@article{PellegriniHowellShepherdetal.2013,
  author    = {Pellegrini, Paul A. and Howell, Nicholas R. and Shepherd, Rachael K. and Lengkeek, Nigel A. and Paulßen, Elisabeth and Katsifis, Andrew G. and Greguric, Ivan},
  title     = {Synthesis and Radiolabelling of DOTA-Linked Glutamine Analogues with 67,68Ga as Markers for Increased Glutamine Metabolism in Tumour Cells},
  series = {Molecules},
  volume    = {18},
  journal   = {Molecules},
  number    = {6},
  publisher = {MDPI},
  address   = {Basel},
  issn      = {1420-3049},
  doi       = {10.3390/molecules18067160},
  pages     = {7160 -- 7178},
  year      = {2013},
  language  = {en}
}
@article{PaulssenLeLengkeeketal.2013,
  author    = {Paulßen, Elisabeth and Le, Van So and Lengkeek, Nigel and Pellegrini, Paul and Jackson, Tim and Greguric, Ivan and Weiner, Ron},
  title     = {Influence of Metal Ions on the 68Ga-labeling of DOTATATE},
  series = {Applied Radiation and Isotopes},
  volume    = {82},
  journal   = {Applied Radiation and Isotopes},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1872-9800},
  doi       = {10.1016/j.apradiso.2013.08.010},
  pages     = {232 -- 238},
  year      = {2013},
  language  = {en}
}
@article{PaulssenLengkeekLeetal.2016,
  author    = {Paulßen, Elisabeth and Lengkeek, Nigel A. and Le, Van So and Pellegrini, Paul A. and Greguric, Ivan and Weiner, Ron},
  title     = {The role of additives in moderating the influence of Fe(III) and Cu(II) on the radiochemical yield of [⁶⁸Ga(DOTATATE)]},
  series = {Applied Radiation and Isotopes},
  volume    = {107},
  journal   = {Applied Radiation and Isotopes},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1872-9800},
  doi       = {10.1016/j.apradiso.2015.09.008},
  pages     = {13 -- 16},
  year      = {2016},
  abstract  = {[⁶⁸Ga(DOTATATE)] has demonstrated its clinical usefulness. Both Fe³⁺ and Cu²⁺, potential contaminants in Gallium-68 generator eluent, substantially reduce the radiochemical (RC) yield of [⁶⁸Ga(DOTATATE)] if the metal/ligand ratio of 1:1 is exceeded. A variety of compounds were examined for their potential ability to reduce this effect. Most had no effect on RC yield. However, addition of phosphate diminished the influence of Fe³⁺ by likely forming an insoluble iron salt. Addition of ascorbic acid reduced Cu²⁺ and Fe³⁺ to Cu⁺ and Fe²⁺ respectively, both of which have limited impact on RC yields. At low ligand amounts (5 nmol DOTATATE), the addition of 30 nmol phosphate (0.19 mM) increased the tolerance of Fe3⁺ from 4 nmol to 10 nmol (0.06 mM), while the addition of ascorbic acid allowed high RC yields (>95\%) in the presence of 40 nmol Fe³⁺ (0.25 mM) and 100 nmol Cu²⁺ (0.63 mM). The effect of ascorbic acid was highly pH-dependant, and gave optimal results at pH 3.},
  language  = {en}
}
@article{PaulssenHoehrHouetal.2015,
  author    = {Paulßen, Elisabeth and Hoehr, Cornelia and Hou, Xinchi and Hanemaayer, Victoire and Zeisler, Stefan and Adam, Michael J. and Ruth, Thomas J. and Celler, Anna and Buckley, Ken and Benard, Francois and Schaffer, Paul},
  title     = {Production of Y-86 and other radiometals for research purposes using a solution target system},
  series = {Nuclear medicine and biology},
  volume    = {42},
  journal   = {Nuclear medicine and biology},
  number    = {11},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1872-9614},
  doi       = {10.1016/j.nucmedbio.2015.06.005},
  pages     = {842 -- 849},
  year      = {2015},
  language  = {en}
}
@article{HoehrPaulssenBenardetal.2014,
  author    = {Hoehr, Cornelia and Paulßen, Elisabeth and Benard, Francois and Lee, Chris Jaeil and Hou, Xinchi and Badesso, Brian and Ferguson, Simon and Miao, Qing and Yang, Hua and Buckley, Ken and Hanemaayer, Victoire and Zeisler, Stefan and Ruth, Thomas and Celler, Anna and Schaffer, Paul},
  title     = {⁴⁴ᶢSc production using a water target on a 13 MeV cyclotron},
  series = {Nuclear medicine and biology},
  volume    = {41},
  journal   = {Nuclear medicine and biology},
  number    = {5},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1872-9614},
  doi       = {10.1016/j.nucmedbio.2013.12.016},
  pages     = {401 -- 406},
  year      = {2014},
  abstract  = {Access to promising radiometals as isotopes for novel molecular imaging agents requires that they are routinely available and inexpensive to obtain. Proximity to a cyclotron center outfitted with solid target hardware, or to an isotope generator for the metal of interest is necessary, both of which can introduce significant hurdles in development of less common isotopes. Herein, we describe the production of ⁴⁴Sc (t₁⸝₂ = 3.97 h, Eavg,β⁺ = 1.47 MeV, branching ratio = 94.27\%) in a solution target and an automated loading system which allows a quick turn-around between different radiometallic isotopes and therefore greatly improves their availability for tracer development. Experimental yields are compared to theoretical calculations.},
