TY  - JOUR
A1  - Miyamato, Ko-ichiro
A1  - Sakakita, Sakura
A1  - Wagner, Torsten
A1  - Schöning, Michael Josef
A1  - Yoshinobu, Tatsuo
T1  - Application of chemical imaging sensor to in-situ pH imaging in the vicinity of a corroding metal surface
JF  - Electrochimica Acta
N2  - The chemical imaging sensor was applied to in-situ pH imaging of the solution in the vicinity of a corroding surface of stainless steel under potentiostatic polarization. A test piece of polished stainless steel was placed on the sensing surface leaving a narrow gap filled with artificial seawater and the stainless steel was corroded under polarization. The pH images obtained during polarization showed correspondence between the region of lower pH and the site of corrosion. It was also found that the pH value in the gap became as low as 2 by polarization, which triggered corrosion.
Y1  - 2015
U6  - http://dx.doi.org/10.1016/j.electacta.2015.07.184
SN  - 0013-4686
VL  - 183
SP  - 137
EP  - 142
PB  - Elsevier
CY  - Amsterdam
ER  - 
TY  - JOUR
A1  - Schusser, Sebastian
A1  - Krischer, Maximillian
A1  - Bäcker, Matthias
A1  - Poghossian, Arshak
A1  - Wagner, Patrick
A1  - Schöning, Michael Josef
T1  - Monitoring of the Enzymatically Catalyzed Degradation of Biodegradable Polymers by Means of Capacitive Field-Effect Sensors
JF  - Analytical Chemistry
N2  - Designing novel or optimizing existing biodegradable polymers for biomedical applications requires numerous tests on the effect of substances on the degradation process. In the present work, polymer-modified electrolyte–insulator–semiconductor (PMEIS) sensors have been applied for monitoring an enzymatically catalyzed degradation of polymers for the first time. The thin films of biodegradable polymer poly(d,l-lactic acid) and enzyme lipase were used as a model system. During degradation, the sensors were read-out by means of impedance spectroscopy. In order to interpret the data obtained from impedance measurements, an electrical equivalent circuit model was developed. In addition, morphological investigations of the polymer surface have been performed by means of in situ atomic force microscopy. The sensor signal change, which reflects the progress of degradation, indicates an accelerated degradation in the presence of the enzyme compared to hydrolysis in neutral pH buffer media. The degradation rate increases with increasing enzyme concentration. The obtained results demonstrate the potential of PMEIS sensors as a very promising tool for in situ and real-time monitoring of degradation of polymers.
Y1  - 2015
U6  - http://dx.doi.org/10.1021/acs.analchem.5b00617
SN  - 1520-6882
VL  - 87
IS  - 13
SP  - 6607
EP  - 6613
PB  - ACS Publications
CY  - Washington, DC
ER  - 
TY  - CHAP
A1  - Oberländer, Jan
A1  - Jildeh, Zaid B.
A1  - Kirchner, Patrick
A1  - Wendeler, Luisa
A1  - Bromm, Alexander
A1  - Iken, Heiko
A1  - Wagner, Patrick
A1  - Keusgen, Michael
A1  - Schöning, Michael Josef
T1  - Experimental and numerical evaluation of interdigitated electrode array for monitoring gaseous sterilization processes
T2  - 12. Dresdner Sensor-Symposium 2015
Y1  - 2015
U6  - http://dx.doi.org/10.5162/12dss2015/P3.11
SP  - 163
EP  - 168
ER  - 
TY  - CHAP
A1  - Breuer, Lars
A1  - Raue, Markus
A1  - Mang, Thomas
A1  - Schöning, Michael Josef
A1  - Thoelen, Ronald
A1  - Wagner, Torsten
T1  - Light-stimulated hydrogel actuators with incorporated graphene oxide for microfluidic applications
T2  - 12. Dresdner Sensor-Symposium 2015
Y1  - 2015
U6  - http://dx.doi.org/10.5162/12dss2015/P5.8
SP  - 206
EP  - 209
ER  - 
TY  - CHAP
A1  - Digel, Ilya
A1  - Sadykov, R.
A1  - Temiz Artmann, Aysegül
A1  - Artmann, Gerhard
T1  - Changes in intestinal microflora in rats induced by oral exposure to low lead (II) concentrations
T2  - Lead Exposure and Poisoning: Clinical Symptoms, Medical Management and Preventive Strategies
Y1  - 2015
SN  - 9781634826990
SP  - 75
EP  - 99
PB  - Nova Science Publ.
ER  - 
TY  - JOUR
A1  - Kowalski, Julia
A1  - Linder, Peter
A1  - Zierke, S.
A1  - Wulfen, B. van
A1  - Clemens, J.
A1  - Konstantinidis, K.
A1  - Ameres, G.
A1  - Hoffmann, R.
A1  - Mikucki, J.
A1  - Tulaczyk, S.
A1  - Funke, O.
A1  - Blandfort, D.
A1  - Espe, Clemens
A1  - Feldmann, Marco
A1  - Francke, Gero
A1  - Hiecker, S.
