@article{FuestKotliarWalteretal.2014,
  author    = {Fuest, Matthias and Kotliar, Konstantin and Walter, Peter and Plange, Niklas},
  title     = {Monitoring intraocular pressure changes after intravitreal Ranibizumab injection using rebound tonometry},
  series = {Ophthalmic and physiological optics},
  volume    = {34},
  journal   = {Ophthalmic and physiological optics},
  number    = {4},
  publisher = {Wiley-Blackwell},
  address   = {Oxford},
  issn      = {1475-1313 (E-Journal); 0275-5408 (Print)},
  doi       = {10.1111/opo.12134},
  pages     = {438 -- 444},
  year      = {2014},
  language  = {en}
}
@article{GuoMiyamotoWagneretal.2014,
  author    = {Guo, Yuanyuan and Miyamoto, Ko-ichiro and Wagner, Torsten and Sch{\"o}ning, Michael Josef and Yoshinobu, Tatsuo},
  title     = {Theoretical study and simulation of light-addressable potentiometric sensors},
  series = {Physica status solidi (A) : applications and materials},
  volume    = {211},
  journal   = {Physica status solidi (A) : applications and materials},
  number    = {6},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {0031-8965},
  doi       = {10.1002/pssa.201330354},
  pages     = {1467 -- 1472},
  year      = {2014},
  abstract  = {The light-addressable potentiometric sensor (LAPS) is a semiconductor-based potentiometric sensor using a light probe with an ability of detecting the concentration of biochemical species in a spatially resolved manner. As an important biomedical sensor, research has been conducted to improve its performance, for instance, to realize high-speed measurement. In this work, the idea of facilitating the device-level simulation, instead of using an equivalent-circuit model, is presented for detailed analysis and optimization of the performance of the LAPS. Both carrier distribution and photocurrent response have been simulated to provide new insight into both amplitude-mode and phase-mode operations of the LAPS. Various device parameters can be examined to effectively design and optimize the LAPS structures and setups for enhanced performance.},
  language  = {en}
}
@article{SchirraWatmuffBauschat2014,
  author    = {Schirra, Julian and Watmuff, Jonathan and Bauschat, J.-Michael},
  title     = {Highly non-planar lifting systems: a relative assessment of existing potential-methodologies to accurately estimate the induced drag},
  series = {32nd AIAA Applied Aerodynamics Conference 2014 : June, 16-20 2014, Atlanta, Ga.},
  journal   = {32nd AIAA Applied Aerodynamics Conference 2014 : June, 16-20 2014, Atlanta, Ga.},
  organization    = {American Institute of Aeronautics and Astronautics},
  isbn      = {978-1-62410-288-2},
  doi       = {10.2514/6.2014-2988},
  pages     = {Publ. online},
  year      = {2014},
  language  = {en}
}
@article{RiedelKartchemnikSchoeningetal.2014,
  author    = {Riedel, Marc and Kartchemnik, Julia and Sch{\"o}ning, Michael Josef and Lisdat, Fred},
  title     = {Impedimetric DNA detection - steps forward to sensorial application},
  series = {Analytical chemistry},
  volume    = {86 (2014)},
  journal   = {Analytical chemistry},
  number    = {15},
  publisher = {ACS Publications},
  address   = {Columbus},
  issn      = {1520-6882 (E-Journal); 0003-2700 (Print); 0096-4484 (Print)},
  doi       = {10.1021/ac501800q},
  pages     = {7867 -- 7874},
  year      = {2014},
  abstract  = {This study describes a label-free impedimetric sensor based on short ssDNA recognition elements for the detection of hybridization events. We concentrate on the elucidation of the influence of target length and recognition sequence position on the sensorial performance. The impedimetric measurements are performed in the presence of the redox system ferri-/ferrocyanide and show an increase in charge transfer resistance upon hybridization of ssDNA to the sensor surface. Investigations on the impedimetric signal stability demonstrate a clear influence of the buffers used during the sensor preparation and the choice of the passivating mercaptoalcanol compound. A stable sensor system has been developed, enabling a reproducible detection of 25mer target DNA in the low nanomolar range. After hybridization, a sensor regeneration can be reached with deionized water by adjustment of effective convection conditions, ensuring a sensor reusability. By investigations of longer targets with overhangs exposed to the solution, we can demonstrate applicability of the impedimetric detection for longer ssDNA. However, a decreasing charge transfer resistance change (ΔRct) is found by extending the overhang. As a strategy to increase the impedance change for longer target strands, the position of the recognition sequence can be designed in a way that a small overhang is exposed to the electrode surface. This is found to result in an increase in the relative Rct change. These results suggest that DNA and consequently negative charge near the electrode possess a larger impact on the impedimetric signal than DNA further away.},
  language  = {en}
}
@article{AlebouyehSamamiPieperBreitbachetal.2014,
  author    = {Alebouyeh Samami, Behzad and Pieper, Martin and Breitbach, Gerd and Hodapp, Josef},
  title     = {Heat production in the windings of the stators of electric machines under stationary condition},
  series = {Heat and mass transfer},
  volume    = {50},
  journal   = {Heat and mass transfer},
  publisher = {Springer},
  address   = {Heidelberg},
  issn      = {0947-7411 (Print) ; 1432-1181 (E-Journal)},
  doi       = {10.1007/s00231-014-1371-8},
  pages     = {1707 -- 1716},
  year      = {2014},
