@article{FingerBraunBil2020,
  author    = {Finger, Felix and Braun, Carsten and Bil, Cees},
  title     = {Impact of Battery Performance on the Initial Sizing of Hybrid-Electric General Aviation Aircraft},
  series = {Journal of Aerospace Engineering},
  volume    = {33},
  journal   = {Journal of Aerospace Engineering},
  number    = {3},
  publisher = {ASCE},
  address   = {Reston, Va.},
  issn      = {1943-5525},
  doi       = {10.1061/(ASCE)AS.1943-5525.0001113},
  year      = {2020},
  abstract  = {Studies suggest that hybrid-electric aircraft have the potential to generate fewer emissions and be inherently quieter when compared to conventional aircraft. By operating combustion engines together with an electric propulsion system, synergistic benefits can be obtained. However, the performance of hybrid-electric aircraft is still constrained by a battery's energy density and discharge rate. In this paper, the influence of battery performance on the gross mass for a four-seat general aviation aircraft with a hybrid-electric propulsion system is analyzed. For this design study, a high-level approach is chosen, using an innovative initial sizing methodology to determine the minimum required aircraft mass for a specific set of requirements and constraints. Only the peak-load shaving operational strategy is analyzed. Both parallel- and serial-hybrid propulsion configurations are considered for two different missions. The specific energy of the battery pack is varied from 200 to 1,000 W⋅h/kg, while the discharge time, and thus the normalized discharge rating (C-rating), is varied between 30 min (2C discharge rate) and 2 min (30C discharge rate). With the peak-load shaving operating strategy, it is desirable for hybrid-electric aircraft to use a light, low capacity battery system to boost performance. For this case, the battery's specific power rating proved to be of much higher importance than for full electric designs, which have high capacity batteries. Discharge ratings of 20C allow a significant take-off mass reduction aircraft. The design point moves to higher wing loadings and higher levels of hybridization if batteries with advanced technology are used.},
  language  = {en}
}
@book{Heuermann2020,
  author    = {Heuermann, Holger},
  title     = {Mikrowellentechnik: Feldsimulation, nichtlineare Schaltungstechnik, Komponenten und Subsysteme, Plasmatechnik, Antennen und Ausbreitung},
  publisher = {Springer Vieweg},
  address   = {Wiesbaden},
  isbn      = {978-3-658-29023-8 (eBook)},
  doi       = {10.1007/978-3-658-29023-8},
  pages     = {Online-Ressource (XIV, 385 S. 374 Abb., 22 Abb. in Farbe)},
  year      = {2020},
  language  = {de}
}
@article{EggertMoulen2020,
  author    = {Eggert, Mathias and Moulen, Tobias},
  title     = {Selektion von Gesch{\"a}ftsprozessen zur Anwendung von Robotic Process Automation am Beispiel einer Versicherung},
  series = {HMD Praxis der Wirtschaftsinformatik},
  volume    = {57},
  journal   = {HMD Praxis der Wirtschaftsinformatik},
  number    = {6},
  publisher = {Springer},
  address   = {Weinheim},
  issn      = {1436-3011},
  doi       = {10.1365/s40702-020-00665-0},
  pages     = {1150 -- 1162},
  year      = {2020},
  abstract  = {H{\"a}ufig bremsen geringe IT-Ressourcen, fehlende Softwareschnittstellen oder eine veraltete und komplex gewachsene Systemlandschaft die Automatisierung von Gesch{\"a}ftsprozessen. Robotic Process Automation (RPA) ist eine vielversprechende Methode, um Gesch{\"a}ftsprozesse oberfl{\"a}chenbasiert und ohne gr{\"o}ßere Systemeingriffe zu automatisieren und Medienbr{\"u}che abzubauen. Die Auswahl der passenden Prozesse ist dabei f{\"u}r den Erfolg von RPA-Projekten entscheidend. Der vorliegende Beitrag liefert daf{\"u}r Selektionskriterien, die aus einer qualitativen Inhaltanalyse von elf Interviews mit RPA-Experten aus dem Versicherungsumfeld resultieren. Das Ergebnis umfasst eine gewichtetet Liste von sieben Dimensionen und 51 Prozesskriterien, welche die Automatisierung mit Softwarerobotern beg{\"u}nstigen bzw. deren Nichterf{\"u}llung eine Umsetzung erschweren oder sogar verhindern. Die drei wichtigsten Kriterien zur Auswahl von Gesch{\"a}ftsprozessen f{\"u}r die Automatisierung mittels RPA umfassen die Entlastung der an dem Prozess mitwirkenden Mitarbeiter (Arbeitnehmer{\"u}berlastung), die Ausf{\"u}hrbarkeit des Prozesses mittels Regeln (Regelbasierte Prozessteuerung) sowie ein positiver Kosten-Nutzen-Vergleich. Praktiker k{\"o}nnen diese Kriterien verwenden, um eine systematische Auswahl von RPA-relevanten Prozessen vorzunehmen. Aus wissenschaftlicher Perspektive stellen die Ergebnisse eine Grundlage zur Erkl{\"a}rung des Erfolgs und Misserfolgs von RPA-Projekten dar.},
  language  = {de}
}
@article{Golland2020,
  author    = {Golland, Alexander},
  title     = {Die „private" Datenverarbeitung im Internet. Verantwortlichkeiten und Rechtm{\"a}ßigkeit bei Nutzung von Plattformdiensten durch nat{\"u}rliche Personen},
  series = {ZD Zeitschrift f{\"u}r Datenschutz},
  volume    = {10},
  journal   = {ZD Zeitschrift f{\"u}r Datenschutz},
  number    = {8},
  editor    = {Hoeren, Thomas and Schneider, Jochen and Selmayr, Martin and Spies, Axel and Wybitul, Tim},
  publisher = {Beck},
  address   = {M{\"u}nchen},
  isbn      = {2192-5593},
  pages     = {397 -- 403},
  year      = {2020},
  language  = {de}
}
@inproceedings{EltesterFerreinSchiffer2020,
  author    = {Eltester, Niklas Sebastian and Ferrein, Alexander and Schiffer, Stefan},
