TY - JOUR A1 - Karschuck, Tobias A1 - Poghossian, Arshak A1 - Ser, Joey A1 - Tsokolakyan, Astghik A1 - Achtsnicht, Stefan A1 - Wagner, Patrick A1 - Schöning, Michael Josef T1 - Capacitive model of enzyme-modified field-effect biosensors: Impact of enzyme coverage JF - Sensors and Actuators B: Chemical N2 - Electrolyte-insulator-semiconductor capacitors (EISCAP) belong to field-effect sensors having an attractive transducer architecture for constructing various biochemical sensors. In this study, a capacitive model of enzyme-modified EISCAPs has been developed and the impact of the surface coverage of immobilized enzymes on its capacitance-voltage and constant-capacitance characteristics was studied theoretically and experimentally. The used multicell arrangement enables a multiplexed electrochemical characterization of up to sixteen EISCAPs. Different enzyme coverages have been achieved by means of parallel electrical connection of bare and enzyme-covered single EISCAPs in diverse combinations. As predicted by the model, with increasing the enzyme coverage, both the shift of capacitance-voltage curves and the amplitude of the constant-capacitance signal increase, resulting in an enhancement of analyte sensitivity of the EISCAP biosensor. In addition, the capability of the multicell arrangement with multi-enzyme covered EISCAPs for sequentially detecting multianalytes (penicillin and urea) utilizing the enzymes penicillinase and urease has been experimentally demonstrated and discussed. KW - Field-effect biosensor KW - Capacitive model KW - Enzyme coverage KW - Multianalyte detection KW - Penicillin Y1 - 2024 U6 - http://dx.doi.org/10.1016/j.snb.2024.135530 SN - 0925-4005 (Print) SN - 1873-3077 (Online) N1 - Corresponding Author: Michael J. Schöning VL - 408 PB - Elsevier CY - Amsterdam ER - TY - JOUR A1 - Turdumamatov, Samat A1 - Belda, Aljoscha A1 - Heuermann, Holger T1 - Shaping a decoupled atmospheric pressure microwave plasma with antenna structures, Maxwell’s equations, and boundary conditions JF - IEEE Transactions on Plasma Science N2 - This article addresses the need for an innovative technique in plasma shaping, utilizing antenna structures, Maxwell’s laws, and boundary conditions within a shielded environment. The motivation lies in exploring a novel approach to efficiently generate high-energy density plasma with potential applications across various fields. Implemented in an E01 circular cavity resonator, the proposed method involves the use of an impedance and field matching device with a coaxial connector and a specially optimized monopole antenna. This setup feeds a low-loss cavity resonator, resulting in a high-energy density air plasma with a surface temperature exceeding 3500 o C, achieved with a minimal power input of 80 W. The argon plasma, resembling the shape of a simple monopole antenna with modeled complex dielectric values, offers a more energy-efficient alternative compared to traditional, power-intensive plasma shaping methods. Simulations using a commercial electromagnetic (EM) solver validate the design’s effectiveness, while experimental validation underscores the method’s feasibility and practical implementation. Analyzing various parameters in an argon atmosphere, including hot S -parameters and plasma beam images, the results demonstrate the successful application of this technique, suggesting its potential in coating, furnace technology, fusion, and spectroscopy applications. KW - 3-D printing KW - Furnace KW - Fusion KW - Hot S-parameter KW - Mode converter Y1 - 2024 U6 - http://dx.doi.org/10.1109/TPS.2024.3383589 SN - 0093-3813 (Print) SN - 1939-9375 (Online) IS - Early Access SP - 1 EP - 9 PB - IEEE ER - TY - JOUR A1 - Böhnisch, Nils A1 - Braun, Carsten A1 - Muscarello, Vincenzo A1 - Marzocca, Pier T1 - About the wing and whirl flutter of a slender wing–propeller system JF - Journal of Aircraft N2 - Next-generation aircraft designs often incorporate multiple large propellers attached along the wingspan (distributed electric propulsion), leading to highly flexible dynamic systems that can exhibit aeroelastic instabilities. This paper introduces a validated methodology to