@article{Alexopoulos2012,
  author    = {Alexopoulos, Spiros},
  title     = {Biogas systems: basics, biogas multifunction, principle of fermentation and hybrid application with a solar tower for the treatment of waste animal manure},
  series = {Journal of Engineering Science and Technology Review},
  volume    = {5},
  journal   = {Journal of Engineering Science and Technology Review},
  number    = {4},
  issn      = {1791-2377},
  pages     = {48 -- 55},
  year      = {2012},
  abstract  = {Two of the main environmental problems of today's society are the continuously increasing production of organic wastes as well as the increase of carbon dioxide in the atmosphere and the related green house effect. A way to solve these problems is the production of biogas. Biogas is a combustible gas consisting of methane, carbon dioxide and small amounts of other gases and trace elements. Production of biogas through anaerobic digestion of animal manure and slurries as well as of a wide range of digestible organic wastes and agricultural residues, converts these substrates into electricity and heat and offers a natural fertiliser for agriculture. The microbiological process of decomposition of organic matter, in the absence of oxygen takes place in reactors, called digesters. Biogas can be used as a fuel in a gas turbine or burner and can be used in a hybrid solar tower system offering a solution for waste treatment of agricultural and animal residues. A solar tower system consists of a heliostat field, which concentrates direct solar irradiation on an open volumetric central receiver. The receiver heats up ambient air to temperatures of around 700°C. The hot air's heat energy is transferred to a steam Rankine cycle in a heat recovery steam generator (HRSG). The steam drives a steam turbine, which in turn drives a generator for producing electricity. In order to increase the operational hours of a solar tower power plant, a heat storage system and/ or hybridization may be considered. The advantage of solar-fossil hybrid power plants, compared to solar-only systems, lies in low additional investment costs due to an adaptable solar share and reduced technical and economical risks. On sunny days the hybrid system operates in a solar-only mode with the central receiver and on cloudy days and at night with the gas turbine only. As an alternative to methane gas, environmentally neutral biogas can be used for operating the gas turbine. Hence, the hybrid system is operated to 100\% from renewable energy sources},
  language  = {en}
}
@article{BialonskiCaronSchloenetal.2016,
  author    = {Bialonski, Stephan and Caron, David A. and Schloen, Julia and Feudel, Ulrike and Kantz, Holger and Moorthi, Stefanie D.},
  title     = {Phytoplankton dynamics in the Southern California Bight indicate a complex mixture of transport and biology},
  series = {Journal of Plankton Research},
  volume    = {38},
  journal   = {Journal of Plankton Research},
  number    = {4},
  publisher = {Oxford University Press},
  address   = {Oxford},
  issn      = {1464-3774},
  doi       = {10.1093/plankt/fbv122},
  pages     = {1077 -- 1091},
  year      = {2016},
  abstract  = {The stimulation and dominance of potentially harmful phytoplankton taxa at a given locale and time are determined by local environmental conditions as well as by transport to or from neighboring regions. The present study investigated the occurrence of common harmful algal bloom (HAB) taxa within the Southern California Bight, using cross-correlation functions to determine potential dependencies between HAB taxa and environmental factors, and potential links to algal transport via local hydrography and currents. A simulation study, in which Lagrangian particles were released, was used to assess travel times due to advection by prevailing ocean currents in the bight. Our results indicate that transport of some taxa may be an important mechanism for the expansion of their distributions into other regions, which was supported by mean travel times derived from our simulation study and other literature on ocean currents in the Southern California Bight. In other cases, however, phytoplankton dynamics were rather linked to local environmental conditions, including coastal upwelling events. Overall, our study shows that complex current patterns in the Southern California Bight may contribute significantly to the formation and expansion of HABs in addition to local environmental factors determining the spatiotemporal dynamics of phytoplankton blooms.},
