@article{MuellerHirschfeldLambertzetal.2014,
  author    = {M{\"u}ller, Martin and Hirschfeld, Julian and Lambertz, Rita and Schulze Lohoff, Andreas and Lustfeld, Hans and Pfeifer, Heinz and Reißel, Martin},
  title     = {Validation of a novel method for detecting and stabilizing malfunctioning areas in fuel cell stacks},
  series = {Journal of power sources},
  volume    = {272},
  journal   = {Journal of power sources},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1873-2755 (E-Journal); 0378-7753 (Print)},
  doi       = {10.1016/j.jpowsour.2014.08.045},
  pages     = {225 -- 232},
  year      = {2014},
  abstract  = {In this paper a setup for detecting malfunctioning areas of MEAs in fuel cell stacks is described. Malfunctioning areas generate electric cross currents inside bipolar plates. To exploit this we suggest bipolar plates consisting not of two but of three layers. The third one is a highly conducting layer and segmented such that the cross currents move along the segments to the surface of the stack where they can be measured by an inductive sensor. With this information a realistic model can be used to detect the malfunctioning area. Furthermore the third layer will prevent any current inhomogeneity of a malfunctioning cell to spread to neighbouring cells in the stack. In this work the results of measurements in a realistic cell setup will be compared with the results obtained in simulation studies with the same configuration. The basis for the comparison is the reliable characterisation of the electrical properties of the cell components and the implication of these results into the simulation model. The experimental studies will also show the limits in the maximum number of segments, which can be used for a reliable detection of cross currents.},
  language  = {en}
}
@article{NachtrodtTietschMostaccietal.2014,
  author    = {Nachtrodt, Frederik and Tietsch, Wolfgang and Mostacci, Domiziano and Scherer, Ulrich W.},
  title     = {Set-up and first operation of a plasma oven for treatment of low level radioactive wastes},
  series = {Nuclear technology and radiation protection},
  volume    = {29},
  journal   = {Nuclear technology and radiation protection},
  number    = {Suppl.},
  publisher = {VINČA Institute of Nuclear Sciences},
  address   = {Belgrad},
  issn      = {1451-3994},
  doi       = {10.2298/NTRP140SS47N},
  pages     = {47 -- 51},
  year      = {2014},
  language  = {en}
}
@article{OberlaenderKirchnerBoyenetal.2014,
  author    = {Oberl{\"a}nder, Jan and Kirchner, Patrick and Boyen, Hans-Gerd and Sch{\"o}ning, Michael Josef},
  title     = {Detection of hydrogen peroxide vapor by use of manganese(IV) oxide as catalyst for calorimetric gas sensors},
  series = {Physica status solidi A: Applications and materials science},
  volume    = {211},
  journal   = {Physica status solidi A: Applications and materials science},
  number    = {6},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {1521-396X (E-Journal); 1862-6319 (E-Journal); 0031-8965 (Print); 1862-6300 (Print)},
  doi       = {10.1002/pssa.201330359},
  pages     = {1372 -- 1376},
  year      = {2014},
  abstract  = {In this work, the catalyst manganese(IV) oxide (MnO2), of calorimetric gas sensors (to monitor the sterilization agent vaporized hydrogen peroxide) has been investigated in more detail. Chemical analyses by means of X-ray-induced photoelectron spectroscopy have been performed to unravel the surface chemistry prior and after exposure to hydrogen peroxide vapor at elevated temperature, as applied in the sterilization processes of beverage cartons. The surface characterization reveals a change in oxidation states of the metal oxide catalyst after exposure to hydrogen peroxide. Additionally, a cleaning effect of the catalyst, which itself is attached to the sensor surface by means of a polymer interlayer, could be observed.},
