TY  - JOUR
A1  - Meliß, Michael
A1  - Oesterwind, Dieter
A1  - Voß, Alfred
T1  - Non-nuclear and non-fossil energy resources and their possibilities for future power generation
JF  - Kerntechnik
N2  - It must be stressed that the assessment of the exploitation possibilities of the energy resources discussed in this paper requires further studies. With this proviso, the situation can be provisionally summarised as follows: The total potential of known geothermal steam sources is only 64 GW. Geothermal energy could therefore only make a significant contribution to covering the worldwide power needs if we succeed in exploiting dry geothermal reservoirs. Exploitation of tidal energy is limited to a few geographically favourable locations. The power generation potential at these locations is only about 64 GW. An important drawback of tidal power is discontinuous power generation. Large scale exploitation of wind, wave and glacier energy, and of ocean heat, requires solution of a number of technological problems. The environmental effects of exploitation of these energy resources are to some extent of a qualitatively different nature from those of operation of fossil-fuel-fired and of nuclear power plants. The scanty knowledge in this area often results in these effects being underestimated. In any case, however, it would be deliberately misleading to postulate that any form of power generation is possible without some detrimental effects on the environment. It may be stated in conclusion that, owing to their small potential or to the as yet insufficiently advanced technological development, none of the energy resources discussed in this paper can make a significant contribution to the solution of middle-term energy supply problems, i.e., to a rapid replacement of mineral oil and natural gas.
Y1  - 1975
U6  - http://dx.doi.org/10.18419/opus-8093
SN  - 0932-3902
N1  - Printausg. in der Bibliothek vorhanden: 63 ZS 010-1975
VL  - 17
IS  - 7
SP  - 301
EP  - 306
PB  - De Gruyter
CY  - Berlin
ER  - 
TY  - CHAP
A1  - Hellmanns, Mark
A1  - Hartung, I.
A1  - Dilger, Klaus
A1  - Böhm, Stefan
T1  - Quality assurance of manual guided joining and welding devices
T2  - Proceedings of the IIW International Conference on Advances in Welding and Allied Technologies : July 16 - 17, 2009, Singapore
Y1  - 2009
SN  - 9789810832605
SP  - 219
EP  - 222
PB  - International Institute of Welding
CY  - Roissy
ER  - 
TY  - CHAP
A1  - Goldbach, Daniel
A1  - Ament, Christoph
ED  - Scharff, Peter
T1  - Stabilized reversing with vehicle trailer combinations
T2  - Crossing borders within the ABC : automation, biomedical engineering and computer science; proceedings; 55. IWK Internationales Wissenschaftliches Kolloquium; 13 - 17 September 2010, Ilmenau
Y1  - 2010
SN  - 978-3-938843-53-6
SP  - 352
EP  - 357
PB  - Verl. ISLE
CY  - Ilmenau
ER  - 
TY  - CHAP
A1  - Hartung, I.
A1  - Dilger, Klaus
A1  - Hellmanns, Mark
A1  - Böhme, Stefan
T1  - Repair of non-weldable steel structures to extend the life cycle
T2  - Proceedings of the IIW International Conference on Advances in Welding and Allied Technologies : July 16 - 17, 2009, Singapore. (Welding in the world ; 53.2009, special issue)
Y1  - 2009
SN  - 978-981-08-3259-9
SP  - 569
EP  - 574
PB  - Springer
CY  - Berlin [u.a.]
ER  - 
TY  - CHAP
A1  - Hellmanns, Mark
A1  - Böhm, Stefan
A1  - Dilger, Klaus
T1  - Weight and noise reduction in power transmissions through epoxy resin foams
T2  - Proceedings of the 31st annual meeting of the Adhesion Society : 17. - 20.2.2008, Austin, Texas
Y1  - 2008
SP  - 291
EP  - 293
PB  - Adhesion Society
CY  - Blacksburg
ER  - 
TY  - CHAP
A1  - Hellmanns, Mark
A1  - Böhm, Stefan
A1  - Dilger, Klaus
T1  - Implementation of a velocity controlled manual applicator for adhesives and sealants in the automotive industry in consideration of quality control
T2  - Proceedings of the 29th annual meeting of the Adhesion Society : 19. - 22.2.2006, Jacksonville, Florida
Y1  - 2006
SN  - 1086-9506
SP  - 68
EP  - 70
PB  - Adhesion Society
CY  - Blacksburg, Va.
ER  - 
TY  - JOUR
A1  - Hellmanns, Mark
A1  - Böhm, Stefan
A1  - Dilger, Klaus
T1  - Manual applications of adhesives
JF  - Journal of adhesion and interface
Y1  - 2006
VL  - Vol. 7
IS  - No. 4
SP  - 24
EP  - 27
ER  - 
TY  - CHAP
A1  - Hellmanns, Mark
A1  - Böhm, Stefan
A1  - Dilger, Klaus
T1  - Progress of the manual application of adhesives
T2  - Proceedings of the 3rd World Congress on Adhesion and Related Phenomena : WCARP-III, October 15 -18, 2006, Beijing, China
Y1  - 2006
SP  - 275
EP  - 277
PB  - Beijing Adhesion Society of China
CY  - Beijing
ER  - 
TY  - CHAP
A1  - Böhm, Stefan
A1  - Hellmanns, Mark
A1  - Backes, Andreas
A1  - Dilger, Klaus
T1  - Lock-in thermography based NDT of automotive parts
T2  - Proceedings of the 3rd World Congress on Adhesion and Related Phenomena : WCARP-III, October 15 -18, 2006, Beijing, China
Y1  - 2006
SP  - 382
EP  - 384
PB  - Beijing Adhesion Society of China
CY  - Beijing
ER  - 
TY  - JOUR
A1  - Böhm, Stefan
A1  - Hellmanns, Mark
A1  - Backes, Andreas
A1  - Dilger, Klaus
T1  - Lock-in thermography based NDT of parts for the automotive industry
JF  - Journal of adhesion and interface
Y1  - 2006
VL  - Vol. 7
IS  - No. 4
SP  - 10
EP  - 12
ER  -