@article{HeuermannGraf1998,
  author    = {Heuermann, Holger and Graf, W.},
  title     = {Direkte on-wafer-Messung des Wellenwiderstandes einer Mikrostreifenleitung},
  series = {Kleinheubacher Berichte : Vortr{\"a}ge und Berichte der gemeinsamen Tagung des U.R.S.I.-Landesausschusses in der Bundesrepublik Deutschland / Hrsg.: Deutsche Telekom AG. 41. 1998 (1998)},
  journal   = {Kleinheubacher Berichte : Vortr{\"a}ge und Berichte der gemeinsamen Tagung des U.R.S.I.-Landesausschusses in der Bundesrepublik Deutschland / Hrsg.: Deutsche Telekom AG. 41. 1998 (1998)},
  year      = {1998},
  language  = {de}
}
@article{SchusserKrischerBaeckeretal.2015,
  author    = {Schusser, Sebastian and Krischer, Maximillian and B{\"a}cker, Matthias and Poghossian, Arshak and Wagner, Patrick and Sch{\"o}ning, Michael Josef},
  title     = {Monitoring of the Enzymatically Catalyzed Degradation of Biodegradable Polymers by Means of Capacitive Field-Effect Sensors},
  series = {Analytical Chemistry},
  volume    = {87},
  journal   = {Analytical Chemistry},
  number    = {13},
  publisher = {ACS Publications},
  address   = {Washington, DC},
  issn      = {1520-6882},
  doi       = {10.1021/acs.analchem.5b00617},
  pages     = {6607 -- 6613},
  year      = {2015},
  abstract  = {Designing novel or optimizing existing biodegradable polymers for biomedical applications requires numerous tests on the effect of substances on the degradation process. In the present work, polymer-modified electrolyte-insulator-semiconductor (PMEIS) sensors have been applied for monitoring an enzymatically catalyzed degradation of polymers for the first time. The thin films of biodegradable polymer poly(d,l-lactic acid) and enzyme lipase were used as a model system. During degradation, the sensors were read-out by means of impedance spectroscopy. In order to interpret the data obtained from impedance measurements, an electrical equivalent circuit model was developed. In addition, morphological investigations of the polymer surface have been performed by means of in situ atomic force microscopy. The sensor signal change, which reflects the progress of degradation, indicates an accelerated degradation in the presence of the enzyme compared to hydrolysis in neutral pH buffer media. The degradation rate increases with increasing enzyme concentration. The obtained results demonstrate the potential of PMEIS sensors as a very promising tool for in situ and real-time monitoring of degradation of polymers.},
  language  = {en}
}
@article{RoepkeKoehlerDruryetal.2020,
  author    = {Roepke, Rene and K{\"o}hler, Klemens and Drury, Vincent and Schroeder, Ulrik and Wolf, Martin R. and Meyer, Ulrike},
  title     = {A pond full of phishing games - analysis of learning games for anti-phishing education},
  series = {Model-driven Simulation and Training Environments for Cybersecurity. MSTEC 2020},
  journal   = {Model-driven Simulation and Training Environments for Cybersecurity. MSTEC 2020},
  publisher = {Springer},
  address   = {Cham},
  isbn      = {978-3-030-62433-0},
  doi       = {10.1007/978-3-030-62433-0_32020},
  pages     = {41 -- 60},
  year      = {2020},
  abstract  = {Game-based learning is a promising approach to anti-phishing education, as it fosters motivation and can help reduce the perceived difficulty of the educational material. Over the years, several prototypes for game-based applications have been proposed, that follow different approaches in content selection, presentation, and game mechanics. In this paper, a literature and product review of existing learning games is presented. Based on research papers and accessible applications, an in-depth analysis was conducted, encompassing target groups, educational contexts, learning goals based on Bloom's Revised Taxonomy, and learning content. As a result of this review, we created the publications on games (POG) data set for the domain of anti-phishing education. While there are games that can convey factual and conceptual knowledge, we find that most games are either unavailable, fail to convey procedural knowledge or lack technical depth. Thus, we identify potential areas of improvement for games suitable for end-users in informal learning contexts.},
  language  = {en}
}
@article{SchoppRohrbachLangeretal.2024,
  author    = {Schopp, Christoph and Rohrbach, Felix and Langer, Luc and Heuermann, Holger},
  title     = {Detection of welding wire length by active S11 measurement},
  series = {IEEE Transactions on Plasma Science},
  journal   = {IEEE Transactions on Plasma Science},
  number    = {Early Access},
  publisher = {IEEE},
  issn      = {0093-3813 (Print)},
  doi       = {10.1109/TPS.2024.3356659},
  pages     = {1 -- 6},
  year      = {2024},
  abstract  = {A novel method to determine the extruded length of a metallic wire for a directed energy deposition (DED) process using a microwave (MW) plasma jet with a straight-through wire feed is presented. The method is based on the relative comparison of the measured frequency response obtained by the large-signal scattering parameter (Hot-S) technique. In the practical working range, repeatability of less than 6\% for a nonactive plasma and 9\% for the active plasma state is found. Measurements are conducted with a focus on a simple solution to decrease the processing time and reduce the integration time of the process into the existing hardware. It is shown that monitoring a single frequency for magnitude and phase changes is sufficient to achieve good accuracy. A combination of different measurement values to determine the length is possible. The applicability to different diameter of the same material is shown as well as a contact detection of the wire and metallic substrate.},
