected for a better understanding of turbulent diffusion's parameter sensitivity. Although both studied models are generally able to reproduce jet trajectory, jet separation downstream of the impingement has been reproduced only by RANS modelling. Additionally, concentrations are better reproduced by FLOW-3D when the proper turbulent Schmidt number is used. This study provides a recommendation on the selection of the turbulence model and the turbulent Schmidt number for future outfall structures design studies.},
  language  = {en}
}
@article{ValeroBung2016,
  author    = {Valero, Daniel and Bung, Daniel B.},
  title     = {Development of the interfacial air layer in the non-aerated region of high-velocity spillway flows: Instabilities growth, entrapped air and influence on the self-aeration onset},
  series = {International Journal of Multiphase Flow},
  volume    = {84},
  journal   = {International Journal of Multiphase Flow},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {0301-9322},
  doi       = {10.1016/j.ijmultiphaseflow.2016.04.012},
  pages     = {66 -- 74},
  year      = {2016},
  abstract  = {Self-aeration is traditionally explained by the water turbulent boundary layer outer edge intersection with the free surface. This paper presents a discussion on the commonly accepted hypothesis behind the computation of the critical point of self-aeration in spillway flows and a new formulation is proposed based on the existence of a developing air flow over the free surface. Upstream of the inception point of self-aeration, some surface roughening has been often reported in previous studies which consequently implies some entrapped air transport and air-water flows coupling. Such air flow is proven in this study by presenting measured air velocities and computing the air boundary layer thickness for a 1V:2H smooth chute flow. Additionally, the growth rate of free surface waves has been analysed by means of Ultrasonic Sensors measurements, obtaining also the entrapped air concentration. High-speed camera imaging has been used for qualitative study of the flow perturbations.},
  language  = {en}
}
@article{BungValero2016,
  author    = {Bung, Daniel B. and Valero, Daniel},
  title     = {Optical flow estimation in aerated flows},
  series = {Journal of Hydraulic Research},
  volume    = {54},
  journal   = {Journal of Hydraulic Research},
  number    = {5},
  publisher = {Taylor \& Francis},
  address   = {London},
  doi       = {10.1080/00221686.2016.1173600},
  pages     = {575 -- 580},
  year      = {2016},
  abstract  = {Optical flow estimation is known from Computer Vision where it is used to determine obstacle movements through a sequence of images following an assumption of brightness conservation. This paper presents the first study on application of the optical flow method to aerated stepped spillway flows. For this purpose, the flow is captured with a high-speed camera and illuminated with a synchronized LED light source. The flow velocities, obtained using a basic Horn-Schunck method for estimation of the optical flow coupled with an image pyramid multi-resolution approach for image filtering, compare well with data from intrusive conductivity probe measurements. Application of the Horn-Schunck method yields densely populated flow field data sets with velocity information for every pixel. It is found that the image pyramid approach has the most significant effect on the accuracy compared to other image processing techniques. However, the final results show some dependency on the pixel intensity distribution, with better accuracy found for grey values between 100 and 150.},
  language  = {en}
}
@article{LopesLeandroCarvalhoetal.2017,
  author    = {Lopes, Pedro and Leandro, Jorge and Carvalho, Rita F. and Bung, Daniel B.},
  title     = {Alternating skimming flow over a stepped spillway},
  series = {Environmental Fluid Mechanics},
  volume    = {17},
  journal   = {Environmental Fluid Mechanics},
  number    = {2},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1573-1510},
  doi       = {10.1007/s10652-016-9484-x},
  pages     = {303 -- 322},
  year      = {2017},
  language  = {en}
}
@article{Hoettges2017,
  author    = {H{\"o}ttges, J{\"o}rg},
  title     = {QKan - Management of drainage system data with QGIS},
  series = {Free and Open Source Software for Geospatial (FOSS4G) Conference Proceedings},
  volume    = {17},
  journal   = {Free and Open Source Software for Geospatial (FOSS4G) Conference Proceedings},
  number    = {Article 13},
  pages     = {95 -- 100},
  year      = {2017},
  language  = {en}
}
@article{ValeroBung2017,
  author    = {Valero, Daniel and Bung, Daniel B.},
  title     = {Artificial Neural Networks and pattern recognition for air-water flow velocity estimation using a single-tip optical fibre probe},
  series = {Journal of Hydro-environment Research},
