@article{FischerKowalskiPudasaini2012,
  author    = {Fischer, Jan-Thomas and Kowalski, Julia and Pudasaini, Shiva P.},
  title     = {Topographic curvature effects in applied avalanche modelling},
  series = {Cold Regions Science and Technology},
  volume    = {74-75},
  journal   = {Cold Regions Science and Technology},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1872-7441},
  doi       = {10.1016/j.coldregions.2012.01.005},
  pages     = {21 -- 30},
  year      = {2012},
  abstract  = {This paper describes the implementation of topographic curvature effects within the RApid Mass MovementS (RAMMS) snow avalanche simulation toolbox. RAMMS is based on a model similar to shallow water equations with a Coulomb friction relation and the velocity dependent Voellmy drag. It is used for snow avalanche risk assessment in Switzerland. The snow avalanche simulation relies on back calculation of observed avalanches. The calibration of the friction parameters depends on characteristics of the avalanche track. The topographic curvature terms are not yet included in the above mentioned classical model. Here, we fundamentally improve this model by mathematically and physically including the topographic curvature effects. By decomposing the velocity dependent friction into a topography dependent term that accounts for a curvature enhancement in the Coulomb friction, and a topography independent contribution similar to the classical Voellmy drag, we construct a general curvature dependent frictional resistance, and thus propose new extended model equations. With three site-specific examples, we compare the apparent frictional resistance of the new approach, which includes topographic curvature effects, to the classical one. Our simulation results demonstrate substantial effects of the curvature on the flow dynamics e.g., the dynamic pressure distribution along the slope. The comparison of resistance coefficients between the two models demonstrates that the physically based extension presents an improvement to the classical approach. Furthermore a practical example highlights its influence on the pressure outline in the run out zone of the avalanche. Snow avalanche dynamics modeling natural terrain curvature centrifugal force friction coefficients.},
  language  = {en}
}
@article{FerreinSteinbauerVassos2012,
  author    = {Ferrein, Alexander and Steinbauer, Gerald and Vassos, Stavros},
  title     = {Action-Based Imperative Programming with YAGI},
  pages     = {24 -- 31},
  year      = {2012},
  abstract  = {Many tasks for autonomous agents or robots are best described by a specification of the environment and a specification of the available actions the agent or robot can perform. Combining such a specification with the possibility to imperatively program a robot or agent is what we call the actionbased imperative programming. One of the most successful such approaches is Golog. In this paper, we draft a proposal for a new robot programming language YAGI, which is based on the action-based imperative programming paradigm. Our goal is to design a small, portable stand-alone YAGI interpreter. We combine the benefits of a principled domain specification with a clean, small and simple programming language, which does not exploit any side-effects from the implementation language. We discuss general requirements of action-based programming languages and outline YAGI, our action-based language approach which particularly aims at embeddability.},
  language  = {en}
}
@article{FerreinMeyer2012,
  author    = {Ferrein, Alexander and Meyer, Thomas},
  title     = {A Brief Overview of Artificial Intelligence in South Africa},
  series = {AI Magazine},
  volume    = {33},
  journal   = {AI Magazine},
  number    = {1},
  publisher = {AAAI},
  address   = {Menlo Park},
  issn      = {0738-4602},
  doi       = {10.1609/aimag.v33i1.2357},
  pages     = {99 -- 101},
  year      = {2012},
  abstract  = {South Africa in recent years is the establishment of a number of research hubs involved in AI activities ranging from mobile robotics and computational intelligence, to knowledge representation and reasoning, and human language technologies. In this survey we take the reader through a quick tour of the research being conducted at these hubs, and touch on an initiative to maintain and extend the current level of interest in AI research in the country.},
  language  = {en}
}
@article{FateriHoetterGebhardt2012,
  author    = {Fateri, Miranda and H{\"o}tter, Jan-Steffen and Gebhardt, Andreas},
  title     = {Experimental and Theoretical Investigation of Buckling Deformation of Fabricated Objects by Selective Laser Melting},
  series = {Physics Procedia},
  volume    = {39},
  journal   = {Physics Procedia},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1875-3892},
  doi       = {10.1016/j.phpro.2012.10.062},
  pages     = {464 -- 470},
  year      = {2012},
  abstract  = {Although Selective Laser Melting (SLM) process is an innovative manufacturing method, there are challenges such as inferior mechanical properties of fabricated objects. Regarding this, buckling deformation which is caused by thermal stress is one of the undesired mechanical properties which must be alleviated. As buckling deformation is more observable in hard to process materials, silver is selected to be studied theoretically and experimentally for this paper. Different scanning strategies are utilized and a Finite Element Method (FEM) is applied to calculate the temperature gradient in order to determine its effect on the buckling deformation of the objects from experiments.},
  language  = {en}
}
@article{EllrichLind2012,
  author    = {Ellrich, Thomas and Lind, Thorsten Patric},
  title     = {Die 'kalte Zwangsverwaltung' durch den Insolvenzverwalter},
