@book{Hoever2014,
  author    = {Hoever, Georg},
  title     = {Vorkurs Mathematik : Theorie und Aufgaben mit vollst{\"a}ndig durchgerechneten L{\"o}sungen. - (Springer-Lehrbuch)},
  publisher = {Springer Spektrum},
  address   = {Berlin [u.a.]},
  isbn      = {978-3-642-54870-3 (Druckausg.)},
  pages     = {X, 292 S. : graph. Darst.},
  year      = {2014},
  language  = {de}
}
@article{HoltrupSadeghfamHeuermannetal.2014,
  author    = {Holtrup, S. and Sadeghfam, Arash and Heuermann, Holger and Awakowicz, P.},
  title     = {Characterization and optimization technique for microwave-driven high-intensity discharge lamps using hot S-parameters},
  series = {IEEE transactions on microwave theories and techniques},
  volume    = {62},
  journal   = {IEEE transactions on microwave theories and techniques},
  number    = {10},
  publisher = {IEEE},
  address   = {New York},
  issn      = {0018-9480},
  doi       = {10.1109/TMTT.2014.2342652},
  pages     = {2471 -- 2480},
  year      = {2014},
  abstract  = {High-intensity discharge lamps can be driven by radio-frequency signals in the ISM frequency band at 2.45 GHz, using a matching network to transform the impedance of the plasma to the source impedance. To achieve an optimal operating condition, a good characterization of the lamp in terms of radio frequency equivalent circuits under operating conditions is necessary, enabling the design of an efficient matching network. This paper presents the characterization technique for such lamps and presents the design of the required matching network. For the characterization, a high-intensity discharge lamp was driven by a monofrequent large signal at 2.45 GHz, whereas a frequency sweep over 300 MHz was performed across this signal to measure so-called small-signal hot S-parameters using a vector network analyzer. These parameters are then used as an equivalent load in a circuit simulator to design an appropriate matching network. Using the measured data as a black-box model in the simulation results in a quick and efficient method to simulate and design efficient matching networks in spite of the complex plasma behavior. Furthermore, photometric analysis of high-intensity discharge lamps are carried out, comparing microwave operation to conventional operation.},
  language  = {en}
}
@article{HuberStreblowMuelleretal.2014,
  author    = {Huber, M. and Streblow, R. and M{\"u}ller, D. and Lange, S. and Joneleit, R. and Sefker, T. and Rau, Sebastian and Wollert, J{\"o}rg},
  title     = {Funksignal{\"u}bertragung in Luftleitungen},
  series = {HLH : L{\"u}ftung, Klima, Heizung, Sanit{\"a}r, Geb{\"a}udetechnik},
  volume    = {Bd. 65},
  journal   = {HLH : L{\"u}ftung, Klima, Heizung, Sanit{\"a}r, Geb{\"a}udetechnik},
  number    = {H. 7/8},
  issn      = {1436-5103},
  pages     = {36 -- 40},
  year      = {2014},
  language  = {de}
}
@inproceedings{HuckPoghossianBuniatyanetal.2014,
  author    = {Huck, Christina and Poghossian, Arshak and Buniatyan, V. and Sch{\"o}ning, Michael Josef},
  title     = {Multi-parameter detection for supporting monitoring and control of biogas processes in agriculture},
  series = {Sensoren und Messsysteme 2014 ; Beitr{\"a}ge der 17. GMA/ITG-Fachtagung vom 3. bis 4. Juni 2014 in N{\"u}rnberg. (ITG-Fachbericht ; 250)},
  booktitle = {Sensoren und Messsysteme 2014 ; Beitr{\"a}ge der 17. GMA/ITG-Fachtagung vom 3. bis 4. Juni 2014 in N{\"u}rnberg. (ITG-Fachbericht ; 250)},
  publisher = {VDE-Verl.},
  address   = {Berlin},
  organization    = {VDI/VDE-Gesellschaft Mess- und Automatisierungstechnik},
  isbn      = {978-3-8007-3622-5},
  pages     = {1 -- 5},
  year      = {2014},
  language  = {en}
}
@article{HuckPoghossianBaeckeretal.2014,
  author    = {Huck, Christina and Poghossian, Arshak and B{\"a}cker, Matthias and Chaudhuri, S. and Zander, W. and Schubert, J. and Begoyan, V. K. and Buniatyan, V. V. and Wagner, P. and Sch{\"o}ning, Michael Josef},
  title     = {Capacitively coupled electrolyte-conductivity sensor based on high-k material of barium strontium titanate},
  series = {Sensors and actuators. B: Chemical},
  journal   = {Sensors and actuators. B: Chemical},
  number    = {198},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1873-3077 (E-Journal); 0925-4005 (Print)},
  doi       = {10.1016/j.snb.2014.02.103},
  pages     = {102 -- 109},
  year      = {2014},
  language  = {en}
}
@article{HuckPoghossianBaeckeretal.2014,
  author    = {Huck, Christina and Poghossian, Arshak and B{\"a}cker, Matthias and Reisert, Steffen and Schubert, J. and Zander, W. and Begoyan, V. K. and Buniatyan, V. V. and Sch{\"o}ning, Michael Josef},
  title     = {Chemical sensors based on a high-k perovskite oxide of barium strontium titanate},
  series = {Procedia Engineering},
  volume    = {87},
  journal   = {Procedia Engineering},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1877-7058},
