TY - THES A1 - Paulzen, Lena T1 - Nachhaltiges Corporate Packaging Design: Am Beispiel von Naturkosmetik Produkten. N2 - Diese Bachelorarbeit widmet sich dem nachhaltigen Packaging-Design von Kosmetikprodukten. Dies wird am Beispiel eines Naturkosmetik-Unternehmens dargestellt. Die Gestaltung einer Shampoo-Flasche wird in dem vorliegenden Projekt exemplarisch für die thematische und gestalterische Untersuchung genutzt. Zudem wurden mit Tube und Tiegel noch zwei weitere Verpackungsformen erstellt. Das Ziel dieser Arbeit ist es, eine nachhaltige Verpackung zu gestalten. Diese soll den hohen CO2-Ausstoß bei der Herstellung von Verpackungen verringern und dabei dem Anspruch des Marketings gerecht werden. Hierbei wurde ein Logo-Design, ein Farbkonzept, eine einheitliche Formsprache und eine Typografie erarbeitet. KW - Corporate Design KW - nachhaltig KW - Packaging Design KW - Naturkosmetik KW - Shampooflasche Y1 - 2021 PB - FH Aachen CY - Aachen ER - TY - JOUR A1 - Blanke, Tobias A1 - Hagenkamp, Markus A1 - Döring, Bernd A1 - Göttsche, Joachim A1 - Reger, Vitali A1 - Kuhnhenne, Markus T1 - Net-exergetic, hydraulic and thermal optimization of coaxial heat exchangers using fixed flow conditions instead of fixed flow rates JF - Geothermal Energy N2 - Previous studies optimized the dimensions of coaxial heat exchangers using constant mass fow rates as a boundary condition. They show a thermal optimal circular ring width of nearly zero. Hydraulically optimal is an inner to outer pipe radius ratio of 0.65 for turbulent and 0.68 for laminar fow types. In contrast, in this study, fow conditions in the circular ring are kept constant (a set of fxed Reynolds numbers) during optimization. This approach ensures fxed fow conditions and prevents inappropriately high or low mass fow rates. The optimization is carried out for three objectives: Maximum energy gain, minimum hydraulic efort and eventually optimum net-exergy balance. The optimization changes the inner pipe radius and mass fow rate but not the Reynolds number of the circular ring. The thermal calculations base on Hellström’s borehole resistance and the hydraulic optimization on individually calculated linear loss of head coefcients. Increasing the inner pipe radius results in decreased hydraulic losses in the inner pipe but increased losses in the circular ring. The net-exergy diference is a key performance indicator and combines thermal and hydraulic calculations. It is the difference between thermal exergy fux and hydraulic efort. The Reynolds number in the circular ring is instead of the mass fow rate constant during all optimizations. The result from a thermal perspective is an optimal width of the circular ring of nearly zero. The hydraulically optimal inner pipe radius is 54% of the outer pipe radius for laminar fow and 60% for turbulent fow scenarios. Net-exergetic optimization shows a predominant infuence of hydraulic losses, especially for small temperature gains. The exact result depends on the earth’s thermal properties and the fow type. Conclusively, coaxial geothermal probes’ design should focus on the hydraulic optimum and take the thermal optimum as a secondary criterion due to the dominating hydraulics. Y1 - 2021 U6 - https://doi.org/10.1186/s40517-021-00201-3 SN - 2195-9706 N1 - Corresponding author: Tobias Blanke VL - 9 IS - Article number: 19 PB - Springer CY - Berlin ER - TY - THES A1 - Khalaimova, Karina T1 - Neuerfindung der Ligaturen N2 - Gegenstand des Projekts ist, Ligaturen als erweiterte Mittel der Informationsübertragung einzusetzen. Ligaturen als zusätzliches Instrument sollen die visuelle Komponente des Textes unterstützen, ihm die gewisse Frische einhauchen und ihn hiermit insgesamt sichtbarer, origineller und moderner machen. Der Einsatzbereich erstreckt sich hierbei in die verschiedensten Bereiche hin über Design und Werbung, als auch im Handel oder in sozialen Bereichen. Hierbei kann eine große Anzahl an Wörtern neue Formen annehmen und mithin an neuem Leben und Bedeutung gewinnen, was sicherlich die allgemeinen Sprachmittel bereichern wird. Auf einer historischen Basis und mit Hilfe der Dekonstruktion wurden neue Formen der Ligaturen geschaffen — seltsame, kontroverse, auffällige und einzigartige. KW - Typografie KW - Ligaturen KW - Schriftmuster KW - Lateinisch KW - Kyrillisch Y1 - 2021 N1 - Für diese Arbeit steht kein Volltext zur Verfügung. PB - FH Aachen CY - Aachen ER - TY - THES A1 - Mühl, Leonie T1 - Neues Erscheinungsbild für den APX: Redesign