  language  = {en}
}
@article{AlexopoulosBreitbachHoffschmidtetal.2008,
  author    = {Alexopoulos, Spiros and Breitbach, Gerd and Hoffschmidt, Bernhard and Stobbe, P.},
  title     = {Computational fluid flow of porous resic ceramic filtering modules and optimization of the channel edge form geometry},
  series = {Proceedings : April 14 - 18, 2008, Leipzig, Germany / hosted by VDI, Society for Chemical and Process Engineering . Vol 2},
  journal   = {Proceedings : April 14 - 18, 2008, Leipzig, Germany / hosted by VDI, Society for Chemical and Process Engineering . Vol 2},
  publisher = {Filtech Exhibitions},
  address   = {Meerbusch},
  pages     = {300 -- 304},
  year      = {2008},
  language  = {en}
}
@article{RaffeisAdjeiKyeremehVroomenetal.2020,
  author    = {Raffeis, Iris and Adjei-Kyeremeh, Frank and Vroomen, Uwe and Westhoff, Elmar and Bremen, Sebastian and Hohoi, Alexandru and B{\"u}hrig-Polaczek, Andreas},
  title     = {Qualification of a Ni-Cu alloy for the laser powder bed fusion process (LPBF): Its microstructure and mechanical properties},
  series = {Applied Sciences},
  volume    = {10},
  journal   = {Applied Sciences},
  number    = {Art. 3401},
  publisher = {MDPI},
  address   = {Basel},
  issn      = {2076-3417},
  doi       = {10.3390/app10103401},
  pages     = {1 -- 15},
  year      = {2020},
  abstract  = {As researchers continue to seek the expansion of the material base for additive manufacturing, there is a need to focus attention on the Ni-Cu group of alloys which conventionally has wide industrial applications. In this work, the G-NiCu30Nb casting alloy, a variant of the Monel family of alloys with Nb and high Si content is, for the first time, processed via the laser powder bed fusion process (LPBF). Being novel to the LPBF processes, optimum LPBF parameters were determined, and hardness and tensile tests were performed in as-built conditions and after heat treatment at 1000 °C. Microstructures of the as-cast and the as-built condition were compared. Highly dense samples (99.8\% density) were achieved after varying hatch distance (80 µm and 140 µm) with scanning speed (550 mm/s-1500 mm/s). There was no significant difference in microhardness between varied hatch distance print sets. Microhardness of the as-built condition (247 HV0.2) exceeded the as-cast microhardness (179 HV0.2.). Tensile specimens built in vertical (V) and horizontal (H) orientations revealed degrees of anisotropy and were superior to conventionally reported figures. Post heat treatment increased ductility from 20\% to 31\% (V), as well as from 16\% to 25\% (H), while ultimate tensile strength (UTS) and yield strength (YS) were considerably reduced.},
  language  = {en}
}
@article{ElsenKraiss1999,
  author    = {Elsen, Ingo and Kraiss, Karl-Friedrich},
  title     = {System concept and realization of a scalable neurocomputing architecture},
  series = {Systems Analysis Modelling Simulation},
  volume    = {35},
  journal   = {Systems Analysis Modelling Simulation},
  number    = {4},
  publisher = {Gordon and Breach Science Publishers},
  address   = {Amsterdam},
  issn      = {0232-9298},
  pages     = {399 -- 419},
  year      = {1999},
  abstract  = {This paper describes the realization of a novel neurocomputer which is based on the concepts of a coprocessor. In contrast to existing neurocomputers the main interest was the realization of a scalable, flexible system, which is capable of computing neural networks of arbitrary topology and scale, with full independence of special hardware from the software's point of view. On the other hand, computational power should be added, whenever needed and flexibly adapted to the requirements of the application. Hardware independence is achieved by a run time system which is capable of using all available computing power, including multiple host CPUs and an arbitrary number of neural coprocessors autonomously. The realization of arbitrary neural topologies is provided through the implementation of the elementary operations which can be found in most neural topologies.},
  language  = {en}
}
