@article{GebhardtFateri2014,
  author    = {Gebhardt, Andreas and Fateri, Miranda},
  title     = {3D-Drucken und die Anwendungen},
  series = {RTejournal - Forum f{\"u}r Rapid Technologie},
  volume    = {11 (2014)},
  journal   = {RTejournal - Forum f{\"u}r Rapid Technologie},
  number    = {1},
  issn      = {1614-0923},
  pages     = {1 -- 9},
  year      = {2014},
  language  = {de}
}
@article{GuoMiyamotoWagneretal.2014,
  author    = {Guo, Yuanyuan and Miyamoto, Ko-ichiro and Wagner, Torsten and Sch{\"o}ning, Michael Josef and Yoshinobu, Tatsuo},
  title     = {Device simulation of the light-addressable potentiometric sensor for the investigation of the spatial resolution},
  series = {Sensors and actuators B: Chemical},
  volume    = {204},
  journal   = {Sensors and actuators B: Chemical},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1873-3077 (E-Journal); 0925-4005 (Print)},
  doi       = {10.1016/j.snb.2014.08.016},
  pages     = {659 -- 665},
  year      = {2014},
  abstract  = {As a semiconductor-based electrochemical sensor, the light-addressable potentiometric sensor (LAPS) can realize two dimensional visualization of (bio-)chemical reactions at the sensor surface addressed by localized illumination. Thanks to this imaging capability, various applications in biochemical and biomedical fields are expected, for which the spatial resolution is critically significant. In this study, therefore, the spatial resolution of the LAPS was investigated in detail based on the device simulation. By calculating the spatiotemporal change of the distributions of electrons and holes inside the semiconductor layer in response to a modulated illumination, the photocurrent response as well as the spatial resolution was obtained as a function of various parameters such as the thickness of the Si substrate, the doping concentration, the wavelength and the intensity of illumination. The simulation results verified that both thinning the semiconductor substrate and increasing the doping concentration could improve the spatial resolution, which were in good agreement with known experimental results and theoretical analysis. More importantly, new findings of interests were also obtained. As for the dependence on the wavelength of illumination, it was found that the known dependence was not always the case. When the Si substrate was thick, a longer wavelength resulted in a higher spatial resolution which was known by experiments. When the Si substrate was thin, however, a longer wavelength of light resulted in a lower spatial resolution. This finding was explained as an effect of raised concentration of carriers, which reduced the thickness of the space charge region. The device simulation was found to be helpful to understand the relationship between the spatial resolution and device parameters, to understand the physics behind it, and to optimize the device structure and measurement conditions for realizing higher performance of chemical imaging systems.},
  language  = {en}
}
@article{KhaydukovaZadorozhnayaKirsanovetal.2014,
  author    = {Khaydukova, M. M. and Zadorozhnaya, O. A. and Kirsanov, D. O. and Iken, Heiko and Rolka, David and Sch{\"o}ning, Michael Josef and Babain, V. A. and Vlasov, Yu. G. and Legin, A. V.},
  title     = {Multivariate processing of atomic-force microscopy images for detection of the response of plasticized polymeric membranes},
  series = {Russian journal of applied chemistry},
  volume    = {87},
  journal   = {Russian journal of applied chemistry},
  number    = {3},
  publisher = {Springer},
  address   = {Dordrecht},
  issn      = {1608-3296 (E-Journal); 1070-4272 (Print)},
  doi       = {10.1134/S1070427214030112},
  pages     = {307 -- 314},
  year      = {2014},
  abstract  = {The possibility of using the atomic-force microscopy as a method for detection of the analytical signal from plasticized polymeric sensor membranes was analyzed. The surfaces of cadmium-selective membranes based on two polymeric matrices were examined. The digital images were processed with multivariate image analysis techniques. A correlation was found between the surface profile of an ion-selective membrane and the concentration of the ion in solution.},
  language  = {en}
}
@article{HoltrupSadeghfamHeuermannetal.2014,
  author    = {Holtrup, S. and Sadeghfam, Arash and Heuermann, Holger and Awakowicz, P.},
  title     = {Characterization and optimization technique for microwave-driven high-intensity discharge lamps using hot S-parameters},
  series = {IEEE transactions on microwave theories and techniques},
  volume    = {62},
  journal   = {IEEE transactions on microwave theories and techniques},
  number    = {10},
  publisher = {IEEE},
  address   = {New York},
  issn      = {0018-9480},
  doi       = {10.1109/TMTT.2014.2342652},
  pages     = {2471 -- 2480},
  year      = {2014},
  abstract  = {High-intensity discharge lamps can be driven by radio-frequency signals in the ISM frequency band at 2.45 GHz, using a matching network to transform the impedance of the plasma to the source impedance. To achieve an optimal operating condition, a good characterization of the lamp in terms of radio frequency equivalent circuits under operating conditions is necessary, enabling the design of an efficient matching network. This paper presents the characterization technique for such lamps and presents the design of the required matching network. For the characterization, a high-intensity discharge lamp was driven by a monofrequent large signal at 2.45 GHz, whereas a frequency sweep over 300 MHz was performed across this signal to measure so-called small-signal hot S-parameters using a vector network analyzer. These parameters are then used as an equivalent load in a circuit simulator to design an appropriate matching network. Using the measured data as a black-box model in the simulation results in a quick and efficient method to simulate and design efficient matching networks in spite of the complex plasma behavior. Furthermore, photometric analysis of high-intensity discharge lamps are carried out, comparing microwave operation to conventional operation.},
