@article{HennemannKohlReisertetal.2013,
  author    = {Hennemann, J{\"o}rg and Kohl, Claus-Dieter and Reisert, Steffen and Kirchner, Patrick and Sch{\"o}ning, Michael Josef},
  title     = {Copper oxide nanofibres for detection of hydrogen peroxide vapour at high concentrations},
  series = {physica status solidi (a)},
  volume    = {210},
  journal   = {physica status solidi (a)},
  number    = {5},
  publisher = {Wiley},
  address   = {Weinheim},
  issn      = {1862-6319},
  doi       = {10.1002/pssa.201200775},
  pages     = {859 -- 863},
  year      = {2013},
  abstract  = {We present a sensor concept based on copper(II)oxide (CuO) nanofibres for the detection of hydrogen peroxide (H2O2) vapour in the percent per volume (\% v/v) range. The fibres were produced by using the electrospinning technique. To avoid water condensation in the pores, the fibres were initially modified by an exposure to H2S to get an enclosed surface. By a thermal treatment at 350 °C the fibres were oxidised back to CuO. Thereby, the visible pores disappear which was verified by SEM analysis. The fibres show a decrease of resistance with increasing H2O2 concentration which is due to the fact that hydrogen peroxide is an oxidising gas and CuO a p-type semiconductor. The sensor shows a change of resistance within the minute range to the exposure until the maximum concentration of 6.9\% v/v H2O2. At operating temperatures below 450 °C the corresponding sensor response to a concentration of 4.1\% v/v increases. The sensor shows a good reproducibility of the signal at different measurements. CuO seems to be a suitable candidate for the detection of H2O2 vapour at high concentrations. Resistance behaviour of the sensor under exposure to H2O2 vapours between 2.3 and 6.9\% v/v at an operating temperature of 450 °C.},
  language  = {en}
}
@article{SchusserMenzelBaeckeretal.2013,
  author    = {Schusser, Sebastian and Menzel, S. and B{\"a}cker, Matthias and Leinhos, Marcel and Poghossian, Arshak and Wagner, P. and Sch{\"o}ning, Michael Josef},
  title     = {Degradation of thin poly(lactic acid) films: characterization by capacitance-voltage, atomic force microscopy, scanning electron microscopy and contact-angle measurements},
  series = {Electrochimica Acta},
  volume    = {Vol. 113},
  journal   = {Electrochimica Acta},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1873-3859 (E-Journal); 0013-4686 (Print)},
  pages     = {779 -- 784},
  year      = {2013},
  language  = {en}
}
@article{BaeckerSchusserPoghossianetal.2013,
  author    = {B{\"a}cker, Matthias and Schusser, Sebastian and Poghossian, Arshak and Sch{\"o}ning, Michael Josef},
  title     = {Degradationsverhalten bioabbaubarer Polymere : siliziumbasierte Sensorik zur {\"U}berwachung},
  series = {GIT Labor-Fachzeitschrift},
  journal   = {GIT Labor-Fachzeitschrift},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {0016-3538},
  pages     = {32 -- 33},
  year      = {2013},
  language  = {de}
}
@inproceedings{TakenagaHerreraWerneretal.2013,
  author    = {Takenaga, Shoko and Herrera, Cony F. and Werner, Frederik and Biselli, Manfred and Schnitzler, Thomas and Sch{\"o}ning, Michael Josef and {\"O}hlschl{\"a}ger, Peter and Wagner, Torsten},
  title     = {Detection of the metabolic activity of cells by differential measurements based on a single light-addressable potentiometric sensor chip},
  series = {11. Dresdner Sensor-Symposium : 9.-11.12.2013},
  booktitle = {11. Dresdner Sensor-Symposium : 9.-11.12.2013},
  organization    = {Dresdner Sensor-Symposium <11, 2013>},
  isbn      = {978-3-9813484-5-3},
  pages     = {63 -- 67},
  year      = {2013},
  language  = {en}
}
@article{IkenAhlbornGerlachetal.2013,
  author    = {Iken, Heiko and Ahlborn, K. and Gerlach, F. and Vonau, W. and Zander, W. and Schubert, J. and Sch{\"o}ning, Michael Josef},
  title     = {Development of redox glasses and subsequent processing by means of pulsed laser deposition for realizing silicon-based thin-film sensors},
  series = {Electrochimica acta},
  journal   = {Electrochimica acta},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1873-3859 (E-Journal); 0013-4686 (Print)},
  pages     = {Available online 30.8.2013},
  year      = {2013},
  language  = {en}
}
@article{PoghossianWeilCherstvyetal.2013,
  author    = {Poghossian, Arshak and Weil, M. and Cherstvy, A. G. and Sch{\"o}ning, Michael Josef},
  title     = {Electrical monitoring of polyelectrolyte multilayer formation by means of capacitive field-effect devices},
  series = {Analytical and bioanalytical chemistry},
  volume    = {405},
  journal   = {Analytical and bioanalytical chemistry},
  number    = {20},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1432-1130 ; 1618-2642},
  doi       = {10.1007/s00216-013-6951-9},
  pages     = {6425 -- 6436},
  year      = {2013},