@article{ElsenKraissKrumbiegeletal.1999,
  author    = {Elsen, Ingo and Kraiss, Karl-Friedrich and Krumbiegel, Dirk and Walter, Peter and Wickel, Jochen},
  title     = {Visual information retrieval for 3D product identification: a midterm report},
  series = {KI - K{\"u}nstliche Intelligenz},
  volume    = {13},
  journal   = {KI - K{\"u}nstliche Intelligenz},
  number    = {1},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1610-1987},
  pages     = {64 -- 67},
  year      = {1999},
  language  = {en}
}
@article{DickhoffHorikawaFunke2021,
  author    = {Dickhoff, Jens and Horikawa, Atsushi and Funke, Harald},
  title     = {Hydrogen Combustion - new DLE Combustor Addresses NOx Emissions and Flashback},
  series = {Turbomachinery international : the global journal of energy equipment},
  volume    = {62},
  journal   = {Turbomachinery international : the global journal of energy equipment},
  number    = {4},
  publisher = {MJH Life Sciences},
  address   = {Cranbury},
  issn      = {2767-2328},
  pages     = {26 -- 27},
  year      = {2021},
  language  = {en}
}
@article{Gaigall2023,
  author    = {Gaigall, Daniel},
  title     = {Allocating and forecasting changes in risk},
  series = {Journal of risk},
  volume    = {25},
  journal   = {Journal of risk},
  number    = {3},
  editor    = {AitSahlia, Farid},
  publisher = {Infopro Digital Risk},
  address   = {London},
  issn      = {1755-2842},
  doi       = {10.21314/JOR.2022.048},
  pages     = {1 -- 24},
  year      = {2023},
  abstract  = {We consider time-dependent portfolios and discuss the allocation of changes in the risk of a portfolio to changes in the portfolio's components. For this purpose we adopt established allocation principles. We also use our approach to obtain forecasts for changes in the risk of the portfolio's components. To put the approach into practice we present an implementation based on the output of a simulation. Allocation is illustrated with an example portfolio in the context of Solvency II. The quality of the forecasts is investigated with an empirical study.},
  language  = {en}
}
@article{Gaigall2023,
  author    = {Gaigall, Daniel},
  title     = {On the applicability of several tests to models with not identically distributed random effects},
  series = {Statistics : A Journal of Theoretical and Applied Statistics},
  volume    = {57},
  journal   = {Statistics : A Journal of Theoretical and Applied Statistics},
  publisher = {Taylor \& Francis},
  address   = {London},
  isbn      = {0323-3944},
  issn      = {1029-4910},
  doi       = {10.1080/02331888.2023.2193748},
  pages     = {14 Seiten},
  year      = {2023},
  abstract  = {We consider Kolmogorov-Smirnov and Cram{\´e}r-von-Mises type tests for testing central symmetry, exchangeability, and independence. In the standard case, the tests are intended for the application to independent and identically distributed data with unknown distribution. The tests are available for multivariate data and bootstrap procedures are suitable to obtain critical values. We discuss the applicability of the tests to random effects models, where the random effects are independent but not necessarily identically distributed and with possibly unknown distributions. Theoretical results show the adequacy of the tests in this situation. The quality of the tests in models with random effects is investigated by simulations. Empirical results obtained confirm the theoretical findings. A real data example illustrates the application.},
  language  = {en}
}
@article{ElsenHartungHornetal.2001,
  author    = {Elsen, Ingo and Hartung, Frank and Horn, Uwe and Kampmann, Markus and Peters, Liliane},
  title     = {Streaming technology in 3G mobile communication systems},
  series = {Computer : innovative technology for computer professionals},
  volume    = {34},
  journal   = {Computer : innovative technology for computer professionals},
  number    = {9 Seiten},
  editor    = {Voas, Jeffrey},
  publisher = {IEEE},
  address   = {New York},
  issn      = {0018-9162},
  pages     = {46 -- 52},
  year      = {2001},
  abstract  = {Third-generation mobile communication systems will combine standardized streaming with a range of unique services to provide high-quality Internet content that meets the specific needs of the rapidly growing mobile market.},
  language  = {en}
}