@article{LagemaatBreukelsVosetal.2016,
  author    = {Lagemaat, Miriam W. and Breukels, Vincent and Vos, Eline K. and B., Adam and Uden, Mark J. van and Orzada, Stephan and Bitz, Andreas and Maas, Marnix C. and Scheenen, Tom W. J.},
  title     = {¹H MR spectroscopic imaging of the prostate at 7T using spectral-spatial pulses},
  series = {Magnetic Resonance in Medicine},
  volume    = {75},
  journal   = {Magnetic Resonance in Medicine},
  number    = {3},
  publisher = {International Society for Magnetic Resonance in Medicine},
  issn      = {1522-2594},
  doi       = {10.1002/mrm.25569},
  pages     = {933 -- 945},
  year      = {2016},
  abstract  = {Purpose To assess the feasibility of prostate ¹H MR spectroscopic imaging (MRSI) using low-power spectral-spatial (SPSP) pulses at 7T, exploiting accurate spectral selection and spatial selectivity simultaneously. Methods A double spin-echo sequence was equipped with SPSP refocusing pulses with a spectral selectivity of 1 ppm. Three-dimensional prostate ¹H-MRSI at 7T was performed with the SPSP-MRSI sequence using an 8-channel transmit array coil and an endorectal receive coil in three patients with prostate cancer and in one healthy subject. No additional water or lipid suppression pulses were used. Results Prostate ¹H-MRSI could be obtained well within specific absorption rate (SAR) limits in a clinically feasible time (10 min). Next to the common citrate signals, the prostate spectra exhibited high spermine signals concealing creatine and sometimes also choline. Residual lipid signals were observed at the edges of the prostate because of limitations in spectral and spatial selectivity. Conclusion It is possible to perform prostate ¹H-MRSI at 7T with a SPSP-MRSI sequence while using separate transmit and receive coils. This low-SAR MRSI concept provides the opportunity to increase spatial resolution of MRSI within reasonable scan times.},
  language  = {en}
}
@article{OrzadaLaddBitz2016,
  author    = {Orzada, Stephan and Ladd, Mark E. and Bitz, Andreas},
  title     = {A method to approximate maximum local SAR in multichannel transmit MR systems without transmit phase information},
  series = {Magnetic Resonance in Medicine},
  volume    = {78},
  journal   = {Magnetic Resonance in Medicine},
  number    = {2},
  publisher = {International Society for Magnetic Resonance in Medicine},
  issn      = {1522-2594},
  doi       = {10.1002/mrm.26398},
  pages     = {805 -- 811},
  year      = {2016},
  abstract  = {Purpose To calculate local specific absorption rate (SAR) correctly, both the amplitude and phase of the signal in each transmit channel have to be known. In this work, we propose a method to derive a conservative upper bound for the local SAR, with a reasonable safety margin without knowledge of the transmit phases of the channels. Methods The proposed method uses virtual observation points (VOPs). Correction factors are calculated for each set of VOPs that prevent underestimation of local SAR when the VOPs are applied with the correct amplitudes but fixed phases. Results The proposed method proved to be superior to the worst-case calculation based on the maximum eigenvalue of the VOPs. The mean overestimation for six coil setups could be reduced, whereas no underestimation of the maximum local SAR occurred. In the best investigated case, the overestimation could be reduced from a factor of 3.3 to a factor of 1.7. Conclusion The upper bound for the local SAR calculated with the proposed method allows a fast estimation of the local SAR based on power measurements in the transmit channels and facilitates SAR monitoring in systems that do not have the capability to monitor transmit phases},
  language  = {en}
}
@article{ChenSchoembergKraffetal.2016,
  author    = {Chen, Bixia and Schoemberg, Tobias and Kraff, Oliver and Dammann, Philipp and Bitz, Andreas and Schlamann, Marc and Quick, Harald H. and Ladd, Mark E. and Sure, Ulrich and Wrede, Karsten H.},
  title     = {Cranial fixation plates in cerebral magnetic resonance imaging: a 3 and 7 Tesla in vivo image quality study},
  series = {Magnetic Resonance Materials in Physics, Biology and Medicine},
  volume    = {29},
  journal   = {Magnetic Resonance Materials in Physics, Biology and Medicine},
  number    = {3},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {1352-8661},
  doi       = {10.1007/s10334-016-0548-1},
  pages     = {389 -- 398},
  year      = {2016},