  language  = {en}
}
@article{KramerHalamkovaPoghossianetal.2013,
  author    = {Kramer, Friederike and Halamkova, Lenka and Poghossian, Arshak and Sch{\"o}ning, Michael Josef and Katz, Evgeny and Halamek, Jan},
  title     = {Biocatalytic analysis of biomarkers for forensic identification of ethnicity between Caucasian and African American},
  series = {The analyst. August 2013},
  volume    = {Vol. 138},
  journal   = {The analyst. August 2013},
  publisher = {Royal Society of Chemistry},
  address   = {Cambridge},
  issn      = {1364-5528 (E-Journal); 0003-2654 (Print)},
  pages     = {6251 -- 6257},
  year      = {2013},
  language  = {en}
}
@article{HeuermannSchiek1993,
  author    = {Heuermann, Holger and Schiek, B.},
  title     = {Procedures for the Determination of the Scattering Parameters for Network Analyzer Calibration},
  series = {IEEE transactions on instrumentation and measurement : IM / Institute of Electrical and Electronics Engineers, Instrumentation and Measurement Group. 42 (1993), H. 2},
  journal   = {IEEE transactions on instrumentation and measurement : IM / Institute of Electrical and Electronics Engineers, Instrumentation and Measurement Group. 42 (1993), H. 2},
  isbn      = {0018-9456},
  pages     = {528 -- 531},
  year      = {1993},
  language  = {en}
}
@article{GoettscheGabrysch2001,
  author    = {G{\"o}ttsche, Joachim and Gabrysch, Karten},
  title     = {Analyse der Studentenwohnungen des Solar-Campus J{\"u}lich / G{\"o}ttsche, Joachim ; Gabrysch, Karten},
  series = {Umwelt, Geb{\"a}ude \& Gesundheit : von Energieeffizienz zur Raumlufthygiene ; Ergebnisse des 6. Fachkongresses der Arbeitsgemeinschaft {\"O}kologischer Forschungsinstitute (AG{\"O}F) am 20. und 21. September 2001 in N{\"u}rnberg / Arbeitsgemeinschaft {\"O}kologischer Forschungsinstitute (AG{\"O}F) e.V. [Red.: Sabine Weber]},
  journal   = {Umwelt, Geb{\"a}ude \& Gesundheit : von Energieeffizienz zur Raumlufthygiene ; Ergebnisse des 6. Fachkongresses der Arbeitsgemeinschaft {\"O}kologischer Forschungsinstitute (AG{\"O}F) am 20. und 21. September 2001 in N{\"u}rnberg / Arbeitsgemeinschaft {\"O}kologischer Forschungsinstitute (AG{\"O}F) e.V. [Red.: Sabine Weber]},
  publisher = {AG{\"O}F},
  address   = {Springe-Eldagsen},
  isbn      = {3-930576-03-1},
  pages     = {134 -- 148},
  year      = {2001},
  language  = {de}
}
@article{Staat1992,
  author    = {Staat, Manfred},
  title     = {Probabilistische Bewertung des bruchmechanischen Verhaltens der Prim{\"a}rkreisdruckumschließung eines HTR-Moduls},
  year      = {1992},
  language  = {de}
}
@article{LeversStaatLaack2016,
  author    = {Levers, A. and Staat, Manfred and Laack, Walter van},
  title     = {Analysis of the long-term effect of the MBST® nuclear magnetic resonance therapy on gonarthrosis},
  series = {Orthopedic Practice},
  volume    = {47},
  journal   = {Orthopedic Practice},
  number    = {11},
  pages     = {521 -- 528},
  year      = {2016},
  language  = {en}
}
@article{FingerBraunBil2020,
  author    = {Finger, Felix and Braun, Carsten and Bil, Cees},
  title     = {Impact of Battery Performance on the Initial Sizing of Hybrid-Electric General Aviation Aircraft},
  series = {Journal of Aerospace Engineering},
  volume    = {33},
  journal   = {Journal of Aerospace Engineering},
  number    = {3},
  publisher = {ASCE},
  address   = {Reston, Va.},
  issn      = {1943-5525},
  doi       = {10.1061/(ASCE)AS.1943-5525.0001113},
  year      = {2020},
  abstract  = {Studies suggest that hybrid-electric aircraft have the potential to generate fewer emissions and be inherently quieter when compared to conventional aircraft. By operating combustion engines together with an electric propulsion system, synergistic benefits can be obtained. However, the performance of hybrid-electric aircraft is still constrained by a battery's energy density and discharge rate. In this paper, the influence of battery performance on the gross mass for a four-seat general aviation aircraft with a hybrid-electric propulsion system is analyzed. For this design study, a high-level approach is chosen, using an innovative initial sizing methodology to determine the minimum required aircraft mass for a specific set of requirements and constraints. Only the peak-load shaving operational strategy is analyzed. Both parallel- and serial-hybrid propulsion configurations are considered for two different missions. The specific energy of the battery pack is varied from 200 to 1,000 W⋅h/kg, while the discharge time, and thus the normalized discharge rating (C-rating), is varied between 30 min (2C discharge rate) and 2 min (30C discharge rate). With the peak-load shaving operating strategy, it is desirable for hybrid-electric aircraft to use a light, low capacity battery system to boost performance. For this case, the battery's specific power rating proved to be of much higher importance than for full electric designs, which have high capacity batteries. Discharge ratings of 20C allow a significant take-off mass reduction aircraft. The design point moves to higher wing loadings and higher levels of hybridization if batteries with advanced technology are used.},
  language  = {en}
}