TY - JOUR A1 - Rau, Christoph A1 - Alexopoulos, Spiros A1 - Breitbach, Gerd A1 - Hoffschmidt, Bernhard A1 - Latzke, Markus A1 - Sattler, Johannes, Christoph T1 - Transient simulation of a solar-hybrid tower power plant with open volumetric receiver at the location Barstow JF - Energy procedia : proceedings of the SolarPACES 2013 International Conference N2 - In this work the transient simulations of four hybrid solar tower power plant concepts with open-volumetric receiver technology for a location in Barstow-Daggett, USA, are presented. The open-volumetric receiver uses ambient air as heat transfer fluid and the hybridization is realized with a gas turbine. The Rankine cycle is heated by solar-heated air and/or by the gas turbine's flue gases. The plant can be operated in solar-only, hybrid parallel or combined cycle-only mode as well as in any intermediate load levels where the solar portion can vary between 0 to 100%. The simulated plant is based on the configuration of a solar-hybrid power tower project, which is in planning for a site in Northern Algeria. The meteorological data for Barstow-Daggett was taken from the software meteonorm. The solar power tower simulation tool has been developed in the simulation environment MATLAB/Simulink and is validated. Y1 - 2014 U6 - http://dx.doi.org/10.1016/j.egypro.2014.03.157 SN - 1876-6102 VL - 49 SP - 1481 EP - 1490 PB - Elsevier CY - Amsterdam ER - TY - JOUR A1 - Alebouyeh Samami, Behzad A1 - Pieper, Martin A1 - Breitbach, Gerd A1 - Hodapp, Josef T1 - Heat production in the windings of the stators of electric machines under stationary condition JF - Heat and mass transfer N2 - In electric machines due to high currents and resistive losses (joule heating) heat is produced. To avoid damages by overheating the design of effective cooling systems is required. Therefore the knowledge of heat sources and heat transfer processes is necessary. The purpose of this paper is to illustrate a good and effective calculation method for the temperature analysis based on homogenization techniques. These methods have been applied for the stator windings in a slot of an electric machine consisting of copper wires and resin. The key quantity here is an effective thermal conductivity, which characterizes the heterogeneous wire resin-arrangement inside the stator slot. To illustrate the applicability of the method, the analysis of a simplified, homogenized model is compared with the detailed analysis of temperature behavior inside a slot of an electric machine according to the heat generation. We considered here only the stationary situation. The achieved numerical results are accurate and show that the applied homogenization technique works in practice. Finally the results of simulations for the two cases, the original model of the slot and the homogenized model chosen for the slot (unit cell), are compared to experimental results. Y1 - 2014 U6 - http://dx.doi.org/10.1007/s00231-014-1371-8 SN - 0947-7411 (Print) ; 1432-1181 (E-Journal) VL - 50 SP - 1707 EP - 1716 PB - Springer CY - Heidelberg ER - TY - JOUR A1 - Alexopoulos, Spiros A1 - Breitbach, Gerd A1 - Hoffschmidt, Bernhard A1 - Stobbe, P. T1 - Computational fluid flow of porous resic ceramic filtering modules and optimization of the channel edge form geometry JF - Proceedings : April 14 - 18, 2008, Leipzig, Germany / hosted by VDI, Society for Chemical and Process Engineering . Vol 2 Y1 - 2008 N1 - Verein Deutscher Ingenieure ; World Filtration Congress ; (10 : ; 2008.04.14-18 : ; Leipzig) ; WFC ; (10 : ; 2008.04.14-18 : ; Leipzig) SP - 300 EP - 304 PB - Filtech Exhibitions CY - Meerbusch ER - TY - JOUR A1 - Alexopoulos, Spiros A1 - Breitbach, Gerd A1 - Hoffschmidt, Bernhard A1 - Stobbe, P. T1 - Optimization of the geometry of porous SiC ceramic filtering modules using numerical methods JF - Developments in porous, biological and geopolymer ceramics : a collection of papers presented at the 31st International Conference on Advanced Ceramics and Composites, January 21 - 26, 2007, Daytona Beach, Florida ; [papers presented at the Symposium on Porous Ceramics: Novel Developments and Applications] / ed.: Manuel Brito ... Vol. ed.: Jonathan Salem ... The American Ceramics Society Y1 - 2008 SN - 9780470196403 N1 - Ceramic engineering and science proceedings ; 28,9 SP - 95 EP - 104 PB - Wiley CY - Hoboken, NJ ER - TY - JOUR A1 - Breitbach, Gerd A1 - Schubert, F. T1 - A contribution to stress prediction in coatings for gas turbine blades JF - Archive of applied mechanics. 73 (2004), H. 9-10 Y1 - 2004 SN - 0939-1533 N1 - 2. ISSN (Druck-Ausg.): 1432-0681 SP - 682 EP - 689 ER - TY - JOUR A1 - Breitbach, Gerd A1 - Schmidt-Plutka, A. A1 - Schubert, F. A1 - Nickel, H. T1 - Deformation behaviour of structures exposed at very high temperatures to cyclic thermal and mechanical loadings JF - Structural mechanics in reactor technology : transactions of the 12th International Conference on Structural Mechanics in Reactor Technology, Stuttgart, Germany, 15-20 August 1993 / ed. Karl F. Kussmaul. - Bd. L : Inelastic behaviour of solids and structures Y1 - 1993 SN - 0-444-81515-5 N1 - SMiRT <12, 1993, Stuttgart> ; L08/3 SP - 203 EP - 208 PB - Elsevier CY - Amsterdam [u.a.] ER - TY - JOUR A1 - Breitbach, Gerd A1 - Schmidt-Plutka, A. A1 - Schubert, F. T1 - Untersuchungen zum Kriechratcheting bei dickwandigen Rohren / G. Breitbach ; A. Schmidt-Plutka ; F. Schubert ... JF - Sicherheit und Verfügbarkeit in der Anlagentechnik mit dem Schwerpunkt Kerntechnik : vorrangige Thematik: Langzeitsicherheit und neue Reaktorkonzepte ; 8. und 9. Oktober 1992 / Staatliche Materialprüfungsanstalt (MPA), Universität Stuttgart. - Bd. 1: Rohrleitungs- und Behälterintegrität, Bruchmechanik, Korrosion : (Vorträge 1 - 32) Y1 - 1992 N1 - (... MPA-Seminar ; 18) ; MPA-Seminar Sicherheit und Verfügbarkeit in der Anlagentechnik mit dem Schwerpunkt Kerntechnik <18, 1992, Stuttgart> SP - 9.1 EP - 9.16 PB - MPA CY - Stuttgart ER - TY - JOUR A1 - Breitbach, Gerd A1 - Deschka, S. A1 - Akiba, M. T1 - High heat flux tests on brazed divertor components in electron and ion beam test facilities / S. Deschka ; M. Akiba ; G. Breitbach ... JF - International journal of refractory metals and hard materials. 11 (1992), H. 6 Y1 - 1992 SN - 0263-4368 N1 - 2. ISSN (Druck-Ausg.): 0263-4368 SP - 367 EP - 375 ER - TY - JOUR A1 - Breitbach, Gerd A1 - Schmidt-Plutka, A. A1 - Schubert, F. T1 - Einfluß von Temperaturschwankungen auf das Verformungsverhalten von Rohren bei hohen Temperaturen JF - VGB-Konferenz "Restlebensdauer 1992" : 6. und 7. Juli 1992, Mannheim ; Vorträge = VGB Conference "Residual Service Life 1992" / VGB Technische Vereinigung der Grosskraftwerksbetreiber e.V. Leitung der Tagung: U. Gramberg. - Bd. 2 Y1 - 1992 N1 - Paper Nr. 25 ; (VGB-TB ; 520) ; VGB-Konferenz "Restlebensdauer 1992" <1992, Mannheim> SP - 1 EP - 16 CY - Mannheim ER - TY - JOUR A1 - Breitbach, Gerd A1 - Klomfass, J. A1 - Hannen, W. T1 - Temperatur- und Dehnungsmessung an komplex beanspruchten metallischen Bauteilen im Temperaturbereich um 900 C / J. Klomfass ; W. Hannen ; G. Breitbach JF - Vorträge der Tagung Werkstoffprüfung 1992 : 3. und 4. Dezember 1992 in Bad Nauheim / DVM, Deutscher Verband für Materialforschung und -prüfung e.V. Veranstaltet von: Deutsche Gesellschaft für Materialkunde ... Y1 - 1992 N1 - Tagung Werkstoffprüfung <1992, Bad Nauheim> ; Deutsche Gesellschaft für Materialkunde SP - 93 EP - 100 PB - DVM CY - Berlin ER -