@article{KolymbasFellinKirsch2006,
  author    = {Kolymbas, Dimitrios and Fellin, W. and Kirsch, Ansgar},
  title     = {Squeezing due to stress relaxation in foliated rock},
  series = {International journal for numerical and analytical methods in geomechanics},
  volume    = {Vol. 30},
  journal   = {International journal for numerical and analytical methods in geomechanics},
  number    = {Iss. 13},
  issn      = {1096-9853 (E-Journal); 0363-9061 (Print)},
  doi       = {10.1002/nag.530},
  pages     = {1357 -- 1367},
  year      = {2006},
  language  = {en}
}
@article{DoeringRegerKuhnhenneetal.2015,
  author    = {D{\"o}ring, Bernd and Reger, Vitali and Kuhnhenne, Markus and Feldmann, Markus and Kesti, Jyrki and Lawson, Mark and Botti, Andrea},
  title     = {Steel solutions for enabling zero-energy buildings},
  series = {Steel Construction - Design and Research},
  volume    = {8},
  journal   = {Steel Construction - Design and Research},
  number    = {3},
  publisher = {Ernst \& Sohn},
  address   = {Berlin},
  issn      = {1867-0539},
  doi       = {10.1002/stco.201510029},
  pages     = {194 -- 200},
  year      = {2015},
  language  = {en}
}
@article{BayonValeroGarciaBartualetal.2016,
  author    = {Bayon, Arnau and Valero, Daniel and Garcia-Bartual, Rafael and Vall{\´e}s-Mor{\´a}n, Francisco Jos{\´e} and L{\´o}pez-Jim{\´e}nez, P. Amparo},
  title     = {Performance assessment of OpenFOAM and FLOW-3D in the numerical modeling of a low Reynolds number hydraulic jump},
  series = {Environmental Modelling \& Software},
  volume    = {80},
  journal   = {Environmental Modelling \& Software},
  publisher = {Elsevier},
  address   = {Amsterdam},
  isbn      = {1364-8152},
  doi       = {10.1016/j.envsoft.2016.02.018},
  pages     = {322 -- 335},
  year      = {2016},
  abstract  = {A comparative performance analysis of the CFD platforms OpenFOAM and FLOW-3D is presented, focusing on a 3D swirling turbulent flow: a steady hydraulic jump at low Reynolds number. Turbulence is treated using RANS approach RNG k-ε. A Volume Of Fluid (VOF) method is used to track the air-water interface, consequently aeration is modeled using an Eulerian-Eulerian approach. Structured meshes of cubic elements are used to discretize the channel geometry. The numerical model accuracy is assessed comparing representative hydraulic jump variables (sequent depth ratio, roller length, mean velocity profiles, velocity decay or free surface profile) to experimental data. The model results are also compared to previous studies to broaden the result validation. Both codes reproduced the phenomenon under study concurring with experimental data, although special care must be taken when swirling flows occur. Both models can be used to reproduce the hydraulic performance of energy dissipation structures at low Reynolds numbers.},
  language  = {en}
}
@article{LopesLeandroCarvalhoetal.2017,
  author    = {Lopes, Pedro and Leandro, Jorge and Carvalho, Rita F. and Bung, Daniel B.},
  title     = {Alternating skimming flow over a stepped spillway},
  series = {Environmental Fluid Mechanics},
  volume    = {17},
  journal   = {Environmental Fluid Mechanics},
  number    = {2},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1573-1510},
  doi       = {10.1007/s10652-016-9484-x},
  pages     = {303 -- 322},
  year      = {2017},
  language  = {en}
}
@article{ValeroBung2016,
  author    = {Valero, Daniel and Bung, Daniel B.},
  title     = {Sensitivity of turbulent Schmidt number and turbulence model to simulations of jets in crossflow},
  series = {Environmental Modelling and Software},
  volume    = {82},
  journal   = {Environmental Modelling and Software},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1364-8152 (electronic)},
  doi       = {10.1016/j.envsoft.2016.04.030},
  pages     = {218 -- 228},
  year      = {2016},
  abstract  = {Environmental discharges have been traditionally designed by means of cost-intensive and time-consuming experimental studies. Some extensively validated models based on an integral approach have been often employed for water quality problems, as recommended by USEPA (i.e.: CORMIX). In this study, FLOW-3D is employed for a full 3D RANS modelling of two turbulent jet-to-crossflow cases, including free surface jet impingement. Results are compared to both physical modelling and CORMIX to better assess model performance. Turbulence measurements have been collected for a better understanding of turbulent diffusion's parameter sensitivity. Although both studied models are generally able to reproduce jet trajectory, jet separation downstream of the impingement has been reproduced only by RANS modelling. Additionally, concentrations are better reproduced by FLOW-3D when the proper turbulent Schmidt number is used. This study provides a recommendation on the selection of the turbulence model and the turbulent Schmidt number for future outfall structures design studies.},
  language  = {en}
}
@article{ValeroBung2016,
  author    = {Valero, Daniel and Bung, Daniel B.},
  title     = {Development of the interfacial air layer in the non-aerated region of high-velocity spillway flows: Instabilities growth, entrapped air and influence on the self-aeration onset},
