@inproceedings{SchopenKemperEsch2021,
  author    = {Schopen, Oliver and Kemper, Hans and Esch, Thomas},
  title     = {Development of a comparison methodology and evaluation matrix for electrically driven compressors in ICE and FC},
  series = {Proceedings of the 1st UNITED - Southeast Asia Automotive Interest Group (SAIG) International Conference},
  booktitle = {Proceedings of the 1st UNITED - Southeast Asia Automotive Interest Group (SAIG) International Conference},
  publisher = {FH Joanneum},
  address   = {Graz},
  isbn      = {978-3-902103-94-9},
  pages     = {45 -- 46},
  year      = {2021},
  abstract  = {In addition to electromobility and alternative drive systems, a focus is set on electrically driven compressors (EDC), with a high potential for increasing the efficiency of internal combustion engines (ICE) and fuel cells [01]. The primary objective is to increase the ICE torque, provided independently of the ICE speed by compressing the intake air and consequently the ICE filling level supported by the compressor. For operation independent from the ICE speed, the EDC compressor is decoupled from the turbine by using an electric compressor motor (CM) instead of the turbine. ICE performances can be increased by the use of EDC where individual compressor parameters are adapted to the respective application area [02] [03]. This task contains great challenges, increased by demands with regard to pollutant reduction while maintaining constant performance and reduced fuel consumption. The FH-Aachen is equipped with an EDC test bench which enables EDC-investigations in various configurations and operating modes. Characteristic properties of different compressors can be determined, which build the basis for a comparison methodology. Subject of this project is the development of a comparison methodology for EDC with an associated evaluation method and a defined overall evaluation method. For the application of this comparison methodology, corresponding series of measurements are carried out on the EDC test bench using an appropriate test device.},
  language  = {en}
}
@inproceedings{StarkRiepingEsch2023,
  author    = {Stark, Ralf and Rieping, Carla and Esch, Thomas},
  title     = {The impact of guide tubes on flow separation in rocket nozzles},
  series = {Aerospace Europe Conference 2023 - 10th EUCASS - 9th CEAS},
  booktitle = {Aerospace Europe Conference 2023 - 10th EUCASS - 9th CEAS},
  pages     = {8 Seiten},
  year      = {2023},
  abstract  = {Rocket engine test facilities and launch pads are typically equipped with a guide tube. Its purpose is to ensure the controlled and safe routing of the hot exhaust gases. In addition, the guide tube induces a suction that effects the nozzle flow, namely the flow separation during transient start-up and shut-down of the engine. A cold flow subscale nozzle in combination with a set of guide tubes was studied experimentally to determine the main influencing parameters.},
  language  = {en}
}
@inproceedings{StarkBartelDitscheetal.2023,
  author    = {Stark, Ralf and Bartel, Sebastian and Ditsche, Florian and Esch, Thomas},
  title     = {Design study of a 30kN LOX/LCH4 aerospike rocket engine for lunar lander application},
  series = {Aerospace Europe Conference 2023 - 10th EUCASS - 9th CEAS},
  booktitle = {Aerospace Europe Conference 2023 - 10th EUCASS - 9th CEAS},
  pages     = {9 Seiten},
  year      = {2023},
  abstract  = {Based on lunar lander concept EL3, various LOX/CH4 aerospike engines were studied. A distinction was made between single and cluster configurations as well as ideal and non-ideal contour concepts. It could be shown that non-ideal aerospike engines promise a significant payload gain.},
  language  = {en}
}