  abstract  = {Objective This study assesses and quantifies impairment of postoperative magnetic resonance imaging (MRI) at 7 Tesla (T) after implantation of titanium cranial fixation plates (CFPs) for neurosurgical bone flap fixation. Materials and methods The study group comprised five patients who were intra-individually examined with 3 and 7 T MRI preoperatively and postoperatively (within 72 h/3 months) after implantation of CFPs. Acquired sequences included T₁-weighted magnetization-prepared rapid-acquisition gradient-echo (MPRAGE), T₂-weighted turbo-spin-echo (TSE) imaging, and susceptibility-weighted imaging (SWI). Two experienced neurosurgeons and a neuroradiologist rated image quality and the presence of artifacts in consensus reading. Results Minor artifacts occurred around the CFPs in MPRAGE and T2 TSE at both field strengths, with no significant differences between 3 and 7 T. In SWI, artifacts were accentuated in the early postoperative scans at both field strengths due to intracranial air and hemorrhagic remnants. After resorption, the brain tissue directly adjacent to skull bone could still be assessed. Image quality after 3 months was equal to the preoperative examinations at 3 and 7 T. Conclusion Image quality after CFP implantation was not significantly impaired in 7 T MRI, and artifacts were comparable to those in 3 T MRI.},
  language  = {en}
}
@inproceedings{ValeroBung2016,
  author    = {Valero, Daniel and Bung, Daniel B.},
  title     = {Interfacial velocity estimation in highly aerated stepped spillway flows with a single tip fibre optical probe and Artificial Neural Networks},
  series = {6th IAHR International Junior Researcher and Engineer Workshop on Hydraulic Structures, May 30th to June 1st 2016. L{\"u}beck, Germany},
  booktitle = {6th IAHR International Junior Researcher and Engineer Workshop on Hydraulic Structures, May 30th to June 1st 2016. L{\"u}beck, Germany},
  doi       = {10.15142/T3Q590},
  pages     = {13 Seiten},
  year      = {2016},
  abstract  = {Air-water flows can be found in different engineering applications: from nuclear engineering to huge hydraulic structures. In this paper, a single tip fibre optical probe has been used to record high frequency (over 1 MHz) phase functions at different locations of a stepped spillway. These phase functions have been related to the interfacial velocities by means of Artificial Neural Networks (ANN) and the measurements of a classical double tip conductivity probe. Special attention has been put to the input selection and the ANN dimensions. Finally, ANN have shown to be able to link the signal rising times and plateau shapes to the air-water interfacial velocity.},
  language  = {en}
}
@inproceedings{BaeckerKochGeigeretal.2016,
  author    = {B{\"a}cker, Matthias and Koch, C. and Geiger, F. and Eber, F. and Gliemann, H. and Poghossian, Arshak and Sch{\"o}ning, Michael Josef},
  title     = {A New Class of Biosensors Based on Tobacco Mosaic Virus and Coat Proteins as Enzyme Nanocarrier},
  series = {Procedia Engineering},
  volume    = {Vol. 168},
  booktitle = {Procedia Engineering},
  issn      = {1877-7058},
  doi       = {10.1016/j.proeng.2016.11.228},
  pages     = {618 -- 621},
  year      = {2016},
  language  = {en}
}
@inproceedings{PoghossianBronderSchejaetal.2016,
  author    = {Poghossian, Arshak and Bronder, Thomas and Scheja, S. and Wu, Chunsheng and Metzger-Boddien, C. and Keusgen, M. and Sch{\"o}ning, Michael Josef},
  title     = {Label-free Electrostatic Detection of DNA Amplification by PCR Using Capacitive Field-effect Devices},
  series = {Procedia Engineering},
  volume    = {Vol. 168},
  booktitle = {Procedia Engineering},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {1877-7058},
  doi       = {10.1016/j.proeng.2016.11.512},
  pages     = {514 -- 517},
  year      = {2016},
  abstract  = {A capacitive field-effect EIS (electrolyte-insulator-semiconductor) sensor modified with a positively charged weak polyelectrolyte of poly(allylamine hydrochloride) (PAH)/single-stranded probe DNA (ssDNA) bilayer has been used for a label-free electrostatic detection of pathogen-specific DNA amplification via polymerase chain reaction (PCR). The sensor is able to distinguish between positive and negative PCR solutions, to detect the existence of target DNA amplicons in PCR samples and thus, can be used as tool for a quick verification of DNA amplification and the successful PCR process.},
  language  = {en}
}
@article{NeuJanserKhatibietal.2016,
  author    = {Neu, Eugen and Janser, Frank and Khatibi, Akbar A. and Orifici, Adrian C.},
