@article{BayonValeroGarciaBartualetal.2016,
  author    = {Bayon, Arnau and Valero, Daniel and Garcia-Bartual, Rafael and Vall{\´e}s-Mor{\´a}n, Francisco Jos{\´e} and L{\´o}pez-Jim{\´e}nez, P. Amparo},
  title     = {Performance assessment of OpenFOAM and FLOW-3D in the numerical modeling of a low Reynolds number hydraulic jump},
  series = {Environmental Modelling \& Software},
  volume    = {80},
  journal   = {Environmental Modelling \& Software},
  publisher = {Elsevier},
  address   = {Amsterdam},
  isbn      = {1364-8152},
  doi       = {10.1016/j.envsoft.2016.02.018},
  pages     = {322 -- 335},
  year      = {2016},
  abstract  = {A comparative performance analysis of the CFD platforms OpenFOAM and FLOW-3D is presented, focusing on a 3D swirling turbulent flow: a steady hydraulic jump at low Reynolds number. Turbulence is treated using RANS approach RNG k-ε. A Volume Of Fluid (VOF) method is used to track the air-water interface, consequently aeration is modeled using an Eulerian-Eulerian approach. Structured meshes of cubic elements are used to discretize the channel geometry. The numerical model accuracy is assessed comparing representative hydraulic jump variables (sequent depth ratio, roller length, mean velocity profiles, velocity decay or free surface profile) to experimental data. The model results are also compared to previous studies to broaden the result validation. Both codes reproduced the phenomenon under study concurring with experimental data, although special care must be taken when swirling flows occur. Both models can be used to reproduce the hydraulic performance of energy dissipation structures at low Reynolds numbers.},
  language  = {en}
}
@article{MiyamotoYuIsodaetal.2016,
  author    = {Miyamoto, Ko-ichiro and Yu, Bing and Isoda, Hiroko and Wagner, Torsten and Sch{\"o}ning, Michael Josef and Yoshinobu, Tatsuo},
  title     = {Visualization of the recovery process of defects in a cultured cell layer by chemical imaging sensor},
  series = {Sensors and Actuators B: Chemical},
  volume    = {236},
  journal   = {Sensors and Actuators B: Chemical},
  publisher = {Elsevier},
  address   = {Amsterdam},
  issn      = {0925-4005},
  doi       = {10.1016/j.snb.2016.04.018},
  pages     = {965 -- 969},
  year      = {2016},
  abstract  = {The chemical imaging sensor is a field-effect sensor which is able to visualize both the distribution of ions (in LAPS mode) and the distribution of impedance (in SPIM mode) in the sample. In this study, a novel cell assay is proposed, in which the chemical imaging sensor operated in SPIM mode is applied to monitor the recovery of defects in a cell layer brought into proximity of the sensing surface. A reduced impedance at a defect formed artificially in a cell layer was successfully visualized in a photocurrent image. The cell layer was cultured over two weeks, during which the temporal change of the photocurrent distribution corresponding to the recovery of the defect was observed.},
  language  = {de}
}
@article{DantismTakenagaWagneretal.2016,
  author    = {Dantism, Shahriar and Takenaga, Shoko and Wagner, Patrick and Wagner, Torsten and Sch{\"o}ning, Michael Josef},
  title     = {Determination of the extracellular acidification of Escherichia coli K12 with a multi-​chamber-​based LAPS system},
  series = {Physica status solidi (a)},
  volume    = {213},
  journal   = {Physica status solidi (a)},
  number    = {6},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {1862-6300},
  doi       = {10.1002/pssa.201533043},
  pages     = {1479 -- 1485},
  year      = {2016},
  abstract  = {On-line monitoring of the metabolic activity of microorganisms involved in intermediate stages of biogas production plays an important role to avoid undesirable "down times" during the biogas production. In order to control this process, an on-chip differential measuring system based on the light-addressable potentiometric sensor (LAPS) principle combined with a 3D-printed multi-chamber structure has been realized. As a test microorganism, Escherichia coli K12 (E. coli K12) were used for cell-based measurements. Multi-chamber structures were developed to determine the metabolic activity of E. coli K12 in suspension for a different number of cells, responding to the addition of a constant or variable amount of glucose concentrations, enabling differential and simultaneous measurements.},
