@article{TippkoetterDeterdingUlber2008,
  author    = {Tippk{\"o}tter, Nils and Deterding, A. and Ulber, Roland},
  title     = {Determination of acetic acid in fermentation broth by gas-diffusion technique},
  series = {Engineering in Life Sciences},
  volume    = {8},
  journal   = {Engineering in Life Sciences},
  number    = {1, Special Issue: Technical Systems for the Use in Life Sciences},
  doi       = {10.1002/elsc.200820227},
  pages     = {62 -- 67},
  year      = {2008},
  abstract  = {Due to the interfering effects of acetic acid in many fermentation processes, a gas-diffusion technique was developed for the online determination of acetic acid. The measurements were accomplished with a flow diffusion analysis (FDA) unit from the TRACE Analytics GmbH, Braunschweig, Germany. The diffusion analysis is based on the UV-absorbance of acetic acid at 205 nm. The measurement was achieved by the separation of an acceptor and a carrier stream (acidified fermentation broth) using a gas permeable polytetrafluoroethylene (PTFE) membrane, whereby broth constituents that would otherwise disturb the UV-measurement of acetic acid, are held back efficiently. Merely, the fermentation by-products, e.g. formic acid, is capable of diffusing through the membrane. While formic acid can disturb the measurement, carbon dioxide does not absorb at 205 nm. The method operates with time-dependent sample enrichment. During the analysis, a small volume of the acceptor stream is stopped for a defined time interval in the acceptor chamber. During this period, the gaseous acetic acid diffuses through the membrane and is enriched in the acceptor chamber. Subsequently after the enrichment, the acceptor stream flows through a UV-detector. The intensity of the signal is proportional to the acetic acid concentration. Online measurements in bioreactors via a sterile filtration probe have been accomplished. A linear calibration in the range of 0.5-5.0 g/L acetic acid with a relative standard deviation of <5 \% was obtained. A sampling rate of 8 samples per hour was possible. The system was applied for the determination of acetic acid in E. coli fermentation broth. The instrument is easy to clean, very user-friendly and does not require any toxic or expensive reagents.},
  language  = {en}
}
@article{WagnerKloockSchoening2007,
  author    = {Wagner, Torsten and Kloock, Joachim P. and Sch{\"o}ning, Michael Josef},
  title     = {Determination of cadmium concentration and pH value in aqueous solutions by means of a handheld light-addressable potentiometric sensor (LAPS) device},
  series = {Electrochemical sensor analysis / edited by S. Alegret ...},
  journal   = {Electrochemical sensor analysis / edited by S. Alegret ...},
  publisher = {Elsevier},
  address   = {Amsterdam},
  isbn      = {978-0-444-53133-9},
  pages     = {e35 -- e44},
  year      = {2007},
  language  = {en}
}
@article{HelsperFissanThielen1983,
  author    = {Helsper, Christoph and Fißan, H. J. and Thielen, H. J.},
  title     = {Determination of Particle Size Distributions by Means of an Electrostatic Classifier / Fißan, H. J.; Helsper, C. ; Thielen, H. J.},
  series = {Journal of Aerosol Science. 14 (1983), H. 3},
  journal   = {Journal of Aerosol Science. 14 (1983), H. 3},
  isbn      = {0021-8502},
  pages     = {354 -- 357},
  year      = {1983},
  language  = {en}
}
@article{FoersterTillmannThust1996,
  author    = {F{\"o}rster, Arnold and Tillmann, K. and Thust, M.},
  title     = {Determination of segregation, elastic strain and thin-foil relaxation in InxGa-1-x As islands on GaAs(001) by high resolution transmission electron microscopy / K. Tillmann ; A. Thust ; M. Lentzen ... A. F{\"o}rster ...},
  series = {Philosophical magazine / Letters. 74 (1996), H. 5},
  journal   = {Philosophical magazine / Letters. 74 (1996), H. 5},
  isbn      = {1362-3036},
  pages     = {309 -- 315},
  year      = {1996},
  language  = {en}
}
@article{HelsperWiedensohlerWeiseetal.1986,
  author    = {Helsper, Christoph and Wiedensohler, A. and Weise, W. and L{\"u}tkemeier, E.},
  title     = {Determination of the Bipolar Charge Equilibrium in Pure Gases / Wiedensohler, A. ; Weise, W. ; Helsper, C. ; L{\"u}tkemeier, E.},
  series = {Aerosols : formation and reactivity ; proceedings of the second International Aerosol Conference, 22-26 Sept. 1986, Berlin (West) / Gesellschaft f{\"u}r Aerosolforschung (GAeF) ; American Association for Aerosol Research (AAAR)},
  journal   = {Aerosols : formation and reactivity ; proceedings of the second International Aerosol Conference, 22-26 Sept. 1986, Berlin (West) / Gesellschaft f{\"u}r Aerosolforschung (GAeF) ; American Association for Aerosol Research (AAAR)},
  publisher = {Pergamon Press},
  address   = {Oxford [u.a.]},
  pages     = {383 -- 386},
  year      = {1986},
  language  = {en}
}
@article{MaggakisKelemenBiselliArtmann2002,
  author    = {Maggakis-Kelemen, Christina and Biselli, Manfred and Artmann, Gerhard},
