TY  - JOUR
A1  - Moritz, W.
A1  - Yoshinobu, T.
A1  - Finger, F.
A1  - Krause, S.
A1  - Martin-Fernandez, M.
A1  - Schöning, Michael Josef
T1  - High resolution LAPS using amorphous silicon as the semiconductor material
JF  - Sensors and Actuators B. 103 (2004), H. 1-2
Y1  - 2004
SN  - 0925-4005
SP  - 436
EP  - 444
ER  - 
TY  - JOUR
A1  - Moret, J.L.T.M.
A1  - Alkemade, J.
A1  - Upcraft, T.M.
A1  - Paulßen, Elisabeth
A1  - Wolterbeek, H.T.
A1  - Ommen, J.R. van
A1  - Denkova, A.G.
T1  - The application of atomic layer deposition in the production of sorbents for ⁹⁹Mo/⁹⁹ᵐTc generator
JF  - Applied Radiation and Isotopes
N2  - New production routes for ⁹⁹Mo are steadily gaining importance. However, the obtained specific activity is much lower than currently produced by the fission of U-235. To be able to supply hospitals with ⁹⁹Mo/⁹⁹ᵐTc generators with the desired activity, the adsorption capacity of the column material should be increased. In this paper we have investigated whether the gas phase coating technique Atomic Layer Deposition (ALD), which can deposit ultra-thin layers on high surface area materials, can be used to attain materials with high adsorption capacity for ⁹⁹Mo. For this purpose, ALD was applied on a silica-core sorbent material to coat it with a thin layer of alumina. This sorbent material shows to have a maximum adsorption capacity of 120 mg/g and has a ⁹⁹ᵐTc elution efficiency of 55 ± 2% based on 3 executive elutions.
Y1  - 2020
U6  - https://doi.org/10.1016/j.apradiso.2020.109266
SN  - 0969-8043
VL  - 164
IS  - 109266
PB  - Elsevier
CY  - Amsterdam
ER  - 
TY  - CHAP
A1  - Moreno, Lia
A1  - Dosev, D.
A1  - Bratov, A.
A1  - Dominguez, C.
A1  - Schöning, Michael Josef
A1  - Kloock, Joachim P.
T1  - Effect of electrical properties of the surrounding medium on the response of an interdigitated electrode array with chalcogenide glass film
T2  - XX Eurosensors : 20th anniversary ; Göteborg, Sweden, 17 - 20 September 2006 ; [proceedings]. - Vol. 1
Y1  - 2006
SN  - 978-91-631-9280-7
N1  - Paper number: T1A-P22
SP  - 384
EP  - 385
CY  - Göteborg
ER  - 
TY  - JOUR
A1  - Moreno i Codinachs, Lia
A1  - Kloock, Joachim P.
A1  - Schöning, Michael Josef
A1  - Baldi, Antoni
A1  - Ipatov, Andrey
A1  - Bratov, Andrey
A1  - Jimenez-Jorquera, Cecilia
T1  - Electronic integrated multisensor tongue applied to grape juice and wine analysis
JF  - Analyst. 133 (2008)
Y1  - 2008
SN  - 1364-5528
SP  - 1440
EP  - 1448
ER  - 
TY  - JOUR
A1  - Moreno i Codinachs, L.
A1  - Birkenstock, C.
A1  - Garma, T.
A1  - Zierold, R.
A1  - Bachmann, J.
A1  - Nielsch, K.
A1  - Schöning, Michael Josef
A1  - Fontcuberta i Morral, A.
