@article{Hillgaertner2010,
  author    = {Hillg{\"a}rtner, Michael},
  title     = {Normative Regulations},
  series = {ECPE Cluster Seminar EMC in Hybrid and Electric Vehicles : 18 May 2010, Fraunhofer Institute Erlangen},
  journal   = {ECPE Cluster Seminar EMC in Hybrid and Electric Vehicles : 18 May 2010, Fraunhofer Institute Erlangen},
  publisher = {European Center for Power Electronics},
  address   = {N{\"u}rnberg},
  pages     = {1 CD-ROM},
  year      = {2010},
  language  = {en}
}
@article{HaselgruberMautnerThiele2010,
  author    = {Haselgruber, Nikolaus and Mautner, Karin and Thiele, Jan},
  title     = {Usage Space Analysis for Reliability Testing},
  series = {Quality and Reliability Engineering International},
  volume    = {26},
  journal   = {Quality and Reliability Engineering International},
  number    = {8},
  publisher = {Wiley},
  address   = {New York},
  issn      = {1099-1638},
  doi       = {10.1002/qre.1155},
  pages     = {877 -- 885},
  year      = {2010},
  abstract  = {During the development process of a complex technical product, one widely used and important technique is accelerated testing where the applied stress on a component is chosen to exceed the reference stress, i.e. the stress encountered in field operation, in order to reduce the time to failure. For that, the reference stress has to be known. Since a complex technical product may fail regarding numerous failure modes, stress in general is highly dimensional rather than scalar. In addition, customers use their products individually, i.e. field operation should be described by a distribution rather than by one scalar stress value. In this paper, a way to span the customer usage space is shown. It allows the identification of worst case reference stress profiles in significantly reduced dimensions with minimal loss of information. The application example shows that even for a complex product like a combustion engine, stress information can be compressed significantly. With low measurement effort it turned out that only three reference stress cycles were sufficient to cover a broad range of customer stress variety.},
  language  = {en}
}
@article{LettiniHavermannGuidettietal.2010,
  author    = {Lettini, Antonio and Havermann, Marc and Guidetti, Marco and Fornaciari, Andrea},
  title     = {Improved functionalities and energy saving potential on mobile machines combining electronics with flow sharing valve and variable displacement pump},
  series = {IFK 7, 7th International Fluid Power Conference, Efficiency through Fluid Power, 7. Internationales Fluidtechnisches Kolloquium, Workshop Proceedings, Vol. 3, Aachen, DE, 22.-24. Mar, 2010},
  journal   = {IFK 7, 7th International Fluid Power Conference, Efficiency through Fluid Power, 7. Internationales Fluidtechnisches Kolloquium, Workshop Proceedings, Vol. 3, Aachen, DE, 22.-24. Mar, 2010},
  publisher = {-},
  isbn      = {978-3-940565-92-1},
  pages     = {103 -- 114},
  year      = {2010},
  language  = {en}
}
@article{FornaciariGuidettiHavermannetal.2010,
  author    = {Fornaciari, Andrea and Guidetti, Marco and Havermann, Marc and Lettini, Antonio},
  title     = {Maccine mobili pi{\`u} efficienti},
  series = {Fluidotecnica},
  journal   = {Fluidotecnica},
  number    = {345},
  publisher = {Quine Business Publisher},
  address   = {Milano},
  pages     = {11 -- 14},
  year      = {2010},
  abstract  = {Secondo le attuali normative tutte le macchine mobili, entro il 2012, dovranno essere soggette a un incremento di efficienza energetica. Un'evoluzione del sistema idraulico potr{\`a} contribuire in maniera significativa al miglioramento richiesto. Elettronica e idraulica sempre pi{\`u} protagoniste.},
  language  = {it}
}
@article{ChristenBarteltKowalski2010,
  author    = {Christen, Marc and Bartelt, Perry and Kowalski, Julia},
  title     = {Back calculation of the In den Arelen avalanche with RAMMS: Interpretation of model results},
  series = {Annals of Glaciology},
  volume    = {51},
  journal   = {Annals of Glaciology},
  number    = {54},
  publisher = {Cambridge University Press},
  address   = {Cambridge},
  isbn      = {1727-5644},
  doi       = {10.3189/172756410791386553},
  pages     = {161 -- 168},
  year      = {2010},
