@article{HoltrupSadeghfamHeuermannetal.2014,
  author    = {Holtrup, S. and Sadeghfam, Arash and Heuermann, Holger and Awakowicz, P.},
  title     = {Characterization and optimization technique for microwave-driven high-intensity discharge lamps using hot S-parameters},
  series = {IEEE transactions on microwave theories and techniques},
  volume    = {62},
  journal   = {IEEE transactions on microwave theories and techniques},
  number    = {10},
  publisher = {IEEE},
  address   = {New York},
  issn      = {0018-9480},
  doi       = {10.1109/TMTT.2014.2342652},
  pages     = {2471 -- 2480},
  year      = {2014},
  abstract  = {High-intensity discharge lamps can be driven by radio-frequency signals in the ISM frequency band at 2.45 GHz, using a matching network to transform the impedance of the plasma to the source impedance. To achieve an optimal operating condition, a good characterization of the lamp in terms of radio frequency equivalent circuits under operating conditions is necessary, enabling the design of an efficient matching network. This paper presents the characterization technique for such lamps and presents the design of the required matching network. For the characterization, a high-intensity discharge lamp was driven by a monofrequent large signal at 2.45 GHz, whereas a frequency sweep over 300 MHz was performed across this signal to measure so-called small-signal hot S-parameters using a vector network analyzer. These parameters are then used as an equivalent load in a circuit simulator to design an appropriate matching network. Using the measured data as a black-box model in the simulation results in a quick and efficient method to simulate and design efficient matching networks in spite of the complex plasma behavior. Furthermore, photometric analysis of high-intensity discharge lamps are carried out, comparing microwave operation to conventional operation.},
  language  = {en}
}
@article{StadlerGarveyEmbsetal.2014,
  author    = {Stadler, Alexander Maximilian and Garvey, Christopher J. and Embs, Jan Peter and Koza, Michael Marek and Unruh, Tobias and Artmann, Gerhard and Zaccai, Guiseppe},
  title     = {Picosecond dynamics in haemoglobin from different species: A quasielastic neutron scattering study},
  series = {Biochimica et biophysica acta (BBA): General Subjects},
  volume    = {1840},
  journal   = {Biochimica et biophysica acta (BBA): General Subjects},
  number    = {10},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1872-8006 (E-Journal); 0304-4165 (Print)},
  doi       = {10.1016/j.bbagen.2014.06.007},
  pages     = {2989 -- 2999},
  year      = {2014},
  language  = {en}
}
@inproceedings{BuniatyanHuckPoghossianetal.2014,
  author    = {Buniatyan, V. V. and Huck, Christina and Poghossian, Arshak and Sch{\"o}ning, Michael Josef and Rustamyan, L. G. and Hovnikyan, H. H.},
  title     = {Equivalent circuit and optimization of impedance characteristics of an electrolyte conductivity sensor},
  series = {Proceedings of State Engineering University Armenia : Series Information technologies, electronics, radio engineering},
  volume    = {Iss. 17},
  booktitle = {Proceedings of State Engineering University Armenia : Series Information technologies, electronics, radio engineering},
  number    = {No. 1},
  pages     = {69 -- 76},
  year      = {2014},
  language  = {en}
}
@article{FrotscherStaat2014,
  author    = {Frotscher, Ralf and Staat, Manfred},
  title     = {Stresses produced by different textile mesh implants in a tissue equivalent},
  series = {BioNanoMaterials},
  volume    = {15},
  journal   = {BioNanoMaterials},
  number    = {1-2},
  publisher = {De Gruyter},
  address   = {Berlin},
  issn      = {2191-4672 (E-Journal); 2193-066X (E-Journal); 0011-8656 (Print); 1616-0177 (Print); 2193-0651 (Print)},
  doi       = {10.1515/bnm-2014-0003},
  pages     = {25 -- 30},
  year      = {2014},
  abstract  = {Two single-incision mini-slings used for treating urinary incontinence in women are compared with respect to the stresses they produce in their surrounding tissue. In an earlier paper we experimentally observed that these implants produce considerably different stress distributions in a muscle tissue equivalent. Here we perform 2D finite element analyses to compare the shear stresses and normal stresses in the tissue equivalent for the two meshes and to investigate their failure behavior. The results clearly show that the Gynecare TVT fails for increasing loads in a zipper-like manner because it gradually debonds from the surrounding tissue. Contrary to that, the tissue at the ends of the DynaMesh-SIS direct may rupture but only at higher loads. The simulation results are in good agreement with the experimental observations thus the computational model helps to interpret the experimental results and provides a tool for qualitative evaluation of mesh implants.},
  language  = {en}
}
@article{AlhwarinFerreinScholl2014,
  author    = {Alhwarin, Faraj and Ferrein, Alexander and Scholl, Ingrid},
  title     = {IR stereo kinect: improving depth images by combining structured light with IR stereo},
  pages     = {1 -- 9},
  year      = {2014},
  language  = {en}
}
@incollection{KirchnerReisertSchoening2014,
