TY  - GEN
A1  - Hille, Sebastian
A1  - Stumpf, Eike
A1  - Mayntz, Joscha
A1  - Dahmann, Peter
T1  - Prediction of sound exposure caused by a landing motor glider with recuperating propellers
T2  - AIAA SCITECH 2023 Forum
N2  - This paper presents an approach to predicting the sound exposure on the ground caused by a landing aircraft with recuperating propellers. The noise source along the trajectory of a flight specified for a steeper approach is simulated based on measurements of sound power levels and additional parameters of a single propeller placed in a wind tunnel. To validate the measured data/measurement results, these simulations are also supported by overflight measurements of a test aircraft. It is shown that the simple source models of propellers do not provide fully satisfactory results since the sound levels are estimated too low. Nevertheless, with a further reference comparison, margins for an acceptable increase in the sound power level of the aircraft on its now steeper approach path could be estimated. Thus, in this case, a +7 dB increase in SWL would not increase the SEL compared to the conventional approach within only 2 km ahead of the airfield.
Y1  - 2023
U6  - https://doi.org/10.2514/6.2023-0211
N1  - AIAA SCITECH 2023 Forum, 23-27 January 2023, National Harbor, Md & Online
PB  - AIAA
CY  - Reston, Va.
ER  - 
TY  - JOUR
A1  - Anik, Sabri
A1  - Frohberg, Martin G.
A1  - Kapoor, Madan Lal
T1  - Prediction of thermodynamic properties of oxygen in binary metallic solvents
JF  - Zeitschrift für Metallkunde
Y1  - 1983
SN  - 0044-3093
VL  - 74
IS  - 6
SP  - 372
EP  - 375
ER  - 
TY  - JOUR
A1  - Schöning, Michael Josef
A1  - Doll, Theodor
A1  - Wagner, Patrick
T1  - Preface / Doll, Theodor ; Wagner, Patrick ; Schöning, Michael J.
JF  - physica status solidi (a) . 206 (2009), H. 3
Y1  - 2009
SN  - 1862-6319
N1  - Special Issue: Engineering of Functional Interfaces (EnFI 08)
SP  - 389
EP  - 390
ER  - 
TY  - JOUR
A1  - Kezerashvili, Roman Ya
A1  - Dachwald, Bernd
T1  - Preface: Solar sailing: Concepts, technology, and missions II
JF  - Advances in Space Research
Y1  - 2021
U6  - https://doi.org/10.1016/j.asr.2021.01.037
SN  - 0273-1177
VL  - 67
IS  - 9
SP  - 2559
EP  - 2560
PB  - Elsevier
CY  - Amsterdam
ER  - 
TY  - CHAP
A1  - Knott, Thomas C.
A1  - Sofronia, Raluca E.
A1  - Gerressen, Marcus
A1  - Law, Yuen
A1  - Davidescu, Arjana
A1  - Savii, George G.
A1  - Gatzweiler, Karl-Heinz
A1  - Staat, Manfred
A1  - Kuhlen, Torsten W.
T1  - Preliminary bone sawing model for a virtual reality-based training simulator of bilateral sagittal split osteotomy
T2  - Biomedical simulation : 6th International Symposium, ISBMS 2014, Strasbourg, France, October 16-17, 2014 : proceedings (Lecture notes in computer science : vol. 8789)
N2  - Successful bone sawing requires a high level of skill and experience, which could be gained by the use of Virtual Reality-based simulators. A key aspect of these medical simulators is realistic force feedback. The aim of this paper is to model the bone sawing process in order to develop a valid training simulator for the bilateral sagittal split osteotomy, the most often applied corrective surgery in case of a malposition of the mandible. Bone samples from a human cadaveric mandible were tested using a designed experimental system. Image processing and statistical analysis were used for the selection of four models for the bone sawing process. The results revealed a polynomial dependency between the material removal rate and the applied force. Differences between the three segments of the osteotomy line and between the cortical and cancellous bone were highlighted.
KW  - Bone sawing
KW  - virtual reality
KW  - training simulator
Y1  - 2014
SN  - 978-3-319-12057-7 (Online)
SN  - 978-3-319-12056-0 (Print)
U6  - https://doi.org/10.1007/978-3-319-12057-7_1
SP  - 1
EP  - 10
PB  - Springer
CY  - Cham
ER  - 
TY  - CHAP
A1  - Kumaran, P.
