TY  - JOUR
A1  - Miyamato, Ko-ichiro
A1  - Sakakita, Sakura
A1  - Wagner, Torsten
A1  - Schöning, Michael Josef
A1  - Yoshinobu, Tatsuo
T1  - Application of chemical imaging sensor to in-situ pH imaging in the vicinity of a corroding metal surface
JF  - Electrochimica Acta
N2  - The chemical imaging sensor was applied to in-situ pH imaging of the solution in the vicinity of a corroding surface of stainless steel under potentiostatic polarization. A test piece of polished stainless steel was placed on the sensing surface leaving a narrow gap filled with artificial seawater and the stainless steel was corroded under polarization. The pH images obtained during polarization showed correspondence between the region of lower pH and the site of corrosion. It was also found that the pH value in the gap became as low as 2 by polarization, which triggered corrosion.
Y1  - 2015
U6  - https://doi.org/10.1016/j.electacta.2015.07.184
SN  - 0013-4686
VL  - 183
SP  - 137
EP  - 142
PB  - Elsevier
CY  - Amsterdam
ER  - 
TY  - JOUR
A1  - Schusser, Sebastian
A1  - Krischer, Maximillian
A1  - Bäcker, Matthias
A1  - Poghossian, Arshak
A1  - Wagner, Patrick
A1  - Schöning, Michael Josef
T1  - Monitoring of the Enzymatically Catalyzed Degradation of Biodegradable Polymers by Means of Capacitive Field-Effect Sensors
JF  - Analytical Chemistry
N2  - Designing novel or optimizing existing biodegradable polymers for biomedical applications requires numerous tests on the effect of substances on the degradation process. In the present work, polymer-modified electrolyte–insulator–semiconductor (PMEIS) sensors have been applied for monitoring an enzymatically catalyzed degradation of polymers for the first time. The thin films of biodegradable polymer poly(d,l-lactic acid) and enzyme lipase were used as a model system. During degradation, the sensors were read-out by means of impedance spectroscopy. In order to interpret the data obtained from impedance measurements, an electrical equivalent circuit model was developed. In addition, morphological investigations of the polymer surface have been performed by means of in situ atomic force microscopy. The sensor signal change, which reflects the progress of degradation, indicates an accelerated degradation in the presence of the enzyme compared to hydrolysis in neutral pH buffer media. The degradation rate increases with increasing enzyme concentration. The obtained results demonstrate the potential of PMEIS sensors as a very promising tool for in situ and real-time monitoring of degradation of polymers.
Y1  - 2015
U6  - https://doi.org/10.1021/acs.analchem.5b00617
SN  - 1520-6882
VL  - 87
IS  - 13
SP  - 6607
EP  - 6613
PB  - ACS Publications
CY  - Washington, DC
ER  - 
TY  - JOUR
A1  - Grundmann, Jan Thimo
A1  - Dachwald, Bernd
A1  - Grimm, Christian D.
A1  - Kahle, Ralph
A1  - Koch, Aaron Dexter
A1  - Krause, Christian
A1  - Lange, Caroline
A1  - Quantius, Dominik
A1  - Ulamec, Stephan
T1  - Spacecraft for Hypervelocity Impact Research – An Overview of Capabilities, Constraints and the Challenges of Getting There
JF  - Procedia Engineering
Y1  - 2015
U6  - https://doi.org/10.1016/j.proeng.2015.04.021
SN  - 1877-7058
N1  - Proceedings of the 2015 Hypervelocity Impact Symposium (HVIS 2015)
VL  - Vol. 103
SP  - 151
EP  - 158
PB  - Elsevier
CY  - Amsterdam
ER  - 
TY  - JOUR
A1  - Kowalski, Julia
A1  - Linder, Peter
A1  - Zierke, S.
A1  - Wulfen, B. van
A1  - Clemens, J.
A1  - Konstantinidis, K.
A1  - Ameres, G.
A1  - Hoffmann, R.
A1  - Mikucki, J.
A1  - Tulaczyk, S.
A1  - Funke, O.
A1  - Blandfort, D.
A1  - Espe, Clemens
A1  - Feldmann, Marco
A1  - Francke, Gero
A1  - Hiecker, S.
A1  - Plescher, Engelbert
A1  - Schöngarth, Sarah
A1  - Dachwald, Bernd
A1  - Digel, Ilya
A1  - Artmann, Gerhard
A1  - Eliseev, D.
A1  - Heinen, D.
A1  - Scholz, F.
A1  - Wiebusch, C.
A1  - Macht, S.
A1  - Bestmann, U.
A1  - Reineking, T.
A1  - Zetzsche, C.
A1  - Schill, K.