T1  - A micron-sized nanoporous multifunction sensing device
JF  - physica status solidi (a) . 206 (2009), H. 3
Y1  - 2009
SN  - 1862-6319
N1  - Special Issue: Engineering of Functional Interfaces (EnFI 08)
SP  - 435
EP  - 441
PB  - Wiley
CY  - Weinheim
ER  - 
TY  - JOUR
A1  - Morat, Mareike
A1  - Faude, Oliver
A1  - Hanssen, Henner
A1  - Ludyga, Sebastian
A1  - Zacher, Jonas
A1  - Eibl, Angi
A1  - Albracht, Kirsten
A1  - Donath, Lars
T1  - Agility Training to Integratively Promote Neuromuscular, Cognitive, Cardiovascular and Psychosocial Function in Healthy Older Adults: A Study Protocol of a One-Year Randomized-Controlled Trial
JF  - International Journal of Environmental Research and Public Health
N2  - Exercise training effectively mitigates aging-induced health and fitness impairments. Traditional training recommendations for the elderly focus separately on relevant physiological fitness domains, such as balance, flexibility, strength and endurance. Thus, a more holistic and functional training framework is needed. The proposed agility training concept integratively tackles spatial orientation, stop and go, balance and strength. The presented protocol aims at introducing a two-armed, one-year randomized controlled trial, evaluating the effects of this concept on neuromuscular, cardiovascular, cognitive and psychosocial health outcomes in healthy older adults. Eighty-five participants were enrolled in this ongoing trial. Seventy-nine participants completed baseline testing and were block-randomized to the agility training group or the inactive control group. All participants undergo pre- and post-testing with interim assessment after six months. The intervention group currently receives supervised, group-based agility training twice a week over one year, with progressively demanding perceptual, cognitive and physical exercises. Knee extension strength, reactive balance, dual task gait speed and the Agility Challenge for the Elderly (ACE) serve as primary endpoints and neuromuscular, cognitive, cardiovascular, and psychosocial meassures serve as surrogate secondary outcomes. Our protocol promotes a comprehensive exercise training concept for older adults, that might facilitate stakeholders in health and exercise to stimulate relevant health outcomes without relying on excessively time-consuming physical activity recommendations.
KW  - agility
KW  - prevention
KW  - healthy aging
KW  - community dwelling
KW  - psychosocial
Y1  - 2020
U6  - https://doi.org/10.3390/ijerph17061853
SN  - 1660-4601
VL  - 17
IS  - 6
SP  - 1
EP  - 14
PB  - MDPI
CY  - Basel
ER  - 
TY  - JOUR
A1  - Morandi, Paolo
A1  - Butenweg, Christoph
A1  - Breis, Khaled
A1  - Beyer, Katrin
A1  - Magenes, Guido
ED  - Ansal, Atilla
T1  - Latest findings on the behaviour factor q for the seismic design of URM buildings
JF  - Bulletin of Earthquake Engineering
N2  - Recent earthquakes as the 2012 Emilia earthquake sequence showed that recently built unreinforced masonry (URM) buildings behaved much better than expected and sustained, despite the maximum PGA values ranged between 0.20–0.30 g, either minor damage or structural damage that is deemed repairable. Especially low-rise residential and commercial masonry buildings with a code-conforming seismic design and detailing behaved in general very well without substantial damages. The low damage grades of modern masonry buildings that was observed during this earthquake series highlighted again that codified design procedures based on linear analysis can be rather conservative. Although advances in simulation tools make nonlinear calculation methods more readily accessible to designers, linear analyses will still be the standard design method for years to come. The present paper aims to improve the linear seismic design method by providing a proper definition of the q-factor of URM buildings. These q-factors are derived for low-rise URM buildings with rigid diaphragms which represent recent construction practise in low to moderate seismic areas of Italy and Germany. The behaviour factor components for deformation and energy dissipation capacity and for overstrength due to the redistribution of forces are derived by means of pushover analyses. Furthermore, considerations on the behaviour factor component due to other sources of overstrength in masonry buildings are presented. As a result of the investigations, rationally based values of the behaviour factor q to be used in linear analyses in the range of 2.0–3.0 are proposed.