A1  - Plescher, Engelbert
A1  - Schöngarth, Sarah
A1  - Dachwald, Bernd
A1  - Digel, Ilya
A1  - Artmann, Gerhard
A1  - Eliseev, D.
A1  - Heinen, D.
A1  - Scholz, F.
A1  - Wiebusch, C.
A1  - Macht, S.
A1  - Bestmann, U.
A1  - Reineking, T.
A1  - Zetzsche, C.
A1  - Schill, K.
A1  - Förstner, R.
A1  - Niedermeier, H.
A1  - Szumski, A.
A1  - Eissfeller, B.
A1  - Naumann, U.
A1  - Helbing, K.
T1  - Navigation technology for exploration of glacier ice with maneuverable melting probes
JF  - Cold Regions Science and Technology
N2  - The Saturnian moon Enceladus with its extensive water bodies underneath a thick ice sheet cover is a potential candidate for extraterrestrial life. Direct exploration of such extraterrestrial aquatic ecosystems requires advanced access and sampling technologies with a high level of autonomy. A new technological approach has been developed as part of the collaborative research project Enceladus Explorer (EnEx). The concept is based upon a minimally invasive melting probe called the IceMole. The force-regulated, heater-controlled IceMole is able to travel along a curved trajectory as well as upwards. Hence, it allows maneuvers which may be necessary for obstacle avoidance or target selection. Maneuverability, however, necessitates a sophisticated on-board navigation system capable of autonomous operations. The development of such a navigational system has been the focal part of the EnEx project. The original IceMole has been further developed to include relative positioning based on in-ice attitude determination, acoustic positioning, ultrasonic obstacle and target detection integrated through a high-level sensor fusion. This paper describes the EnEx technology and discusses implications for an actual extraterrestrial mission concept.
Y1  - 2016
U6  - http://dx.doi.org/10.1016/j.coldregions.2015.11.006
SN  - 0165-232X
IS  - 123
SP  - 53
EP  - 70
PB  - Elsevier
CY  - Amsterdam
ER  - 
TY  - JOUR
A1  - Dikta, Gerhard
A1  - Kühlheim, René
A1  - Mendonca, Jorge
A1  - Una-Alcarez, Jacobo de
T1  - Asymptotic representation of presmoothed Kaplan–Meier integrals with covariates in a semiparametric censorship model
JF  - Journal of Statistical Planning and Inference
Y1  - 2015
U6  - http://dx.doi.org/10.1016/j.jspi.2015.12.001
SN  - 0378-3758
VL  - Vol. 171
SP  - 10
EP  - 37
PB  - Elsevier
CY  - Amsterdam
ER  - 
TY  - JOUR
A1  - Duong, Minh Tuan
A1  - Nguyen, Nhu Huynh
A1  - Staat, Manfred
T1  - Physical response of hyperelastic models for composite materials and soft tissues
JF  - Asia pacific journal on computational engineering
Y1  - 2015
U6  - http://dx.doi.org/10.1186/s40540-015-0015-x
SN  - 2196-1166
VL  - 2
IS  - 3 (December 2015)
SP  - 1
EP  - 18
ER  - 
TY  - CHAP
A1  - Frotscher, Ralf
A1  - Duong, Minh Tuan
A1  - Staat, Manfred
T1  - Simulating beating cardiomyocytes with electromechanical coupling
T2  - II. International Conference on Biomedical Technology : 28-30 October 2015 Hannover, Germany / T. Lenarz, P. Wriggers (Eds.)
Y1  - 2015
SP  - 1
EP  - 2
ER  - 
TY  - JOUR
A1  - Oberländer, Jan
A1  - Jildeh, Zaid B.
A1  - Kirchner, Patrick
A1  - Wendeler, Luisa
A1  - Bromm, Alexander
A1  - Iken, Heiko
A1  - Wagner, Patrick
A1  - Keusgen, Michael
A1  - Schöning, Michael Josef
T1  - Study of Interdigitated Electrode Arrays Using Experiments and Finite Element Models for the Evaluation of Sterilization Processes
JF  - Sensors
N2  - In this work, a sensor to evaluate sterilization processes with hydrogen peroxide vapor has been characterized. Experimental, analytical and numerical methods were applied to evaluate and study the sensor behavior. The sensor set-up is based on planar interdigitated electrodes. The interdigitated electrode structure consists of 614 electrode fingers spanning over a total sensing area of 20 mm2. Sensor measurements were conducted with and without microbiological spores as well as after an industrial sterilization protocol. The measurements were verified using an analytical expression based on a first-order elliptical integral. A model based on the finite element method with periodic boundary conditions in two dimensions was developed and utilized to validate the experimental findings.
Y1  - 2015
U6  - http://dx.doi.org/10.3390/s151026115
SN  - 1424-8220
N1  - This article belongs to the Special Issue "Gas Sensors—Designs and Applications"
VL  - 15
IS  - 10
SP  - 26115
EP  - 26127
PB  - MDPI
CY  - Basel
ER  -