A1  - Förstner, R.
A1  - Niedermeier, H.
A1  - Szumski, A.
A1  - Eissfeller, B.
A1  - Naumann, U.
A1  - Helbing, K.
T1  - Navigation technology for exploration of glacier ice with maneuverable melting probes
JF  - Cold Regions Science and Technology
N2  - The Saturnian moon Enceladus with its extensive water bodies underneath a thick ice sheet cover is a potential candidate for extraterrestrial life. Direct exploration of such extraterrestrial aquatic ecosystems requires advanced access and sampling technologies with a high level of autonomy. A new technological approach has been developed as part of the collaborative research project Enceladus Explorer (EnEx). The concept is based upon a minimally invasive melting probe called the IceMole. The force-regulated, heater-controlled IceMole is able to travel along a curved trajectory as well as upwards. Hence, it allows maneuvers which may be necessary for obstacle avoidance or target selection. Maneuverability, however, necessitates a sophisticated on-board navigation system capable of autonomous operations. The development of such a navigational system has been the focal part of the EnEx project. The original IceMole has been further developed to include relative positioning based on in-ice attitude determination, acoustic positioning, ultrasonic obstacle and target detection integrated through a high-level sensor fusion. This paper describes the EnEx technology and discusses implications for an actual extraterrestrial mission concept.
Y1  - 2016
U6  - https://doi.org/10.1016/j.coldregions.2015.11.006
SN  - 0165-232X
IS  - 123
SP  - 53
EP  - 70
PB  - Elsevier
CY  - Amsterdam
ER  - 
TY  - JOUR
A1  - Taddei, Francesca
A1  - Butenweg, Christoph
A1  - Klinkel, S.
T1  - Parametric investigation of the soil-structure interaction effects on the dynamic behaviour of a shallow foundation supported wind turbine considering a layered soil
JF  - Wind energy : an international journal for progress and applications in wind power conversion technology
Y1  - 2015
U6  - https://doi.org/10.1002/we.1703
SN  - 1099-1824 (E-Journal); 1095-4244 (Print)
VL  - Volume 18
IS  - Issue 3
SP  - 399
EP  - 417
PB  - Wiley
CY  - Weinheim
ER  - 
TY  - JOUR
A1  - Edip, Kemal
A1  - Garevski, Mihail
A1  - Butenweg, Christoph
A1  - Sesov, Vlatko
A1  - Cvetanovska, Julijana
A1  - Gjorgiev, Igor
T1  - Numerical simulation of geotechnical problems by coupled finite and infinite elements
JF  - Journal of civil engineering and architecture
Y1  - 2013
SN  - 1934-7359 (E-Journal)
VL  - 7
IS  - 1
SP  - 68
EP  - 77
PB  - David Publishing
CY  - Libertyville
ER  - 
TY  - JOUR
A1  - Holtschoppen, Britta
A1  - Butenweg, Christoph
A1  - Meskouris, Konstantin
T1  - Seismic design of non-structural components in industrial facilities
JF  - International journal of engineering under uncertainty
Y1  - 2009
SN  - 0975-4806
VL  - Volume 1
SP  - 1
EP  - 13
ER  - 
TY  - JOUR
A1  - Gömmel, Andreas
A1  - Butenweg, Christoph
A1  - Bolender, Katrin
A1  - Grunendahl, Arno
T1  - A muscle controlled finite-element model of laryngeal abduction and adduction
JF  - Computer methods in biomechanics and biomedical engineering
Y1  - 2007
SN  - 1476-8259 (E-Journal); 1025-5842 (Print)
VL  - Volume 10
IS  - Issue 5
SP  - 377
EP  - 388
ER  - 
TY  - JOUR
A1  - Rochefort, E. de
A1  - Verver, M.
A1  - Grunendahl, A.
A1  - Mooi, H.
A1  - Butenweg, Christoph
T1  - Detailed modelling of the lumbar spine for investigations of low back pain
JF  - SAE transactions : papers presented at Society and Section meetings / Society of Automotive Engineers
Y1  - 2005
SN  - 0096-736X
VL  - Volume 114
IS  - Part 7
SP  - 788
EP  - 796
ER  - 
TY  - JOUR
A1  - Mistler, Michael
A1  - Anthoine, A.
A1  - Butenweg, Christoph
T1  - In-plane and out-of-plane homogenisation of masonry
JF  - Computers & structures
Y1  - 2007
U6  - https://doi.org/10.1016/j.compstruc.2006.08.087
SN  - 1879-2243 (E-Journal); 0045-7949 (Print)
VL  - Volume 85
IS  - Issues 17-18
SP  - 1321
EP  - 1330
ER  -