  language  = {en}
}
@article{InfantinoPaulssenMostaccietal.2016,
  author    = {Infantino, Angelo and Paulßen, Elisabeth and Mostacci, Domiziano and Schaffer, Paul and Trinczek, Michael and Hoehr, Cornelia},
  title     = {Assessment of the production of medical isotopes using the Monte Carlo code FLUKA: Simulations against experimental measurements},
  series = {Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms},
  volume    = {366},
  journal   = {Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1872-9584},
  doi       = {10.1016/j.nimb.2015.10.067},
  pages     = {117 -- 123},
  year      = {2016},
  abstract  = {The Monte Carlo code FLUKA is used to simulate the production of a number of positron emitting radionuclides, ¹⁸F, ¹³N, ⁹⁴Tc, ⁴⁴Sc, ⁶⁸Ga, ⁸⁶Y, ⁸⁹Zr, ⁵²Mn, ⁶¹Cu and ⁵⁵Co, on a small medical cyclotron with a proton beam energy of 13 MeV. Experimental data collected at the TR13 cyclotron at TRIUMF agree within a factor of 0.6 ± 0.4 with the directly simulated data, except for the production of ⁵⁵Co, where the simulation underestimates the experiment by a factor of 3.4 ± 0.4. The experimental data also agree within a factor of 0.8 ± 0.6 with the convolution of simulated proton fluence and cross sections from literature. Overall, this confirms the applicability of FLUKA to simulate radionuclide production at 13 MeV proton beam energy.},
  language  = {en}
}
@article{LiuSchaapBallemansetal.2017,
  author    = {Liu, Z. and Schaap, K. S. and Ballemans, L. and de Blois, E. and Rohde, M. and Paulßen, Elisabeth},
  title     = {Measurement of reaction kinetics of [177Lu]Lu-DOTA-TATE using a microfluidic system},
  series = {Dalton Transactions},
  volume    = {46},
  journal   = {Dalton Transactions},
  number    = {42},
  issn      = {1477-9234},
  doi       = {10.1039/C7DT01830D},
  pages     = {14669 -- 14676},
  year      = {2017},
  language  = {en}
}
@article{RauppSchmittWalzetal.2018,
  author    = {Raupp, Sebastian M. and Schmitt, Marcel and Walz, Anna-Lena and Diehm, Ralf and Hummel, Helga and Scharfer, Philip and Schabel, Wilhelm},
  title     = {Slot die stripe coating of low viscous fluids},
  series = {Journal of Coatings Technology and Research},
  volume    = {15},
  journal   = {Journal of Coatings Technology and Research},
  number    = {5},
  publisher = {Springer},
  issn      = {1935-3804},
  doi       = {10.1007/s11998-017-0039-y},
  pages     = {899 -- 911},
  year      = {2018},
  abstract  = {Slot die coating is applied to deposit thin and homogenous films in roll-to-roll and sheet-to-sheet applications. The critical step in operation is to choose suitable process parameters within the process window. In this work, we investigate an upper limit for stripe coatings. This maximum film thickness is characterized by stripe merging which needs to be avoided in a stable process. It is shown that the upper limit reduces the process window for stripe coatings to a major extent. As a result, stripe coatings at large coating gaps and low viscosities are only possible for relatively thick films. Explaining the upper limit, a theory of balancing the side pressure in the gap region in the cross-web direction has been developed.},
  language  = {en}
}
@article{Delaittre2019,
  author    = {Delaittre, Guillaume},
  title     = {Telechelic Poly(2-Oxazoline)s},
  series = {European Polymer Journal},
  journal   = {European Polymer Journal},
  number    = {In Press, Journal Pre-proof, 109281},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {0014-3057},
  doi       = {10.1016/j.eurpolymj.2019.109281},
  year      = {2019},
  language  = {en}
}
@article{CapitainWagnerHummeletal.2021,
  author    = {Capitain, Charlotte and Wagner, Sebastian and Hummel, Joana and Tippk{\"o}tter, Nils},
  title     = {Investigation of C-N Formation Between Catechols and Chitosan for the Formation of a Strong, Novel Adhesive Mimicking Mussel Adhesion},
  series = {Waste and Biomass Valorization},
  volume    = {12},
  journal   = {Waste and Biomass Valorization},
  publisher = {Springer Nature},
  address   = {Cham},
  issn      = {1877-265X},
  doi       = {10.1007/s12649-020-01110-5},
  pages     = {1761 -- 1779},
  year      = {2021},
  language  = {en}
}