@article{BarnatFariaBosse2017,
  author    = {Barnat, Miriam and Faria, Joana Abelha and Bosse, Elke},
  title     = {Heterogenit{\"a}t und Studierf{\"a}higkeit: Erste Ergebnisse einer L{\"a}ngsschnittbefragung},
  series = {Qualit{\"a}t in der Wissenschaft: QiW ; Zeitschrift f{\"u}r Qualit{\"a}tsentwicklung in Forschung, Studium und Administration},
  volume    = {11},
  journal   = {Qualit{\"a}t in der Wissenschaft: QiW ; Zeitschrift f{\"u}r Qualit{\"a}tsentwicklung in Forschung, Studium und Administration},
  number    = {1},
  publisher = {UVW Universit{\"a}ts-Verlag Webler},
  address   = {Bielefeld},
  issn      = {1860-3041},
  pages     = {17 -- 24},
  year      = {2017},
  language  = {de}
}
@article{BarnatBosseMergner2017,
  author    = {Barnat, Miriam and Bosse, Elke and Mergner, Julia},
  title     = {Forschungsbasierte Qualit{\"a}tsentwicklung f{\"u}r die Studieneingangsphase},
  series = {Zeitschrift f{\"u}r Hochschulentwicklung (ZFHE)},
  volume    = {12},
  journal   = {Zeitschrift f{\"u}r Hochschulentwicklung (ZFHE)},
  number    = {3},
  issn      = {2219-6994},
  doi       = {10.3217/zfhe-12-03/05},
  pages     = {71 -- 91},
  year      = {2017},
  language  = {de}
}
@article{FunkeKeinzKustereretal.2017,
  author    = {Funke, Harald and Keinz, Jan and Kusterer, K. and Haj Ayed, A. and Kazari, M. and Kitajima, J. and Horikawa, A. and Okada, K.},
  title     = {Development and Testing of a Low NOX Micromix Combustion Chamber for an Industrial Gas Turbine},
  series = {International Journal of Gas Turbine, Propulsion and Power Systems},
  volume    = {9},
  journal   = {International Journal of Gas Turbine, Propulsion and Power Systems},
  number    = {1},
  issn      = {1882-5079},
  doi       = {10.38036/jgpp.9.1_27},
  pages     = {27 -- 36},
  year      = {2017},
  abstract  = {The Micromix combustion principle, based on cross-flow mixing of air and hydrogen, promises low emission applications in future gas turbines. The Micromix combustion takes place in several hundreds of miniaturized diffusion-type micro-flames. The major advantage is the inherent safety against flash-back and low NOx-emissions due to a very short residence time of reactants in the flame region. The paper gives insight into the Micromix design and scaling procedure for different energy densities and the interaction of scaling laws and key design drivers in gas turbine integration. Numerical studies, experimental testing, gas turbine integration and interface considerations are evaluated. The aerodynamic stabilization of the miniaturized flamelets and the resulting flow field, flame structure and NOx formation are analysed experimentally and numerically. The results show and confirm the successful adaption of the low NOx Micromix characteristics for a range of different nozzle sizes, energy densities and thermal power output.},
  language  = {de}
}
@article{PfaffEnning2017,
  author    = {Pfaff, Raphael and Enning, Manfred},
  title     = {Die nachhaltige Alternative zum autonomen Lastwagen},
  series = {Deine Bahn},
  journal   = {Deine Bahn},
  number    = {10},
  pages     = {22 -- 26},
  year      = {2017},
  language  = {de}
}
@article{Reichert2017,
  author    = {Reichert, Walter},
  title     = {Berufseinstieg f{\"u}r Wirtschaftsingenieure - Bachelor oder Master?},
  series = {Berufsstart},
  journal   = {Berufsstart},
  year      = {2017},
  language  = {de}
}
@article{Wollert2017,
  author    = {Wollert, J{\"o}rg},
  title     = {Echtzeit-Ethernet - Basis f{\"u}r Industrie 4.0},
  series = {Design \& Elektronik},
  journal   = {Design \& Elektronik},
  number    = {12},
  publisher = {WEKA-Fachmedien},
  address   = {Haar, M{\"u}nchen},
  issn      = {0933-8667},
  pages     = {38 -- 41},
  year      = {2017},
  language  = {de}
}
@article{CzarneckiGeierPflug2017,
  author    = {Czarnecki, Christian and Geier, Jari and Pflug, Karolin},
  title     = {Netzvirtualisierung durch SDN und NFV : Unternehmensprozesse auf dem Pr{\"u}fstand},
  series = {LANline},
  journal   = {LANline},
  publisher = {AWI Aktuelles Wissen Verl.-Ges.},
  address   = {Trostberg},
  issn      = {0942-4172},
  year      = {2017},
  abstract  = {Kundenanforderungen an Netzwerke haben sich in den vergangenen Jahren stark ver{\"a}ndert. Mit NFV und SDN sind Unternehmen technisch in der Lage, diesen gerecht zu werden. Die Provider stehen jedoch vor großen Herausforderungen: Insbesondere Produkte und Prozesse m{\"u}ssen angepasst und agiler werden, um die St{\"a}rken von NFV und SDN zum Kundenvorteil auszuspielen.},
  language  = {de}
}
@article{KilicRaatschenKoerfgenetal.2017,
  author    = {Kilic, S. A. and Raatschen, Hans-J{\"u}rgen and K{\"o}rfgen, B. and Apaydin, N. M. and Astaneh-Asl, A.},
