@article{BragardBragard2003,
  author    = {Bragard, Michael and Bragard, G.},
  title     = {Erweiterungen f{\"u}r das CBL2-Messinterface von Texas-Instruments},
  series = {Der mathematische und naturwissenschaftliche Unterricht : MNU ; Organ des Deutschen Vereins zur F{\"o}rderung des Mathematischen und Naturwissenschaftlichen Unterrichts e.V.},
  volume    = {56},
  journal   = {Der mathematische und naturwissenschaftliche Unterricht : MNU ; Organ des Deutschen Vereins zur F{\"o}rderung des Mathematischen und Naturwissenschaftlichen Unterrichts e.V.},
  number    = {2},
  publisher = {Seeberger},
  address   = {Neuss},
  issn      = {0025-5866},
  pages     = {87 -- 88},
  year      = {2003},
  abstract  = {Das von Texas-Instruments (TI) vertriebene Interface CBL2 wird {\"u}ber einige TI-Grafik-Rechner (TI-92, TI-89 usw.) angesteuert. Wegen seiner Handlichkeit wird dieses System beim Unterricht in wechselnden R{\"a}umen »großen« Messwerterfassungssystemen oft vorgezogen. Das CBL2 bietet drei analoge Eing{\"a}nge, die immerhin mit 10 Bit Aufl{\"o}sung und bis zu einer Frequenz von 50 kHz arbeiten. Weiterhin besitzt das CBL2 eine Buchse f{\"u}r angeblich nur einen digitalen Ein- bzw. Ausgang. An diesem Eingang wird standardm{\"a}ßig haupts{\"a}chlich der Bewegungssensor CBR betrieben. In diesem Beitrag werden Erweiterungsm{\"o}glichkeiten dieses Anschlusses beschrieben.},
  language  = {de}
}
@phdthesis{Bragard2012,
  author    = {Bragard, Michael},
  title     = {The integrated emitter turn-off thyristor : an innovative MOS-gated high-power device. - (Aachener Beitr{\"a}ge des ISEA ; 62)},
  publisher = {Shaker},
  address   = {Aachen},
  isbn      = {978-3-8440-1152-4},
  pages     = {III, 164 S. : Ill., graph. Darst.},
  year      = {2012},
  abstract  = {This thesis introduces the Integrated Emitter Turn-Off (IETO) Thyristor as a new high-power device. Known state-of-the-art research activities like the Dual GCT, the ETO thyristor and the ICT were presented and critically reviewed. A comparison with commercialized solutions identifies the pros and cons of each type of device family. Based on this analysis, the IETO structure is proposed, covering most benefits of each device class. In particular the combination of a MOS-assisted turn-off with a thyristor-based device allows a voltage-controlled MOS switching and the low on-state voltage of the thyristors. The following synthesis of an IETO device stands on a three-dimensional field of optimization spanned by electric, mechanical and thermal aspects. From an electric point of view, the lowest possible parasitic inductance and resistance within the commutation path are optimization criteria. The mechanical construction has to withstand the required contact pressure of multiple kilo Newtons. Finally, thermal borders limit the maximum average current of the device. FEM simulations covering these three aspects are performed for several design proposals. An IETO prototype is constructed and measurements on various test benches attest thermal, mechanical and electric performance. A local decoupling of the external driver stage and the presspack housing is presented by a cable connection. This separation enables a thermal and mechanical independence, which is advantageous in terms of vibrations and thermal cycles including increased reliability. The electric pulse performance of the prototype device is a factor of 3.1 above today''s solutions. In single-pulse measurements, a current up to 1600 A was successfully turned off at 115°C with an active silicon area of 823 mm². One reason for this increased turn-off capability is the extremely low-inductive construction. Additional functionality of the IETO thyristor like over-current self-protection and defined short-circuit failure state are successfully verified.},
  language  = {en}
}
@inproceedings{BragardKoellenspergerDeDoncker2007,
  author    = {Bragard, Michael and K{\"o}llensperger, P. and De Doncker, R. W.},
  title     = {Der Internally Commutated Thyristor (ICT) : ein neuartiger GCT mit integrierter Ausschalteinheit},
  series = {"Nowoczesne urządzenia zasilające w energetyce" : X międzynarodowa konferencja naukowo techniczna, Zakopane, 14-16 marca 2007 r. : materiały konferencyjne},
  booktitle = {"Nowoczesne urządzenia zasilające w energetyce" : X międzynarodowa konferencja naukowo techniczna, Zakopane, 14-16 marca 2007 r. : materiały konferencyjne},
  editor    = {Dmowski, Antoni},
  publisher = {APS Energia},
  address   = {Warszawa},
  isbn      = {83-918709-7-9},
  pages     = {7.1 -- 7.9},
  year      = {2007},
  language  = {de}
}
@book{Muehl2014,
  author    = {M{\"u}hl, Thomas},
  title     = {Einf{\"u}hrung in die elektrische Messtechnik : Grundlagen, Messverfahren, Anwendungen. - 4. aktualisierte u. erw. Aufl.},
  edition   = {4., aktualisierte u. erw. Aufl.},
  publisher = {Springer},