investigate the aeroelastic instabilities of wing–propeller systems and to understand the dynamic mechanism leading to wing and whirl flutter and transition from one to the other. Factors such as nacelle positions along the wing span and chord and its propulsion system mounting stiffness are considered. Additionally, preliminary design guidelines are proposed for flutter-free wing–propeller systems applicable to novel aircraft designs. The study demonstrates how the critical speed of the wing–propeller systems is influenced by the mounting stiffness and propeller position. Weak mounting stiffnesses result in whirl flutter, while hard mounting stiffnesses lead to wing flutter. For the latter, the position of the propeller along the wing span may change the wing mode shapes and thus the flutter mechanism. Propeller positions closer to the wing tip enhance stability, but pusher configurations are more critical due to the mass distribution behind the elastic axis. Y1 - 2024 U6 - http://dx.doi.org/10.2514/1.C037542 SN - 1533-3868 SP - 1 EP - 14 PB - American Institute of Aeronautics and Astronautics ER - TY - JOUR A1 - Schopp, Christoph A1 - Rohrbach, Felix A1 - Langer, Luc A1 - Heuermann, Holger T1 - Detection of welding wire length by active S11 measurement JF - IEEE Transactions on Plasma Science N2 - A novel method to determine the extruded length of a metallic wire for a directed energy deposition (DED) process using a microwave (MW) plasma jet with a straight-through wire feed is presented. The method is based on the relative comparison of the measured frequency response obtained by the large-signal scattering parameter (Hot-S) technique. In the practical working range, repeatability of less than 6% for a nonactive plasma and 9% for the active plasma state is found. Measurements are conducted with a focus on a simple solution to decrease the processing time and reduce the integration time of the process into the existing hardware. It is shown that monitoring a single frequency for magnitude and phase changes is sufficient to achieve good accuracy. A combination of different measurement values to determine the length is possible. The applicability to different diameter of the same material is shown as well as a contact detection of the wire and metallic substrate. KW - Circuit simulation KW - Hot S-parameter KW - Modeling KW - Plasma KW - Plasma diagnostics Y1 - 2024 U6 - http://dx.doi.org/10.1109/TPS.2024.3356659 SN - 0093-3813 (Print) SN - 1939-9375 (Online) IS - Early Access SP - 1 EP - 6 PB - IEEE ER - TY - JOUR A1 - Pieronek, Lukas A1 - Kleefeld, Andreas T1 - On trajectories of complex-valued interior transmission eigenvalues JF - Inverse problems and imaging : IPI N2 - This paper investigates the interior transmission problem for homogeneous media via eigenvalue trajectories parameterized by the magnitude of the refractive index. In the case that the scatterer is the unit disk, we prove that there is a one-to-one correspondence between complex-valued interior transmission eigenvalue trajectories and Dirichlet eigenvalues of the Laplacian which turn out to be exactly the trajectorial limit points as the refractive index tends to infinity. For general simply-connected scatterers in two or three dimensions, a corresponding relation is still open, but further theoretical results and numerical studies indicate a similar connection. KW - Interior transmission problem KW - Eigenvalue trajectories KW - Complex-valued eigenvalues Y1 - 2024 U6 - http://dx.doi.org/10.3934/ipi.2023041 SN - 1930-8337 (Print) SN - 1930-8345 (Online) VL - 18 IS - 2 SP - 480 EP - 516 PB - AIMS CY - Springfield, Mo ER - TY - JOUR T1 - Dimensionen Nr. 30 / 2023: Magazin der FH Aachen University of Applied Sciences - Der Mensch im Mittelpunkt N2 - 06| Warum es gemeinsam besser geht 10| Interview 14| Wer ist hier der Boss? 18| Schnittstelle zwischen Mensch und Technik 22| Zweite Heimat Jülich 28| Zwischen Angst und Hoffnung 32| Eine Sternstunde für die FH Aachen 36| Gegen alle Widerstände 38| Ein Ort, der bleibt 42| Der Aufblühende 46| Der Computer sitzt am Steuer 52| Da geht das Herz auf 54| Hoch hinaus 58| Beratungsangebote 60| Das alte