KW  - Unreinforced masonry buildings
KW  - Modern constructions
KW  - Seismic design
KW  - Linear elastic analysis
KW  - Behaviour factor q
Y1  - 2022
U6  - https://doi.org/10.1007/s10518-022-01419-7
SN  - 1573-1456
SN  - 1570-761X
VL  - 20
IS  - 11
SP  - 5797
EP  - 5848
PB  - Springer Nature
CY  - Cham
ER  - 
TY  - CHAP
A1  - Morandi, Paolo
A1  - Butenweg, Christoph
A1  - Breis, Khaled
A1  - Beyer, Katrin
A1  - Magenes, Guido
ED  - Arion, Cristian
ED  - Scupin, Alexandra
ED  - Ţigănescu, Alexandru
T1  - Behaviour factor q for the seismic design of URM buildings
T2  - The Third European Conference on Earthquake Engineering and Seismology
N2  - Recent earthquakes showed that low-rise URM buildings following codecompliant seismic design and details behaved in general very well without substantial damages. Although advances in simulation tools make nonlinear calculation methods more readily accessible to designers, linear analyses will still be the standard design method for years to come. The present paper aims to improve the linear seismic design method by providing a proper definition of the q-factor of URM buildings. Values of q-factors are derived for low-rise URM buildings with rigid diaphragms, with reference to modern structural configurations realized in low to moderate seismic areas of Italy and Germany. The behaviour factor components for deformation and energy dissipation capacity and for overstrength due to the redistribution of forces are derived by means of pushover analyses. As a result of the investigations, rationally based values of the behaviour factor q to be used in linear analyses in the range of 2.0 to 3.0 are proposed.
KW  - unreinforced masonry buildings
KW  - modern constructions
KW  - seismic design
KW  - linear elastic analysis;
KW  - behaviour factor q
Y1  - 2022
SN  - 978-973-100-533-1
N1  - 3ECEES - Third European Conference on Earthquake Engineering and Seismology, September 4 – September 9, 2022, Bucharest
SP  - 1184
EP  - 1194
ER  - 
TY  - JOUR
A1  - Morais, Paulo V.
A1  - Suman, Pedro H.
A1  - Schöning, Michael Josef
A1  - Siqueira Junior, José R.
A1  - Orlandi, Marcelo O.
T1  - Layer-by-layer film based on Sn₃O₄ nanobelts as sensing units to detect heavy metals using a capacitive field-effect sensor platform
JF  - Chemosensors
N2  - Lead and nickel, as heavy metals, are still used in industrial processes, and are classified as “environmental health hazards” due to their toxicity and polluting potential. The detection of heavy metals can prevent environmental pollution at toxic levels that are critical to human health. In this sense, the electrolyte–insulator–semiconductor (EIS) field-effect sensor is an attractive sensing platform concerning the fabrication of reusable and robust sensors to detect such substances. This study is aimed to fabricate a sensing unit on an EIS device based on Sn₃O₄ nanobelts embedded in a polyelectrolyte matrix of polyvinylpyrrolidone (PVP) and polyacrylic acid (PAA) using the layer-by-layer (LbL) technique. The EIS-Sn₃O₄ sensor exhibited enhanced electrochemical performance for detecting Pb²⁺ and Ni²⁺ ions, revealing a higher affinity for Pb²⁺ ions, with sensitivities of ca. 25.8 mV/decade and 2.4 mV/decade, respectively. Such results indicate that Sn₃O₄ nanobelts can contemplate a feasible proof-of-concept capacitive field-effect sensor for heavy metal detection, envisaging other future studies focusing on environmental monitoring.
KW  - Sn₃O₄
KW  - nanobelts
KW  - field-effect sensor
KW  - LbL films
KW  - heavy metals
Y1  - 2023
U6  - https://doi.org/10.3390/chemosensors11080436
SN  - 2227-9040
N1  - This article belongs to the Special Issue The Application of Electrochemical Sensors or Biosensors Based on Nanomaterials
VL  - 11
IS  - 8
PB  - MDPI
CY  - Basel
ER  - 
TY  - JOUR
A1  - Morais, Paulo V.
A1  - Silva, Anielle C. A.
A1  - Dantas, Noelio O.
A1  - Schöning, Michael Josef
A1  - Siqueira, José R., Jr.
T1  - Hybrid Layer‐by‐Layer Film of Polyelectrolytes‐Embedded Catalytic CoFe2O4 Nanocrystals as Sensing Units in Capacitive Electrolyte‐Insulator‐Semiconductor Devices
JF  - physica status solidi a : applications and materials sciences
Y1  - 2019
U6  - https://doi.org/10.1002/pssa.201900044
VL  - 216
IS  - 1900044
SP  - 1
EP  - 9
PB  - Wiley
CY  - Weinheim
ER  -