  abstract  = {In electric machines due to high currents and resistive losses (joule heating) heat is produced. To avoid damages by overheating the design of effective cooling systems is required. Therefore the knowledge of heat sources and heat transfer processes is necessary. The purpose of this paper is to illustrate a good and effective calculation method for the temperature analysis based on homogenization techniques. These methods have been applied for the stator windings in a slot of an electric machine consisting of copper wires and resin. The key quantity here is an effective thermal conductivity, which characterizes the heterogeneous wire resin-arrangement inside the stator slot. To illustrate the applicability of the method, the analysis of a simplified, homogenized model is compared with the detailed analysis of temperature behavior inside a slot of an electric machine according to the heat generation. We considered here only the stationary situation. The achieved numerical results are accurate and show that the applied homogenization technique works in practice. Finally the results of simulations for the two cases, the original model of the slot and the homogenized model chosen for the slot (unit cell), are compared to experimental results.},
  language  = {en}
}
@article{GuoSekiMiyamotoetal.2014,
  author    = {Guo, Yuanyuan and Seki, Kosuke and Miyamoto, Ko-ichiro and Wagner, Torsten and Sch{\"o}ning, Michael Josef and Yoshinobu, Tatsuo},
  title     = {Novel photoexcitation method for light-addressable potentiometric sensor with higher spatial resolution},
  series = {Applied physics express : APEX},
  volume    = {7},
  journal   = {Applied physics express : APEX},
  number    = {6},
  publisher = {IOP},
  address   = {Bristol},
  issn      = {1882-0786 (E-Journa); 1882-0778 (Print)},
  doi       = {10.7567/APEX.7.067301},
  pages     = {067301-4},
  year      = {2014},
  abstract  = {A novel photoexcitation method for the light-addressable potentiometric sensor (LAPS) is proposed to achieve a higher spatial resolution of chemical images. The proposed method employs a combined light source that consists of a modulated light probe, which generates the alternating photocurrent signal, and a ring of constant illumination surrounding it. The constant illumination generates a sheath of carriers with increased concentration which suppresses the spread of photocarriers by enhanced recombination. A device simulation was carried out to verify the effect of constant illumination on the spatial resolution, which demonstrated that a higher spatial resolution can be obtained.},
  language  = {en}
}
@article{WhiteheadOehlschlaegerAlmajhdietal.2014,
  author    = {Whitehead, Mark and {\"O}hlschl{\"a}ger, Peter and Almajhdi, Fahad N. and Alloza, Leonor and Marz{\´a}bal, Pablo and Meyers, Ann E. and Hitzeroth, Inga I. and Rybicki, Edward P.},
  title     = {Human papillomavirus (HPV) type 16 E7 protein bodies cause tumour regression in mice},
  series = {BMC cancer},
  journal   = {BMC cancer},
  number    = {14:367},
  publisher = {BioMed Central},
  address   = {London},
  issn      = {1471-2407},
  doi       = {10.1186/1471-2407-14-367},
  pages     = {1 -- 15},
  year      = {2014},
  language  = {en}
}
@article{WagnerDollSchoening2014,
  author    = {Wagner, Patrick and Doll, Theodor and Sch{\"o}ning, Michael Josef},
  title     = {Engineering of functional interfaces / Patrick Wagner ; Theodor Doll ; Michael J. Sch{\"o}ning (eds.)},
  series = {Physica status solidi (A) : Applications and materials science},
  volume    = {211},
  journal   = {Physica status solidi (A) : Applications and materials science},
  number    = {6},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {1521-396X (E-Book); 1862-6319 (E-Book); 0031-8965 (Print); 1862-6300 (Print)},
  doi       = {10.1002/pssa.201470241},
  pages     = {1339 -- 1339},
  year      = {2014},
  language  = {en}
}
@article{RaueWambachGloeggleretal.2014,
  author    = {Raue, Markus and Wambach, M. and Gl{\"o}ggler, S. and Grefen, Dana and Kaufmann, R. and Abetz, C. and Georgopanos, P. and Handge, U. A. and Mang, Thomas and Bl{\"u}mich, B. and Abetz, V.},
  title     = {Investigation of historical hard rubber ornaments of Charles Goodyear},
  series = {Macromolecular chemistry and physics},
  volume    = {Vol. 215},
  journal   = {Macromolecular chemistry and physics},
  number    = {No. 3},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {1022-1352},
  pages     = {245 -- 254},
  year      = {2014},
  language  = {en}
}
@article{VogtMottaghyRathetal.2014,
  author    = {Vogt, C. and Mottaghy, Darius and Rath, V. and Marquart, G. and Dijkshoorn, L. and Wolf, A. and Clauser, C.},
  title     = {Vertical variation in heat flow on the Kola Peninsula: palaeoclimate or fluid flow?},
  series = {Geophysical Journal International},
  volume    = {199},
  journal   = {Geophysical Journal International},
  number    = {2},
  publisher = {Oxford University Press},
  address   = {Oxford},
  issn      = {1365-246X},
  doi       = {10.1093/gji/ggu282},
  pages     = {829 -- 843},
  year      = {2014},
  abstract  = {Following earlier studies, we present forward and inverse simulations of heat and fluid transport of the upper crust using a local 3-D model of the Kola area. We provide best estimates for palaeotemperatures and permeabilities, their errors and their dependencies. Our results allow discriminating between the two mentioned processes to a certain extent, partly resolving the non-uniqueness of the problem. We find clear indications for a significant contribution of advective heat transport, which, in turn, imply only slightly lower ground surface temperatures during the last glacial maximum relative to the present value. These findings are consistent with the general background knowledge of (i) the fracture zones and the corresponding fluid movements in the bedrock and (ii) the glacial history of the Kola area.},
  language  = {en}
}