TY - CHAP A1 - Schwager, Christian A1 - Angele, Florian A1 - Schwarzbözl, Peter A1 - Teixeira Boura, Cristiano José A1 - Herrmann, Ulf T1 - Model predictive assistance for operational decision making in molten salt receiver systems T2 - SolarPACES: Solar Power & Chemical Energy Systems N2 - Despite the challenges of pioneering molten salt towers (MST), it remains the leading technology in central receiver power plants today, thanks to cost effective storage integration and high cost reduction potential. The limited controllability in volatile solar conditions can cause significant losses, which are difficult to estimate without comprehensive modeling [1]. This paper presents a Methodology to generate predictions of the dynamic behavior of the receiver system as part of an operating assistance system (OAS). Based on this, it delivers proposals if and when to drain and refill the receiver during a cloudy period in order maximize the net yield and quantifies the amount of net electricity gained by this. After prior analysis with a detailed dynamic two-phase model of the entire receiver system, two different reduced modeling approaches where developed and implemented in the OAS. A tailored decision algorithm utilizes both models to deliver the desired predictions efficiently and with appropriate accuracy. KW - Power plants KW - Associated liquids KW - Decision theory KW - Electrochemistry Y1 - 2023 SN - 978-0-7354-4623-6 U6 - https://doi.org/10.1063/5.0151514 SN - 1551-7616 (online) SN - 0094-243X (print) N1 - SolarPACES: SOLAR POWER & CHEMICAL ENERGY SYSTEMS: 27th International Conference on Concentrating Solar Power and Chemical Energy Systems, 27 September–1 October 2021, Online IS - 2815 / 1 PB - AIP conference proceedings / American Institute of Physics CY - Melville, NY ER - TY - BOOK A1 - Sept, Marcel A1 - Zillinger, Christina A1 - Wiechert, Johanna A1 - Thelen, Marius ED - Kroll-Ludwigs, Kathrin ED - Bassen-Metz, Yasmine ED - Bernecker, Andreas ED - Eggert, Mathias ED - Fritz, Thomas ED - Golland, Alexander ED - Höhne, Tim ED - Tran, Duc Hung ED - Vogt, Jürgen T1 - Aachener Online-Schriften Wirtschaft und Recht. Band 6. 01/2023 N2 - Inhaltsverzeichnis - Bachelorarbeiten 1. Zukunft der Rente – Kann eine Erwerbstätigenversicherung das demografische Problem nachhaltig lösen? - Marcel Sept | Seite 4-73 2. Die versammlungsgebundenen Aktionärsrechte in der neuen virtuellen Hauptversammlung – eine Bewertung aus Unternehmer- und Aktionärssicht - Christina Zillinger | Seite 74-130 3. Praxisleitfaden für den Arbeitgeber zum gesetzlichen Sonderkündigungsschutz – Was muss der Arbeitgeber tun, um durch Gesetz besonders geschützten Arbeitnehmern kündigen zu können? - Johanna Wiechert | Seite 131-195 4. Die Steuervergünstigung bei Umstrukturierungen im Konzern nach § 6a GrEStG im Lichte der aktuellen Rechtsprechung - Marius Thelen | Seite 196-265 T3 - Aachener Online-Schriften Wirtschaft und Recht - 6 Y1 - 2023 PB - FH Aachen / Fachbereich Wirtschaftswissenschaften CY - Aachen ER - TY - THES A1 - Shafaghi, Shiva T1 - Zan, Zendegi, Azadi N2 - Das Projekt „Zan, Zendegi, Azadi" (Frau, Leben, Freiheit) setzt sich mit der aktuellen Situation im Iran auseinander. Bereits nach der Machtübernahme der islamischen Republik im Jahr 1979 wird die iranische Bevölkerung durch das brutale Regime unterdrückt und zum Schweigen gezwungen. Dieser Druck hat sich lange aufgestaut und nun gibt es seit Jahren in größeren Abständen Proteste gegen die Regierung. Der gewaltsame Tod der kurdischen Iranerin Mahsā Jîna Amīnī in Polizeigewahrsam am 16.09.2022 hat eine beispiellose Welle des Protests in allen Landesteilen Irans ausgelöst. Ihr Protest wird von Frauen angeführt und hat sich in eine beeindruckende Welle des Widerstands und der Rebellion entwickelt. Die unterschiedlichen Medien in diesem Projekt wie Dokumentarfotografie, Illustration, Projektion und Texte geben Betrachter:innen einen Eindruck der unmittelbaren Wirkung der revolutionären Ereignisse und der Reaktion des totalitären Regimes auf die Betroffenen. KW - Frau KW - Leben KW - Freiheit KW - Revolution KW - Iran Y1 - 2023 PB - FH Aachen CY - Aachen ER - TY - THES A1 - Shah, Akshat T1 - Vita : Rehabilitation assistance for digital professionals N2 - Vita ist ein Produkt zur Unterstützung von Physiotherapie und Rehabilitation für moderne digitale Profis. Es