  title     = {Automated modal parameter-based anomaly detection under varying wind excitation},
  series = {Structural Health Monitoring},
  volume    = {15},
  journal   = {Structural Health Monitoring},
  number    = {6},
  publisher = {Sage},
  address   = {London},
  issn      = {1475-9217},
  doi       = {10.1177/1475921716665803},
  pages     = {1 -- 20},
  year      = {2016},
  abstract  = {Wind-induced operational variability is one of the major challenges for structural health monitoring of slender engineering structures like aircraft wings or wind turbine blades. Damage sensitive features often show an even bigger sensitivity to operational variability. In this study a composite cantilever was subjected to multiple mass configurations, velocities and angles of attack in a controlled wind tunnel environment. A small-scale impact damage was introduced to the specimen and the structural response measurements were repeated. The proposed damage detection methodology is based on automated operational modal analysis. A novel baseline preparation procedure is described that reduces the amount of user interaction to the provision of a single consistency threshold. The procedure starts with an indeterminate number of operational modal analysis identifications from a large number of datasets and returns a complete baseline matrix of natural frequencies and damping ratios that is suitable for subsequent anomaly detection. Mahalanobis distance-based anomaly detection is then applied to successfully detect the damage under varying severities of operational variability and with various degrees of knowledge about the present operational conditions. The damage detection capabilities of the proposed methodology were found to be excellent under varying velocities and angles of attack. Damage detection was less successful under joint mass and wind variability but could be significantly improved through the provision of the currently encountered operational conditions.},
  language  = {en}
}
@incollection{FeldmannDoeringPyschny2016,
  author    = {Feldmann, M. and D{\"o}ring, Bernd and Pyschny, D.},
  title     = {Floor systems; Sustainabilty analyses and assessments of steel bridges},
  series = {Sustainable steel buildings : a practical guide for structures and envelopes},
  booktitle = {Sustainable steel buildings : a practical guide for structures and envelopes},
  publisher = {Wiley Blackwell},
  address   = {Chichester, West Sussex},
  isbn      = {978-1-118-74079-8 (PDF)},
  pages     = {198 -- 223},
  year      = {2016},
  language  = {en}
}
@inproceedings{DroszezSannoGoldmannetal.2016,
  author    = {Droszez, Anna and Sanno, Maximilian and Goldmann, Jan-Peter and Albracht, Kirsten and Br{\"u}ggemann, Gerd-Peter and Braunstein, Bjoern},
  title     = {Differences between take-off behavior during vertical jumps and two artistic elements},
  series = {34th International Conference of Biomechanics in Sport, Tsukuba, Japan, July 18-22, 2016},
  booktitle = {34th International Conference of Biomechanics in Sport, Tsukuba, Japan, July 18-22, 2016},
  issn      = {1999-4168},
  pages     = {577 -- 580},
  year      = {2016},
  language  = {en}
}
@article{RoeschKratzHeringetal.2016,
  author    = {R{\"o}sch, C. and Kratz, F. and Hering, T. and Trautmann, S. and Umanskaya, N. and Tippk{\"o}tter, Nils and M{\"u}ller-Renno, C.M. and Ulber, R. and Hannig, M. and Ziegler, C.},
  title     = {Albumin-lysozyme interactions: cooperative adsorption on titanium and enzymatic activity},
  series = {Colloids and Surfaces B: Biointerfaces},
  volume    = {149},
  journal   = {Colloids and Surfaces B: Biointerfaces},
  number    = {1},
  publisher = {Elsevier},
  address   = {Amsterdam},
  doi       = {10.1016/j.colsurfb.2016.09.048},
  pages     = {115 -- 121},
  year      = {2016},
  abstract  = {The interplay of albumin (BSA) and lysozyme (LYZ) adsorbed simultaneously on titanium was analyzed by gel electrophoresis and BCA assay. It was found that BSA and lysozyme adsorb cooperatively. Additionally, the isoelectric point of the respective protein influences the adsorption. Also, the enzymatic activity of lysozyme and amylase (AMY) in mixtures with BSA was considered with respect to a possible influence of protein-protein interaction on enzyme activity. Indeed, an increase of lysozyme activity in the presence of BSA could be observed. In contrast, BSA does not influence the activity of amylase.},
  language  = {en}
}