TY  - JOUR
A1  - Reisert, Steffen
A1  - Schneider, Benno
A1  - Geissler, Hanno
A1  - Gompel, Matthias van
A1  - Wagner, Patrick
A1  - Schöning, Michael Josef
T1  - Multi-sensor chip for the investigation of different types of metal oxides for the detection of H2O2 in the ppm range
JF  - physica status solidi (a)
N2  - In this work, a multi-sensor chip for the investigation of the sensing properties of different types of metal oxides towards hydrogen peroxide in the ppm range is presented. The fabrication process and physical characterization of the multi-sensor chip are described. Pure SnO2 and WO3 as well as Pd- and Pt-doped SnO2 films are characterized in terms of their sensitivity to H2O2. The sensing films have been prepared by drop-coating of water-dispensed nano-powders. A physical characterization, including scanning electron microscopy and X-ray diffraction analysis of the deposited metal-oxide films, was done. From the measurements in hydrogen peroxide atmosphere, it could be shown, that all of the tested metal oxide films are suitable for the detection of H2O2 in the ppm range. The highest sensitivity and reproducibility was achieved using Pt-doped SnO2.

Calibration plot of a SnO2, WO3, Pt-, and Pd-doped SnO2 gas sensor for H2O2 concentrations in the ppm range.
Y1  - 2013
SN  - 1862-6319
VL  - 210
IS  - 5
SP  - 898
EP  - 904
PB  - Wiley
CY  - Weinheim
ER  - 
TY  - JOUR
A1  - Takenaga, Shoko
A1  - Schneider, Benno
A1  - Erbay, E.
A1  - Biselli, Manfred
A1  - Schnitzler, Thomas
A1  - Schöning, Michael Josef
A1  - Wagner, Torsten
T1  - Fabrication of biocompatible lab-on-chip devices for biomedical applications by means of a 3D-printing process
JF  - Physica status solidi (a)
N2  - A new microfluidic assembly method for semiconductor-based biosensors using 3D-printing technologies was proposed for a rapid and cost-efficient design of new sensor systems. The microfluidic unit is designed and printed by a 3D-printer in just a few hours and assembled on a light-addressable potentiometric sensor (LAPS) chip using a photo resin. The cell growth curves obtained from culturing cells within microfluidics-based LAPS systems were compared with cell growth curves in cell culture flasks to examine biocompatibility of the 3D-printed chips. Furthermore, an optimal cell culturing within microfluidics-based LAPS chips was achieved by adjusting the fetal calf serum concentrations of the cell culture medium, an important factor for the cell proliferation.
Y1  - 2015
U6  - http://dx.doi.org/10.1002/pssa.201532053
SN  - 1862-6319
VL  - 212
IS  - 6
SP  - 1347
EP  - 1352
PB  - Wiley
CY  - Weinheim
ER  -