@article{ValeroBung2016,
  author    = {Valero, Daniel and Bung, Daniel B.},
  title     = {Development of the interfacial air layer in the non-aerated region of high-velocity spillway flows: Instabilities growth, entrapped air and influence on the self-aeration onset},
  series = {International Journal of Multiphase Flow},
  volume    = {84},
  journal   = {International Journal of Multiphase Flow},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {0301-9322},
  doi       = {10.1016/j.ijmultiphaseflow.2016.04.012},
  pages     = {66 -- 74},
  year      = {2016},
  abstract  = {Self-aeration is traditionally explained by the water turbulent boundary layer outer edge intersection with the free surface. This paper presents a discussion on the commonly accepted hypothesis behind the computation of the critical point of self-aeration in spillway flows and a new formulation is proposed based on the existence of a developing air flow over the free surface. Upstream of the inception point of self-aeration, some surface roughening has been often reported in previous studies which consequently implies some entrapped air transport and air-water flows coupling. Such air flow is proven in this study by presenting measured air velocities and computing the air boundary layer thickness for a 1V:2H smooth chute flow. Additionally, the growth rate of free surface waves has been analysed by means of Ultrasonic Sensors measurements, obtaining also the entrapped air concentration. High-speed camera imaging has been used for qualitative study of the flow perturbations.},
  language  = {en}
}
@article{GhoschBaierSchuetzetal.2016,
  author    = {Ghosch, S. and Baier, M. and Sch{\"u}tz, J. and Schneider, Felix and Scherer, Ulrich W.},
  title     = {Analysis of electronic autoradiographs by mathematical post-processing},
  series = {Radiation Effects and Defects in Solids: Incorporating plasma science and plasma technology},
  volume    = {171},
  journal   = {Radiation Effects and Defects in Solids: Incorporating plasma science and plasma technology},
  number    = {1-2},
  publisher = {Taylor \& Francis},
  address   = {London},
  issn      = {1029-4953},
  doi       = {10.1080/10420150.2016.1155587},
  pages     = {161 -- 172},
  year      = {2016},
  abstract  = {Autoradiography is a well-established method of nuclear imaging. When different radionuclides are present simultaneously, additional processing is needed to distinguish distributions of radionuclides. In this work, a method is presented where aluminium absorbers of different thickness are used to produce images with different cut-off energies. By subtracting images pixel-by-pixel one can generate images representing certain ranges of β-particle energies. The method is applied to the measurement of irradiated reactor graphite samples containing several radionuclides to determine the spatial distribution of these radionuclides within pre-defined energy windows. The process was repeated under fixed parameters after thermal treatment of the samples. The greyscale images of the distribution after treatment were subtracted from the corresponding pre-treatment images. Significant changes in the intensity and distribution of radionuclides could be observed in some samples. Due to the thermal treatment parameters the most significant differences were observed in the ³H and ¹⁴C inventory and distribution.},
  language  = {en}
}
@inproceedings{BroennerHoefkenSchuba2016,
  author    = {Broenner, Simon and H{\"o}fken, Hans-Wilhelm and Schuba, Marko},
  title     = {Streamlining extraction and analysis of android RAM images},
  series = {Proceedings of the 2nd international conference on information systems security and privacy},
  booktitle = {Proceedings of the 2nd international conference on information systems security and privacy},
  organization    = {ICISSP International Conference on Information Systems Security and Privacy <2, 2016, Rome, Italy>},
  isbn      = {978-989-758-167-0},
  doi       = {10.5220/0005652802550264},
  pages     = {255 -- 264},
  year      = {2016},
  language  = {en}
}
@article{BelavyAlbrachtBruggemannetal.2016,
  author    = {Belavy, Daniel L. and Albracht, Kirsten and Bruggemann, Gert-Peter and Vergroesen, Pieter-Paul A. and Dieen, Jaap H. van},
  title     = {Can exercise positively influence the intervertebral disc?},