  language  = {en}
}
@article{HacklMuellerStaatetal.2016,
  author    = {Hackl, Michael and M{\"u}ller, Lars-Peter and Staat, Manfred and Kahmann, Stephanie Lucina and Wegmann, Kilian},
  title     = {Proximal phalangeal neck fractures of the hand — a biomechanical comparison of three fixation techniques},
  series = {Knee surgery, sports traumatology, arthroscopy},
  volume    = {Volume 24},
  journal   = {Knee surgery, sports traumatology, arthroscopy},
  number    = {Supplement 1},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {0942-2056},
  doi       = {10.1007/s00167-016-4080-7},
  pages     = {148 -- 149},
  year      = {2016},
  abstract  = {Plate osteosynthesis of displaced proximal phalangeal neck fractures of the hand allows early mobilization due to a stable internal fixation. Nevertheless, joint stiffness—because of soft tissue irritation—represents a common complication leading to high complication rates. Del Pinal et al. recently reported promising clinical results for a new, minimally invasive fixation technique with a cannulated headless intramedullary compression screw. Hence, the aim of this study was to compare plate fixation of proximal phalangeal neck fractures to less two less invasive techniques: Crossed k-wire fixation and intramedullary screw fixation. We hypothesized that these fixation techniques provide inferior stability when compared to plate osteosynthesis.},
  language  = {en}
}
@article{HacklKahmannWegmannetal.2016,
  author    = {Hackl, Michael and Kahmann, Stephanie Lucina and Wegmann, Kilian and Ries, Christian and Staat, Manfred and M{\"u}ller, Lars-Peter},
  title     = {Shortening osteotomy of the proximal radius — a treatment option for isolated osteoarthritis of the lateral column of the elbow joint?},
  series = {Knee surgery, sports traumatology, arthroscopy},
  volume    = {Volume 24},
  journal   = {Knee surgery, sports traumatology, arthroscopy},
  number    = {Supplement 1},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {0942-2056},
  doi       = {10.1007/s00167-016-4080-7},
  pages     = {128 -- 129},
  year      = {2016},
  abstract  = {Treatment of posttraumatic osteoarthritis of the radial column of the elbow joint remains a challenging yet common issue. While partial joint replacement leads to high revision rates, radial head excision has shown to severely increase joint instability. Shortening osteotomy of the radius could be an option to decrease the contact pressure of the radiohumeral joint and thereby pain levels without causing valgus instability. Hence, the aim of this biomechanical study was to evaluate the effects of radial shortening on axial load distribution and valgus stability of the elbow joint.},
  language  = {en}
}
@article{HacklLeschingerStaatetal.2016,
  author    = {Hackl, Michael and Leschinger, T. and Staat, Manfred and M{\"u}ller, Lars-Peter and Wegmann, Kilian},
  title     = {Reconstruction of the interosseous membrane in the Essex Lopresti lesion — a biomechanical evaluation},
  series = {Knee surgery, sports traumatology, arthroscopy},
  volume    = {Volume 24},
  journal   = {Knee surgery, sports traumatology, arthroscopy},
  number    = {Supplement 1},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {0942-2056},
  doi       = {10.1007/s00167-016-4080-7},
  pages     = {130 -- 131},
  year      = {2016},
  abstract  = {Surgical reconstruction of the interosseous membrane (IOM) could restore longitudinal forearm stability to avoid persisting disability due to capituloradial and ulnocarpal impingement in Essex Lopresti lesions. This biomechanical study aimed to assess longitudinal forearm stability of intact specimens, after sectioning of the IOM and after reconstruction with a TightRope construct using either a single or double bundle technique.},