  title     = {Determination of the elastic shear modulus of cultured human red blood cells},
  series = {Biomedizinische Technik. 47 (2002), H. Suppl. 1 Pt. 1},
  journal   = {Biomedizinische Technik. 47 (2002), H. Suppl. 1 Pt. 1},
  isbn      = {0013-5585},
  pages     = {106 -- 109},
  year      = {2002},
  language  = {en}
}
@article{WernerKrumbeSchumacheretal.2011,
  author    = {Werner, Frederik and Krumbe, Christoph and Schumacher, Katharina and Groebel, Simone and Spelthahn, Heiko and Stellberg, Michael and Wagner, Torsten and Yoshinobu, Tatsuo and Selmer, Thorsten and Keusgen, Michael and Baumann, Marcus and Sch{\"o}ning, Michael Josef},
  title     = {Determination of the extracellular acidification of Escherichia coli by a light-addressable potentiometric sensor},
  series = {Physica status solidi (a) : applications and material science. 208 (2011), H. 6},
  journal   = {Physica status solidi (a) : applications and material science. 208 (2011), H. 6},
  publisher = {Wiley},
  address   = {Weinheim},
  isbn      = {1862-6319},
  pages     = {1340 -- 1344},
  year      = {2011},
  language  = {en}
}
@article{DantismTakenagaWagneretal.2016,
  author    = {Dantism, Shahriar and Takenaga, Shoko and Wagner, Patrick and Wagner, Torsten and Sch{\"o}ning, Michael Josef},
  title     = {Determination of the extracellular acidification of Escherichia coli K12 with a multi-​chamber-​based LAPS system},
  series = {Physica status solidi (a)},
  volume    = {213},
  journal   = {Physica status solidi (a)},
  number    = {6},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {1862-6300},
  doi       = {10.1002/pssa.201533043},
  pages     = {1479 -- 1485},
  year      = {2016},
  abstract  = {On-line monitoring of the metabolic activity of microorganisms involved in intermediate stages of biogas production plays an important role to avoid undesirable "down times" during the biogas production. In order to control this process, an on-chip differential measuring system based on the light-addressable potentiometric sensor (LAPS) principle combined with a 3D-printed multi-chamber structure has been realized. As a test microorganism, Escherichia coli K12 (E. coli K12) were used for cell-based measurements. Multi-chamber structures were developed to determine the metabolic activity of E. coli K12 in suspension for a different number of cells, responding to the addition of a constant or variable amount of glucose concentrations, enabling differential and simultaneous measurements.},
  language  = {en}
}
@article{HasanKeilStaatetal.2012,
  author    = {Hasan, Istabrak and Keil, Ludger and Staat, Manfred and Wahl, Gerhard and Bourauel, Christoph},
  title     = {Determination of the frictional coefficient of the implant-antler interface : experimental approach},
  series = {Biomedical Engineering / Biomedizinische Technik},
  volume    = {57},
  journal   = {Biomedical Engineering / Biomedizinische Technik},
  number    = {5},
  publisher = {De Gruyter},
  address   = {Berlin},
  issn      = {1862-278X},
  pages     = {359 -- 363},
  year      = {2012},
  abstract  = {The similar bone structure of reindeer antler to human bone permits studying the osseointegration of dental implants in the jawbone. As the friction is one of the major factors that have a significant influence on the initial stability of immediately loaded dental implants, it is essential to define the frictional coefficient of the implant-antler interface. In this study, the kinetic frictional forces at the implant-antler interface were measured experimentally using an optomechanical setup and a stepping motor controller under different axial loads and sliding velocities. The corresponding mean values of the static and kinetic frictional coefficients were within the range of 0.5-0.7 and 0.3-0.5, respectively. An increase in the frictional forces with increasing applied axial loads was registered. The measurements showed an evidence of a decrease in the magnitude of the frictional coefficient with increasing sliding velocity. The results of this study provide a considerable assessment to clarify the suitable frictional coefficient to be used in the finite element contact analysis of antler specimens.},
  language  = {en}
}
@article{ArpshofenPoolSommeretal.1983,
  author    = {Arpshofen, Ingo and Pool, M. J. and Sommer, Ferdinand and Gerling, Ulrich and Predel, Bruno and Schultheiss, Emil},
  title     = {Determination of the integral mixing enthalpies in the Cu-Pd-Si liquid ternary alloy system at 1600 K},
  series = {Zeitschrift f{\"u}r Metallkunde : international journal of materials research and advanced techniques. Bd. 74, H. 1},
  journal   = {Zeitschrift f{\"u}r Metallkunde : international journal of materials research and advanced techniques. Bd. 74, H. 1},
  issn      = {0044-3093 ; 0179-4841},
  pages     = {25 -- 32},
  year      = {1983},
  language  = {en}
}