  series = {Forderungs-Praktiker : WIKI},
  journal   = {Forderungs-Praktiker : WIKI},
  number    = {1},
  publisher = {FCH},
  address   = {Heidelberg},
  pages     = {16 -- 21},
  year      = {2012},
  language  = {de}
}
@article{EilmannRigling2012,
  author    = {Eilmann, Britta and Rigling, Andreas},
  title     = {Tree-growth analyses to estimate tree species' drought tolerance},
  series = {Tree Physiology},
  volume    = {32},
  journal   = {Tree Physiology},
  number    = {2},
  editor    = {Abrams, Marc},
  publisher = {Oxford University Press},
  address   = {Oxford},
  issn      = {0829-318X (Print)},
  doi       = {10.1093/treephys/tps004},
  pages     = {178 -- 187},
  year      = {2012},
  abstract  = {Climate change is challenging forestry management and practices. Among other things, tree species with the ability to cope with more extreme climate conditions have to be identified. However, while environmental factors may severely limit tree growth or even cause tree death, assessing a tree species' potential for surviving future aggravated environmental conditions is rather demanding. The aim of this study was to find a tree-ring-based method suitable for identifying very drought-tolerant species, particularly potential substitute species for Scots pine (Pinus sylvestris L.) in Valais. In this inner-Alpine valley, Scots pine used to be the dominating species for dry forests, but today it suffers from high drought-induced mortality. We investigate the growth response of two native tree species, Scots pine and European larch (Larix decidua Mill.), and two non-native species, black pine (Pinus nigra Arnold) and Douglas fir (Pseudotsuga menziesii Mirb. var. menziesii), to drought. This involved analysing how the radial increment of these species responded to increasing water shortage (abandonment of irrigation) and to increasingly frequent drought years. Black pine and Douglas fir are able to cope with drought better than Scots pine and larch, as they show relatively high radial growth even after irrigation has been stopped and a plastic growth response to drought years. European larch does not seem to be able to cope with these dry conditions as it lacks the ability to recover from drought years. The analysis of trees' short-term response to extreme climate events seems to be the most promising and suitable method for detecting how tolerant a tree species is towards drought. However, combining all the methods used in this study provides a complete picture of how water shortage could limit species.},
  language  = {en}
}
@article{CzarneckiSpiliopoulou2012,
  author    = {Czarnecki, Christian and Spiliopoulou, Myra},
  title     = {A holistic framework for the implementation of a next generation network},
  series = {International Journal of Business Information Systems},
  volume    = {9},
  journal   = {International Journal of Business Information Systems},
  number    = {4},
  publisher = {Inderscience Enterprises},
  address   = {Olney, Bucks},
  issn      = {1746-0972},
  doi       = {10.1504/IJBIS.2012.046291},
  pages     = {385 -- 401},
  year      = {2012},
  abstract  = {As the potential of a next generation network (NGN) is recognised, telecommunication companies consider switching to it. Although the implementation of an NGN seems to be merely a modification of the network infrastructure, it may trigger or require changes in the whole company, because it builds upon the separation between service and transport, a flexible bundling of services to products and the streamlining of the IT infrastructure. We propose a holistic framework, structured into the layers 'strategy', 'processes' and 'information systems' and incorporate into each layer all concepts necessary for the implementation of an NGN, as well as the alignment of these concepts. As a first proof-of-concept for our framework we have performed a case study on the introduction of NGN in a large telecommunication company; we show that our framework captures all topics that are affected by an NGN implementation.},
  language  = {en}
}
@article{ChwallekEngelenOswaldetal.2012,
  author    = {Chwallek, Constanze and Engelen, Andreas and Oswald, Monika and Brettel, Malte},
  title     = {Die Wir­kung des F{\"u}h­rungs­ver­hal­tens des Top-Ma­nage­ments auf die un­ter­neh­me­ri­sche Ori­en­tie­rung - ein 5-L{\"a}n­der-Ver­gleich},
  series = {Zfbf : Schmalenbachs Zeitschrift f{\"u}r betriebswirtschaftliche Forschung},
  journal   = {Zfbf : Schmalenbachs Zeitschrift f{\"u}r betriebswirtschaftliche Forschung},
  number    = {2},
  publisher = {Springer Fachmedien},
  address   = {Wiesbaden},
  issn      = {0341-2687},
  pages     = {138 -- 165},
  year      = {2012},
  language  = {de}
}
@article{ChludekTran2012,
  author    = {Chludek, Astrid and Tran, Duc Hung},
  title     = {Der Reformvorschlag des IAS 12 gem. ED/2009/2 - Ein Pl{\"a}doyer f{\"u}r die Einf{\"u}hrung der valuation allowance},
  series = {KoR Zeitschrift f{\"u}r kapitalmarktorientierte Rechnungslegung},
  journal   = {KoR Zeitschrift f{\"u}r kapitalmarktorientierte Rechnungslegung},
  number    = {1},
  publisher = {Fachmedien Otto Schmidt},
  address   = {D{\"u}sseldorf},
  issn      = {1617-8084},
  pages     = {4 -- 8},
  year      = {2012},
  language  = {de}
}
@article{Baehr2012,
  author    = {B{\"a}hr, Brigitte},
  title     = {[Gert Hoepner] im Interview zum Thema ; Verpackungspolitik - mehr als H{\"u}lle},
  series = {Packaging journal : Technologie, Logistik, Marketing, Produkte},
  journal   = {Packaging journal : Technologie, Logistik, Marketing, Produkte},
  number    = {5},
  publisher = {Ella Verlag},
  address   = {H{\"u}rth},
  issn      = {1610-0336},
  pages     = {78 -- 80},
  year      = {2012},
  language  = {de}
}