@article{BaeckerRaueSchusseretal.2012,
  author    = {B{\"a}cker, Matthias and Raue, Markus and Schusser, Sebastian and Jeitner, C. and Breuer, L. and Wagner, P. and Poghossian, Arshak and F{\"o}rster, Arnold and Mang, Thomas and Sch{\"o}ning, Michael Josef},
  title     = {Microfluidic chip with integrated microvalves based on temperature- and pH-responsive hydrogel thin films},
  series = {Physica Status Solidi (a)},
  volume    = {209},
  journal   = {Physica Status Solidi (a)},
  number    = {5},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {1862-6319},
  doi       = {10.1002/pssa.201100763},
  pages     = {839 -- 845},
  year      = {2012},
  abstract  = {Two types of microvalves based on temperature-responsive poly(N-isopropylacrylamide) (PNIPAAm) and pH-responsive poly(sodium acrylate) (PSA) hydrogel films have been developed and tested. The PNIPAAm and PSA hydrogel films were prepared by means of in situ photopolymerization directly inside the fluidic channel of a microfluidic chip fabricated by combining Si and SU-8 technologies. The swelling/shrinking properties and height changes of the PNIPAAm and PSA films inside the fluidic channel were studied at temperatures of deionized water from 14 to 36 °C and different pH values (pH 3-12) of Titrisol buffer, respectively. Additionally, in separate experiments, the lower critical solution temperature (LCST) of the PNIPAAm hydrogel was investigated by means of a differential scanning calorimetry (DSC) and a surface plasmon resonance (SPR) method. Mass-flow measurements have shown the feasibility of the prepared hydrogel films to work as an on-chip integrated temperature- or pH-responsive microvalve capable to switch the flow channel on/off.},
  language  = {en}
}
@article{StaatVu2012,
  author    = {Staat, Manfred and Vu, Duc Khoi},
  title     = {Limit analysis of flaws in pressurized pipes and cylindrical vessels Part II: Circumferential defects},
  series = {Engineering Fracture Mechanics ; 97(2013), H. 1},
  volume    = {97},
  journal   = {Engineering Fracture Mechanics ; 97(2013), H. 1},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {0013-7944},
  doi       = {10.1016/j.engfracmech.2012.05.017},
  pages     = {314 -- 333},
  year      = {2012},
  abstract  = {Upper and lower bound theorems of limit analyses have been presented in part I of the paper. Part II starts with the finite element discretization of these theorems and demonstrates how both can be combined in a primal-dual optimization problem. This recently proposed numerical method is used to guide the development of a new class of closed-form limit loads for circumferential defects, which show that only large defects contribute to plastic collapse with a rapid loss of strength with increasing crack sizes. The formulae are compared with primal-dual FEM limit analyses and with burst tests. Even closer predictions are obtained with iterative limit load solutions for the von Mises yield function and for the Tresca yield function. Pressure loading of the faces of interior cracks in thick pipes reduces the collapse load of circumferential defects more than for axial flaws. Axial defects have been treated in part I of the paper.},
  language  = {en}
}