  doi       = {10.1016/j.proeng.2014.11.258},
  pages     = {28 -- 31},
  year      = {2014},
  abstract  = {High-k perovskite oxide of barium strontium titanate (BST) represents a very attractive multi-functional transducer material for the development of (bio-)chemical sensors for liquids. In this work, BST films have been applied as a sensitive transducer material for a label-free detection of adsorbed charged macromolecules (positively charged polyelectrolytes) and concentration of hydrogen peroxide vapor as well as protection insulator layer for a contactless electrolyte-conductivity sensor. The experimental results of characterization of individual sensors are presented. Special emphasis is devoted towards the development of a capacitively-coupled contactless electrolyte-conductivity sensor.},
  language  = {en}
}
@article{HuckPoghossianKerroumietal.2014,
  author    = {Huck, Christina and Poghossian, Arshak and Kerroumi, Iman and Schusser, Sebastian and B{\"a}cker, Matthias and Zander, Willi and Schubert, J{\"u}rgen and Buniatyan, Vahe V. and Martirosyan, Norayr W. and Wagner, Patrick and Sch{\"o}ning, Michael Josef},
  title     = {Multiparameter sensor chip with Barium Strontium Titanate as multipurpose material},
  series = {Electroanalysis},
  volume    = {26},
  journal   = {Electroanalysis},
  number    = {5},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {1521-4109 (E-Journal); 1040-0397 (Print)},
  doi       = {10.1002/elan.201400076},
  pages     = {980 -- 987},
  year      = {2014},
  abstract  = {It is well known that biochemical and biotechnological processes are strongly dependent and affected by a variety of physico-chemical parameters such as pH value, temperature, pressure and electrolyte conductivity. Therefore, these quantities have to be monitored or controlled in order to guarantee a stable process operation, optimization and high yield. In this work, a sensor chip for the multiparameter detection of three physico-chemical parameters such as electrolyte conductivity, pH and temperature is realized using barium strontium titanate (BST) as multipurpose material. The chip integrates a capacitively coupled four-electrode electrolyte-conductivity sensor, a capacitive field-effect pH sensor and a thin-film Pt-temperature sensor. Due to the multifunctional properties of BST, it is utilized as final outermost coating layer of the processed sensor chip and serves as passivation and protection layer as well as pH-sensitive transducer material at the same time. The results of testing of the individual sensors of the developed multiparameter sensor chip are presented. In addition, a quasi-simultaneous multiparameter characterization of the sensor chip in buffer solutions with different pH value and electrolyte conductivity is performed. To study the sensor behavior and the suitability of BST as multifunctional material under harsh environmental conditions, the sensor chip was exemplarily tested in a biogas digestate.},
  language  = {en}
}
@inproceedings{HoettgesMueller2014,
  author    = {H{\"o}ttges, J{\"o}rg and M{\"u}ller, Andreas},
  title     = {Einsatz von GIS und CAD zur Schaffung langfristig nutzbarer Planungsdaten},
  series = {15. K{\"o}lner Kanal- und Kl{\"a}ranlagen-Kolloquium : 1. und 2. Oktober 2014 im Maternushaus, K{\"o}ln / ISA, Inst. und Lehrstuhl f{\"u}r Siedlungswasserwirtschaft und Siedlungsabfallwirtschaft der RWTH Aachen ... Hrsg. von J. Pinnekamp. Bearb. von V. K{\"o}lling},
  booktitle = {15. K{\"o}lner Kanal- und Kl{\"a}ranlagen-Kolloquium : 1. und 2. Oktober 2014 im Maternushaus, K{\"o}ln / ISA, Inst. und Lehrstuhl f{\"u}r Siedlungswasserwirtschaft und Siedlungsabfallwirtschaft der RWTH Aachen ... Hrsg. von J. Pinnekamp. Bearb. von V. K{\"o}lling},
  publisher = {Ges. zur F{\"o}rderung der Siedlungswasserwirtschaft an der RWTH Aachen},
  address   = {Aachen},
  organization    = {FH Aachen, University of Applied Sciences},
  isbn      = {978-3-938996-74-4},
  pages     = {12/1 -- 12/12},
  year      = {2014},
  language  = {de}
}
@book{Huening2014,
  author    = {H{\"u}ning, Felix},
  title     = {The fundamentals of electrical engineering for mechatronics},
  publisher = {de Gruyter},
  address   = {Berlin},
  isbn      = {978-3-11-034991-7 (Druckausg.)},
  pages     = {IX, 208 S.},
  year      = {2014},
  language  = {en}
}
@inproceedings{Huening2014,
  author    = {H{\"u}ning, Felix},
  title     = {Power semiconductors : key components for HEV/EV},
  series = {FISITA 2014 World Automotive Congress : 2 - 6 June, Maastricht, the Netherlands International Federation of Automotive Engineering Societies},
  booktitle = {FISITA 2014 World Automotive Congress : 2 - 6 June, Maastricht, the Netherlands International Federation of Automotive Engineering Societies},
  publisher = {KIVI},
  address   = {[s.l.]},
  pages     = {1 USB-Speicherstick},
  year      = {2014},
  language  = {en}
}