  language  = {en}
}
@article{Olbertz2014,
  author    = {Olbertz, Klaus},
  title     = {Der neue gesetzliche Mindestlohn - was gilt und was Unternehmen k{\"u}nftig beachten m{\"u}ssen},
  series = {Gesellschafts- und Wirtschaftsrecht : GWR},
  journal   = {Gesellschafts- und Wirtschaftsrecht : GWR},
  issn      = {1868-1816},
  pages     = {521 -- 524},
  year      = {2014},
  abstract  = {Ab dem 1.1.2015 ist es soweit: Deutschland erh{\"a}lt einen fl{\"a}chendeckenden und weitgehend branchenunabh{\"a}ngigen gesetzlichen Mindestlohn. Danach haben grunds{\"a}tzlich alle abh{\"a}ngig besch{\"a}ftigten Arbeitnehmer einen Anspruch auf eine Entlohnung von wenigstens 8,50 EUR brutto je Arbeitsstunde. Die Auswirkungen d{\"u}rften enorm sein. Das Bundesministerium f{\"u}r Arbeit und Soziales geht jedenfalls davon aus, dass aufgrund der Einf{\"u}hrung des gesetzlichen Mindestlohns mehrere Millionen Besch{\"a}ftigte einen h{\"o}heren Lohn beanspruchen k{\"o}nnen. Der nachfolgende Beitrag gibt einen {\"U}berblick {\"u}ber die wesentlichen Inhalte des gesetzlichen Mindestlohns und Hinweise f{\"u}r Anwendungsprobleme in der betrieblichen Praxis.},
  language  = {de}
}
@article{Olbertz2014,
  author    = {Olbertz, Klaus},
  title     = {Gestaltung des Anstellungsvertrags - Der Compliance-Beauftragte},
  series = {Arbeit und Arbeitsrecht : AuA},
  journal   = {Arbeit und Arbeitsrecht : AuA},
  number    = {7},
  publisher = {Huss Medien},
  address   = {Berlin},
  issn      = {0323-4568},
  pages     = {400 -- 403},
  year      = {2014},
  abstract  = {Ein Compliance-Beauftragter soll daf{\"u}r Sorge tragen, dass aus dem Unternehmen heraus keine Rechtsverletzungen begangen werden. Aber welche rechtlichen Notwendigkeiten und M{\"o}glichkeiten resultieren daraus f{\"u}r die Gestaltung des Anstellungsvertrags?},
  language  = {de}
}
@article{Olbertz2014,
  author    = {Olbertz, Klaus},
  title     = {Die arbeitsrechtliche Stellung des Prokuristen - Handelsrechtlicher Kompetenzzuwachs mit arbeitsrechtlichen Konsequenzen},
  series = {NWB - Steuer- und Wirtschaftsrecht},
  journal   = {NWB - Steuer- und Wirtschaftsrecht},
  number    = {21},
  publisher = {NWB-Verlag},
  address   = {Herne},
  issn      = {1860-9449},
  pages     = {1591 -- 1596},
  year      = {2014},
  abstract  = {Die Besch{\"a}ftigung von Prokuristen ist g{\"a}ngige betriebliche Praxis. Unternehmen stehen dabei immer wieder vor der Frage, ob und welche Arbeitnehmer sie zu Prokuristen bestellen sollen. Nicht selten bleiben hierbei die arbeitsrechtlichen Konsequenzen, die mit der Bestellung eines Arbeitnehmers zum Prokuristen einhergehen k{\"o}nnen, unber{\"u}cksichtigt, wie diverse Gerichtsentscheidungen zeigen. Dieser Beitrag soll einen {\"U}berblick {\"u}ber die arbeitsrechtlichen Folgen bei der Besch{\"a}ftigung von Prokuristen geben und der betrieblichen Praxis somit gleichzeitig als Entscheidungshilfe dienen, wenn es um das Ob und Wie der m{\"o}glichen Bestellung eines Arbeitnehmers zum Prokuristen geht.},
  language  = {de}
}
@article{PasteurTippkoetterKampeisetal.2014,
  author    = {Pasteur, Aline and Tippk{\"o}tter, Nils and Kampeis, Percy and Ulber, Roland},
  title     = {Optimization of high gradient magnetic separation filter units for the purification of fermentation products},
  series = {IEEE TRANSACTIONS ON MAGNETICS},
  volume    = {50},
  journal   = {IEEE TRANSACTIONS ON MAGNETICS},
  number    = {10},
  publisher = {IEEE},
  address   = {New York, NY},
  issn      = {0018-9464},
  doi       = {10.1109/TMAG.2014.2325535},
  pages     = {Artikel 5000607},
  year      = {2014},
