@article{BungErpicumTullis2020,
  author    = {Bung, Daniel Bernhard and Erpicum, S{\´e}bastien and Tullis, Blanke P.},
  title     = {Advances in hydraulic structures engineering},
  series = {Journal of Hydraulic Engineering},
  volume    = {147},
  journal   = {Journal of Hydraulic Engineering},
  number    = {1},
  publisher = {ASCE},
  address   = {Reston, Va.},
  issn      = {0733-9429 (Druckausgabe)},
  doi       = {10.1061/(ASCE)HY.1943-7900.0001851},
  pages     = {1 Seite},
  year      = {2020},
  language  = {en}
}
@article{ValeroChansonBung2019,
  author    = {Valero, Daniel and Chanson, Hubert and Bung, Daniel Bernhard},
  title     = {Robust estimators for turbulence properties assessment},
  pages     = {1 -- 24},
  year      = {2019},
  language  = {en}
}
@article{HagenkampBlankeDoering2021,
  author    = {Hagenkamp, Markus and Blanke, Tobias and D{\"o}ring, Bernd},
  title     = {Thermoelectric building temperature control: a potential assessment},
  series = {International Journal of Energy and Environmental Engineering},
  volume    = {13},
  journal   = {International Journal of Energy and Environmental Engineering},
  publisher = {Springer},
  address   = {Berlin},
  doi       = {10.1007/s40095-021-00424-x},
  pages     = {241 -- 254},
  year      = {2021},
  abstract  = {This study focuses on thermoelectric elements (TEE) as an alternative for room temperature control. TEE are semi-conductor devices that can provide heating and cooling via a heat pump effect without direct noise emissions and no refrigerant use. An efficiency evaluation of the optimal operating mode is carried out for different numbers of TEE, ambient temperatures, and heating loads. The influence of an additional heat recovery unit on system efficiency and an unevenly distributed heating demand are examined. The results show that TEE can provide heat at a coefficient of performance (COP) greater than one especially for small heating demands and high ambient temperatures. The efficiency increases with the number of elements in the system and is subject to economies of scale. The best COP exceeds six at optimal operating conditions. An additional heat recovery unit proves beneficial for low ambient temperatures and systems with few TEE. It makes COPs above one possible at ambient temperatures below 0 ∘C. The effect increases efficiency by maximal 0.81 (from 1.90 to 2.71) at ambient temperature 5 K below room temperature and heating demand Q˙h=100W but is subject to diseconomies of scale. Thermoelectric technology is a valuable option for electricity-based heat supply and can provide cooling and ventilation functions. A careful system design as well as an additional heat recovery unit significantly benefits the performance. This makes TEE superior to direct current heating systems and competitive to heat pumps for small scale applications with focus on avoiding noise and harmful refrigerants.},
  language  = {en}
}
@article{KerpenBungValeroetal.2017,
  author    = {Kerpen, Nils B. and Bung, Daniel Bernhard and Valero, Daniel and Schlurmann, Torsten},
  title     = {Energy dissipation within the wave run-up at stepped revetments},
  series = {Journal of Ocean University of China},
  volume    = {16},
  journal   = {Journal of Ocean University of China},
  number    = {4},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1993-5021},
  doi       = {10.1007/s11802-017-3355-z},
  pages     = {649 -- 654},
  year      = {2017},
  language  = {en}
}
@article{ValeroBung2016,
  author    = {Valero, Daniel and Bung, Daniel Bernhard},
  title     = {Development of the interfacial air layer in the non-aerated region of high-velocity spillway flows: Instabilities growth, entrapped air and influence on the self-aeration onset},
  series = {International Journal of Multiphase Flow},
  volume    = {84},
  journal   = {International Journal of Multiphase Flow},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {0301-9322},
  doi       = {10.1016/j.ijmultiphaseflow.2016.04.012},
  pages     = {66 -- 74},
  year      = {2016},
  abstract  = {Self-aeration is traditionally explained by the water turbulent boundary layer outer edge intersection with the free surface. This paper presents a discussion on the commonly accepted hypothesis behind the computation of the critical point of self-aeration in spillway flows and a new formulation is proposed based on the existence of a developing air flow over the free surface. Upstream of the inception point of self-aeration, some surface roughening has been often reported in previous studies which consequently implies some entrapped air transport and air-water flows coupling. Such air flow is proven in this study by presenting measured air velocities and computing the air boundary layer thickness for a 1V:2H smooth chute flow. Additionally, the growth rate of free surface waves has been analysed by means of Ultrasonic Sensors measurements, obtaining also the entrapped air concentration. High-speed camera imaging has been used for qualitative study of the flow perturbations.},
  language  = {en}