  volume    = {19},
  journal   = {Journal of Hydro-environment Research},
  number    = {3},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1570-6443},
  doi       = {10.1016/j.jher.2017.08.004},
  pages     = {150 -- 159},
  year      = {2017},
  language  = {en}
}
@article{KerpenBungValeroetal.2017,
  author    = {Kerpen, Nils B. and Bung, Daniel B. and Valero, Daniel and Schlurmann, Torsten},
  title     = {Energy dissipation within the wave run-up at stepped revetments},
  series = {Journal of Ocean University of China},
  volume    = {16},
  journal   = {Journal of Ocean University of China},
  number    = {4},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1993-5021},
  doi       = {10.1007/s11802-017-3355-z},
  pages     = {649 -- 654},
  year      = {2017},
  language  = {en}
}
@article{WoliszSchuetzBlankeetal.2017,
  author    = {Wolisz, Henryk and Sch{\"u}tz, Thomas and Blanke, Tobias and Hagenkamp, Markus and Kohrn, Markus and Wesseling, Mark and M{\"u}ller, Dirk},
  title     = {Cost optimal sizing of smart buildings' energy system components considering changing end-consumer electricity markets},
  series = {Energy},
  volume    = {137},
  journal   = {Energy},
  publisher = {Elsevier},
  address   = {Amsterdam},
  doi       = {10.1016/j.energy.2017.06.025},
  pages     = {715 -- 728},
  year      = {2017},
  language  = {en}
}
@article{ValeroBung2018,
  author    = {Valero, Daniel and Bung, Daniel B.},
  title     = {Reformulating self-aeration in hydraulic structures: Turbulent growth of free surface perturbations leading to air entrainment},
  series = {International Journal of Multiphase Flow},
  volume    = {100},
  journal   = {International Journal of Multiphase Flow},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {0301-9322},
  doi       = {10.1016/j.ijmultiphaseflow.2017.12.011},
  pages     = {127 -- 142},
  year      = {2018},
  abstract  = {A new formulation for the prediction of free surface dynamics related to the turbulence occurring nearby is proposed. This formulation, altogether with a breakup criterion, can be used to compute the inception of self-aeration in high velocity flows like those occurring in hydraulic structures. Assuming a simple perturbation geometry, a kinematic and a non-linear momentum-based dynamic equation are formulated and forces acting on a control volume are approximated. Limiting steepness is proposed as an adequate breakup criterion. Role of the velocity fluctuations normal to the free surface is shown to be the main turbulence quantity related to self-aeration and the role of the scales contained in the turbulence spectrum are depicted. Surface tension force is integrated accounting for large displacements by using differential geometry for the curvature estimation. Gravity and pressure effects are also contemplated in the proposed formulation. The obtained equations can be numerically integrated for each wavelength, hence resulting in different growth rates and allowing computation of the free surface roughness wavelength distribution. Application to a prototype scale spillway (at the Aviemore dam) revealed that most unstable wavelength was close to the Taylor lengthscale. Amplitude distributions have been also obtained observing different scaling for perturbations stabilized by gravity or surface tension. The proposed theoretical framework represents a new conceptualization of self-aeration which explains the characteristic rough surface at the non-aerated region as well as other previous experimental observations which remained unresolved for several decades.},
  language  = {en}
}
@article{ValeroBung2018,
  author    = {Valero, Daniel and Bung, Daniel B.},
  title     = {Vectrino profiler spatial filtering for shear flows based on the mean velocity gradient equation},
  series = {Journal of Hydraulic Engineering},
  volume    = {144},
  journal   = {Journal of Hydraulic Engineering},
  number    = {7},
  publisher = {ASCE},
  address   = {Reston, Va.},
  issn      = {0733-9429},
  doi       = {10.1061/(ASCE)HY.1943-7900.0001485},
  year      = {2018},
  abstract  = {A new methodology is proposed to spatially filter acoustic Doppler velocimetry data from a Vectrino profiler based on the differential mean velocity equation. Lower and upper bounds are formulated in terms of physically based flow constraints. Practical implementation is discussed, and its application is tested against data gathered from an open-channel flow over a stepped macroroughness surface. The method has proven to detect outliers occurring all over the distance range sampled by the Vectrino profiler and has shown to remain applicable out of the region of validity of the velocity gradient equation. Finally, a statistical analysis suggests that physically obtained bounds are asymptotically representative.},
  language  = {en}
}