  abstract  = {High gradient magnetic separation (HGMS) has been established since the early 1970s. A more recent application of these systems is the use in bioprocesses. To integrate the HGMS in a fermentation process, it is necessary to optimize the separation matrix with regard to the magnetic separation characteristics and permeability of the non-magnetizable components of the fermentation broth. As part of the work presented here, a combined fluidic and magnetic force finite element model simulation was created using the software COMSOL Multiphysics and compared with separation experiments. Finally, as optimal lattice orientation of the separation matrix, a transversal rhombohedral arrangement was defined. The high suitability of the new filter matrix has been verified by separation experiments.},
  language  = {en}
}
@article{PhamStaat2014,
  author    = {Pham, Phu Tinh and Staat, Manfred},
  title     = {FEM-based shakedown analysis of hardening structures},
  series = {Asia Pacific journal on computational engineering},
  journal   = {Asia Pacific journal on computational engineering},
  number    = {1},
  publisher = {SpringerOpen},
  address   = {Berlin},
  issn      = {2196-1166 (E-Journal)},
  doi       = {10.1186/2196-1166-1-4},
  pages     = {Article No. 4},
  year      = {2014},
  abstract  = {This paper develops a new finite element method (FEM)-based upper bound algorithm for limit and shakedown analysis of hardening structures by a direct plasticity method. The hardening model is a simple two-surface model of plasticity with a fixed bounding surface. The initial yield surface can translate inside the bounding surface, and it is bounded by one of the two equivalent conditions: (1) it always stays inside the bounding surface or (2) its centre cannot move outside the back-stress surface. The algorithm gives an effective tool to analyze the problems with a very high number of degree of freedom. Our numerical results are very close to the analytical solutions and numerical solutions in literature.},
  language  = {en}
}
@article{PoghossianSchoening2014,
  author    = {Poghossian, Arshak and Sch{\"o}ning, Michael Josef},
  title     = {Label-free sensing of biomolecules with field-effect devices for clinical applications},
  series = {Electroanalysis},
  volume    = {26},
  journal   = {Electroanalysis},
  number    = {6},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {1521-4109 (E-Journal); 1040-0397 (Print)},
  doi       = {10.1002/elan.201400073},
  pages     = {1197 -- 1213},
  year      = {2014},
  abstract  = {Among the variety of transducer concepts proposed for label-free detection of biomolecules, the semiconductor field-effect device (FED) is one of the most attractive platforms. As medical techniques continue to progress towards diagnostic and therapies based on biomarkers, the ability of FEDs for a label-free, fast and real-time detection of multiple pathogenic and physiologically relevant molecules with high specificity and sensitivity offers very promising prospects for their application in point-of-care and personalized medicine for an early diagnosis and treatment of diseases. The presented paper reviews recent advances and current trends in research and development of different FEDs for label-free, direct electrical detection of charged biomolecules by their intrinsic molecular charge. The authors are mainly focusing on the detection of the DNA hybridization event, antibody-antigen affinity reaction as well as clinically relevant biomolecules such as cardiac and cancer biomarkers.},
  language  = {en}
}
@article{PyschnyDoeringFeldmann2014,
  author    = {Pyschny, D. and D{\"o}ring, Bernd and Feldmann, M.},
  title     = {Ermittlung der thermischen Leistungsf{\"a}higkeit des neuartigen multifunktionalen Verbunddeckensystems InaDeck},
  series = {Bauingenieur : die richtungsweisende Zeitschrift im Bauingenieurswesen},
  volume    = {89},
  journal   = {Bauingenieur : die richtungsweisende Zeitschrift im Bauingenieurswesen},
  number    = {3},
  publisher = {VDI Fachmedien},
  address   = {D{\"u}sseldorf},
  issn      = {0005-6650},
  pages     = {116 -- 124},
  year      = {2014},
  language  = {de}
}