}
@article{Bung2013,
  author    = {Bung, Daniel Bernhard},
  title     = {Non-intrusive detection of air-water surface roughness in self-aerated chute flows},
  series = {Journal of hydraulic research},
  volume    = {Vol. 51},
  journal   = {Journal of hydraulic research},
  number    = {Iss. 3},
  publisher = {Taylor \& Francis},
  address   = {London},
  issn      = {1814-2079 (E-Journal); 0022-1686 (Print)},
  pages     = {322 -- 329},
  year      = {2013},
  language  = {en}
}
@article{Bung2021,
  author    = {Bung, Daniel Bernhard},
  title     = {Extreme flooding in Western Germany: some thoughts on hazards, return periods and risk},
  series = {Hydrolink},
  journal   = {Hydrolink},
  number    = {4},
  publisher = {International Association for Hydro-Environment Engineering and Research (IAHR)},
  address   = {Madrid},
  pages     = {108 -- 113},
  year      = {2021},
  abstract  = {The low-pressure system Bernd involved extreme rainfalls in the Western part of Germany in July 2021, resulting in major floods, severe damages and a tremendous number of casualties. Such extreme events are rare and full flood protection can never be ensured with reasonable financial means. But still, this event must be starting point to reconsider current design concepts. This article aims at sharing some thoughts on potential hazards, the selection of return periods and remaining risk with the focus on Germany.},
  language  = {en}
}
@article{Bung2011,
  author    = {Bung, Daniel Bernhard},
  title     = {Developing flow in skimming flow regime on embankment stepped spillways},
  series = {Journal of hydraulic research},
  volume    = {Vol. 49},
  journal   = {Journal of hydraulic research},
  number    = {Iss. 5},
  publisher = {Taylor \& Francis},
  address   = {London},
  issn      = {1814-2079 (E-Journal); 0022-1686 (Print)},
  pages     = {639 -- 648},
  year      = {2011},
  language  = {en}
}
@article{WoliszSchuetzBlankeetal.2017,
  author    = {Wolisz, Henryk and Sch{\"u}tz, Thomas and Blanke, Tobias and Hagenkamp, Markus and Kohrn, Markus and Wesseling, Mark and M{\"u}ller, Dirk},
  title     = {Cost optimal sizing of smart buildings' energy system components considering changing end-consumer electricity markets},
  series = {Energy},
  volume    = {137},
  journal   = {Energy},
  publisher = {Elsevier},
  address   = {Amsterdam},
  doi       = {10.1016/j.energy.2017.06.025},
  pages     = {715 -- 728},
  year      = {2017},
  language  = {en}
}
@article{BlankeHagenkampDoeringetal.2021,
  author    = {Blanke, Tobias and Hagenkamp, Markus and D{\"o}ring, Bernd and G{\"o}ttsche, Joachim and Reger, Vitali and Kuhnhenne, Markus},
  title     = {Net-exergetic, hydraulic and thermal optimization of coaxial heat exchangers using fixed flow conditions instead of fixed flow rates},
  series = {Geothermal Energy},
  volume    = {9},
  journal   = {Geothermal Energy},
  number    = {Article number: 19},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {2195-9706},
  doi       = {10.1186/s40517-021-00201-3},
  pages     = {23 Seiten},
  year      = {2021},
  abstract  = {Previous studies optimized the dimensions of coaxial heat exchangers using constant mass fow rates as a boundary condition. They show a thermal optimal circular ring width of nearly zero. Hydraulically optimal is an inner to outer pipe radius ratio of 0.65 for turbulent and 0.68 for laminar fow types. In contrast, in this study, fow conditions in the circular ring are kept constant (a set of fxed Reynolds numbers) during optimization. This approach ensures fxed fow conditions and prevents inappropriately high or low mass fow rates. The optimization is carried out for three objectives: Maximum energy gain, minimum hydraulic efort and eventually optimum net-exergy balance. The optimization changes the inner pipe radius and mass fow rate but not the Reynolds number of the circular ring. The thermal calculations base on Hellstr{\"o}m's borehole resistance and the hydraulic optimization on individually calculated linear loss of head coefcients. Increasing the inner pipe radius results in decreased hydraulic losses in the inner pipe but increased losses in the circular ring. The net-exergy diference is a key performance indicator and combines thermal and hydraulic calculations. It is the difference between thermal exergy fux and hydraulic efort. The Reynolds number in the circular ring is instead of the mass fow rate constant during all optimizations. The result from a thermal perspective is an optimal width of the circular ring of nearly zero. The hydraulically optimal inner pipe radius is 54\% of the outer pipe radius for laminar fow and 60\% for turbulent fow scenarios. Net-exergetic optimization shows a predominant infuence of hydraulic losses, especially for small temperature gains. The exact result depends on the earth's thermal properties and the fow type. Conclusively, coaxial geothermal probes' design should focus on the hydraulic optimum and take the thermal optimum as a secondary criterion due to the dominating hydraulics.},
  language  = {en}
}