TY  - JOUR
A1  - Harris, Isaac
A1  - Kleefeld, Andreas
T1  - The inverse scattering problem for a conductive boundary condition and transmission eigenvalues
JF  - Applicable Analysis
N2  - In this paper, we consider the inverse scattering problem associated with an inhomogeneous media with a conductive boundary. In particular, we are interested in two problems that arise from this inverse problem: the inverse conductivity problem and the corresponding interior transmission eigenvalue problem. The inverse conductivity problem is to recover the conductive boundary parameter from the measured scattering data. We prove that the measured scatted data uniquely determine the conductivity parameter as well as describe a direct algorithm to recover the conductivity. The interior transmission eigenvalue problem is an eigenvalue problem associated with the inverse scattering of such materials. We investigate the convergence of the eigenvalues as the conductivity parameter tends to zero as well as prove existence and discreteness for the case of an absorbing media. Lastly, several numerical and analytical results support the theory and we show that the inside–outside duality method can be used to reconstruct the interior conductive eigenvalues.
KW  - Transmission eigenvalues
KW  - Conductive boundary condition
KW  - Inverse scattering
Y1  - 2018
U6  - https://doi.org/10.1080/00036811.2018.1504028
SN  - 1563-504X
VL  - 99
IS  - 3
SP  - 508
EP  - 529
PB  - Taylor & Francis
CY  - London
ER  - 
TY  - JOUR
A1  - Hasan, Istabrak
A1  - Keil, Ludger
A1  - Staat, Manfred
A1  - Wahl, Gerhard
A1  - Bourauel, Christoph
T1  - Determination of the frictional coefficient of the implant-antler interface : experimental approach
JF  - Biomedical Engineering / Biomedizinische Technik
N2  - The similar bone structure of reindeer antler to human bone permits studying the osseointegration of dental implants in the jawbone. As the friction is one of the major factors that have a significant influence on the initial stability of immediately loaded dental implants, it is essential to define the frictional coefficient of the implant-antler interface. In this study, the kinetic frictional forces at the implant-antler interface were measured experimentally using an optomechanical setup and a stepping motor controller under different axial loads and sliding velocities. The corresponding mean values of the static and kinetic frictional coefficients were within the range of 0.5–0.7 and 0.3–0.5, respectively. An increase in the frictional forces with increasing applied axial loads was registered. The measurements showed an evidence of a decrease in the magnitude of the frictional coefficient with increasing sliding velocity. The results of this study provide a considerable assessment to clarify the suitable frictional coefficient to be used in the finite element contact analysis of antler specimens.
Y1  - 2012
SN  - 1862-278X
VL  - 57
IS  - 5
SP  - 359
EP  - 363
PB  - De Gruyter
CY  - Berlin
ER  - 
TY  - JOUR
A1  - Hauser, C.
A1  - Kotliar, Konstantin
A1  - Tholen, S.
A1  - Hasenau, A.
A1  - Suttmann, Y.
A1  - Renders, L.
A1  - Heemann, U.
A1  - Baumann, M.
A1  - Schmaderer, C.
T1  - Dynamische retinale Gefäßreaktion bei Hämodialysepatienten
JF  - Nieren- und Hochdruckkrankheiten
Y1  - 2015
U6  - https://doi.org/10.5414/NHX01743a
SN  - 0300-5224
VL  - 44
IS  - 11
SP  - 480
EP  - 480
PB  - Dustri-Verlag
CY  - Oberhaching
ER  - 
TY  - JOUR
A1  - Heel, Mareike van
A1  - Dikta, Gerhard
A1  - Braekers, Roel
T1  - Bootstrap based goodness‑of‑fit tests for binary multivariate regression models
JF  - Journal of the Korean Statistical Society
N2  - We consider a binary multivariate regression model where the conditional expectation of a binary variable given a higher-dimensional input variable belongs to a parametric family. Based on this, we introduce a model-based bootstrap (MBB) for higher-dimensional input variables. This test can be used to check whether a sequence of independent and identically distributed observations belongs to such a parametric family. The approach is based on the empirical residual process introduced by Stute (Ann Statist 25:613–641, 1997). In contrast to Stute and Zhu’s approach (2002) Stute & Zhu (Scandinavian J Statist 29:535–545, 2002), a transformation is not required. Thus, any problems associated with non-parametric regression estimation are avoided. As a result, the MBB method is much easier for users to implement. To illustrate the power of the MBB based tests, a small simulation study is performed. Compared to the approach of Stute & Zhu (Scandinavian J Statist 29:535–545, 2002), the simulations indicate a slightly improved power of the MBB based method. Finally, both methods are applied to a real data set.