  abstract  = {The semiconductor field-effect platform represents a powerful tool for detecting the adsorption and binding of charged macromolecules with direct electrical readout. In this work, a capacitive electrolyte-insulator-semiconductor (EIS) field-effect sensor consisting of an Al-p-Si-SiO2 structure has been applied for real-time in situ electrical monitoring of the layer-by-layer formation of polyelectrolyte (PE) multilayers (PEM). The PEMs were deposited directly onto the SiO2 surface without any precursor layer or drying procedures. Anionic poly(sodium 4-styrene sulfonate) and cationic weak polyelectrolyte poly(allylamine hydrochloride) have been chosen as a model system. The effect of the ionic strength of the solution, polyelectrolyte concentration, number and polarity of the PE layers on the characteristics of the PEM-modified EIS sensors have been studied by means of capacitance-voltage and constant-capacitance methods. In addition, the thickness, surface morphology, roughness and wettabilityof the PE mono- and multilayers have been characterised by ellipsometry, atomic force microscopy and water contact-angle methods, respectively. To explain potential oscillations on the gate surface and signal behaviour of the capacitive field-effect EIS sensor modified with a PEM, a simplified electrostatic model that takes into account the reduced electrostatic screening of PE charges by mobile ions within the PEM has been proposed and discussed.},
  language  = {en}
}
@article{MuribGrinsvenGrietenetal.2013,
  author    = {Murib, M. S. and Grinsven, B. van and Grieten, L. and Janssens, S. D. and Vermeeren, V. and Eersels, K. and Broeders, J. and Ameloot, M. and Michiels, L. and Ceuninck, W. De and Haenen, K. and Sch{\"o}ning, Michael Josef and Wagner, Patrick},
  title     = {Electronic monitoring of chemical DNA denaturation on nanocrystalline diamond electrodes with different molarities and flow rates},
  series = {Physica Status Solidi (A). Vol. 210 (2013), iss. 5},
  journal   = {Physica Status Solidi (A). Vol. 210 (2013), iss. 5},
  publisher = {Wiley-VCH},
  address   = {Berlin},
  issn      = {0031-8965},
  pages     = {911 -- 917},
  year      = {2013},
  language  = {en}
}
@misc{IngebrandtWagnerSchoening2013,
  author    = {Ingebrandt, Sven and Wagner, Patrick and Sch{\"o}ning, Michael Josef},
  title     = {Engineering of functional interfaces / guest eds. Sven Ingebrandt ; Patrick Wagner ; Michael J. Sch{\"o}ning},
  series = {Physica Status Solidi (A)},
  volume    = {Vol. 210},
  journal   = {Physica Status Solidi (A)},
  number    = {Iss. 5},
  issn      = {1521-396X (E-Journal); 1862-6319 (E-Journal); 0031-8965 (Print); 1862-6300 (Print)},
  pages     = {845},
  year      = {2013},
  language  = {en}
}
@article{WernerWagnerYoshinobuetal.2013,
  author    = {Werner, Frederik and Wagner, Torsten and Yoshinobu, Tatsuo and Keusgen, Michael and Sch{\"o}ning, Michael Josef},
  title     = {Frequency behaviour of light-addressable potentiometric sensors},
  series = {Physica Status Solidi (A)},
  volume    = {210},
  journal   = {Physica Status Solidi (A)},
  number    = {5},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {1521-396X ; 0031-8965},
  doi       = {10.1002/pssa.201200929},
  pages     = {884 -- 891},
  year      = {2013},
  abstract  = {Light-addressable potentiometric sensors (LAPS) are semiconductor-based potentiometric sensors, with the advantage to detect the concentration of a chemical species in a liquid solution above the sensor surface in a spatially resolved manner. The addressing is achieved by a modulated and focused light source illuminating the semiconductor and generating a concentration-depending photocurrent. This work introduces a LAPS set-up that is able to monitor the electrical impedance in addition to the photocurrent. The impedance spectra of a LAPS structure, with and without illumination, as well as the frequency behaviour of the LAPS measurement are investigated. The measurements are supported by electrical equivalent circuits to explain the impedance and the LAPS-frequency behaviour. The work investigates the influence of different parameters on the frequency behaviour of the LAPS. Furthermore, the phase shift of the photocurrent, the influence of the surface potential as well as the changes of the sensor impedance will be discussed.},
  language  = {en}
}
@article{ItabashiKosakaMiyamotoetal.2013,
  author    = {Itabashi, Akinori and Kosaka, Naoki and Miyamoto, Ko-ichiro and Wagner, Torsten and Sch{\"o}ning, Michael Josef},
  title     = {High-speed chemical imaging system based on front-side-illuminated LAPS},
  series = {Sensors and actuators B: Chemical},
  volume    = {182},
  journal   = {Sensors and actuators B: Chemical},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1873-3077},
  doi       = {10.1016/j.snb.2013.03.016},
  pages     = {315 -- 321},
  year      = {2013},
  abstract  = {The chemical imaging sensor is a semiconductor-based chemical sensor that can visualize the spatial distribution of specific ions on the sensing surface. The conventional chemical imaging system based on the light-addressable potentiometric sensor (LAPS), however, required a long time to obtain a chemical image, due to the slow mechanical scan of a single light beam. For high-speed imaging, a plurality of light beams modulated at different frequencies can be employed to measure the ion concentrations simultaneously at different locations on the sensor plate by frequency division multiplex (FDM). However, the conventional measurement geometry of back-side illumination limited the bandwidth of the modulation frequency required for FDM measurement, because of the low-pass filtering characteristics of carrier diffusion in the Si substrate. In this study, a high-speed chemical imaging system based on front-side-illuminated LAPS was developed, which achieved high-speed spatiotemporal recording of pH change at a rate of 70 frames per second.},
  language  = {en}
}