  author    = {Kirchner, Patrick and Reisert, Steffen and Sch{\"o}ning, Michael Josef},
  title     = {Calorimetric gas sensors for hydrogen peroxide monitoring in aseptic food processes},
  series = {Gas sensing fundamentals. (Springer Series on Chemical Sensors and Biosensors ; 15)},
  booktitle = {Gas sensing fundamentals. (Springer Series on Chemical Sensors and Biosensors ; 15)},
  publisher = {Springer},
  address   = {Heidelberg},
  isbn      = {978-3-642-54518-4 (Print) ; 978-3-642-54519-1 (Online)},
  doi       = {10.1007/5346_2013_51},
  pages     = {279 -- 309},
  year      = {2014},
  abstract  = {For the sterilisation of aseptic food packages it is taken advantage of the microbicidal properties of hydrogen peroxide (H2O2). Especially, when applied in vapour phase, it has shown high potential of microbial inactivation. In addition, it offers a high environmental compatibility compared to other chemical sterilisation agents, as it decomposes into oxygen and water, respectively. Due to a lack in sensory detection possibilities, a continuous monitoring of the H2O2 concentration was recently not available. Instead, the sterilisation efficacy is validated using microbiological tests. However, progresses in the development of calorimetric gas sensors during the last 7 years have made it possible to monitor the H2O2 concentration during operation. This chapter deals with the fundamentals of calorimetric gas sensing with special focus on the detection of gaseous hydrogen peroxide. A sensor principle based on a calorimetric differential set-up is described. Special emphasis is given to the sensor design with respect to the operational requirements under field conditions. The state-of-the-art regarding a sensor set-up for the on-line monitoring and secondly, a miniaturised sensor for in-line monitoring are summarised. Furthermore, alternative detection methods and a novel multi-sensor system for the characterisation of aseptic sterilisation processes are described.},
  language  = {en}
}
@incollection{SchoeningPoghossianGluecketal.2014,
  author    = {Sch{\"o}ning, Michael Josef and Poghossian, Arshak and Gl{\"u}ck, Olaf and Thust, Marion},
  title     = {Electrochemical methods for the determination of chemical variables in aqueous media},
  series = {Measurement, instrumentation, and sensors handbook / ed. by John G. Webster [u.a.] Vol. 2 : Electromagnetic, optical, radiation, chemical, and biomedical measurement},
  booktitle = {Measurement, instrumentation, and sensors handbook / ed. by John G. Webster [u.a.] Vol. 2 : Electromagnetic, optical, radiation, chemical, and biomedical measurement},
  publisher = {CRC Pr.},
  address   = {Boca Raton, Fla.},
  isbn      = {978-1-4398-4891-3},
  pages     = {55-1 -- 55-54},
  year      = {2014},
  language  = {en}
}
@inproceedings{HuckPoghossianBuniatyanetal.2014,
  author    = {Huck, Christina and Poghossian, Arshak and Buniatyan, V. and Sch{\"o}ning, Michael Josef},
  title     = {Multi-parameter detection for supporting monitoring and control of biogas processes in agriculture},
  series = {Sensoren und Messsysteme 2014 ; Beitr{\"a}ge der 17. GMA/ITG-Fachtagung vom 3. bis 4. Juni 2014 in N{\"u}rnberg. (ITG-Fachbericht ; 250)},
  booktitle = {Sensoren und Messsysteme 2014 ; Beitr{\"a}ge der 17. GMA/ITG-Fachtagung vom 3. bis 4. Juni 2014 in N{\"u}rnberg. (ITG-Fachbericht ; 250)},
  publisher = {VDE-Verl.},
  address   = {Berlin},
  organization    = {VDI/VDE-Gesellschaft Mess- und Automatisierungstechnik},
  isbn      = {978-3-8007-3622-5},
  pages     = {1 -- 5},
  year      = {2014},
  language  = {en}
}
@inproceedings{WernerYoshinobuMiyamotoetal.2014,
  author    = {Werner, Frederik and Yoshinobu, T. and Miyamoto, K. and Sch{\"o}ning, Michael Josef and Wagner, Torsten},
  title     = {Semiconductor-based sensors for imaging of chemical processes},
  series = {Sensoren und Messsysteme 2014 ; Beitr{\"a}ge der 17. GMA/ITG-Fachtagung vom 3. bis 4. Juni 2014 in N{\"u}rnberg. (ITG-Fachbericht ; 250)},
  booktitle = {Sensoren und Messsysteme 2014 ; Beitr{\"a}ge der 17. GMA/ITG-Fachtagung vom 3. bis 4. Juni 2014 in N{\"u}rnberg. (ITG-Fachbericht ; 250)},
  publisher = {VDE-Verl.},
  address   = {D{\"u}sseldorf},
  organization    = {VDI/VDE-Gesellschaft Mess- und Automatisierungstechnik},
  isbn      = {978-3-8007-3622-5},
  pages     = {1 -- 5},
  year      = {2014},
  language  = {en}
}
@inproceedings{WuBronderPoghossianetal.2014,
  author    = {Wu, Chunsheng and Bronder, Thomas and Poghossian, Arshak and Sch{\"o}ning, Michael Josef},
  title     = {DNA-hybridization detection using light-addressable potentiometric sensor modified with gold layer},
  series = {Sensoren und Messsysteme 2014 ; Beitr{\"a}ge der 17. GMA/ITG-Fachtagung vom 3. bis 4. Juni 2014 in N{\"u}rnberg. (ITG-Fachbericht ; 250)},
  booktitle = {Sensoren und Messsysteme 2014 ; Beitr{\"a}ge der 17. GMA/ITG-Fachtagung vom 3. bis 4. Juni 2014 in N{\"u}rnberg. (ITG-Fachbericht ; 250)},
  publisher = {VDE-Verl.},
  address   = {D{\"u}sseldorf},
  organization    = {VDI/VDE-Gesellschaft Mess- und Automatisierungstechnik},
  isbn      = {978-3-8007-3622-5},
  pages     = {1 -- 4},
  year      = {2014},
  language  = {en}
}