Y1  - 2021
U6  - https://doi.org/10.1007/s42952-021-00142-4
SN  - 2005-2863 (Online)
SN  - 1226-3192 (Print)
N1  - Corresponding author: Mareike van Heel
VL  - 51
PB  - Springer Nature
CY  - Singapur
ER  - 
TY  - CHAP
A1  - Heer, Thomas
A1  - Redkowitz, Daniel
A1  - Kraft, Bodo
T1  - Tool Support for the Integration of Light-Weight Ontologies
N2  - Abstract of the authors: In many areas of computer science ontologies become more and more important. The use of ontologies for domain modeling often brings up the issue of ontology integration. The task of merging several ontologies, covering specific subdomains, into one united ontology has to be solved. Many approaches for ontology integration aim at automating the process of ontology alignment. However, a complete automation is not feasible, and user interaction is always required. Nevertheless, most ontology integration tools offer only very limited support for the interactive part of the integration process. In this paper, we present a novel approach for the interactive integration of ontologies. The result of the ontology integration is incrementally updated after each definition of a correspondence between ontology elements. The user is guided through the ontologies to be integrated. By restricting the possible user actions, the integrity of all defined correspondences is ensured by the tool we developed. We evaluated our tool by integrating different regulations concerning building design.
KW  - Ontologie <Wissensverarbeitung>
KW  - Knowledge Management
KW  - Ontology Engineering
KW  - Information Integration Tools
KW  - Human Factors
Y1  - 2008
SN  - 978-3-642-00670-8
ER  - 
TY  - JOUR
A1  - Heiden, W.
A1  - Turek, M.
A1  - Schöning, Michael Josef
T1  - TasteIT : Analyzing chemical sensor data using fuzzy logic
Y1  - 2011
SN  - 978-1-4244-9910-6
N1  - 2011 IEEE Workshop on Merging Fields of Computational Intelligence and Sensor Technology ; 11.-15. April 2011 Paris, France
SP  - 1
EP  - 6
PB  - IEEE
CY  - New York
ER  - 
TY  - JOUR
A1  - Heiden, W.
A1  - Turek, M.
A1  - Schöning, Michael Josef
T1  - Analysis of chemical sensor data
JF  - Proceedings of the 4th Russian-German Workshop "Innovation Information Technologies: Theory and practice" : Ufa, Russia, April 8-13, 2011 / eds. Yupsova, Nafisa ...
Y1  - 2011
SN  - 978-5-4221-0159-7
SP  - 76
EP  - 81
PB  - State Aviation Technical Univ.
CY  - Ufa
ER  - 
TY  - JOUR
A1  - Heiduschka, P.
A1  - Romann, I.
A1  - Ecken, H.
A1  - Schöning, Michael Josef
A1  - Schuhmann, W.
A1  - Thanos, S.
T1  - Defined adhesion and growth of neurones on artificial structured substrates
JF  - Scaling down in electrochemistry : electrochemical micro- and nanosystem technology ; proceedings of the 3rd International Symposium on Electrochemical Microsystem Technologies, Garmisch-Patenkirchen, Germany, 11 - 15 September 2000 / ed. by J. W. Schultz
Y1  - 2001
SN  - 0-08-044014-2
SP  - 299
EP  - 307
PB  - Elsevier [u.a.]
CY  - Amsterdam [u.a.]