hilft beim Aufspüren und Erkennen von Haltungsfehlern und gibt positives und sinnvolles Feedback. Ziel des Feedbacks ist es, ein Gefühl des Vertrauens in den Genesungsprozess zu schaffen und durch die Nachahmung der menschlichen Berührung neue, positive Haltungsgewohnheiten zu entwickeln und zu kultivieren. KW - Haltung KW - Positives Feedback KW - Industriedesign KW - Rehabilitaion KW - Digital Y1 - 2023 N1 - Für diese Arbeit steht kein Volltext zur Verfügung. PB - FH Aachen CY - Aachen ER - TY - JOUR A1 - Sildatke, Michael A1 - Karwanni, Hendrik A1 - Kraft, Bodo A1 - Zündorf, Albert T1 - A distributed microservice architecture pattern for the automated generation of information extraction pipelines JF - SN Computer Science N2 - Companies often build their businesses based on product information and therefore try to automate the process of information extraction (IE). Since the information source is usually heterogeneous and non-standardized, classic extract, transform, load techniques reach their limits. Hence, companies must implement the newest findings from research to tackle the challenges of process automation. They require a flexible and robust system that is extendable and ensures the optimal processing of the different document types. This paper provides a distributed microservice architecture pattern that enables the automated generation of IE pipelines. Since their optimal design is individual for each input document, the system ensures the ad-hoc generation of pipelines depending on specific document characteristics at runtime. Furthermore, it introduces the automated quality determination of each available pipeline and controls the integration of new microservices based on their impact on the business value. The introduced system enables fast prototyping of the newest approaches from research and supports companies in automating their IE processes. Based on the automated quality determination, it ensures that the generated pipelines always meet defined business requirements when they come into productive use. KW - Architectural design KW - Model-driven software engineering KW - Software and systems modeling KW - Enterprise information systems KW - Information extraction Y1 - 2023 U6 - https://doi.org/10.1007/s42979-023-02256-4 SN - 2661-8907 N1 - Corresponding authors: Michael Sildatke, Hendrik Karwanni IS - 4, Article number: 833 PB - Springer Singapore CY - Singapore ER - TY - CHAP A1 - Stark, Ralf A1 - Bartel, Sebastian A1 - Ditsche, Florian A1 - Esch, Thomas T1 - Design study of a 30kN LOX/LCH4 aerospike rocket engine for lunar lander application T2 - Aerospace Europe Conference 2023 - 10th EUCASS - 9th CEAS N2 - Based on lunar lander concept EL3, various LOX/CH4 aerospike engines were studied. A distinction was made between single and cluster configurations as well as ideal and non-ideal contour concepts. It could be shown that non-ideal aerospike engines promise a significant payload gain. Y1 - 2023 N1 - Lausanne, July 9-13, 2023 ER - TY - CHAP A1 - Stark, Ralf A1 - Rieping, Carla A1 - Esch, Thomas T1 - The impact of guide tubes on flow separation in rocket nozzles T2 - Aerospace Europe Conference 2023 - 10th EUCASS - 9th CEAS N2 - Rocket engine test facilities and launch pads are typically equipped with a guide tube. Its purpose is to ensure the controlled and safe routing of the hot exhaust gases. In addition, the guide tube induces a suction that effects the nozzle flow, namely the flow separation during transient start-up and shut-down of the engine. A cold flow subscale nozzle in combination with a set of guide tubes was studied experimentally to determine the main influencing parameters. KW - Guide Tube KW - TICTOP KW - Nozzle KW - Suction Y1 - 2023 N1 - Lausanne, July 9-13, 2023 ER - TY - THES A1 - Stercken, Maike T1 - Social Media - Segen oder Fluch? : Eine Aufklärungskampagne zu Auswirkungen von Social Media Nutzung N2 - Das Projekt „Social Media – Segen oder Fluch“ beschäftigt sich mit negativen Auswirkungen, die die Nutzung Sozialer Medien haben kann. Soziale Medien werden heutzutage ständig und von fast jedem genutzt, vor allem von Jugendlichen und jungen Erwachsenen. Vielen ist aber nicht bewusst, dass sich die Nutzung negativ auf sie und ihre Gesundheit auswirken kann. Eine Kampagne soll daran etwas ändern. Soziale Medien bzw. der Content, der