  series = {Sports Medicine},
  volume    = {46},
  journal   = {Sports Medicine},
  number    = {4},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1179-2035},
  doi       = {10.1007/s40279-015-0444-2},
  pages     = {473 -- 485},
  year      = {2016},
  abstract  = {To better understand what kinds of sports and exercise could be beneficial for the intervertebral disc (IVD), we performed a review to synthesise the literature on IVD adaptation with loading and exercise. The state of the literature did not permit a systematic review; therefore, we performed a narrative review. The majority of the available data come from cell or whole-disc loading models and animal exercise models. However, some studies have examined the impact of specific sports on IVD degeneration in humans and acute exercise on disc size. Based on the data available in the literature, loading types that are likely beneficial to the IVD are dynamic, axial, at slow to moderate movement speeds, and of a magnitude experienced in walking and jogging. Static loading, torsional loading, flexion with compression, rapid loading, high-impact loading and explosive tasks are likely detrimental for the IVD. Reduced physical activity and disuse appear to be detrimental for the IVD. We also consider the impact of genetics and the likelihood of a 'critical period' for the effect of exercise in IVD development. The current review summarises the literature to increase awareness amongst exercise, rehabilitation and ergonomic professionals regarding IVD health and provides recommendations on future directions in research.},
  language  = {en}
}
@article{MiyamotoSatoAbeetal.2016,
  author    = {Miyamoto, Ko-Ichiro and Sato, Takuya and Abe, Minami and Wagner, Torsten and Sch{\"o}ning, Michael Josef and Yoshinobu, Tatsuo},
  title     = {Light-addressable potentiometric sensor as a sensing element in plug-based microfluidic devices},
  series = {Micromachines},
  volume    = {7},
  journal   = {Micromachines},
  number    = {7},
  publisher = {MDPI},
  address   = {Basel},
  issn      = {2072-666X},
  doi       = {10.3390/mi7070111},
  pages     = {111},
  year      = {2016},
  abstract  = {A plug-based microfluidic system based on the principle of the light-addressable potentiometric sensor (LAPS) is proposed. The LAPS is a semiconductor-based chemical sensor, which has a free addressability of the measurement point on the sensing surface. By combining a microfluidic device and LAPS, ion sensing can be performed anywhere inside the microfluidic channel. In this study, the sample solution to be measured was introduced into the channel in a form of a plug with a volume in the range of microliters. Taking advantage of the light-addressability, the position of the plug could be monitored and pneumatically controlled. With the developed system, the pH value of a plug with a volume down to 400 nL could be measured. As an example of plug-based operation, two plugs were merged in the channel, and the pH change was detected by differential measurement.},
  language  = {en}
}
@inproceedings{KerpenBungValeroetal.2016,
  author    = {Kerpen, Nils B. and Bung, Daniel B. and Valero, Daniel and Schlurmann, Torsten},
  title     = {Energy dissipation within the wave run-up at stepped revetments},
  series = {8th Chinese-German Joint Symposium on Hydraulic and Ocean Engineering, Qingdao, China},
  booktitle = {8th Chinese-German Joint Symposium on Hydraulic and Ocean Engineering, Qingdao, China},
  pages     = {6 Seiten},
  year      = {2016},
  language  = {en}
}
@inproceedings{BungValero2016,
  author    = {Bung, Daniel B. and Valero, Daniel},
  title     = {Image processing techniques for velocity estimation in highly aerated flows: bubble image velocimetry vs. optical flow},
  series = {Sustainable Hydraulics in the Era of Global Change : Proceedings of the 4th IAHR Europe Congress (Liege, Belgium, 27-29 July 2016)},
  booktitle = {Sustainable Hydraulics in the Era of Global Change : Proceedings of the 4th IAHR Europe Congress (Liege, Belgium, 27-29 July 2016)},
  editor    = {Dewals, Benjamin},
  publisher = {CRC Press},
  isbn      = {978-1-138-02977-4},
  doi       = {10.1201/b21902-31},
  pages     = {151 -- 157},
  year      = {2016},
  language  = {en}
}
@article{JahnkeRousselHombachetal.2016,
