@article{KraffBitzBreyeretal.2011,
  author    = {Kraff, Oliver and Bitz, Andreas and Breyer, Tobias and Kruszona, Stefan and Maderwald, Stefan and Brote, Irina and Gizewski, Elke R. and Ladd, Mark E. and Quick, Harald H.},
  title     = {A transmit/receive radiofrequency array for imaging the carotid arteries at 7 Tesla: coil design and first in vivo results},
  series = {Investigative Radiology},
  volume    = {46},
  journal   = {Investigative Radiology},
  number    = {4},
  publisher = {Wolters Kluwer},
  address   = {K{\"o}ln},
  issn      = {1536-0210},
  doi       = {10.1097/RLI.0b013e318206cee4},
  pages     = {246 -- 254},
  year      = {2011},
  abstract  = {Objective: To develop a transmit/receive radiofrequency (RF) array for magnetic resonance imaging (MRI) of the carotid arteries at 7 T. The prototype is characterized in numerical simulations and bench measurements, and the feasibility of plaque imaging at 7 T is demonstrated in first in vivo images. Materials and Methods: The RF phased array coil consists of 8 surface loop coils. To allow imaging of both sides of the neck, the RF array is divided into 2 coil clusters, each with 4 overlapping loop elements. For safety validation, numerical computations of the RF field distribution and the corresponding specific absorption rate were performed on the basis of a heterogeneous human body model. To validate the coil model, maps of the transmit B1+ field were compared between simulation and measurement. In vivo images of a healthy volunteer and a patient (ulcerating plaque and a 50\% stenosis of the right internal carotid artery) were acquired using a 3-dimensional FLASH sequence with a high isotropic spatial resolution of 0.54 mm as well as using pulse-triggered proton density (PD)/T2-weighted turbo spin echo sequences. Results: Measurements of the S-parameters yielded a reflection and isolation of the coil elements of better than -18 and -13 dB, respectively. Measurements of the g-factor indicated good image quality for parallel imaging acceleration factors up to 2.4. A similar distribution and a very good match of the absolute values were found between the measured and simulated B1+ transmit RF field for the validation of the coil model. In vivo images revealed good signal excitation of both sides of the neck and a high vessel-to-background image contrast for the noncontrast-enhanced 3-dimensional FLASH sequence. Imaging at 7 T could depict the extent of stenosis, and revealed the disruption and ulcer of the plaque. Conclusions: This study demonstrates that 2 four-channel transmit/receive RF arrays for each side of the neck is a suitable concept for in vivo MRI of the carotid arteries at 7 Tesla. Further studies are needed to explore and exploit the full potential of 7 T high-field MRI for carotid atherosclerotic plaque imaging.},
  language  = {en}
}
@article{SiekerNeunerDimitrovaetal.2011,
  author    = {Sieker, Tim and Neuner, Andreas and Dimitrova, Darina and Tippk{\"o}tter, Nils and Muffler, Kai and Bart, Hans-J{\"o}rg and Heinzle, Elmar and Ulber, Roland},
  title     = {Ethanol production from grass silage by simultaneous pretreatment, saccharification and fermentation: First steps in the process development},
  series = {Engineering in Life Sciences},
  volume    = {11},
  journal   = {Engineering in Life Sciences},
  number    = {4},
  publisher = {Wiley},
  address   = {Weinheim},
  doi       = {10.1002/elsc.201000160},
  pages     = {436 -- 442},
  year      = {2011},