  address   = {Wiesbaden},
  isbn      = {978-3-8348-2063-1 ; 978-3-8348-0899-8},
  pages     = {XI, 320 S.},
  year      = {2014},
  language  = {de}
}
@inproceedings{NoetzoldUphuesWegeneretal.2013,
  author    = {N{\"o}tzold, K. and Uphues, A. and Wegener, R. and Fink, K. and Bragard, Michael and Griessel, R. and Soter, S.},
  title     = {Inverter based test setup for LVRT verification of a full-scale 2 MW wind power converter},
  series = {15th European Conference on Power Electronics and Applications (EPE), 2013 : 2 - 6 Sept. 2013, Lille, France / [EPE Association; PELS, IEEE Power Electronics Society]},
  booktitle = {15th European Conference on Power Electronics and Applications (EPE), 2013 : 2 - 6 Sept. 2013, Lille, France / [EPE Association; PELS, IEEE Power Electronics Society]},
  publisher = {IEEE},
  address   = {Piscataway, NJ},
  isbn      = {978-1-4799-0115-9 (Online-Ausg.)},
  doi       = {10.1109/EPE.2013.6634752},
  pages     = {1037 -- 1042},
  year      = {2013},
  language  = {en}
}
@inproceedings{NoetzoldUphuesWegeneretal.2012,
  author    = {N{\"o}tzold, K. and Uphues, A. and Wegener, R. and Soter, S. and Fink, K. and Bragard, Michael and Griessel, R.},
  title     = {Inverter based test setup for LVRT verification of a full-scale 2 MW wind power converter},
  series = {EPE Joint Wind Energy and T\&D Chapters Seminar : 28th and 29th of June 2012, in the Utzon Centre, Aalborg, Denmark ; papers, posters, presentations. - Session 2: Grid connection, compliance},
  booktitle = {EPE Joint Wind Energy and T\&D Chapters Seminar : 28th and 29th of June 2012, in the Utzon Centre, Aalborg, Denmark ; papers, posters, presentations. - Session 2: Grid connection, compliance},
  publisher = {EPE Association},
  address   = {Brussels},
  year      = {2012},
  language  = {en}
}
@inproceedings{KoellenspergerBragardPlumetal.2007,
  author    = {K{\"o}llensperger, P. and Bragard, Michael and Plum, T. and De Doncker, R. W.},
  title     = {The dual GCT : a new high-power device using optimized GCT technology},
  series = {Conference record of the 2007 IEEE Industry Applications Conference : 42. IAS annual meeting ; September 23 - 27, 2007, New Orleans, Louisiana, USA},
  booktitle = {Conference record of the 2007 IEEE Industry Applications Conference : 42. IAS annual meeting ; September 23 - 27, 2007, New Orleans, Louisiana, USA},
  publisher = {IEEE Operations Center},
  address   = {Piscataway, NJ},
  isbn      = {978-1-4244-1260-0 (Online)},
  doi       = {10.1109/07IAS.2007.76},
  pages     = {358 -- 365},
  year      = {2007},
  language  = {en}
}
@article{KoellenspergerBragardPlumetal.2009,
  author    = {K{\"o}llensperger, P. and Bragard, Michael and Plum, T. and De Doncker, R. W.},
  title     = {The dual GCT : new high-power device using optimized GCT technology},
  series = {IEEE transactions on industry applications},
  volume    = {45},
  journal   = {IEEE transactions on industry applications},
  number    = {5},
  issn      = {0093-9994},
  doi       = {10.1109/TIA.2009.2027364},
  pages     = {1754 -- 1762},
  year      = {2009},
  language  = {en}
}
@inproceedings{BragardSoltauDeDonckeretal.2010,
  author    = {Bragard, Michael and Soltau, N. and De Doncker, R. W. and Schmiegel, A.},
  title     = {Design and implementation of a 5 kW photovoltaic system with li-ion battery and additional DC-DC converter},
  series = {2010 IEEE Energy Conversion Congress and Exposition (ECCE 2010) : Atlanta, Georgia, USA, 12 - 16 September 2010 / [sponsored by the IEEE Power Electronics and Industry Applications Societies]},
  booktitle = {2010 IEEE Energy Conversion Congress and Exposition (ECCE 2010) : Atlanta, Georgia, USA, 12 - 16 September 2010 / [sponsored by the IEEE Power Electronics and Industry Applications Societies]},
  publisher = {IEEE},
  address   = {Piscataway, NJ},
  isbn      = {978-1-4244-5286-6 (Print)},
  doi       = {10.1109/ECCE.2010.5618220},
  pages     = {2944 -- 2949},
  year      = {2010},
  language  = {en}
}
@inproceedings{BragardConradDeDoncker2010,
  author    = {Bragard, Michael and Conrad, M. and De Doncker, R. W.},
  title     = {The integrated emitter turn-off thyristor (IETO) : an innovative thyristor based high power semiconductor device using MOS assisted turn-off},
  series = {2010 IEEE Energy Conversion Congress and Exposition (ECCE 2010) : Atlanta, Georgia, USA, 12 - 16 September 2010 / [sponsored by the IEEE Power Electronics and Industry Applications Societies]},
  booktitle = {2010 IEEE Energy Conversion Congress and Exposition (ECCE 2010) : Atlanta, Georgia, USA, 12 - 16 September 2010 / [sponsored by the IEEE Power Electronics and Industry Applications Societies]},
  publisher = {IEEE},
  address   = {Piscataway, NJ},
  isbn      = {978-1-4244-5286-6 (Print)},
  doi       = {10.1109/ECCE.2010.5618410},
  pages     = {4551 -- 4557},
  year      = {2010},
  language  = {en}
}