ER  - 
TY  - JOUR
A1  - Heieis, Jule
A1  - Böcker, Jonas
A1  - D'Angelo, Olfa
A1  - Mittag, Uwe
A1  - Albracht, Kirsten
A1  - Schönau, Eckhard
A1  - Meyer, Andreas
A1  - Voigtmann, Thomas
A1  - Rittweger, Jörn
T1  - Curvature of gastrocnemius muscle fascicles as function of muscle–tendon complex length and contraction in humans
JF  - Physiological Reports
N2  - It has been shown that muscle fascicle curvature increases with increasing contraction level and decreasing muscle–tendon complex length. The analyses were done with limited examination windows concerning contraction level, muscle–tendon complex length, and/or intramuscular position of ultrasound imaging. With this study we aimed to investigate the correlation between fascicle arching and contraction, muscle–tendon complex length and their associated architectural parameters in gastrocnemius muscles to develop hypotheses concerning the fundamental mechanism of fascicle curving. Twelve participants were tested in five different positions (90°/105°*, 90°/90°*, 135°/90°*, 170°/90°*, and 170°/75°*; *knee/ankle angle). They performed isometric contractions at four different contraction levels (5%, 25%, 50%, and 75% of maximum voluntary contraction) in each position. Panoramic ultrasound images of gastrocnemius muscles were collected at rest and during constant contraction. Aponeuroses and fascicles were tracked in all ultrasound images and the parameters fascicle curvature, muscle–tendon complex strain, contraction level, pennation angle, fascicle length, fascicle strain, intramuscular position, sex and age group were analyzed by linear mixed effect models. Mean fascicle curvature of the medial gastrocnemius increased with contraction level (+5 m−1 from 0% to 100%; p = 0.006). Muscle–tendon complex length had no significant impact on mean fascicle curvature. Mean pennation angle (2.2 m−1 per 10°; p < 0.001), inverse mean fascicle length (20 m−1 per cm−1; p = 0.003), and mean fascicle strain (−0.07 m−1 per +10%; p = 0.004) correlated with mean fascicle curvature. Evidence has also been found for intermuscular, intramuscular, and sex-specific intramuscular differences of fascicle curving. Pennation angle and the inverse fascicle length show the highest predictive capacities for fascicle curving. Due to the strong correlations between pennation angle and fascicle curvature and the intramuscular pattern of curving we suggest for future studies to examine correlations between fascicle curvature and intramuscular fluid pressure.
KW  - biomechanics
KW  - connective tissue
KW  - physiology
KW  - ultrasound
Y1  - 2023
U6  - https://doi.org/10.14814/phy2.15739
SN  - 2051-817X
VL  - 11
IS  - 11
SP  - e15739, Seite 1-11
PB  - Wiley
ER  - 
TY  - JOUR
A1  - Heinke, Lars N.
A1  - Knicker, Axel J.
A1  - Albracht, Kirsten
T1  - Evaluation of passively induced shoulder stretch reflex using an isokinetic dynamometer in male overhead athletes
JF  - Isokinetics and Exercise Science
N2  - BACKGROUND: Muscle stretch reflexes are widely considered to beneficially influence joint stability and power generation in the lower limbs. While in the upper limbs and especially in the muscles surrounding the shoulder joint such evidence is lacking. OBJECTIVE: To quantify the electromyographical response in the muscles crossing the shoulder of specifically trained overhead athletes to an anterior perturbation force. METHODS: Twenty healthy male participants performed six sets of different external shoulder rotation stretches on an isokinetic dynamometer over a range of amplitudes and muscle pre-activation moment levels. All stretches were applied with a dynamometer acceleration of 10,000∘/s2 and a velocity of 150∘/s. Electromyographical response was measured via sEMG. RESULTS: Consistent reflexes were not observed in all experimental conditions. The reflex latencies revealed a significant muscle main effect (F (2,228) = 99.31, p< 0.001; η2= 0.466; f= 0.934) and a pre-activation main effect (F (1,228) = 142.21, p< 0.001; η2= 0.384; f= 1.418). The stretch reflex amplitude yielded a significant pre-activation main effect (F (1,222) = 470.373, p< 0.001; η2= 0.679; f= 1.454). CONCLUSION: Short latency muscle reflexes showed a tendency to an anterior to posterior muscle recruitment whereby the main internal rotator muscles of the shoulder revealed the most consistent results.
Y1  - 2018
U6  - https://doi.org/10.3233/IES-184111
SN  - 1878-5913
VL  - 26
IS  - 4
SP  - 265
EP  - 274
PB  - IOS Press
CY  - Amsterdam
ER  -