Schätzchen T3 - Dimensionen - Magazin der FH Aachen University of Applied Sciences - 01/2023 Y1 - 2023 CY - Aachen ER - TY - THES A1 - Lambertus, Jan-Michael T1 - CardboardCastle N2 - „CardboardCastle“ ist ein 3D-Animationsfilm. Der Film zeigt die lebendig gewordene Welt zweier Königreiche aus Pappe, die in einem Streit um einen magischen Zauberstab verwickelt sind. Das Projekt beweist, dass es möglich ist, mit der Software „Blender“ einen vollwertigen und hochwertigen 3D-Animationsfilm zu erstellen. Dabei wurden alle Assets bis auf Texturen selbst hergestellt. Die virtuelle Pappe spielt hierbei eine fundamentale Rolle, für diese wurde ein vollkommen neuer Workflow entwickelt, welcher es ermöglicht, realistische Pappe zu visualisieren. „CardboardCastle“ setzt auf eine cinematische Inszenierung von Licht und vereint technisches Wissen mit unterhaltenden Inhalten. Dabei zeigt er die kindliche Vorstellungskraft und lädt die Zuschauer ein, sich an ihre eigenen kindlichen Fantasien zu erinnern. KW - 3D KW - Animation KW - Computergrafik KW - Blender Y1 - 2024 PB - FH Aachen CY - Aachen ER - TY - THES A1 - Frings, Christina T1 - Unerwünscht : Anti-Gestaltung im öffentlichen Raum N2 - »Unerwünscht« widmet sich einer Art von architektonischer Gestaltung, die auf tückische Weise als »defensive Architektur« bezeichnet wird. In Form einer Zeitung bietet sie einen umfassenden Einblick in das Thema und gewährt einen vielseitigen Blick in eine Thematik, die im Interesse der Verantwortlichen lieber im Verborgenen geblieben wäre. Defensive Architektur bezeichnet strategische Baumaßnahmen in der Stadt- und Bauplanung, die darauf abzielen, unerwünschte Personengruppen durch unpraktisches oder unbequemes Design von bestimmten Orten fernzuhalten. Diese Maßnahmen richten sich beispielsweise gegen obdachlose Menschen, Jugendliche oder Skateboarder*innen. Die überwiegende Mehrheit der Bevölkerung ist sich weder der Existenz von solchen architektonischen Maßnahmen noch ihrer Auswirkungen auf das Leben der Betroffenen bewusst. »Unerwünscht« zielt darauf ab, diese Lücke in der öffentlichen Wahrnehmung zu schließen. KW - Zeitung KW - Zeitungsdesign KW - Defensive Architektur KW - Feindliche Architektur KW - Anti-Obdachlosen Architektur Y1 - 2024 PB - FH Aachen CY - Aachen ER - TY - THES A1 - Jansen, Marie T1 - Budzi Budzi N2 - Mit über 1300 Büdchen in 86 Veedeln ist Köln Deutschlands Kiosk-Hauptstadt. Sie sind ein prägendes Element von Nachbarschaften und gehören zum Kölner Stadtbild einfach dazu wie der Dom und der Rhein. Durch Anekdoten, Interviews, Beiträge zur Popkultur, alte Fotografien, Momentaufnahmen und vertraute Grafiken sowie einer festen Formsprache entsteht das erste Büdchenmagazin für Köln. Das Periodikum erscheint alle drei Monate und liegt kostenfrei in den Büdchen aus. Es ist eine Publikation die beweist, dass Büdchen mehr als gängige Verkaufsstellen sind, sondern Knotenpunkte unserer Gesellschaft. KW - Kiosk KW - Magazin KW - Köln KW - Büdchen KW - Kultur Y1 - 2024 PB - FH Aachen CY - Aachen ER - TY - THES A1 - Liedtke, Janna T1 - Lehrmaterial für den Tiroler Skilehrerverband: Konzeption für eine crossmediale Neugestaltung N2 - Der Tiroler Skilehrerverband bereitet angehende Skilehrer:innen auf die verschiedenen Schneesportlehrer-Prüfungen vor. Skilehrer:innen spielen eine entscheidende Rolle im Erfolg des Wintertourismus, was ihre gesellschaftliche und wirtschaftliche Relevanz unterstreicht. Die zeitgemäße Neugestaltung des Lehrmaterials soll eine effektive Vermittlung von Lerninhalten ermöglichen. Durch die Kombination von Informationsdesign, Corporate Design und Editorial Design wird die Verständlichkeit und Attraktivität des Materials gesteigert. Die Integration einer Lernapp ermöglicht eine interaktive und multimediale Lernerfahrung sowie mehr Flexibilität für die Lernenden. Die crossmediale Neugestaltung wirkt den Problemen veralteter Darstellungsformen entgegen. Es wird deutlich, dass gut gestaltetes Lehrmaterial bei gleichbleibenden Inhalten zu einer besseren Lernerfahrung führt. KW - Lehrmaterial KW - Neugestaltung KW - Informationsdesign KW - Lernapp KW - Skilehrer Y1 - 2024 PB - FH Aachen CY - Aachen ER -