  title     = {A smart factory setup based on the RoboCup logistics league},
  series = {2020 IEEE Conference on Industrial Cyberphysical Systems (ICPS)},
  booktitle = {2020 IEEE Conference on Industrial Cyberphysical Systems (ICPS)},
  publisher = {IEEE},
  address   = {New York, NY},
  doi       = {10.1109/ICPS48405.2020.9274766},
  pages     = {297 -- 302},
  year      = {2020},
  abstract  = {In this paper we present SMART-FACTORY, a setup for a research and teaching facility in industrial robotics that is based on the RoboCup Logistics League. It is driven by the need for developing and applying solutions for digital production. Digitization receives constantly increasing attention in many areas, especially in industry. The common theme is to make things smart by using intelligent computer technology. Especially in the last decade there have been many attempts to improve existing processes in factories, for example, in production logistics, also with deploying cyber-physical systems. An initiative that explores challenges and opportunities for robots in such a setting is the RoboCup Logistics League. Since its foundation in 2012 it is an international effort for research and education in an intra-warehouse logistics scenario. During seven years of competition a lot of knowledge and experience regarding autonomous robots was gained. This knowledge and experience shall provide the basis for further research in challenges of future production. The focus of our SMART-FACTORY is to create a stimulating environment for research on logistics robotics, for teaching activities in computer science and electrical engineering programmes as well as for industrial users to study and explore the feasibility of future technologies. Building on a very successful history in the RoboCup Logistics League we aim to provide stakeholders with a dedicated facility oriented at their individual needs.},
  language  = {en}
}
@book{LohseLaumannWolf2020,
  author    = {Lohse, Wolfram and Laumann, J{\"o}rg and Wolf, Christian},
  title     = {Stahlbau 2},
  edition   = {21., vollst. akt. und {\"u}berarb. Aufl.},
  publisher = {Springer Vieweg},
  address   = {Wiesbaden},
  isbn      = {978-3-8348-2116-4},
  doi       = {10.1007/978-3-8348-2116-4},
  year      = {2020},
  language  = {de}
}
@misc{Golland2020,
  author    = {Golland, Alexander},
  title     = {Anspruch gegen einen Suchmaschinenbetreiber auf L{\"o}schung von Suchergebnissen},
  series = {ZD Zeitschrift f{\"u}r Datenschutz},
  volume    = {2020},
  journal   = {ZD Zeitschrift f{\"u}r Datenschutz},
  number    = {10},
  publisher = {Beck},
  address   = {M{\"u}nchen},
  issn      = {2192-5593},
  pages     = {531 -- 532},
  year      = {2020},
  language  = {de}
}
@article{Golland2020,
  author    = {Golland, Alexander},
  title     = {Weckruf f{\"u}r deutsche Großunternehmen? - Der neue Entwurf des IT-Sicherheitsgesetz 2.0},
  series = {K\&R Kommunikation \& Recht},
  volume    = {23},
  journal   = {K\&R Kommunikation \& Recht},
  number    = {7-8},
  publisher = {DFV Mediengruppe},
  address   = {Frankfurt a.M.},
  isbn      = {1434-6354},
  pages     = {I},
  year      = {2020},
  language  = {de}
}
@misc{Golland2020,
  author    = {Golland, Alexander},
  title     = {Rezension zu: Auernhammer - DSGVO/BDSG, Kommentar (7. Auflage, 2020)},
  series = {DSB Datenschutz-Berater},
  volume    = {44},
  journal   = {DSB Datenschutz-Berater},
  number    = {10},
  publisher = {DFV Mediengruppe},
  address   = {Frankfurt a.M.},
  issn      = {0170-7256},
  pages     = {260},
  year      = {2020},
  language  = {de}
}
@article{HoffstadtPohenDickeetal.2020,
  author    = {Hoffstadt, Kevin and Pohen, Gino D. and Dicke, Max D. and Paulsen, Svea and Krafft, Simone and Zang, Joachim W. and Fonseca-Zang, Warde A. da and Leite, Athaydes and Kuperjans, Isabel},
  title     = {Challenges and prospects of biogas from energy cane as supplement to bioethanol production},
  series = {Agronomy},
  volume    = {10},
  journal   = {Agronomy},
  number    = {6},
  publisher = {MDPI},
  address   = {Basel},
  issn      = {2073-4395},
  doi       = {10.3390/agronomy10060821},
  year      = {2020},
  abstract  = {Innovative breeds of sugar cane yield up to 2.5 times as much organic matter as conventional breeds, resulting in a great potential for biogas production. The use of biogas production as a complementary solution to conventional and second-generation ethanol production in Brazil may increase the energy produced per hectare in the sugarcane sector. Herein, it was demonstrated that through ensiling, energy cane can be conserved for six months; the stored cane can then be fed into a continuous biogas process. This approach is necessary to achieve year-round biogas production at an industrial scale. Batch tests revealed specific biogas potentials between 400 and 600 LN/kgVS for both the ensiled and non-ensiled energy cane, and the specific biogas potential of a continuous biogas process fed with ensiled energy cane was in the same range. Peak biogas losses through ensiling of up to 27\% after six months were observed. Finally, compared with second-generation ethanol production using energy cane, the results indicated that biogas production from energy cane may lead to higher energy yields per hectare, with an average energy yield of up to 162 MWh/ha. Finally, the Farm²CBG concept is introduced, showing an approach for decentralized biogas production.},
  language  = {en}
}