  author    = {Jahnke, Siegfried and Roussel, Johanna and Hombach, Thomas and Kochs, Johannes and Fischbach, Andreas and Huber, Gregor and Scharr, Hanno},
  title     = {phenoSeeder - A robot system for automated handling and phenotyping of individual seeds},
  series = {Plant physiology},
  volume    = {172},
  journal   = {Plant physiology},
  number    = {3},
  publisher = {Oxford University Press},
  address   = {Oxford},
  issn      = {0032-0889},
  doi       = {10.1104/pp.16.01122},
  pages     = {1358 -- 1370},
  year      = {2016},
  abstract  = {The enormous diversity of seed traits is an intriguing feature and critical for the overwhelming success of higher plants. In particular, seed mass is generally regarded to be key for seedling development but is mostly approximated by using scanning methods delivering only two-dimensional data, often termed seed size. However, three-dimensional traits, such as the volume or mass of single seeds, are very rarely determined in routine measurements. Here, we introduce a device named phenoSeeder, which enables the handling and phenotyping of individual seeds of very different sizes. The system consists of a pick-and-place robot and a modular setup of sensors that can be versatilely extended. Basic biometric traits detected for individual seeds are two-dimensional data from projections, three-dimensional data from volumetric measures, and mass, from which seed density is also calculated. Each seed is tracked by an identifier and, after phenotyping, can be planted, sorted, or individually stored for further evaluation or processing (e.g. in routine seed-to-plant tracking pipelines). By investigating seeds of Arabidopsis (Arabidopsis thaliana), rapeseed (Brassica napus), and barley (Hordeum vulgare), we observed that, even for apparently round-shaped seeds of rapeseed, correlations between the projected area and the mass of seeds were much weaker than between volume and mass. This indicates that simple projections may not deliver good proxies for seed mass. Although throughput is limited, we expect that automated seed phenotyping on a single-seed basis can contribute valuable information for applications in a wide range of wild or crop species, including seed classification, seed sorting, and assessment of seed quality.},
  language  = {en}
}
@article{Wrede2016,
  author    = {Wrede, Oliver},
  title     = {Continuity in travel information},
  series = {Information Design Journal},
  volume    = {22},
  journal   = {Information Design Journal},
  number    = {2},
  publisher = {John Benjamins},
  address   = {Amsterdam},
  issn      = {0142-5471},
  doi       = {10.1075/idj.22.2.09wre},
  pages     = {172 -- 178},
  year      = {2016},
  abstract  = {This article discusses the contrast between the information transportation companies provide to travellers and that of their brand messaging. Companies' brand messaging often portrays the service they provide as pleasant, stress free and perfect. Customers and users of the service, on the other hand, often describe their experience of the service as a negative one. This article suggests that the brand value would be greater if transportation companies paid more attention to the users' experience when designing their information systems, particularly in worst case scenarios.},
  language  = {en}
}
@article{FerreinSteinbauer2016,
  author    = {Ferrein, Alexander and Steinbauer, Gerald},
  title     = {20 Years of RoboCup - A Subjective Retrospection},
  series = {KI - K{\"u}nstliche Intelligenz},
  volume    = {30},
  journal   = {KI - K{\"u}nstliche Intelligenz},
  number    = {3},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1610-1987},
  doi       = {10.1007/s13218-016-0449-5},
  pages     = {225 -- 232},
  year      = {2016},
  abstract  = {This summer, RoboCup competitions were held for the 20th time in Leipzig, Germany. It was the second time that RoboCup took place in Germany, 10 years after the 2006 RoboCup in Bremen. In this article, we give an overview on the latest developments of RoboCup and what happened in the different leagues over the last decade. With its 20th edition, RoboCup clearly is a success story and a role model for robotics competitions. From our personal view point, we acknowledge this by giving a retrospection about what makes RoboCup such a success.},
  language  = {en}
}