des LVR - Archäologischen Park Xanten und des Römermuseums N2 - Der Archäologische Park Xanten (APX) gilt als Deutschlands einziger archäologischer Freiluftpark. Er zeichnet sich im Verbund mit dem Römermuseum durch seine Lage auf dem historischen Grund einer römischen Metropole und seine kontinuierliche Forschungsaktivität aus und bietet so ein einzigartiges Umfeld von kultureller Relevanz. Ziel dieses Projektes war es, ein neues Erscheinungsbild zu entwickeln, welches klar die Thematik des Parks in den Medien erkennbar macht. Das Corporate Design dient dazu, die Inhalte des Verbundes in einem einheitlichen System medienübergreifend zu präsentieren. Das Design unterstützt den APX in seiner Funktion als Begegnungs- und Bildungsstätte. Aufgrund dessen ist es im Hinblick auf das Ziel relevant, das Interesse an Kulturgeschichte und Forschung zu wecken. KW - Redesign KW - Corporate Design KW - Archäologie KW - Museumsidendität KW - Branding Y1 - 2021 N1 - Für diese Arbeit steht kein Volltext zur Verfügung. PB - FH Aachen CY - Aachen ER - TY - JOUR A1 - Golland, Alexander T1 - Neuregelungen zum Datenschutz: Ein Update für Website-Betreiber. Reform des Telekommunikations- und Telemedienrechts verabschiedet JF - NWB Rechnungswesen - BBK Y1 - 2021 SN - 0340-9848 IS - 14 SP - 672 EP - 674 ER - TY - JOUR A1 - Albanna, Walid A1 - Conzen, Catharina A1 - Weiss, Miriam A1 - Seyfried, Katharina A1 - Kotliar, Konstantin A1 - Schmidt, Tobias Philip A1 - Kuerten, David A1 - Hescheler, Jürgen A1 - Bruecken, Anne A1 - Schmidt-Trucksäss, Arno A1 - Neumaier, Felix A1 - Wiesmann, Martin A1 - Clusmann, Hans A1 - Schubert, Gerrit Alexander T1 - Non-invasive assessment of neurovascular coupling after aneurysmal subarachnoid hemorrhage: a prospective observational trial using retinal vessel analysis JF - Frontiers in Neurology N2 - Delayed cerebral ischemia (DCI) is a common complication after aneurysmal subarachnoid hemorrhage (aSAH) and can lead to infarction and poor clinical outcome. The underlying mechanisms are still incompletely understood, but animal models indicate that vasoactive metabolites and inflammatory cytokines produced within the subarachnoid space may progressively impair and partially invert neurovascular coupling (NVC) in the brain. Because cerebral and retinal microvasculature are governed by comparable regulatory mechanisms and may be connected by perivascular pathways, retinal vascular changes are increasingly recognized as a potential surrogate for altered NVC in the brain. Here, we used non-invasive retinal vessel analysis (RVA) to assess microvascular function in aSAH patients at different times after the ictus. Y1 - 2021 U6 - https://doi.org/10.3389/fneur.2021.690183 SN - 1664-2295 VL - 12 IS - 12 SP - 1 EP - 15 ER - TY - JOUR A1 - Monakhova, Yulia A1 - Diehl, Bernd W.K. T1 - Novel approach of qNMR workflow by standardization using 2H integral: Application to any intrinsic calibration standard JF - Talanta N2 - Quantitative nuclear magnetic resonance (qNMR) is routinely performed by the internal or external standardization. The manuscript describes a simple alternative to these common workflows by using NMR signal of another active nuclei of calibration compound. For example, for any arbitrary compound quantification by NMR can be based on the use of an indirect concentration referencing that relies on a solvent having both 1H and 2H signals. To perform high-quality quantification, the deuteration level of the utilized deuterated solvent has to be estimated. In this contribution the new method was applied to the determination of deuteration levels in different deuterated solvents (MeOD, ACN, CDCl3, acetone, benzene, DMSO-d6). Isopropanol-d6, which contains a defined number of deuterons and protons, was used for standardization. Validation characteristics (precision, accuracy, robustness) were calculated and the results showed that the method can be used in routine practice. Uncertainty budget was also evaluated. In general, this novel approach, using standardization by 2H integral, benefits from reduced sample preparation steps and uncertainties, and can be applied in different application areas (purity determination, forensics, pharmaceutical analysis, etc.). KW - qNMR KW - Deuterium NMR KW - Deuterated solvents KW - Standardization Y1 - 2021 SN - 0039-9140 U6 - https://doi.org/10.1016/j.talanta.2020.121504 VL - 222 IS - Article number: 121504 PB - Elsevier ER - TY - CHAP A1 - Kroniger, Daniel A1 - Horikawa, Atsushi A1 - Funke, Harald A1 - Pfäffle, Franziska T1 - Numerical investigation of micromix hydrogen flames at different combustor pressure levels T2 - The Proceedings of the International Conference on Power Engineering (ICOPE) N2 - This study investigates the influence of pressure on the temperature distribution of the micromix (MMX) hydrogen flame and the NOx emissions. A steady computational fluid dynamic (CFD) analysis is performed by simulating a reactive flow with a detailed chemical reaction model. The numerical analysis is validated based on experimental investigations. A quantitative correlation is parametrized based on the numerical results. We find, that the flame initiation point shifts with increasing pressure from anchoring behind a downstream located bluff body towards anchoring upstream at the hydrogen jet. The numerical NOx emissions trend regarding to a variation of pressure is in good agreement with the experimental results. The pressure has an impact on both, the residence time within the maximum temperature region and on the peak temperature itself. In conclusion, the numerical model proved to be adequate for future prototype design exploration studies targeting on improving the operating range. KW - Gas turbine combustion KW - Hydrogen KW - NOx emissions KW - Flame temperature KW - Flame residence time Y1 - 2021 U6 - https://doi.org/10.1299/jsmeicope.2021.15.2021-0237 N1 - International Conference on Power Engineering 2021 (ICOPE-2021). October 17 - 21, 2021. Kobe, Japan (Online) ER - TY - CHAP A1 - Kotliar, Konstantin ED - Pallikaris, I. ED - Tsilimbaris, M. K. ED - Dastiridou, A. I. T1 - Ocular rigidity: clinical approach T2 - Ocular Rigidity, Biomechanics and Hydrodynamics of the Eye N2 - The term ocular rigidity is widely used in clinical ophthalmology. Generally it is assumed as a resistance of the whole eyeball to mechanical deformation and relates to biomechanical properties of the eye and its tissues. Basic principles and formulas for clinical tonometry, tonography and pulsatile ocular blood flow measurements are based on the concept of ocular rigidity. There is evidence for altered ocular rigidity in aging, in several eye diseases and after eye surgery. Unfortunately, there is no consensual view on ocular rigidity: it used to make a quite different sense for different people but still the same name. Foremost there is no clear consent between biomechanical engineers and ophthalmologists on the concept. Moreover ocular rigidity is occasionally characterized using various parameters with their different physical dimensions. In contrast to engineering approach, clinical approach to ocular rigidity claims to characterize the total mechanical response of the eyeball to its deformation without any detailed considerations on eye morphology or material properties of its tissues. Further to the previous chapter this section aims to describe clinical approach to ocular rigidity from the perspective of an engineer in an attempt to straighten out this concept, to show its advantages, disadvantages and various applications. KW - Coefficient of ocular rigidity KW - Eyeball KW - Corneo-scleral shell KW - Pressure-volume relationship KW - Differential tonometry Y1 - 2021 SN - 978-3-030-64422-2 U6 - https://doi.org/10.1007/978-3-030-64422-2_2 SP - 15 EP - 43 PB - Springer CY - Cham ER - TY - THES A1 - Koc, Özge Fethiye T1 - OFEKO: Lehrmaterial für sehbehinderte Kinder N2 - In einer Mischklasse, bestehend aus sehenden und nicht-sehenden Kindern, welche nicht schriftlich oder spielerisch miteinander kommunizieren können, gehen einige soziale Aspekte und Lernübungen verloren. Partnerarbeiten und das gegenseitige Kontrollieren der Richtigkeit, beispielsweise bei der Anwendung von Satzzeichen, sind Möglichkeiten, welche die Kinder ohne ein gemeinsames Material nicht wahrnehmen können. Diese Arbeit ermöglicht ein gemeinsames Arbeiten aller Kinder durch dasselbe Material. Hierfür dienen dreidimensionale Objekte, welche im STL-Dateiformat zur Verfügung stehen. Es eignet sich für schriftliche und geografische Arbeiten. Des Weiteren ist ein Memory-Spiel enthalten, welches ebenso von sehenden und nicht-sehenden Kinder gespielt werden kann. Diese STLs können weltweit verschickt werden, sodass diese beliebig mit einem 3D-Drucker gedruckt werden können. KW - Empathie KW - Mischklasse KW - STL Dateiformat KW - Partnerarbeiten KW - Empathy Y1 - 2021 N1 - Für diese Arbeit steht kein Volltext zur Verfügung. PB - FH Aachen CY - Aachen ER -