  language  = {en}
}
@article{WegmannHacklStaatetal.2016,
  author    = {Wegmann, Kilian and Hackl, Michael and Staat, Manfred and Mayer, Katharina and M{\"u}ller, Lars-Peter},
  title     = {Double plate osteosynthesis of proximal ulna fractures: biomechanical and clinical results},
  series = {Knee surgery, sports traumatology, arthroscopy},
  volume    = {Volume 24},
  journal   = {Knee surgery, sports traumatology, arthroscopy},
  number    = {Supplement 1},
  publisher = {Springer},
  address   = {Berlin},
  issn      = {0942-2056},
  doi       = {10.1007/s00167-016-4079-0},
  pages     = {58 -- 59},
  year      = {2016},
  abstract  = {While plate fixation of proximal ulna fractures might lead to superior clinical results compared to tension band wiring, regular plates represent an established risk factor for wound complications. The olecranon double plates (Medartis, Basel, CH) might decrease complications related to the osteosynthesis because of their low profile and better anatomical fit. This study aimed to evaluate the biomechanical performance and clinical results of the olecranon double plates.},
  language  = {en}
}
@article{Wollert2016,
  author    = {Wollert, J{\"o}rg},
  title     = {Rapid Application Development},
  series = {Design \& Elektronik},
  journal   = {Design \& Elektronik},
  number    = {4},
  publisher = {WEKA-Fachmedien},
  address   = {M{\"u}nchen},
  issn      = {0933-8667},
  pages     = {8 -- 11},
  year      = {2016},
  abstract  = {Das IoT ist ohne eingebettete Systeme undenkbar. Erst kleine und kleinste Mikrocontroller mit intelligenten Kommunikationsschnittstellen und Anbindung ans Internet erm{\"o}glichen sinnvolles und fl{\"a}chendeckendes Einsammeln von Daten. Doch wie kompliziert ist der Einstieg in die Embedded-Welt? Dieser Artikel gibt Einblick, wie die »Arduino-Plattform« die Einstiegsh{\"u}rden f{\"u}r eingebettete Systeme dramatisch reduzieren kann.},
  language  = {de}
}
@article{Wollert2016,
  author    = {Wollert, J{\"o}rg},
  title     = {Industrial Internet of Things : Seifenblase oder Revolution},
  series = {Elektronik},
  journal   = {Elektronik},
  number    = {7},
  publisher = {WEKA-Fachmedien},
  address   = {M{\"u}nchen},
  issn      = {0013-5658},
  pages     = {39 -- 45},
  year      = {2016},
  language  = {de}
}
@article{BreuerRaueStrobeletal.2016,
  author    = {Breuer, Lars and Raue, Markus and Strobel, M. and Mang, Thomas and Sch{\"o}ning, Michael Josef and Thoelen, R. and Wagner, Torsten},
  title     = {Hydrogels with incorporated graphene oxide as light-addressable actuator materials for cell culture environments in lab-on-chip systems},
  series = {Physica status solidi (a)},
  volume    = {213},
  journal   = {Physica status solidi (a)},
  number    = {6},
  publisher = {Wiley-VCH},
  address   = {Weinheim},
  issn      = {1862-6300},
  doi       = {10.1002/pssa.201533056},
  pages     = {1520 -- 1525},
  year      = {2016},
  abstract  = {Abstractauthoren Graphene oxide (GO) nanoparticles were incorporated in temperature-sensitive Poly(N-isopropylacrylamide) (PNIPAAm) hydrogels. The nanoparticles increase the light absorption and convert light energy into heat efficiently. Thus, the hydrogels with GO can be stimulated spatially resolved by illumination as it was demonstrated by IR thermography. The temporal progression of the temperature maximum was detected for different concentrations of GO within the polymer network. Furthermore, the compatibility of PNIPAAm hydrogels with GO and cell cultures was investigated. For this purpose, culture medium was incubated with hydrogels containing GO and the viability and morphology of chinese hamster ovary (CHO) cells was examined after several days of culturing in presence of this medium.},
  language  = {en}
}