  abstract  = {Grass silage provides a great potential as renewable feedstock. Two fractions of the grass silage, a press juice and the fiber fraction, were evaluated for their possible use for bioethanol production. Direct production of ethanol from press juice is not possible due to high concentrations of organic acids. For the fiber fraction, alkaline peroxide or enzymatic pretreatment was used, which removes the phenolic acids in the cell wall. In this study, we demonstrate the possibility to integrate the enzymatic pretreatment with a simultaneous saccharification and fermentation to achieve ethanol production from grass silage in a one-process step. Achieved yields were about 53 g ethanol per kg silage with the alkaline peroxide pretreatment and 91 g/kg with the enzymatic pretreatment at concentrations of 8.5 and 14.6 g/L, respectively. Furthermore, it was shown that additional supplementation of the fermentation medium with vitamins, trace elements and nutrient salts is not necessary when the press juice is directly used in the fermentation step.},
  language  = {en}
}
@article{PothMonzonTippkoetteretal.2011,
  author    = {Poth, Sebastian and Monzon, Magaly and Tippk{\"o}tter, Nils and Ulber, Roland},
  title     = {Lignocellulosic biorefinery: Process integration of hydrolysis and fermentation (SSF process)},
  series = {Holzforschung},
  volume    = {65},
  journal   = {Holzforschung},
  number    = {5},
  publisher = {De Gruyter},
  address   = {Berlin},
  pages     = {633 -- 637},
  year      = {2011},
  abstract  = {The aim of the present work is the process integration and the optimization of the enzymatic hydrolysis of wood and the following fermentation of the products to ethanol. The substrate is a fiber fraction obtained by organosolv pre-treatment of beech wood. For the ethanol production, a co-fermentation by two different yeasts (Saccharomyces cerevisiae and Pachysolen tannophilus) was carried out to convert glucose as well as xylose. Two approaches has been followed: 1. A two step process, in which the hydrolysis of the fiber fraction and the fermentation to product are separated from each other. 2. A process, in which the hydrolysis and the fermentation are carried out in one single process step as simultaneous saccharification and fermentation (SSF). Following the first approach, a yield of about 0.15 g ethanol per gram substrate can be reached. Based on the SSF, one process step can be saved, and additionally, the gained yield can be raised up to 0.3 g ethanol per gram substrate.},
  language  = {en}
}
@article{ElQuardiStreckertBitzetal.2011,
  author    = {El Quardi, A. and Streckert, J. and Bitz, Andreas and M{\"u}nkner, S. and Engel, J. and Hansen, V.},
  title     = {New fin-line devices for radiofrequency exposure of small biological samples in vitro allowing whole-cell patch clamp recordings},
  series = {Bioelectromagnetics},
  volume    = {32},
  journal   = {Bioelectromagnetics},
  number    = {2},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1521-186X},
  doi       = {10.1002/bem.20621},
  pages     = {102 -- 112},
  year      = {2011},
  abstract  = {The development and analysis of three waveguides for the exposure of small biological in vitro samples to mobile communication signals at 900 MHz (GSM, Global System for Mobile Communications), 1.8 GHz (GSM), and 2 GHz (UMTS, Universal Mobile Telecommunications System) is presented. The waveguides were based on a fin-line concept and the chamber containing the samples bathed in extracellular solution was placed onto two fins with a slot in between, where the exposure field concentrates. Measures were taken to allow for patch clamp recordings during radiofrequency (RF) exposure. The necessary power for the achievement of the maximum desired specific absorption rate (SAR) of 20 W/kg (average over the mass of the solution) was approximately Pin = 50 mW, Pin = 19 mW, and Pin = 18 mW for the 900 MHz, 1800 MHz, and 2 GHz devices, respectively. At 20 W/kg, a slight RF-induced temperature elevation in the solution of no more than 0.3 °C was detected, while no thermal offsets due to the electromagnetic exposure could be detected at the lower SAR settings (2, 0.2, and 0.02 W/kg). A deviation of 10\% from the intended solution volume yielded a calculated SAR deviation of 8\% from the desired value. A maximum ±10\% variation in the local SAR could occur when the position of the patch clamp electrode was altered within the area where the cells to be investigated were located.},