  series = {International Journal of Multiphase Flow},
  volume    = {84},
  journal   = {International Journal of Multiphase Flow},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {0301-9322},
  doi       = {10.1016/j.ijmultiphaseflow.2016.04.012},
  pages     = {66 -- 74},
  year      = {2016},
  abstract  = {Self-aeration is traditionally explained by the water turbulent boundary layer outer edge intersection with the free surface. This paper presents a discussion on the commonly accepted hypothesis behind the computation of the critical point of self-aeration in spillway flows and a new formulation is proposed based on the existence of a developing air flow over the free surface. Upstream of the inception point of self-aeration, some surface roughening has been often reported in previous studies which consequently implies some entrapped air transport and air-water flows coupling. Such air flow is proven in this study by presenting measured air velocities and computing the air boundary layer thickness for a 1V:2H smooth chute flow. Additionally, the growth rate of free surface waves has been analysed by means of Ultrasonic Sensors measurements, obtaining also the entrapped air concentration. High-speed camera imaging has been used for qualitative study of the flow perturbations.},
  language  = {en}
}
@article{Hoettges2017,
  author    = {H{\"o}ttges, J{\"o}rg},
  title     = {QKan - Management of drainage system data with QGIS},
  series = {Free and Open Source Software for Geospatial (FOSS4G) Conference Proceedings},
  volume    = {17},
  journal   = {Free and Open Source Software for Geospatial (FOSS4G) Conference Proceedings},
  number    = {Article 13},
  pages     = {95 -- 100},
  year      = {2017},
  language  = {en}
}
@article{ValeroBung2018,
  author    = {Valero, Daniel and Bung, Daniel B.},
  title     = {Reformulating self-aeration in hydraulic structures: Turbulent growth of free surface perturbations leading to air entrainment},
  series = {International Journal of Multiphase Flow},
  volume    = {100},
  journal   = {International Journal of Multiphase Flow},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {0301-9322},
  doi       = {10.1016/j.ijmultiphaseflow.2017.12.011},
  pages     = {127 -- 142},
  year      = {2018},
  abstract  = {A new formulation for the prediction of free surface dynamics related to the turbulence occurring nearby is proposed. This formulation, altogether with a breakup criterion, can be used to compute the inception of self-aeration in high velocity flows like those occurring in hydraulic structures. Assuming a simple perturbation geometry, a kinematic and a non-linear momentum-based dynamic equation are formulated and forces acting on a control volume are approximated. Limiting steepness is proposed as an adequate breakup criterion. Role of the velocity fluctuations normal to the free surface is shown to be the main turbulence quantity related to self-aeration and the role of the scales contained in the turbulence spectrum are depicted. Surface tension force is integrated accounting for large displacements by using differential geometry for the curvature estimation. Gravity and pressure effects are also contemplated in the proposed formulation. The obtained equations can be numerically integrated for each wavelength, hence resulting in different growth rates and allowing computation of the free surface roughness wavelength distribution. Application to a prototype scale spillway (at the Aviemore dam) revealed that most unstable wavelength was close to the Taylor lengthscale. Amplitude distributions have been also obtained observing different scaling for perturbations stabilized by gravity or surface tension. The proposed theoretical framework represents a new conceptualization of self-aeration which explains the characteristic rough surface at the non-aerated region as well as other previous experimental observations which remained unresolved for several decades.},
  language  = {en}
}
@article{ValeroBung2017,
  author    = {Valero, Daniel and Bung, Daniel B.},
  title     = {Artificial Neural Networks and pattern recognition for air-water flow velocity estimation using a single-tip optical fibre probe},
  series = {Journal of Hydro-environment Research},
  volume    = {19},
  journal   = {Journal of Hydro-environment Research},
  number    = {3},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1570-6443},
  doi       = {10.1016/j.jher.2017.08.004},
  pages     = {150 -- 159},
  year      = {2017},
  language  = {en}
}
@article{KerpenBungValeroetal.2017,
  author    = {Kerpen, Nils B. and Bung, Daniel B. and Valero, Daniel and Schlurmann, Torsten},
  title     = {Energy dissipation within the wave run-up at stepped revetments},
  series = {Journal of Ocean University of China},
  volume    = {16},
  journal   = {Journal of Ocean University of China},
  number    = {4},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1993-5021},
  doi       = {10.1007/s11802-017-3355-z},
  pages     = {649 -- 654},
  year      = {2017},
  language  = {en}
}