  abstract  = {Two- and three-dimensional avalanche dynamics models are being increasingly used in hazard-mitigation studies. These models can provide improved and more accurate results for hazard mapping than the simple one-dimensional models presently used in practice. However, two- and three-dimensional models generate an extensive amount of output data, making the interpretation of simulation results more difficult. To perform a simulation in three-dimensional terrain, numerical models require a digital elevation model, specification of avalanche release areas (spatial extent and volume), selection of solution methods, finding an adequate calculation resolution and, finally, the choice of friction parameters. In this paper, the importance and difficulty of correctly setting up and analysing the results of a numerical avalanche dynamics simulation is discussed. We apply the two-dimensional simulation program RAMMS to the 1968 extreme avalanche event In den Arelen. We show the effect of model input variations on simulation results and the dangers and complexities in their interpretation.},
  language  = {en}
}
@article{PieperKlein2010,
  author    = {Pieper, Martin and Klein, Peter},
  title     = {Numerical solution of the heat equation with non-linear, time derivative-dependent source term},
  series = {International Journal for Numerical Methods in Engineering},
  volume    = {84},
  journal   = {International Journal for Numerical Methods in Engineering},
  number    = {10},
  publisher = {Wiley},
  address   = {Chichester},
  issn      = {0029-5981},
  doi       = {10.1002/nme.2937},
  pages     = {1205 -- 1221},
  year      = {2010},
  abstract  = {The mathematical modeling of heat conduction with adsorption effects in coated metal structures yields the heat equation with piecewise smooth coefficients and a new kind of source term. This term is special, because it is non-linear and furthermore depends on a time derivative. In our approach we reformulated this as a new problem for the usual heat equation, without source term but with a new non-linear coefficient. We gave an existence and uniqueness proof for the weak solution of the reformulated problem. To obtain a numerical solution, we developed a semi-implicit and a fully implicit finite volume method. We compared these two methods theoretically as well as numerically. Finally, as practical application, we simulated the heat conduction in coated aluminum fibers with adsorption in the zeolite coating. Copyright © 2010 John Wiley \& Sons, Ltd.},
  language  = {en}
}
@article{SchollSchubertZieneretal.2010,
  author    = {Scholl, Ingrid and Schubert, N. and Ziener, P. and Pietrzyk, U.},
  title     = {GPU-basiertes Volumenrendering von multimodalen medizinischen Bilddaten in Echtzeit},
  series = {Bildverarbeitung f{\"u}r die Medizin 2010 : Algorithmen, Systeme, Anwendungen ; Proceedings des Workshops vom 14. bis 16. M{\"a}rz in Aachen / Thomas M. Deserno ... (Hrsg.)},
  journal   = {Bildverarbeitung f{\"u}r die Medizin 2010 : Algorithmen, Systeme, Anwendungen ; Proceedings des Workshops vom 14. bis 16. M{\"a}rz in Aachen / Thomas M. Deserno ... (Hrsg.)},
  publisher = {Springer},
  address   = {Berlin},
  isbn      = {978-3-642-11967-5},
  pages     = {400 -- 404},
  year      = {2010},
  language  = {de}
}
@article{BerretzSkorupaSanderetal.2010,
  author    = {Berretz, F. and Skorupa, S. and Sander, Volker and Belloum, A.},
  title     = {Towards an actor-driven workflow management system for grids},
  series = {International Symposium on Collaborative Technologies and Systems (CTS), 2010 : 17 - 21 May 2010, Chicago, Illinois, USA / IEEE},
  journal   = {International Symposium on Collaborative Technologies and Systems (CTS), 2010 : 17 - 21 May 2010, Chicago, Illinois, USA / IEEE},
  publisher = {IEEE},
  address   = {Piscataway, NJ},
  isbn      = {978-1-4244-6619-1},
  pages     = {611 -- 616},
  year      = {2010},
  language  = {en}
}
@article{Timme2010,
  author    = {Timme, Michael},
  title     = {K{\"u}ndigung des Mietverh{\"a}ltnisses wegen nicht gezahlter Kosten eines Rechtsstreits},
  series = {Monatsschrift f{\"u}r deutsches Recht : MdR ; Zeitschrift f{\"u}r die Zivilrechts-Praxis. 30 (2010), H. 19},
  journal   = {Monatsschrift f{\"u}r deutsches Recht : MdR ; Zeitschrift f{\"u}r die Zivilrechts-Praxis. 30 (2010), H. 19},
  isbn      = {0340-1812},
  pages     = {1089 -- 1091},
  year      = {2010},
  language  = {de}
}
@article{KernSchelthoffMathieu2010,
  author    = {Kern, Alexander and Schelthoff, Christof and Mathieu, Moritz},
  title     = {Probability of lightning strikes to air-terminations of structures using the electro-geometrical model theory and the statistics of lightning current parameters},
  pages     = {750-1 -- 750-8},
  year      = {2010},
  language  = {en}
}