  language  = {en}
}
@article{TippkoetterWollnyKampeisetal.2011,
  author    = {Tippk{\"o}tter, Nils and Wollny, S. and Kampeis, P. and Oster, J. and Schneider, H. and Ulber, R.},
  title     = {Magnetseparation von Proteinen : Separation von Zielmolek{\"u}len durch hochselektive Aptamere},
  series = {GIT Labor-Fachzeitschrift},
  volume    = {55},
  journal   = {GIT Labor-Fachzeitschrift},
  number    = {10},
  publisher = {Wiley},
  address   = {Weinheim},
  pages     = {666},
  year      = {2011},
  abstract  = {Durch die Kombination von Oligonukleotid-Liganden (Aptameren) hoher Bindungsaffinit{\"a}ten mit hochselektiv abtrennbaren magnetisierbaren Mikropartikeln wird eine einstufige Separation von Zielmolek{\"u}len aus mikrobiologischen Produktionsans{\"a}tzen m{\"o}glich. Die Aptamere werden hierf{\"u}r reversibel auf den Partikeloberfl{\"a}chen gebunden und f{\"u}r die spezifische Isolierung von Bioprodukten eingesetzt. Die Abtrennung der beladenen Partikel erfolgt durch einen neuen Rotor-Stator-Separator mit Hochgradient-Magnetfeld.},
  language  = {de}
}
@article{Wilke2011,
  author    = {Wilke, Thomas},
  title     = {[Rezension zu: ] Simone Meyder: "Mehr k{\"o}niglich als frei". Robert de Cotte und das Bauen in Straßburgnach 1681, M{\"u}nster: Waxmann 2010},
  series = {Sehepunkte},
  volume    = {11},
  journal   = {Sehepunkte},
  number    = {2},
  issn      = {1618-6168},
  year      = {2011},
  language  = {de}
}
@article{Tran2011,
  author    = {Tran, Duc Hung},
  title     = {Corporate Governance und Eigenkapitalkosten - Bestandsaufnahme des Schrifttums unter besonderer Ber{\"u}cksichtigung des Informationsaspektes und Forschungsperspektiven},
  series = {Zeitschrift f{\"u}r Betriebswirtschaft},
  volume    = {81},
  journal   = {Zeitschrift f{\"u}r Betriebswirtschaft},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1861-8928},
  doi       = {10.1007/s11573-011-0461-z},
  pages     = {551 -- 585},
  year      = {2011},
  language  = {de}
}
@article{Tran2011,
  author    = {Tran, Duc Hung},
  title     = {Die Bilanzierung immaterieller Verm{\"o}gensgegenst{\"a}nde nach BilMoG: Normative Erkenntnisse empirischer Befunde},
  series = {KoR Zeitschrift f{\"u}r kapitalmarktorientierte Rechnungslegung},
  volume    = {11},
  journal   = {KoR Zeitschrift f{\"u}r kapitalmarktorientierte Rechnungslegung},
  issn      = {1437-8981},
  pages     = {538 -- 542},
  year      = {2011},
  language  = {de}
}
@article{Tran2011,
  author    = {Tran, Duc Hung},
  title     = {Wirkungslosigkeit der Entsprechenserkl{\"a}rung gem. \S161 AktG},
  series = {Betriebs-Berater: BB ; Recht, Wirtschaft, Steuern},
  volume    = {66},
  journal   = {Betriebs-Berater: BB ; Recht, Wirtschaft, Steuern},
  publisher = {Beck},
  address   = {M{\"u}nchen},
  issn      = {0340-7918},
  pages     = {2025},
  year      = {2011},
  abstract  = {Das Ziel des Deutschen Corporate Governance Kodex (DCGK) besteht in der Verbesserung der Transparenz und Qualit{\"a}t der deutschen Corporate Governance, wobei die Sanktionierung der Nichteinhaltung des DCGK einzig durch etwaige Kapitalmarktreaktionen erfolgt. Folgende Befunde sprechen jedoch daf{\"u}r, dass durch die Abgabe der Entsprechenserkl{\"a}rung gem. \S 161 AktG die f{\"u}r das Enforcement des Kodex angenommene Selbstregulierung durch den Kapitalmarkt nicht stattfindet, und demnach Verbesserungsbedarf besteht},
  language  = {de}
}
@article{KrollLudwigs2011,
  author    = {Kroll-Ludwigs, Kathrin},
  title     = {Anmerkung zu EuGH, Urt. v. 1.3.2011, Rs. C-236/09 Association belge des Consomma-teurs Test-Achats},
  series = {JuristenZeitung (JZ)},
  volume    = {66},
  journal   = {JuristenZeitung (JZ)},
  number    = {14},
  publisher = {Mohr Siebeck},
  address   = {T{\"u}bingen},
  issn      = {1868-7067},
  doi       = {10.1628/002268811796448996},
  pages     = {734 -- 737},
  year      = {2011},
  language  = {de}
}