die Nutzer:innen negativ beeinflusst, ist wie ein Monster, vor dem sich die Nutzer:innen in acht nehmen müssen. Angesprochen werden hauptsächlich 12-29-jährige, die Soziale Medien nutzen. Die Kampagne soll durch verschiedene Maßnahmen wie Plakatwerbung und Posts auf Social Media Kanälen, den negativen Auswirkungen von Social Media Nutzung entgegenwirken. Sie soll über die Auswirkungen aufklären und zu einem bewussteren Umgang mit Sozialen Netzwerken anregen. KW - Soziale Medien KW - Monster KW - Gefahr KW - Depressionen KW - Kampagne Y1 - 2023 PB - FH Aachen CY - Aachen ER - TY - CHAP A1 - Steuer-Dankert, Linda T1 - Training future skills - sustainability, interculturality & innovation in a digital design thinking format T2 - Proceedings of the 19th International CDIO Conference N2 - The complex questions of today for a world of tomorrow are characterized by their global impact. Solutions must therefore not only be sustainable in the sense of the three pillars of sustainability (economic, environmental, and social) but must also function globally. This goes hand in hand with the need for intercultural acceptance of developed services and products. To achieve this, engineers, as the problem solvers of the future, must be able to work in intercultural teams on appropriate solutions, and be sensitive to intercultural perspectives. To equip the engineers of the future with the so-called future skills, teaching concepts are needed in which students can acquire these methods and competencies in application-oriented formats. The presented course "Applying Design Thinking - Sustainability, Innovation and Interculturality" was developed to teach future skills from the competency areas Digital Key Competencies, Classical Competencies and Transformative Competencies. The CDIO Standard 3.0, in particular the standards 5, 6, 7 and 8, was used as a guideline. The course aims to prepare engineering students from different disciplines and cultures for their future work in an international environment by combining a digital teaching format with an interdisciplinary, transdisciplinary and intercultural setting for solving sustainability challenges. The innovative moment lies in the digital application of design thinking and the inclusion of intercultural as well as trans- and interdisciplinary perspectives in innovation development processes. In this paper, the concept of the course will be presented in detail and the particularities of a digital implementation of design thinking will be addressed. Subsequently, the potentials and challenges will be reflected and practical advice for integrating design thinking in engineering education will be given. KW - Design Thinking KW - Sustainability KW - Future Skills KW - Interculturality KW - Interdisciplinarity Y1 - 2023 N1 - 19th International CDIO Conference, hosted by NTNU, Trondheim, Norway, June 26-29, 2023 ER - TY - CHAP A1 - Steuer-Dankert, Linda T1 - A crazy little thing called sustainability T2 - 51st Annual Conference of the European Society for Engineering Education (SEFI) N2 - Achieving the 17 Sustainable Development Goals (SDGs) set by the United Nations (UN) in 2015 requires global collaboration between different stakeholders. Industry, and in particular engineers who shape industrial developments, have a special role to play as they are confronted with the responsibility to holistically reflect sustainability in industrial processes. This means that, in addition to the technical specifications, engineers must also question the effects of their own actions on an ecological, economic and social level in order to ensure sustainable action and contribute to the achievement of the SDGs. However, this requires competencies that enable engineers to apply all three pillars of sustainability to their own field of activity and to understand the global impact of industrial processes. In this context, it is relevant to understand how industry already reflects sustainability and to identify competences needed for sustainable development. KW - Transformative Competencies KW - Future Skills KW - Transdisciplinarity KW - Interdisciplinarity KW - Sustainability Y1 - 2023 U6 - https://doi.org/10.21427/9CQR-VC94 N1 - 51st Annual Conference of the European Society for Engineering Education, Technological University Dublin, 10th-14th September, 2023 ER -