  language  = {en}
}
@article{StadlerGarveyEmbsetal.2014,
  author    = {Stadler, Alexander Maximilian and Garvey, Christopher J. and Embs, Jan Peter and Koza, Michael Marek and Unruh, Tobias and Artmann, Gerhard and Zaccai, Guiseppe},
  title     = {Picosecond dynamics in haemoglobin from different species: A quasielastic neutron scattering study},
  series = {Biochimica et biophysica acta (BBA): General Subjects},
  volume    = {1840},
  journal   = {Biochimica et biophysica acta (BBA): General Subjects},
  number    = {10},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1872-8006 (E-Journal); 0304-4165 (Print)},
  doi       = {10.1016/j.bbagen.2014.06.007},
  pages     = {2989 -- 2999},
  year      = {2014},
  language  = {en}
}
@article{GebhardtHoetterZiebura2014,
  author    = {Gebhardt, Andreas and H{\"o}tter, Jan-Steffen and Ziebura, Dawid},
  title     = {Impact of SLM build parameters on the surface quality},
  series = {RTejournal - Forum f{\"u}r Rapid Technologien},
  volume    = {11 (2014)},
  journal   = {RTejournal - Forum f{\"u}r Rapid Technologien},
  number    = {1},
  issn      = {1614-0923},
  pages     = {1 -- 14},
  year      = {2014},
  language  = {de}
}
@article{FrotscherStaat2014,
  author    = {Frotscher, Ralf and Staat, Manfred},
  title     = {Stresses produced by different textile mesh implants in a tissue equivalent},
  series = {BioNanoMaterials},
  volume    = {15},
  journal   = {BioNanoMaterials},
  number    = {1-2},
  publisher = {De Gruyter},
  address   = {Berlin},
  issn      = {2191-4672 (E-Journal); 2193-066X (E-Journal); 0011-8656 (Print); 1616-0177 (Print); 2193-0651 (Print)},
  doi       = {10.1515/bnm-2014-0003},
  pages     = {25 -- 30},
  year      = {2014},
  abstract  = {Two single-incision mini-slings used for treating urinary incontinence in women are compared with respect to the stresses they produce in their surrounding tissue. In an earlier paper we experimentally observed that these implants produce considerably different stress distributions in a muscle tissue equivalent. Here we perform 2D finite element analyses to compare the shear stresses and normal stresses in the tissue equivalent for the two meshes and to investigate their failure behavior. The results clearly show that the Gynecare TVT fails for increasing loads in a zipper-like manner because it gradually debonds from the surrounding tissue. Contrary to that, the tissue at the ends of the DynaMesh-SIS direct may rupture but only at higher loads. The simulation results are in good agreement with the experimental observations thus the computational model helps to interpret the experimental results and provides a tool for qualitative evaluation of mesh implants.},
  language  = {en}
}
@article{AlhwarinFerreinScholl2014,
  author    = {Alhwarin, Faraj and Ferrein, Alexander and Scholl, Ingrid},
  title     = {IR stereo kinect: improving depth images by combining structured light with IR stereo},
  pages     = {1 -- 9},
  year      = {2014},
  language  = {en}
}
@article{FiedlerHennMelcher2014,
  author    = {Fiedler, Gerda and Henn, Gudrun and Melcher, Karin},
  title     = {ANPAK - ein semesterbegleitender Anpassungskurs},
  series = {Zeitschrift f{\"u}r Hochschulentwicklung},
  volume    = {9},
  journal   = {Zeitschrift f{\"u}r Hochschulentwicklung},
  number    = {4},
  publisher = {{\"O}GHD},
  address   = {Wien},
  issn      = {2219-6994},
  pages     = {85 -- 100},
  year      = {2014},
  abstract  = {In Folge mehrj{\"a}hriger statistischer Untersuchungen an der FH Aachen ist unter anderem ein Eingangstest entstanden, der als Diagnosetool f{\"u}r einen erfolgreichen Studieneinstieg verwendet wird. Es hat sich herausgestellt, dass ein Testergebnis von weniger als 25 (von maximal 56 erreichbaren) Punkten die Chance auf einen erfolgreichen Studieneinstieg deutlich verringert. Ungef{\"a}hr die H{\"a}lfte aller Erstsemester hat weniger als 25 Punkte im Eingangstest. Weniger als 20 \% dieser Gruppe bestehen innerhalb eines Jahres die Klausur Mathematik 1. Die investierte Zeit von zwei Semestern ist mit Blick auf den Wissenszuwachs und damit letztendlich den Studienerfolg nicht effizient genutzt. Deshalb haben wir im WS 2013/14 einen semesterbegleitenden Anpassungskurs f{\"u}r diese Gruppe installiert. Ziel eines solchen Kurses ist es, die Student/innen innerhalb eines Jahres in die Lage zu versetzen, nach zwei Semestern problemlos den Vorlesungen in Mathematik zu folgen. Dieser Artikel beschreibt das Konzept dieses Anpassungskurses und zeigt erste Ergebnisse und Probleme des Pilotdurchgangs auf.},
  language  = {de}
}
@article{BaeckerSchusserPoghossianetal.2014,
  author    = {B{\"a}cker, Matthias and Schusser, Sebastian and Poghossian, Arshak and Sch{\"o}ning, Michael Josef},
  title     = {Multi-Parametererfassung mit siliziumbasiertem Sensorchip: Aus Drei mach Eins},
  series = {GIT Labor-Fachzeitschrift},
  journal   = {GIT Labor-Fachzeitschrift},
  number    = {2},
  publisher = {Wiley},
  issn      = {0016-3538},
  pages     = {28 -- 30},
  year      = {2014},
  language  = {de}
}