A1  - Gopinathan, M.
A1  - Razali, N. M.
A1  - Kuperjans, Isabel
A1  - Hariffin, B.
A1  - Hamdan, H.
T1  - Preliminary evaluation of atomization characteristics of improved biodiesel for gas turbine application
T2  - IOP Conference Series: Earth and Environmental Science (EES)
Y1  - 2013
U6  - https://doi.org/10.1088/1755-1315/16/1/012014
SN  - 1755-1315
VL  - 16
IS  - 1
SP  - 012014/1
EP  - 012014/4
PB  - Institute of Physics Publishing (IOP)
CY  - London [u.a.]
ER  - 
TY  - JOUR
A1  - Biener, Ernst
A1  - Sasse, T.
A1  - Bökers, H.
T1  - Preliminary or final capping of sanitary landfills? : Technical and economical aspects
JF  - Sardinia 99 : proceedings / Seventh International Waste Management and Landfill Symposium, [4 - 8 October 1999, S. Margherita di Pula, Cagliari, Sardinia, Italy]. Ed.: Thomas H. Christensen. -  Bd. 3 : Barriers, waste mechanics and landfill design
Y1  - 1999
N1  - International Waste Management and Landfill Symposium <7, 1999, Cagliari>
SP  - 287
EP  - 294
PB  - CISA, Environmental Sanitary Engineering Centre
CY  - Cagliari
ER  - 
TY  - JOUR
A1  - Khodaverdi, M.
A1  - Pauly, F.
A1  - Schroder, G.
A1  - Ziemons, Karl
A1  - Sievering, R.
A1  - Halling, H.
T1  - Preliminary studies of a micro-CT for a combined small animal PET/CT scanner
JF  - 2001 IEEE Nuclear Science Symposium Conference Record, Vol. 3
N2  - We are developing an X-ray computed tomography (CT) system which will be combined with a high resolution animal PET system. This permits acquisition of both molecular and anatomical images in a single machine. In particular the CT will also be utilized for the quantification of the animal PET data by providing accurate data for attenuation correction. A first prototype has been built using a commercially available plane silicon diode detector. A cone-beam reconstruction provides the images using the Feldkamp algorithm. First measurements with this system have been performed on a mouse. It could be shown that the CT setup fulfils all demands for a high quality image of the skeleton of the mouse. It is also suited for soft tissue measurements. To improve contrast and resolution and to acquire the X-ray energy further development of the system, especially the use of semiconductor detectors and iterative reconstruction algorithms are planned.
Y1  - 2002
SN  - 1082-3654
SP  - 1605
EP  - 1606
ER  - 
TY  - CHAP
A1  - Peloni, A.
A1  - Ceriotti, M.
A1  - Dachwald, Bernd
T1  - Preliminary trajectory design of a multiple NEO rendezvous mission through solar sailing
T2  - Proceedings of the International Astronautical Congress, IAC, Vol. 8, 2014
Y1  - 2015
SN  - 978-1-63439-986-9
SP  - 5352
EP  - 5366
PB  - Curran
CY  - Red Hook, NY
ER  - 
TY  - BOOK
A1  - Lauth, Jakob
A1  - Harreus, Albrecht
A1  - Götz, Norbert
A1  - Rang, Harald [u.a.]
T1  - Preparation O-(2-Hydroxyalkyl)Oximes = of Verfahren zur Herstellung von O-(2-Hydroxy)Oximen : Europäische Patentschrift EP0775107B1 ; Veröffentlichungstag im Patentblatt: 18.11.1999 / Anmelder: BASF AG, 67063 Ludwigshafen. Erfinder: Albrecht Harreus ; Norbert Götz ; Harald Rang ... Günter Lauth
Y1  - 1999
N1  - Volltext über Datenbank: http://publikationen.dpma.de/ ; Text in engl. ; Deutsche Übersetzung unter DE69512786T2 ; Internationale Veröffentlichungsnummer: WO 96/04238
PB  - Europäisches Patentamt
CY  - [München u.a.]
ER  -