  title     = {FE Model of the Fatih Sultan Mehmet Suspension Bridge Using Thin Shell Finite Elements},
  series = {Arabian Journal for Science and Engineering},
  volume    = {42},
  journal   = {Arabian Journal for Science and Engineering},
  number    = {3},
  publisher = {Springer Nature},
  issn      = {2191-4281},
  doi       = {10.1007/s13369-016-2316-y},
  pages     = {1103 -- 1116},
  year      = {2017},
  abstract  = {This paper presents the results of an eigenvalue analysis of the Fatih Sultan Mehmet Bridge. A high-resolution finite element model was created directly from the available design documents. All physical properties of the structural components were included in detail, so no calibration to the measured data was necessary. The deck and towers were modeled with shell elements. A nonlinear static analysis was performed before the eigenvalue calculation. The calculated natural frequencies and corresponding mode shapes showed good agreement with the available measured ambient vibration data. The calculation of the effective modal mass showed that nine modes had single contributions higher than 5 \% of the total mass. They were in a frequency range up to 1.2 Hz. The comparison of the results for the torsional modes especially demonstrated the advantage of using thin shell finite elements over the beam modeling approach.},
  language  = {en}
}
@article{DantismTakenagaWagneretal.2017,
  author    = {Dantism, Shahriar and Takenaga, Shoko and Wagner, Torsten and Wagner, Patrick and Sch{\"o}ning, Michael Josef},
  title     = {Differential imaging of the metabolism of bacteria and eukaryotic cells based on light-addressable potentiometric sensors},
  series = {Electrochimica Acta},
  volume    = {246},
  journal   = {Electrochimica Acta},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {0013-4686},
  doi       = {10.1016/j.electacta.2017.05.196},
  pages     = {234 -- 241},
  year      = {2017},
  abstract  = {A light-addressable potentiometric sensor (LAPS) is a field-effect-based potentiometric sensor with an electrolyte/insulator/semiconductor (EIS) structure, which is able to monitor analyte concentrations of (bio-)chemical species in aqueous solutions in a spatially resolved way. Therefore, it is also an appropriate tool to record 2D-chemical images of concentration variations on the sensor surface. In the present work, two differential, LAPS-based measurement principles are introduced to determine the metabolic activity of Escherichia coli (E. coli) K12 and Chinese hamster ovary (CHO) cells as test microorganisms. Hereby, we focus on i) the determination of the extracellular acidification rate (ΔpH/min) after adding glucose solutions to the cell suspensions; and ii) recording the amplitude increase of the photocurrent (Iph) related to the produced acids from E. coli K12 bacteria and CHO cells on the sensor surface by 2D-chemical imaging. For this purpose, 3D-printed multi-chamber structures were developed and mounted on the planar sensor-chip surface to define four independent compartments, enabling differential measurements with varying cell concentrations. The differential concept allows eliminating unwanted drift effects and, with the four-chamber structures, measurements on the different cell concentrations were performed simultaneously, thus reducing also the overall measuring time.},
  language  = {en}
}
@article{JildehKirchnerOberlaenderetal.2017,
  author    = {Jildeh, Zaid B. and Kirchner, Patrick and Oberl{\"a}nder, Jan and Kremers, Alexander and Wagner, Torsten and Wagner, Patrick H. and Sch{\"o}ning, Michael Josef},
  title     = {FEM-based modeling of a calorimetric gas sensor for hydrogen peroxide monitoring},
  series = {physica status solidi a : applications and materials sciences},
  journal   = {physica status solidi a : applications and materials sciences},
  number    = {Early View},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {1862-6319},
  doi       = {10.1002/pssa.201600912},
  year      = {2017},
  abstract  = {A physically coupled finite element method (FEM) model is developed to study the response behavior of a calorimetric gas sensor. The modeled sensor serves as a monitoring device of the concentration of gaseous hydrogen peroxide (H2 O2) in a high temperature mixture stream in aseptic sterilization processes. The principle of operation of a calorimetric H2 O2 sensor is analyzed and the results of the numerical model have been validated by using previously published sensor experiments. The deviation in the results between the FEM model and experimental data are presented and discussed.},
  language  = {en}
}